Systems
are interconnected groups of purpose.
See Also: Equipment, Test Systems, System Integrators, System Test
-
product
Human Vibration Software Modules
Metra Mess- und Frequenztechnik in Radebeul e.K.
*Component of VibroMetra system*Measurement of hand - arm vibrations to EN ISO 5349:2001*One, two or three axes possible*Measuring duration from 1 minute to 1 day *High reliability by user guidance*Good / Bad evaluation of the results*Results are stored in a calculation sheet for the daily exposure A(8) which may include several activities, no external software required, Excel export possible*Offline measurement
-
product
DSP Based Serial Communication Board
CPCI-ISC8
The CPCI-ISC8 is an intelligent DSP based serial communication board. This 3U board is based on the CPCIIPC product and has been modified to remove the IPinterface and to support additional I/O features. The CPCIISC8 provides mechanical support and the electrical interfaces for an I/O mezzanine board. Multiple CPCI-ISC8 boards may be installed in a single system.
-
product
SKYbolt II 6U VME 8-Slot
Delivering performance of 16 GFLOPS the SKYbolt II 6U VME solution adds intelligent support for system services and high-performance data transfers as the carrier board for the Merlin daughtercard which contains the compute processors, I/O interfaces, and global memory
-
product
Residual Gas Analyzer System
LRGAS-100, -200, -300
Complete with RGA sensor, software, & electronics, vacuum pumping system, and mobile cart.Variety of sampling fittings.Automatic pump down.100, 200, or 300 amu sensor.Standard model contains an 80 L/s turbo pumping system with stainless steel manifold.Small footprint.Plugs into a common 120 VAC power outlet.Full front panel control.
-
product
Motor Vehicle Inspect Lines Engineer Program
Foshan Analytical Instrument Co, Ltd.
It is suitable for measurement of motor vehicles equipped ignition engine with max total mass more than 3500kg. Including the dual idle speed method test. Meet the requirement of GB18285-2005"Limits and Measurement Methods for Exhaust Pollutomts from Vehicles Equipped Igintion Eigine under Two-speed Idle conditions and simple Driving Mode Conditions". The system can select the prompt mode of the dirver mode or the prompt mode of lattice screen.
-
product
5 kW and 10 kW RP7900 Series Regenerative Power System
RP7900 Series
The RP7900 Series regenerative power system is a family of 5 kW and 10 kW bi-directional, regenerative DC power supplies that reduces the cost of test with highly integrated capabilities. The regenerative capability enables the energy consumed to be put back onto the grid cleanly, saving costs from energy consumption and cooling, while not interfering with the grid. The RP7900 helps you overcome your toughest power test challenges by delivering industry-leading specifications and innovative features in an integrated solution for today's advanced high power automated test equipment (ATE)power testing needs. The RP7900 provides the fastest, most accurate, integrated regenerative power system.
-
product
160W Triple Output Power Supply, 6V, 10A & 2X 25V, 2A
E36313A
The 160-Watt E36313A is a clean reliable bench power supply for general purpose applications. It combines convenient benchtop capabilities with flexible system features in a compact intuitive package. This is one of three models in this product family. The E36312A (80 W)offers the same feature set with reduced power and the E36311A (80 W) is the most economic model with reduced feature set.
-
product
Battery Conductance and Electrical System Tester
MDX-P300
The MDX-P300 is the first tester available from Midtronics which features an integrated printer allowing for immediate printing of test results. Now it is easier than ever to show thecurrent state of the battery and electrical system by providing customers with a printed result of the battery and system test. Using patented Conductance Technology, perform a quick, simple, and accurate battery or system test in seconds, and review the printout with the customer for added impact to preventive maintenance routines and customer service.
-
product
10GbE Network Attached Storage
HSR10
Curtiss-Wright Defense Solutions
The High-Speed Recorder 10 (HSR10) is a network attached storage (NAS) device designed for high-speed network recording based on a double 10 Gigabit Ethernet (GbE) port layout. What’s more, to adhere to security requirements for mission-critical applications, this unit is designed with two-layer encryption and follows industry-standard NAS protocols permitting system design flexibility.
-
product
PDS Motion Scan
Allows a 3D Scanning sonar user to collect motion compensated 3D point clouds from a moving platformTeledyne PDS MotionScan system allows a 3D Scanning sonar user to collect motion compensated 3D point clouds from a moving platform. The MotionScan system is comprised of: an RTK capable dual antenna GPS with precision heading output, a heave, pitch and roll sensor, a topside control console. In combination with a BlueView 3D Multibeam Scanning Sonar this creates a full survey package.
-
product
240V Socket Tester Check Plug
CP501
The most popular socket tester available - detects 28 fault conditions.
A quick and easy way to ensure that 13A sockets are correctly wired, indicated by 3 bright long life LEDs.
Wiring faults are indicated by one or more of the LEDs failing to illuminate, with the pattern of lit LEDs indicating the type of fault detected. This fail-safe system means that any LED not lit indicates a fault. The robust ABS housing has a sculpted shape for easy removal and there is a look up chart on the tester for quick fault diagnosis.
The plug induces less than 5mA of earth leakage, well below RCD trip thresholds.
-
product
High-Resolution VMEbus Laser Axis Board
10897D
The 10897D High-resolution VMEbus laser axis board provides excellent resolution of up to 0.3 nm with a high resolution interferometer. The data age uncertainty is dramatically reduced allowing extremely accurate measurement and control of moving systems. The very high data rates accommodate high-bandwidth and high-performance closed-loop applications. Configured with appropriate lasers and optics components, the 10897D supplies unsurpassed positioning accuracy for dynamic measurement.
-
product
2x8 QPSK Mixer
To be used for optical coherent detection such as DP-QPSK receivers, Optoplex’s ten-port 2x8 Coherent Mixer (aka QPSK mixer) combines the incoming signal with a local oscillator to generate eight light states in the complex-field space. The eight light output signals can then be coupled into four pairs of balanced detectors. The block diagram below shows the application of a 2x8 coherent mixer in a DP-QPSK receiver. Since the mixing process is data rate independent, the devices can be used for any data rate in applications such as 40Gb/s or 100Gb/s transmission systems.
-
product
Tire Rolling Resistance Test System
This system measures the rolling resistance of each tire accurately. In addition to the simultaneous measurement of tire loss resistance and rolling resistance coefficient for each drive by mode operation (JC08, WLTC), coasting test, constant acceleration/deceleration test and transient mode test are able to be performed. Furthermore, measurement of driving noise/ vibration of the tire, effect of the tire loss due to the temperature change can be verified by adding options.Conforming the JIS D 4234: 2009 and ISO 28580: 2009.
-
product
PCI Resistor Card 4-Channel 1 Ohm To 63.7 Ohm
50-293-011
The 50-293 is a Programmable Resistor card with either two channels of 16-bit or four channels of 8-bit resistor chains in a single PCI card. The card is ideal for simulating sensors for control and management systems under test, allowing the user to verify system response in design verification or manufacturing test applications.
-
product
System Simulation Software
SimulationX
Not only does it cover more physical domains than the competition including the all-new new libraries for acoustics and electric power. It is also the sheer endless possibilities of this utterly flexible tool to integrate with virtually any development environment through various interfaces, add-ins and export functionalities.
-
product
Standalone with Drop-In Test Systems
800 Series ATE
The Circuit Check 800 Series ATE provides the versatility of utilizing the economical drop-in fixturing present in the 600 Series or an integrated dedicated fixture, while simultaneously providing the increased test equipment capacity of the 1000 Series. This combination produces a cost effective full turnkey test solution.
-
product
AC DC Test Equipment
The products impress with a variety of technical features: TFT display, Ethernet interface, automatic test sequence to a fully electronic generator for even faster and more accurate tests. Our safety testers can be used both stand-alone without a PC as well as integrate with existing systems.
-
product
Advanced Power Supply
N6900 Series
The Advanced Power System (APS) N6900 Series power supply is ideal for automated test equipment (ATE) applications where high performance is critical. Adding any combination of the four performance options will increase performance where you want it most. Versatility has never been faster.
-
product
Radar Input and Scan Conversion
Cougar
Curtiss-Wright Defense Solutions
Cougar is an open standards-based high performance solution for capturing, converting and mixing radar video. Cougar is available as a VME card set or as part of a turnkey solution ready for deployment. The two-slot VME modular Cougar system provides the complete functionality required to integrate and implement a wide range of radar input/scan conversion configurations for demanding, embedded military applications.
-
product
PCI Data Acquisition Boards
AD8CH12B-100DMA Series - Single low-spur 8-bit, 100 MS/s
Model AD8CH12-100DMA has eight simultaneous-sampling 12-bit A/D converters, and can continuously acquire and transfer hundreds of megabytes or even gigabytes of A/D data directly into host system memory at up to 100 MB/s, via 64 or 32 bit PCIbus DMA. It can acquire and transfer eight 8-bit A/D channels at up to 12.5 MSPS each (100MB/sec aggregate), or eight 12-bit A/D channels at up to 6.25 MSPS each, or four 8-bit channels at up to 25 MSPS each, or four 12-bit channels at up to 12.5 MSPS each.
-
product
Micromachining Laser Systems
Versatility in terms of materials Taper controlled drilling Only top – quality components Intelligent laser machining software Beam focus adjustment Beam power (pulse energy) control Many options for system customization Table top system Small footprint Cost effective workstation User-friendly, flexible, upgradeable system control
-
product
Diving Technology Test Systems
Ingenieurbüro Dr. Hillger Ultrasonic-Techniques
The imaging ultrasonic testing systems of the USPC 30XX series are optimized for testing a wide variety of materials and provide high-resolution findings in the form of A, B, C, D and F images. The hardware consists of an industrial PC, in which a motor controller and an ADC card are installed, as well as a HILL-SCAN pulser/receiver unit. An overview of the available systems is given in Table 1.
-
product
ARINC 615A Software Data Loader and Loader Target Development Kits
Avionics Interface Technologies
AIT provides 615A software libraries which can be embedded into a variety of host avionics systems to support both data loader and target side ARINC 615A operations.
-
product
Magnet Testing
RMP Rotor Measuring Station
The RMP Rotor Measuring Station is a universal measuring system for the precise measurement and quality control of multi-pole permanent magnet rotors.
-
product
System for the Analysis of 10/25/40/50/100Gbps Ethernet and Gen 6 (32GFC) Fibre Channel
SierraNet T328
The SierraNet T328 system provides for analysis of 10/25/40/50/100Gbps Ethernet and Gen 6 (32GFC) Fibre Channel data capture and protocol verification for developers & protocol test engineers in LAN, SAN, NAS and other Ethernet and Fibre Channel applications. Available with eight SFP28 FlexPorts™ for maximum configuration and utility, the SierraNet T328 includes an easy to use, customizable software interface, large capture buffers, and the most advanced T.A.P4 capture, triggering and filtering capabilities in the industry.
-
product
Hydrophone Booster Amplifier
Optional enhancement to the basic hydrophone measurement system to provide further amplification of the hydrophone signal.
-
product
LXI Microwave Multiplexer, 50Ω 4-Channel 13-Bank 6GHz SMA
60-802-013
The 60-802-013 is a 4-channel, 13-bank RF multiplexer suitable for switching 50Ω signals up to 6GHz. It is part of a range of LXI Microwave Multiplexers which are available with bandwidths between 6GHz and 40GHz and support for between 1 and 16 banks of 4 or 6-channel multiplexers. It is ideal for constructing complex microwave switching systems for many applications. Connection is by high performance front panel mounted SMA or SMA-2.9 connectors.
-
product
T7 Fiber-Optic Cable Assembly for GPIB-140, 50 m
182805-050
2-Pin Male to 2-Pin Male, Core/Clad 62.5/125 um, 850 nm Wavelength Fiber-Optic Cable for GPIB-140A Extender - The GPIB T7 Cable, sometimes referred to as GPIB Cable, connects your system to high-speed GPIB-140A extender devices. You can use the GPIB T7 Cable with a GPIB extender to increase the cable length of your system up to 1 km without comprising the integrity of your GPIB system or requiring any application modifications. The GPIB T7 Cable is offered in different lengths.
-
product
Imaging Modules
Teledyne e2v has developed compact MIPI modules which feature our own high performance CMOS image sensors inside a pre-focused, industrial-grade scanning optic. As a turnkey sensor/optics for imaging systems, these modules offers customers significant reduction in development time and cost savings. Only a few screws are needed to mount the module, with simple connection to the image processing system through an FPC cable connector. Software development efforts can also be reduced by using some limited API-layer Linux software drivers. This enables the module to be seamlessly interfaced to popular ISP platforms.
