Bus

The FS5000 Jitterlyzer performs physical layer serial bus jitter evaluation. It can inject controlled jitter and measure the characteristics of incoming jitter. When teamed with a protocol analyzer, it can correlate these measurements with protocol analysis . The benefits of this low-cost solution are numerous. Physical-layer tests can be perf ...more

onTAP provides comprehensive boundary-scan test development tools with powerful run time software including pin-level diagnostics. onTAP provides everything required for robust JTAG test solutions. Robust ATPG for high fault coverage and precise pin-level diagnostics. Interconnect, Bus Wire, Pull-up/Pull-down, TAP Infrastructure tests, Shorts ...more

MIL-STD-1553 A, B, & McAir MULTI PROTOCOLS Simulator/Analyzer/Tester type 2 PCMCIA BUS Interface Card - The PC401 can be used for Validation Testing, ProductionTesting, full bus simulation and monitoring, as a generalpurpose 1553 interface or a stand alone bus Analyzer. Forprecise message scheduling and measurements, the Majorand minor fra ...more

MIL-STD-1553 A, B & McAir MULTI PROTOCOLS Simulator / Analyzer / Tester CPCI BUS Interface Card - The CPCI301 can be used for Validation Testing, Production Testing, full bus simulation and monitoring, as a general purpose 1553 interface or a stand alone bus Analyzer. For precise message scheduling and measurements, the Major and minor fra ...more

Traditionally, PC-based waveform digitizers provide raw data to user applications which then analyze the data on the host PC using techniques such as peak detection. Often waveform data throughput exceeds the capacity of the data bus or the speed of traditional peak detection analysis routines. For these requirements, GaGe now offers on-board ...more

The PDA16 is a dual channel waveform capture board that provides a remarkable combination of high speed and high resolution sampling along with a very large memory capacity. Signal frequencies up to 700 MHz can be accurately captured either in baseband or in higher order Nyquist zones using under-sampling techniques. The PDA16 is a PCI/PCI-X 64-b ...more

The CP213 is a single-width, 6U, CompactPCI/PXI module with either 32 or 64 differential analog input channels that can alternately be configured under software control as 64 or 128 single-ended analog input channels. A 16-bit ADC scans each channel at a scan rate chosen by the user. The number of channels scanned and scan rate are software se ...more

The Vanguard PCI Bus Analyzer is a complete solution for PCI/PCI-X debug, analysis, exercising, protocol detection, and compliance checking. It includes a 10/100 Mbit/s Ethernet interface, taking the power and flexibility found in VMETRO's range of Bus Analyzers to unprecedented levels of productivity. The bus analyzer is controlled via USB or ...more

Fixed Frequency CompactPCI electronic filter/amplifier cards from 1.0 Hz to 100 kHz. ...more

USB to GPIB Controller Module for WIN PCs with an USB bus. Converts any PC with a USB interface into a full-function, IEEE 488.2 Bus Controller. The 488-USB performs all of the basic IEEE 488.1 functions such as talker, listener and system controller. Its IEEE-488.2 controller routines make it fully compliant with the IEEE 488.2 specification. ...more

USB-to-GPIB Hub Controller controls GPIB instruments and provides 6 powered USB ports for controlling USB instruments or for adding devices to the USB bus. Includes ICS and National Instruments style 488.2 drivers, ICS's enhanced GPIBkybd Controller program, demo programs, test utilities, USB cable and Instruction Manual. ...more

The Model 4842 GPIB Bus Switch is a GPIBcontrolled switch that enables several GPIBControllers to share one or more GPIBdevice(s) or lets a single GPIB Controlleroperate multiple Bus systems. The 4842 isbasically a GPIB controlled A-B-C switch forthe GPIB bus. When used as a Bus Switch, the4842 lets a GPIB controller connected to thecommon por ...more

Model 4860A GPIB Bus Isolated Expander provides 2000 volts of isolation between two GPIB buses and drives up to 14 additional bus devices. Automatically locates Bus talker to eliminate address switches. IEEE-488.2 compatible. ...more

Model 4862 Bus Expander expands bus drive current to handle 14 additional devices. Automatically locates Bus talker to eliminate address switches. IEEE-488.2 compatible. ...more

A IEEE-488.2 GPIB to digital interface with 40 I/O lines that can be used to easily adapt devices with digital signals to the IEEE-488/GPIB/HP-IP bus. Signal monitor feature allows the 4803 to detect signal changes on 15 inputs. High-current drivers and input pullup resistors. Drives more devices, longer lines and inputs CMOS signals or switch ...more

An enhanced bidirectional IEEE-488.2/GPIB to serial interface that can be used to adapt devices with RS-232 and RS-485 (RS-422) serial interfaces to the GPIB Bus. A 256 Kbyte RAM buffers up to 252,000 characters and frees the computer for other tasks while the 4894B transparently transfers data to or from the serial device when in the G mode. ...more

90MHz 32-bit Motorola Coldfire M5307 CPU, with a processing capacity of 75 MIPS; 16MB SDRAM, 2MB Flash Memory; One 10M Ethernet 10BASET Interface (RJ45), two Asynchronous Serial-ports (UART), one I2C Bus Interface, Real-time Clock, Watchdog Timer Hardware, Four-channel DMA and Dual 16-bit Timers; Two 84-line connectors connecting almost all da ...more

The 40-569 PXI Matrix BRIC provides a range of high density bus matrix inputs and resource distributor bussed configurations capable of switching up to 2A and up to 250V AC/220V DC. The 40-569 BRIC modules are available in 4 or 8 slot PXI sizes and are constructed using high quality electromechanical relays. Typical applications include signal ...more

VMEbus fixed frequency and programmable filter products from 1.0 Hz to 2.0 MHz and fixed and programmable amplifier products from -12 dB to +60 dB. ...more

The Vanguard PMC Bus Analyzer is a complete solution for PCI / PCI-X analysis, exercising, protocol detection, and compliance checking in a PMC environment. The product includes a 10/100 Mbit/s Ethernet interface, taking the power and flexibility found in VMETRO's range of Bus Analyzers to unprecedented levels of productivity. ...more

A wide range of PXI modules is available for the communication with bus systems, especially for automotive applications. They support the CAN-bus, the K-line and the LIN-bus. Every communication port has its own microcontroller on the module, i.e. realtime capability of the single ports is ensured. The communciation cards are easily integrated ...more

The Model 58542 provides faster CW measurements than any other VXIbus power meter, with readings over the GPIB exceeding 150 readings per second and an exclusive Burst Mode capturing more than 5000 readings per second. The Model 58542 also lets you measure pulsed RF signals simply by using a Giga-tronics peak power sensor, while a detector out ...more

High-performance, economical USB1.1/2.0 protocol analyzer - vital for USB developers and debugging! $2999.00 ...more

The VX402C-64 Active Module Carrier allows a 3U or 6U VME, VXI (A or B), or VME64 module to be used in a C-size VXI mainframe chassis. The carrier provides an actively buffered electrical interface for the standard bus signals. ...more

The Dual/Quad 10/100-TX Mb/s Ethernet Adapter provides up to four Ethernet connections over twisted pair media. Options are available for Front-Panel RJ45 accessibility, or Rear I/O accessibility via a VITA 36 PIM module. The card is built around Intel 82551ER Ethernet controllers that provide an integrated media access controller (MAC) and physica ...more