Showing results: 1 - 9 of 9 items found.
-
Geosonic -
BioAge s.r.l.
An Infrasonic Array works like a sonic antenna, it is able to detect the magnitude and the source of sound waves. The Geosonic array is able to detect also pressure waves that the human ears can’t hear. A typical pressure wave is that generated by an explosion or by any physical phenomena (natural or human created) that generates an air pressure wave, which means that the Geosonic array can be used to detect a lot of phenomena, like:
-
INFRASONITUS -
BioAge s.r.l.
The infrasonic signal, acquired by a suitable microphone, is filtered by an active low-pass filter of the fifth order with a cut-off frequency at 20 Hz, with low noise, then it is sampled and acquired by a 16-bit ADC with a speed of 50 samples. / sec. The amplification factor can be set to 0.1 / 0.5 / 1/10.The infrasonic monitoring system includes a complete diagnostic functionality that performs an exhaustive functional test without the use of other tools: this function is extremely useful when the system is installed on the volcano at high altitudes.
-
MISS -
BioAge s.r.l.
The Micro Smart System is one of the many autonomous systems with very low consumption designed by BioAge. The system is characterized by autonomous operation with very low energy consumption thanks to its operation in "Energy Harvesting" which allows to exploit the power supply from a micro solar panel with which each sensor is equipped. Furthermore, these systems are equipped with radio frequency communication able to remotely transmit the information acquired by the sensors on board, it is therefore possible to create a network of sensors, operating autonomously and with a very high autonomy thanks to solar energy.
-
G-MIX 3CH -
BioAge s.r.l.
G-MIX is a versatile integrated system that can be easily used to create innumerable gas mixtures, the gas flows are accurately controlled by three MFCs (Mass Flow Controllers), each MFC has stored within its memory the calibrate tables for 10 gases different. The entire hydraulic system was created using AISI316 stainless steel pipes, fittings and valves, using the best solution available for this type of application. The stoichiometric composition of the gaseous mixture can be easily controlled via a software developed by Bioage, with an intuitive and friendly interface that can be easily installed on a common PC and communication with G-MIX is possible by means of a USB port. The System Can be used in Stand-Alone mode, without any connection to the PC thanks to the easy and intuitive LCD display with which each MFC is equipped, setting the gas parameters using an intuitive keyboard with which the MFC is equipped.
-
EUREKA -
BioAge s.r.l.
Eureka is a QCM / EQCM (Quartz Crystal Microbalance) nanogravimetric measuring instrument capable of mass measurements in the order of nano-grams and pico-grams. Eureka can be used with gas and liquids, the cells are made by BioAge and sold with the instrument. The tool is the most versatile among those existing on the market, with an excellent quality / price ratio. It is a portable instrument as it is powered only by the PC USB port. The instrument is extremely compact, light, reliable and designed according to the current state of microelectronics. To use Eureka simply connect it to a PC USB port and install the capture software, running in Windows ™ environment,which turns out to be very simple to use, so you can do the first experiments in a very short time. For liquid measurements Eureka is an electrochemical system, therefore, electrochemical and nanogravimetric measurements can be performed at the same time (EQCM). Eureka, if connected to a self-powered portable PC, allows to perform measurements and experiments in total freedom in environments where grid voltage is not available,or experiments that are carried out in large areas in total freedom of movement. Measurements can be made on liquids, thanks to the static cell or the flow cell, or BioAge is able to design and create customized cells according to the needs of the user, varying volumes, dimensions and materials. The instrument is very versatile because the frequency measurement range can range from 0 to 50MHz, depending on the quartz crystal used. or use a gas cell designed for gas phase analysis, BioAge is able to design and produce customized cells according to the user's needs, varying volumes, dimensions and materials.The instrument is very versatile because the frequency measurement range can range from 0 to 50MHz, depending on the quartz crystal used. or use a gas cell designed for gas phase analysis, BioAge is able to design and produce customized cells according to the user's needs, varying volumes, dimensions and materials. The instrument is very versatile because the frequency measurement range can range from 0 to 50MHz, depending on the quartz crystal used.
-
G-MIX 5CH -
BioAge s.r.l.
G-MIX is an integrated versatile system that can be easily employed to set up countless gaseous mixtures, the gaseous flows are accurately controlled by five MFC (Mass Flow Controller), every MFC has stored inside its memory the calibration tables for 10 different gases. All the hydraulic system has been realized by means of Stainless Steel AISI316 pipes, connectors and valves, this is the best available solution for this kind of applications. The stoichiometric composition of the gaseous mixture can be easily controlled by means of a software, running under Windows, with an intuitive and friendly user interface, the software can be easily installed on a common PC and the communication with G-MIX is possible by means of an USB port. G-MIX can be used as a stand-alone system too, without connecting it to a PC, because every MFC is supplied with a graphic LCD display and with a little user keypad that can be used to set up the gas flow value. The G-MIX system can be used to create gaseous mixtures with a well controlled and known chemical composition, these mixtures can be used in the laboratory to perform countless experiments such the test and/or the calibration of sensors and/or transducers or the characterization of chemical films. The GMIX system is extremely compact and completely enclosed in a hard and smart enclosure of satin aluminum, the interior of the enclosure is brightened by high intensity LED diodes, and it is visible thanks to a clear polycarbonate front panel. The excellent materials used to realize G-MIX allow the use of corrosive and/or toxic gases, providing a reliable and very hard system.
-
Elettra -
BioAge s.r.l.
Elettra has been designed to operate on its own, but it is also possible to connect it to a PC to control it and acquire, view and save data thanks to its extremely easy to use software that runs under MS-Windows™. The data acquisition process can be controlled extremely quickly thanks to the PLAY, PAUSE and STOP keys. Captured data can be saved in an Excel compatible format and graphs saved as bitmap images. By clicking on a button, the software is able to open the Excel program installed on the PC, enter all the data and create countless graphs, ready to be inserted in your documents and publications. At any moment it is possible to take a picture of the graph showing the frequency variation and save it as a bitmap image, to be able to insert it in documents and publications. The same keys that are present on the instrument are found on the software, these allow you to control the instrument remotely. On the frequency variation graph it is possible to zoom in on the regions of interest, it is also possible to display two cursors on the graph, thanks to these cursors it is possible to easily and immediately calculate the value of the frequency variation between any two points on the graph. The software is extremely easy to use and performs many other useful functions, such as automatic recognition of the computer port to which the instrument is connected. BioAge builds tools and writes software only after having carefully listened to the needs and requirements of the users of the final products, this process has the purpose of creating products that are easily usable and that have all the characteristics and functions that the user expects to have.
-
-
Dike -
BioAge s.r.l.
During an experiment to detect an affinity reaction on biological material, a molecule of interest is attached to the quartz crystal of the measurement channel, this deposition can be achieved by direct binding or by capture through another protein, the result of this process is to make the quartz sensitive to the molecule to be detected.
