Showing product results. 451 - 465 of 1410 products found.
-
Tinius Olsen
This new moisture analyzer is less expensive, just as swift to generate a result, and as accurate as comparable heat and weigh or microwave technique-based testers. The patented method of the HydroTracer determines the absolute water content where the mass of the water is measured within the reactor.
-
LAR Process Analysers AG
Relative humidity (RH) is the ratio of the partial pressure of water vapor to the equilibrium vapor pressure of water at a given temperature. A relative humidity meter or hygrometer measures the relative humidity in the air.High-precision relative humidity and temperature meter (hygrometer) for industrial use.
-
M5310 C - SUEZ Water Technologies & Solutions
Sievers M5310 C Total Organic Carbon (TOC) Analyzers are designed for the drinking water industry and environmental water quality monitoring. Offering an operating range of 4 ppb to 50 ppm, these analyzers are engineered to support disinfection byproduct compliance.
-
Los Gatos Research, Inc.
The Dissolved Gas Extraction Unit (DGEU) allows continuous concentration measurements of dissolved gases in water and other liquids in real time*. The DGEU extracts gas from a liquid stream through an internal hydrophobic micro-porous membrane (comprised of polypropylene hollow fibers). Internal water and gas pumps and mass flow controllers allow precise control of flow rates and pressures of the liquid in the DGEU and the strip gas which is sent to the gas analyzer. By accurately controlling the water flow rate through the membrane, gas pressure on the outside of the membrane, and water pressure on the inside of the membrane, the DGEU is able to generate precise and reproducible results.
-
Premier Electrosystems
Premier Electrosystems' Standing Loss System is used to calculate the energy consumption measurement of a filled water heater, after steady state conditions have been reached when connected to electrical supply and when no water is drawn for a minimum of 48 hours.The star rating for the electric geysers is given based on the standing losses. Standing loss or heat/energy loss of a water heater to the surrounding in 48 hours is an important factor used by BEE (Bureau of Energy Efficiency) to decide on star rating of a water heater. The unit of Standing Loss is Energy consumed per 24 hrs for a difference of 45 ° C (kWh/24 hrs/ 45 ° C).
-
Meggitt
Our high performance analytical systems have been used in the nuclear industry since 1980. They enable operators to monitor hydrogen and oxygen levels at critical locations within both boiling water reactors (BWR) and pressurised water reactors (PWR).
-
HR8005 - HighReach Measuring & Controlling System Co.,Ltd
HR8005 input high temperature liquid level transmitter is used to measure the water level and water temperature change of high temperature surge well, digital temperature error compensation in full temperature zone, and store the compensation parameters in non-volatile memory.
-
CD601 - Milwaukee Instruments
The Milwaukee CD601 digital electrical conductivity (EC) Pen is designed for aquariums, aquaculture, pools, water conditioning and many other applications. The CD601 helps you make sure that your water has the right amount of nutrient to help keep fish tanks healthy or helps you keep your filters up-to-date and clean for water filtration. Keep EC in your target range to help your achieve better results.
-
NUL-229 - Neulog
This logger sensor is based on measuring the partial vacuum pressure in a tensiometer. A tensiometer is a closed tube with a special ceramic part in its end. The tensiometer is filled with water and put in the soil. If the soil is dry, water goes out by diffusion through the ceramic holes and partial vacuum pressure is created in the tensiometer. When we wet the soil, the partial vacuum in the tensiometer pulls water into the tensiometer and the vacuum decreases. This is why soil moisture is measured in pressure level.
-
Hach Lange GmbH
Hach has developed deep expertise in turbidity measurement. Our instruments continuously deliver superior accuracy and reliable results for both ultra clean and high turbidity water applications. Hach's complete portfolio of both laboratory and portable instruments provides solutions for all of your challenging municipal or industrial applications. From drinking water, to chemical, to pharmaceutical, to food processing, to waste water we offer the best turbidity instrument for y...
-
STAG RP1 - Baraldi S.r.l.
Water based innovative product, Slight cooling power on the butt shear.
-
KF Titrando - Metrohm AG
High-end titrators for determining any water content from 0.001 to 100%
-
-
-
KL-138 - Kelilong Electron Co.Ltd,
Its result is read out directly from its meter head with 4-digits LCD display. It is an ideal instrument to examine whether the protective water or inspected water is conforming to the standard or not. The instrument is convenient, accurate, portable and easy to operate, especially for field measurement.
