Monitoring
-
product
PXI 24 Channel High Voltage Multiplexer
40-320-101
The 40-310/320 Range of High Voltage Switching Modules will hot switch up to 750V peak and cold switch up to 1000V peak in either general purpose relay (40-310) or multiplexer (40-320) configurations. These modules contain high-quality reed relays with switching ratings comfortably higher than the 40-310/320 specification. Applications for the 40-310/320 series modules include; circuit board isolation testing, relay testing, semiconductor breakdown monitoring and cable harness insulation testing.
-
product
Surface Contamination Monitors
Small-sized devices for measuring the ambient dose equivalent rate and the ambient dose equivalent of X-ray and gamma radiation, as well as measuring the flux density of beta particles (AT6130).
-
product
Monitoring Probe
ATSC 3.0/1.0
Combined with a NMS or TestTree’s GlobalViewer, the EdgeProbe Advanced provides a powerful broadcast network alert & diagnosis tool allowing DTV network operators to monitor global trends and anticipate potential failures.EdgeProbe Advanced is able to monitor ATSC 3.0/1.0 signals at Transmitter output through its RF inputs (up to 4 in 1RU), as well as at Modulator input and Head-End/distribution links through IP (STLTP) inputs.
-
product
IEC61850 Digital Substation Testing
With the development of power system, more and more digital substation based on IEC61850 has been built in the world. IEC61850 is the new communication protocol which is adopted by power system so as to change the analog complicated wiring connection and protocol conversion. Based on IEC61850, all Messages, such as GOOSE, SV, MMS, PTP, etc, could be communicated on the Ethernet via fiber optical cable connection. In China, the digital substation have started since 2003, until now there are already more than 6000 digital substation put on operation, China Power Grid is planning to build 5000 more new digital substations. PONOVO, as the leading power system testing solution provider, have launched plenty of IEC61850 digital testing tools, not only digital relay test set, but also MU test set, multi-functional analyzer, 24 hours online monitoring and analyzing system, etc so that users could have suitable testing equipment for the digital substation commissioning and testings.
-
product
ESD Event Detector
Novx MiniPulse
Simco-Ion's Novx MiniPulse ESD Event Detector is designed for tool and process monitoring. This affordable, small footprint embeddable monitor has been developed to warn of product damage risks at the point of electrostatic discharge. The MiniPulse uses time domain and threshold discrimination to detect pulse electromagnetic energy. Through the use of specific antenna configurations and placement, the MiniPulse can provide ESD event detection for well-defined small areas.
-
product
Single Slot Intelligent Interface Card
IIB-3910-CPCI
The IIB-3910-CPCI is a single slot intelligent interface card providing complete STANAG 3838 and STANAG 3910 test, simulation and bus analysis capability for the CompactPCI Bus. The IIB-3910-CPCI supports concurrent Bus Controller (BC) and up to 31 Remote Terminals (RT) with Bus Monitor (BM). An additional stand-alone Chronological Bus Monitor (CBM) facility is also provided, with powerful multi-level triggering capability. Full error injection capability in both 3838 and 3910 modes is provided in BC and RTs modes, with full error detection in BC, RT, BM and CBM modes. Dual redundant 3838 interface, with user selectable dual redundant optical or single redundant electrical 3910 interface are featured. 2 Mbytes of dual ported RAM are provided. The board is supplied with C drivers in source code and Windows menu driven software as standard.
-
product
Process Analyzers
2060
The 2060 Process analyzer enables customized online monitoring of industrial processes with multiple parameters and streams. The 2060 Process Analyzer is the most versatile analyzer in the Metrohm Process Analytics product portfolio. With a variety of techniques, the analyzer enables 24/7 online monitoring of critical chemical parameters in industrial processes and wastewater streams.
-
product
Handsfree Telephone Communication Tester
TestPhone 850
The TestPhone 850 provides both handset and handsfree telephone communication. The product provides a standard Public Switched Telephone Networks (PSTN) interface, user interface and handset and/or handsfree vocal interface to allow the user to originate or answer standard PSTN calls on both Dual-tone Multi-frequency (DTMF - tone dialling) and Loop Disconnect (LD - pulse dialling) lines. In addition the product features on-hook audio line monitoring, PSTN line polarity indication, automatic on-hook/power-off and integral ADSL digital line filtering.
-
product
Air Pollution Multigas Calibrator
APMC-370
Dilution of gases with high accuracy and precision requires high quality MFC’s, especially for high dilution ratios and ranges. Consequently HORIBA’s APMC-370 is equipped with digital MFC’s. These MFC’s are factory calibrated, optional also with a special Polynomial Calibration. HORIBA Europe‘s APMC-370 is designed to calibrate gas analyzers manually, remotely controlled or automatically. It is installed in air pollution monitoring stations for quality assurance in the laboratory and also in the production of gas analyzers.
-
product
X-Ray And Gamma Detector Systems
The XR-100CR is a new high performance x-ray detector, preamplifier, and cooler system using a thermoelectrically cooled Si-PIN photodiode as an xray detector. Also mounted on the 2-stage cooler are the input FET and a novel feedback circuit. These components are kept at approximately -55 °C, and are monitored by an internal temperature sensor. The hermetic TO-8 package of the detector has a light tight, vacuum tight thin Beryllium window to enable soft xray detection. The XR-100T-CdTe represents a breakthrough in xray detector technology by providing “off-the-shelf” performance previously available only from expensive cryogenically cooled systems. The XR-100-CdTe is also suited for measuring gamma rays.
-
product
High Power RF Amplifiers
Corry Micronics' line of high power RF amplifiers feature up to 40% efficiency. an extended temperature range of -30 degC to 55 degC for MIL-STD applications, and status monitoring signals that provide diagnostic information.
-
product
Altitude Test Chamber
Aircraft and its components are subject to extreme pressure and climatic conditions during flights. These parameters have a significant influence on the functioning of individual components, and they must be monitored and measured for safety reasons. CME Altitude chamber allow for the testing of aerospace components in an environment with controlled pressure, temperature and humidity parameters. An altitude of 100,000 feet [10 mbar] can be simulated in the test space.
-
product
PDS Bucket Dredger Monitoring Software
Your product description goes here.Teledyne RESON supplies integrated Bucket Dredge Monitoring System. The system includes sensors as inclinometers, ruggedized PC systems, positioning systems and our TELEDYNE PDS software. We can also supply motion sensors, tide gauges, draft sensors and spud pole position sensors.TELEDYNE PDS provides the functionality especially designed for the dredge operator to carry out their job more efficiently.
-
product
Digital Wideband Receiver Family
IZT R3000
The IZT R3000 is a professional digital hf, vhf and uhf receiver. Its world-class rf performance and state-of-the art digital signal processing make it the ideal sensor for direction finders, signal recording and COMINT systems. The IZT R3000 has been ordered by the German Federal Network Agency as ITU-compliant Monitoring Receiver.
-
product
Environmental Monitoring Systems
Sensaphone Family
Comprehensive line of remote monitoring products that safeguard valuable assets by tracking critical environmental data such as temperature, humidity and power failures. Sensaphone products provide alerts and proactive monitoring data to homeowners and facility managers in many areas including telecommunications, oil and gas, water and wastewater, HVACR, agriculture, healthcare, data centers and greenhouses.
-
product
Data Monitoring System
1S663-001
The 1S663-001 Data Monitoring System was specifically developed for the Cessna Citation X and serves as the primary diagnostic tool for the aircraft?? electronic Logic Modules. The system is FAA certified for airborne operation. Aft compartment and cabin modules can be tested two at a time while remaining in place. The system is also capable of monitoring the fuel quantity system during flight.
-
product
Colorimeter
ColorCAL MKII
Cambridge Research Systems Ltd
Calibrated and affordable colorimeter performs better than a spectroradiometer for gamma correction. Computer-controlled, bus powered USB colorimeter with an easy to use cross-platform software interface, designed for characterising and calibrating your CRT or LCD monitor.
-
product
HFC Analyzer
X16
The Kronback Tracers X16 is a DOCSIS 3.1 compatible suite of HFC monitoring tools such as return path analyzer, sweep system, downstream carrier monitor. Return path monitoring includes an advanced quality engine to log history information of noise and quality and alerts if ingress is present. Features such as NMS gateway and a dedicated RF switch increases the flexibility.
-
product
XMC - Module VITA61/42
XMC-1553-2-IO
The XMC-1553-2-IO-2 uses a DDC® Total-ACE® communication device as its 1553 bus controller, or as a remote terminal with concurrent bus monitor terminal. Dual controller has a dual redundant channel with built in transceivers and transformer. The controller has the capability to emulate up to 31 RT addresses simultaneously.
-
product
Intermittent Break Analyzer
JW3324
Shanghai Joinwit Optoelectronic Tech,co.,Ltd
JW3324 Intermittent break analyzer is used to monitor the intermittent disconnection of interconnection devices in dynamic environment such as vibration. It can detect the contact reliability under vibration and display the time and times of disconnection.Connectors and cables are widely used in aviation, aerospace systems and military equipment. Therefore, JW3324 Intermittent break analyzer is a basic testing instrument used by manufacturers, research institutions and operators for manufacture-testing, research -developing, engineering construction and maintenance.
-
product
Data Acquisition
Data Acquisition used to monitor and record data that characterizes the physical integrity and performance of aircraft, engines, and other large structures, as well as automate the functional testing of complex electronic systems.
-
product
USB OTDR
FiberPal UFO Series
The Radaiantech UFO series is a compact, cost-effective, plug-and-play Optical Time-domain Reflectometer(OTDR) unit, designed for full-range fiber fault detection. It is ideal for optical fiber installation, maintenance, field construction, and other on-site fault-location analysis. As a USB peripheral, UFO is the good choice of OTDR to integrate with remote optical monitoring systems. The OTDR unit is designed as a green PC peripheral compatible with Windows 98, 2000 or above. The application program (AP) sends OTDR command from the computer to the unit and gets data back through USB connection. The USB OTDR gets power from the USB port and an internal rechargeable Li-ion battery.
-
product
3-Channel LOW PIM Attenuator
Corry Micronics' 3 channel, LOW PIM attenuator covers the 400 to 3000 MHz frequency range and has been specifically designed for major mobile access carriers who are attempting to measure or monitor passive intermodulation distortion/interference in communications systems.
-
product
Gas Monitors
Ultima® X Series
Designed to provide thorough, continuous monitoring of many hazardous gases, the indoor/outdoor Ultima X Series Gas Monitors offer excellent performance and MSA quality craftsmanship.
-
product
Monitors
MW Series
The MW Series contains cutting edge, two-way, stage monitor systems designed for any high-energy live performance stage.
-
product
PXI Monitored Multiplexer, Quad 25-Channel, 1-Pole
40-619-104
The 40-619-104 is a high density PXI 2 A multiplexer module in quad 25-channel configuration using high quality electro-mechanical signal relays allowing each channel to switch current up to 2 A and voltage up to 250 VAC/DC.
-
product
MIL-STD-1553 A / B Test And Simulation PCI Express Module
PCIe-C1553
*Dual redundant*1, 2 or 4 channels*Simultaneous bus controller, 31 remote terminals, bus monitor*Error entry and detection*FPGA based hardware architecture*Multi-level trigger for data acquisition and filtering*10 programmable, discrete I / O (up to 30V)*IRIG-B timecode encoder / decoder with free-running mode*Real-time recording and physical bus playback*Supports: C, C ++, C # and .net*Driver support: Windows, Linux, LabView Real-Time and other systems
-
product
SparkFun Coulomb Counter Breakout
LTC4150
Odometers are extremely useful for cars, they tell you how far you have gone, wouldn't it be nice if you were able to have a device that does the same for electrical current? The LTC4150 SparkFun Coulomb Counter Breakout is here to be your odometer for current. If you are wondering: a coulomb is defined as, to put it simply, one amp for one second. This breakout is capable of constantly monitoring the current your sensor is using, is able to add it up, and will give you a pulse each time a given amount of amp-hours have been used. When used effectively and if you start with a full battery, you’ll always know exactly how much of it is left!
-
product
Convergence Gauge
This small, handheld, opto-mechanical device is used to measure the convergence error between the lines of a CRT display. This sturdy, accurate tool is sufficient to obtain measurements that are invaluable to engineers, manufacturers, and quality inspectors. The CM7A series is made for monitors, the CM14A series is for medium-sized screens, and the CM28A series is for large-screen and rear-projection big-screen TVs.
-
product
Mobile Network Monitor
Qosmotec Software Solutions GmbH
MVNOs and MVNEs as well as network operators themselves take advantage of LTS as a monitoring tool for the live network that detects and alarms about any performance degradations or outages. The LTS Mobile Network Monitor reports any inconsistencies immediately in form of an e-mail alarm or via SNMP traps. KPIs obtained by the system can also be queried at any time via SNMP, so that testers are permanently aware of the availability, reliability, quality, and integrity of the mobile network services from the subscribers’ point of view.
