Showing product results. 1 - 15 of 740 products found.
-
Wavecontrol, S.L.
Low-frequency amplifiers Current sources Systems with multiple amplifiers Customized systems
-
LFG-200 - Kharkovenergopribor Ltd.
LFG-200 is a cable test van-mountable signal generator used as part of a cable tracing and fault location set for the following applications.
-
LFG-2500 - Kharkovenergopribor Ltd.
• tracing – finding the route and burial depth of the underground utilities;• fault location – pinpointing phase-to-sheath and interphase short-circuit faults;• cable identification – identifying a correct cable in a bunch.
-
LFG-50 - Kharkovenergopribor Ltd.
• tracing – finding the route and determining the burial depth of underground cables and other hidden utilities;• fault location – pinpointing interphase and phase-to-sheath short circuits faults;• cable identification – identifying a correct cable from a bunch.
-
-
AC135 - Semapi Corp
Low Frequency Accelerometer, Top Exit Connector / Cable, 500 mV/g Served
-
-
AC136 - Semapi Corp
Low Frequency Accelerometer, Side Exit Connector / Cable, 500 mV/g
-
T&C Power Conversion
0 kHz to 3 MHz 100W - 4000W 1 input, up to 7 outputs Step-Up / Step-Down Transformers Impedance matching outputs from 1.2 Ohms to 2500 Ohms Compact Design Compatible with T&C''s Class A 10 kHz - 20 MHz LF Generators & Amps Compatible with Class B 20 kHz - 6 MHz LF Generators & Amps
-
IMV Corporation
A compact Signal Amplifier to make optimal signal processing being connected with the Servo type Accelerometers. It is used for Vibration Acceleration Measurement, Waveform Observation, for various Analysis in combination with the AC Voltage Meter, Oscilloscope, FFT Analyzer respectively. Furthermore, Voltage signals from the Microphones or Sound Level Meters can be output to the instruments like Recorders along with the Vibration Signals.
-
VLFC - Meyer Sound Laboratories Inc.
Think extremely low. With a range of 13-30 Hz—the lowest reach of any Meyer Sound speaker—the VLFC extends below the threshold of human hearing to let your audience feel the sound like never before.
-
RFOptic
RF Optic’s RF over Fiber modules (RFoF) are suitable for telecommunications, satellite, radio telescopes, distribution antennas, broadcasting audio and video, timing synchronization and GPS applications. For example, point-to-point antennas can be connected from several meters to many kilometers away from the control room by fiber cables; Base stations can be connected through fiber to remote sector antennas; Satellite antennas can be connected through fiber cable to remote sites via by RF over Fiber solutions.
-
WADP-0.1 HZ - Wuhan Sangao Electrical Test Installations Limit Co.
Should be based on the subjects to choose the appropriate specifications of products. When in use, sample capacity shall not be more than the rated capacity of the instrument . Sample capacity is too small, will affect the output waveform . If less than 0.05 μ F, the instrument will not normal output. Can the auxiliary output parallel capacitor of 0.1 μ f . Below is the capacity of some equipment, for your reference
-
Type NLF-2 - National RF, Inc
A Hot, Active, Noise Reducing Antenna System that will sit on your desk and copy 2200, 1700, and 600 through 160 Meter Experimental and Amateur Radio Signals!
-
A10-M - Quartzlock (UK) Ltd.
Frequency Referencing, Calibration, Standards Lab, Production Test for Oscillator Manufacturers. A very high stability LOW NOISE 10MHz Rubidium Reference, primarily for production test of quartz oscillators and RF instrumentation frequency referencing. This industry standard 2U rack-mount instrument has a long heritage and ongoing production life for this latest 2009 version that features RS232 monitoring and control of the DPLL, locking the Ultra Low Noise OCXO to the Rubidium. Damping and Bandwidth is controlled by integrator digital gain, proportional digital gain, pre-filter order and subsample rate. Eight values of user selected bandwidth are available.