Polarization Extinction Ratio
a measure of the degree of polarization. AKA: PER
See Also: Fiber Optic Cable Test
-
product
PXI Ethernet Interface Module
The PXI Ethernet Interface Module equips PXI systems with high-bandwidth Ethernet-based connectivity with up to 40 Gb/s data rates per port. Featuring compatibility with industry-standard network and automatic cable polarity detection, this module is ideal for high-performance data transfer and vision applications on the PXI platform. Additionally, the PXI Ethernet Interface Module has independent bandwidth to support up to four GigE Vision cameras without PoE.
-
product
Universal Preamplifier 14
UP14
For Two Dimensional Magnetic Recording (TDMR) and Heat-assisted Magnetic Recording (HAMR) Headamplifiers. Universal Preamplifier 14 (UP14) is designed for TDMR and HAMR Head Amplifiers. With new Guzik RWA4000 TDMR, UP14 allows to process signals from three Read Channels. It also supports two high speed data channels for Write data and Laser data. UP14 has two channels for dynamic TFC control and allows to program TFC power per sector and close loop TFC power control in each channel. UP14 can gen...show more -
product
Switch Modules - 16 Single or Two Pole Relays Arranged as Four Separate 4x1 Multiplexers
JX16/4(4x1)-1 and -2
This module has 16 single or two pole relays arranged as four separate4x1 multiplexers as shown in the figure. The muxes may be operated and wired individually for up to 64 4x1"s per chassis, or jumpered together to form 8x1"s or 16x1"s or jumpered to the backplane to form up to a 256x1 mux or two 128x1 muxes. It is available with Type S, M or LT reed relays.
-
product
Mobile Gas Leak Detection System
ABB Ability
ABB Ability mobile gas leak detection system uses ABB’s patented Off-Axis Integrated Cavity Output Spectroscopy (OA-ICOS) technique which has a sensitivity and precision more than 3000 times greater than legacy methods. This enables identification of leaks several hundred feet away from the source. Current traditional leak detection technology is slow, laborious and costly. Operators walk on foot near the pipeline with hand-held sensors making paper-based reports.This is slow and can lead to dan...show more -
product
acA4024-8gc, Color GigE Vision, 12 MP, 8 FPS Area Scan Camera
787062-01
The acA4024-8gc is a Color Basler Ace GigE Vision Camera with a 12 MP resolution and a maximum image acquisition speed of 8 frames per second. The acA4024-8gc uses a IMX226 sensor and is quality tested and calibrated for high performance and reliability. This camera can be used with NI hardware and software to build machine vision systems.
-
product
Anemometers
An anemometer measures wind speed. Indoors, an anemometer measures air speed, air velocity or air flow. The air flow rate in buildings is often measured in cubic feet per minute (CFM) using anemometers to assess the performance of heating, ventilation and air conditioning (HVAC) systems and equipment.PCE Instruments (PCE) offers a variety of anemometer products to meet the air flow and wind speed measurement needs of professionals in industries such as HVAC, construction, marine and wind power a...show more -
product
CO2 Data Logger
HOBO MX1102
Onset’s HOBO MX1102 CO2 logger makes it more convenient than ever to measure and record CO2 in buildings and other non-condensing environments. It measures CO2 from 0 – 5,000 parts per million (ppm) – and our free HOBOmobile™ app allows you to access data right from your mobile phone or tablet within a 100-foot range. The MX1102 also features a USB port so it can be used with a computer running HOBOware Pro graphing and analysis software.
-
product
Radioactivity
Higher than the natural ambient/background radiation, it originates from building materials or is inhomogeneous at geological faults and underground watercourses. It causes cell damage (tumors), cell death, etc. Radioactivity (=ionizing radiation) is measured in sieverts per hour (Sv/h) or simply as a count rate (pulses/second [Ips] or pulses/minute [Ipm]).
-
product
High Speed LED Pick And Place
MCLEDV6
Assemble LED lighting products, including long tube boards and flexible strips, at rates reaching 30,000 LEDs per hour, with a high-speed, dedicated LED placer. The MCLEDV6 has a 23.6" (600 mm) max board length and includes automatic, on-the-fly full vision alignment.
-
product
PXI 2.5W Programmable Resistor Module, 4-Channel, 1Ω to 31.5Ω
40-251-110
The 40-251-110 is a programmable resistor module with 4 channels which can be set between 1Ω and 31.5Ω with 0.125Ω resolution The 40-251 range provides a simple solution for applications requiring up to 2.5W of power handling per channel. The 40-251 is available in a variety of resistance ranges and resolution capabilities that meet the needs of most functional test systems.
-
product
Automated Front & Backside Mask Aligner System
Model 6000
With over 4 decades of manufacturing in the semiconductor industry, OAI meets the growing challenge of a dynamic market with an elite class of production photolithography equipment. Built on the proven OAI modular platform, the Model 6000 has front and backside alignment that is fully automated with a submicron printing capability as well as submicron top to bottom front side alignment accuracy which delivers performance that is unmatched at any price. Choose either topside or optional backsi...show more -
product
PMA Suite For The PSL-3424: 802.3at And 802.3bt PSE's
*Tests 802.3 at/bt PSE’s with Any Combination of 2-Pair and 4-Pair PSE ports up to 90W per port*Automatically assess PSE PM Stability and Capacity Management*Tests PSE’s that grant power with Multi-Event, LLDP, or Both Multi-Event and LLDP*Automatically Adapts to PSE maximum assigned class (MAC) and power demotions on 2-Pair and 4-Pair ports*Tests PSE’s with up to 96 PoE Ports*Emulated PD’s are 802.3 specification compliant including built-in support for multi-event classification, power demotion, and 802.3at/802.3bt LLDP*Highly Informative Reports cover dozens of parameters using Colorful Graphics*Available to PSL-3424A and PSL-3424L as optional license feature
-
product
XMC Module
XMC-FPD-xxx
XMC Bus VITA 42• 3.3V I/O, 5V tolerant businterfaces• Local Bus Clock rates at66MHz• Compliant PCIeSpecification, r1.0a x1• Direct slave data transfers• DMA Capability• Up to 160Mb/s Transfer• DMA Transfer per Fifo Level
-
product
DMX Splitter
One in plus through and four out, din mount, opto-isolated. Required after 32 devices as per the DMX512-A standard. The splitter allows for an inexpensive way to add loads of addresses, or simply to route multiple daisy chained cables.
-
product
PXI/PXIe 15W Programmable Resistor Module
42-254-012
The 40-254-012 (PXI) and 42-254-012 (PXIe) are programmable resistor modules with 2 channels which can be set between 1Ω and 120Ω with 0.5Ω resolution The 40-254 range provides a simple solution for applications requiring up to 15W of power handling per channel.
-
product
PXI Express High Speed Optical FPGA Board
HSS-8324-DSP
The Conduant HSS-8324 FPGA board provides a user programmable hardware platform that is able to sustain full-duplex high-bandwidth transfers through its 8-lane Gen3 PXI Express (PXIe) interface and its two 12-lane HSS interfaces while performing complex calculations. The PXIe interface provides a theoretical maximum throughput of 8 GBps (simultaneous in and out) while each HSS port (12 lanes up to 16 Gbps per lane) supports a full duplex transfer at theoretical rates over 190 Gbps.
-
product
PXIe/CPCIe Data Storage Module
Trifecta-SSD-RAID
Trifecta-SSD Modules feature a PCIe Gen 3 x8 interface and a unique architecture that supports up to eight (8) M.2 NVMe SSDs in a single slot which enable the modules to sustain up to ~7 GB/Sec sequential read and write performance without incurring the write “hiccups” or “glitches” that plague other RAID Modules with only four SSDs. This capability is essential for systems that stream 1+ GHz bandwidth per channel for long durations.
-
product
Power Supplies
CUG-950B
At 950 watts, the CUG-950 power supply supplies your system with the boost it needs to deliver the top experience for intense graphic rendered games. It delivers up to 2.8 times performance increase over a single graphics processing unit system, giving high-end gamers approximately 60 frames per second at resolutions as high as 2560x1600. With 950W, the CUG can power your system smoothly allowing gamers to obtain an uninterrupted experience with the best balanced power, cooling, and noise level system.
-
product
EasyMatrixCode
Automatic detection of the code in the imageDecodes ECC200, ECC000, ECC050, ECC080, ECC100 and ECC140 codesComputes quality indicators as per ANSI/AIM, ISO/IEC 15415, ISO/IEC TR 29158 and SEMI T10-0701 standardsVery fast operationImpressive robustness to noise, blur and distortionSupport of GS1 Data Matrix codesEfficient reading of codes in grid layoutMultiple codes reading
-
product
Light Meters
A light meter is a very sensitive electronic measuring device used to help monitor the illumination of any given area. Most light meter devices are small in size, simple to operate and equipped with an easy-to-read lighted screen made of special glass. Typically, a heavy-duty housing protects the light sensor inside the light meter from damage. A light meter is used for measuring brightness in lux (lx), foot candle (fc) or candela per square meter (cd/m²)measuring units. Some light meter devices...show more -
product
PXI 2.5W Programmable Resistor Module, 4-Channel, 1.5Ω to 925Ω
40-251-021
The 40-251-021 is a programmable resistor module with 4 channels which can be set between 1.5Ω and 925Ω with 0.25Ω resolution The 40-251 range provides a simple solution for applications requiring up to 2.5W of power handling per channel. The 40-251 is available in a variety of resistance ranges and resolution capabilities that meet the needs of most functional test systems.
-
product
16 Bit Digitizer PCIe Gen-3 Oszilloscope, 2 Channels 1GS/s 4GS Speicher
RazorMax / CompuScope Express 161G2
The new extremely fast and high-resolution Gage digitizers of the series RazorMax Express CompuScope offer with a half long Single slot PCI Express card a resolution of 16 bit and a sampling rate of 1 GS/s (per channel).
-
product
UAT Test Management
User Acceptance Testing is the final stage of the Software Development Life Cycle, which is conducted by the users. User Acceptance Testing is extremely important to determine whether the project is working fine as per the end user's point of view. The UAT test management process has to be done in an organized manner to reap maximum benefits from the process.
-
product
Analyzer for Safety Agency Production Line Testing
HypotULTRAIII
Ethernet Communication CardUSB/RS-232, GPIB & Printer InterfacesData Storage CardInterconnection to Modular Scanning MatrixOptional 10 Volt Analog InterfaceStorage of up to 50 setups with 30 steps per setupPatented SmartGFI® functionPatented prompt and hold functionPatented CAL-ALERT® functionPatented VERI-CHEK® functionReal Current measurementDual Continuity test modesBuilt-in security settingsLine and Load regulation
-
product
Surge Arrestor Testing Equipment
SA 30i+
SA 30i+, the wireless Leakage Current Analyser from SCOPE is a State of the Art, On-line test system for Residual Life Assessment of Metal Oxide Surge Arresters. The instrument measures and directly displays the values of Total Leakage Current and Third Harmonic Resistive Leakage Current. It provides system harmonic compensation as per IEC 60099-5-B2. It provides Corrected Resistive Leakage Current after applying correction factors for change in system voltage & temperature.
-
product
Handheld Digital Tachometer
TurboTester
The TurboTester® is an innovative and cost-effective handheld digital tachometer for testing and quality control of dental handpieces and ultrasonic scalers. The TurboTester® is a non-contact instrument which measures rotational speed (rotations / revolutions per minute) of high and low-speed handpieces and the vibration frequency of ultrasonic scalers.
-
product
Cable Fault Locator
We are one of the leading manufacturers, exporters of suppliers of a premium quality range of Cable Fault Locator that is extensively used to trace and locate the fault of underground cables. This fault locator is manufactured at our hi-tech manufacturing unit as per international quality standards under the supervision of our professionals using superior quality components. Offered fault locator is made available in different specifications to meet the diverse requirements of the clients. Our honorable clients can avail this Cable Fault Locator from us at industry-leading prices.
-
product
Compliance Test Systems
LMG Test Suite
ZES ZIMMER Electronic Systems GmbH
The ZES ZIMMER test system LMG Test Suite tests in accordance with the currently valid version of EN 61000-3-2/-12 or EN 61000-3-3/-11 and also supports measurements per ECE R-10.4 Annex 11 (e.g. electromagnetic compatibility of vehicles). As a manufacturer of precision power measurement technology, we are represented on the international standards committee. As a result, changes in standards are immediately incorporated into our test systems.
-
product
High-Performance Industrial Controller
GEVA 1000
GEVA is a high-performance industrial controller that offers excellent cost savings for multi-camera vision applications, such as final inspection of large assemblies. As the name implies, GEVA provides expandable Gigabit Ethernet camera interfaces that significantly drive down system cost.At the heart of GEVA is a powerful dual core processor, equipped with high-speed memory resources to tackle the most demanding applications. Two dedicated camera ports are provided, each with enough bandwidth ...show more -
product
CMAS Analyzers and Field Monitors
Backed by at least one of the 8 corrosion sensor patents wholly owned by Corr Instruments, our nanoCorr analyzers and field monitors are widely used for online and real-time localized and general corrosion monitoring. These ultra-high precision instruments measure extremely low currents in the pico-ampere levels, which can be translated into a corrosion rate as low as a few nanometers per year, in some applications (PDF). Our analyzers and monitors are based on the patented coupled multielectrode array sensor (CMAS) technology which measures the flow of electrons from corroding electrodes to one or more cathodes.
