-
product
Portable Dew Point Monitor
1500
The Model 1500 is a self contained system; not only is there no field assembly required, there’s no need to carry around a myriad of individual components such as control boxes, sensors, cables, pumps, and power cords. Simply attach the sample line, adjust the flow (with the integral flow meter) and turn on the power. Within minutes you’ll be collecting field dew point data with the same chilled mirror accuracy of a lab standard hygrometer. And with a nominal battery life of 12 hours, you will be able to collect for the entire shift or spot check your processes for several days.
-
product
Cooling Systems
Aerodyn Engineering designs and manufactures its own line of cooling carts. Our cooling carts will supply filtered coolant to the slip ring while in operation. Aerodyn Engineering’s cooling units are extremely reliable and are designed and manufactured with the highest quality components and craftsmanship available in the industry today. Magnetically coupled pumps are employed within our system to deliver the cooling fluid, with full user instruments showing flow rate and system pressures.
-
product
Vapor Source Mass Flow Controller With Viscous Choked Flow
The 1150C Vapor Source Mass Flow Controllers are pressure based measurement and control systems designed to meter and control vapor from low vapor pressure liquid and solid sources directly, without the need of a carrier gas using viscous flow through a choked orifice.
-
product
Submersion Level Detector
SL-180C
For waste water and sewage water facilities: Pumping stations, Flow conduits in treatment plants and so on.
-
product
On-board Emissions Measurement System
OBS-ONE PM unit
OBS-ONE PM unit is the industry-leading on-board Particulate Matter (PM) measurement system. It collects PM on a filter paper, using a partial flow gravimetric sampling method, while simultaneously measuring real-time PM. A key feature of this design is the use of a venturi flow meter which enables reliable proportional sampling and accurate exhaust gas flow measurement under transient flow conditions. Combine the GAS unit and PM unit to perform certification tests on heavy duty and non-road vehicles.
-
product
Gravimetric Dust Measuring Devices
Easy setup, accurate measurement, rapid resultsGravimetric dust measurement devices extract a partial gas flow from the duct under predefined conditions and use a filter to separate out the dust particles. The amount of dust is ascertained by weighing the filter. The differential pressure is measured to determine the extracted volume. These two values are then used to calculate the concentration of dust in the duct with a high level of accuracy. Gravimetric dust measurement is ideal for calibrating other dust measuring devices and for taking the kinds of comparative measurements that are required by the relevant authorities.
-
product
Positive Displacement Flow Meters
Omega's Positive Displacement Flow Meters are ideal for viscous fluids such as oils, fuels, and solvents that are difficult for other types of flow meters to measure.
-
product
Dual-Pump Continuous Flow Systems
Teledyne LABS SyriXus continuous-flow systems couple two pump modules to a single controller, and use an active or passive valve manifold to provide non-stop, continuous feed of almost any fluid. The controller refills one pump while the other is delivering, using special algorithms to equalize pressure and flow of both pumps. This allows virtually pulseless transition at pump switchover while maintaining accurate flow rate.Two different valve packages are available to accommodate all types of fluids and specific requirements of your experiment or process.
-
product
QorIQ P2020 Processor AMC
AMC717
The AMC717 is a Processor AMC (PrAMC) in a single module, mid size AdvancedMC™ (AMC) form factor based on the Freescale P2020. The module follows the AMC.1, AMC.2 and the AMC.4 specifications. The module is ideal for data flow management within a chassis. The PCIe/SRIO interface is configurable as Host or Agent mode. The PCIe option runs as x4 while the SRIO can run as x4 or dual x1. The module has option for up to 4GBytes of DDR3 memory with ECC. It provides Dual GbE to the rear per AMC.2 specification and a single GbE to the front.
-
-
product
Bi-Directional Digital Hydraulic Testers
DHT302, DHT402 Series
The most popular sizes of digital hydraulic tester. Measure flow, pressure, temperature & speed. Flows up to 400 lpm (100 US gpm).
-
product
IEC60529 Jet Nozzle IPX5/6
CX-IPX5
Shenzhen Chuangxin Instruments Co., Ltd.
Test Set consists of a jet handle that is equipped with a pressure gauge and an easy-to-adjust flow valve.The interchangeable nozzles assemble easily to the jet handle. The nozzles are made from stainless steel.
-
product
5CH Gas Mixer
G-MIX 5CH
G-MIX is an integrated versatile system that can be easily employed to set up countless gaseous mixtures, the gaseous flows are accurately controlled by five MFC (Mass Flow Controller), every MFC has stored inside its memory the calibration tables for 10 different gases.
-
product
Humidity and Temperature
T3000 - serie multimeasure
Whether you need to conduct analyses of supply and exhaust air flows, condensation, poor machine cooling, porous seals, climate fluctuations, heat build-up, excessively dry or damp materials or carry out leak detection on pressure tanks or line systems – both for preventive maintenance and building diagnostics and damage analysis – you can handle the most diverse tasks with a single measuring device!
-
product
Flow Meters
900 Series
The Blancett Series 900 flow meters are rugged, low-priced and specifically designed to measure floodwater line flow in secondary oil recovery operations. Using time-proven rotary vane and multi-jet impeller mechanisms, the Series 900 flow meters will provide reliable long-term measurement and totalization with minimum attention and maintenance.
-
product
Standard Mass Flow Meter
Series II
Offers outstanding value in a wide range of industrial and lab applications. Exceptional accuracy and repeatability with flow ranges from 0.014 cc/min up to 1670 l/min. and working pressures up to 6000 PSIA. Offers multi-gas and multi-range capability
-
product
PAR Quantum Radiometric Probe
LP471PAR
Quantum-radiometric probe for measuring the PHOTONS FLOW in the chlorophyll field PAR (photosynthetically Active Radiation 400nm…700 nm), μmol m-²s-¹ measure, cosine correction diffuser.
-
-
product
IEC60529 IPX5/6 Water Jet Nozzle
Shenzhen Chuangxin Instruments Co., Ltd.
IEC60529 IPX5/6 Water Jet Nozzle is designed according to the requirements of IPX5 and IPX6 code of GB4208 and IEC60529 standard. IEC60529 IPX5/6 Water Jet Nozzle is used to test the waterproof performance of the appliance and electronic. The IEC60529 IPX5/6 Water Jet Nozzle consists of a jet handle that is equipped with a pressure gauge and an easy-to-adjust flow valve. The interchangeable nozzles assemble easily to the jet handle. The nozzles are made from stainless steel.
-
product
Dual Pitot Tube Flow Meter
PTFM-ONE-DT
The Dual Pitot Tube Flow Meter, PTFM-ONE DT is a standalone interface for measuring exhaust gas flow rate of combustion engines. The system uses the tried-and-tested pitot tube principle with high-frequency transducers, with a sampling rate of 1kHz to accurately measure highly pulsating exhaust flows. This rapid capture rate ensures that any pulsations or exotic behaviour caused by the engine is measured, and the unique design of the PTFM-ONE DT means reverse flows can be calculated, with the same guarantee of sensitivity.
-
product
Basic Heating Module
Microwave heating analysis including loads rotation and translation, frequency tuning, heat flow and material parameters modification as a function of dissipated power. QW-BHM (Basic Heating Module) for QuickWave 3D provides a novel regime of operating the FDTD solver: the possibility of simulating microwave heating problems.The software has been prepared to work in sophisticated regimes, modelling rotation and movement of the heated load(s) even along complicated trajectories, etc. Transfer of the heat generated by electromagnetic fields can be modelled with external or internal Heat Transfer Module or by coupling QuickWave 3D simulations to external computational fluid dynamics packages.
-
product
Metal Magmeter Flow Sensor
2552
The Signet 2552 Metal Magmeter features all-stainless steel construction. The PVDF nosepiece and FPM O-rings are the only other wetted materials. The 2552 installs quickly into standard ISO 7-R 1 or ISO 7-R 1 (1 in. to 1 in. NPT) pipe outlets, and is adjustable to fit pipes from DN50 to DN2550 (2 to 102 in.). Two sensor lengths allow maximum flexibility to accommodate a variety of hardware configurations, including ball valves for hot-tap installations.
-
product
Biomagnetic Devices
Electrical measurements of physiological potentials are well established in clinical diagnostics. The flow of an electrical current creates a corresponding magnetic field. Thus bioelectric activity will generate biomagnetic fields. These fields can be detected with Tristan SQUID magnetometers. For many of the classical electrical techniques such as ECG and EEG, there are corresponding magnetic techniques (magnetocardiography or MCG and magnetoencephalography or MEG). In some cases (magnetopneumo...show more -
product
Silicon Detectors
Through the photovoltaic effect, detectors provide a means of transforming light energy to an electrical current. The root of the theory behind this phenomenon is a small energy gap between the valence and conduction bands of the detector. When light, with enough energy to excite an electron from the valence to the conduction band, is incident upon the detector, the resulting accumulation of charge leads to a flow of current in an external circuit. Since light is not the only source of energy th...show more -
product
Stopped-flow/quench Flow
The SFM-4000 stopped-flow series is available for single, double or triple mixing applications (two reaction steps or one reaction step and one concentration change step before the final observed reaction). The SFM-4000 stopped-flow family has been designed to ensure the shortest possible dead time the highest precision and to minimize sample consumption as much as possible.
-
product
Thermal Mass Flow Controllers & Meters for Various Flow Ranges
Teledyne Hastings Instruments brings decades of experience to offer a full line of thermal mass flow controllers and meters. Our products provide solutions for a wide range of applications which include high and low flow ranges, corrosive gases and very high-temperature environments. With the assistance of our experienced application engineers and global sales network, we will help you find a reliable, repeatable, and durable solution for applications in both laboratory and industrial environments. Your needs can be met by using quality flow instruments designed and manufactured by Teledyne Hastings.
-
product
Wafer Back Side Cooling System
GR-300 Series
The GR-300 Series can control gases used to cool the back side of wafers that are fixed in position by an electrostatic chuck system.The stability and accuracy of the GR-300 makes it ideal for controlling the flow of Helium and Argon in wafer cooling systems.
-
product
Weschler Zahn Viscosimeter
The Zahn viscosimeter is a bullet-shaped, corrosion-resistant, stainless steel cup with a precision drilled orifice. Five sizes are available for use on very thin oils to extremely heavy mixtures (20-1200 Centipoise). Viscosity is determined by the time required for a definite volume of liquid to flow through the orifice. These easy-to-use products were originally manufactured by G.E. and are still Made in USA.
-
product
Nonwovens Solutions
OptiBond™
The capability to monitor and / or control dispensing in real-time helps improve production efficiency and reduce waste. Available as standalone systems or melter-integrated capability, flow monitoring and closed-loop flow control help produce disposable hygiene products faster, more efficiently and at lower costs. Nordson offers a broad range of products to help you improve product quality, reduce material waste, and increase production efficiency. These include: TruFlow meters, dividers / splitters, and applicators. GP 200 remote metering stations, Harmony applicators; Concert flow controllers and VersaBlue Plus or AltaBlue Plus melters.
-
product
Dataflow
An extensive range of flow metering products. Dataflow 4-20mA and pulse output flow transmitters and the Dataflow Compact inline flow transmitter for reading up to 150 LPM.
