Showing results: 646 - 660 of 6459 items found.
-
DCM-2608 -
Tecpel Co., Ltd.
AC current up to 1500A;DC current up to 2000A. AC voltage up to 750V;DC voltage up to 1000V. Resistance up to 40M£[. Frequency up to 400kHz. Capacitance measurement
-
CMP-401 -
Sonel S.A.
DC current measurement and AC current.AC/DC voltage measurement up to 600V.Resistance measurement and continuity test: * continuity test with acoustic signalling (beeper) for resistance below 50.Temperature measurement (Fahrenheit and Celsius units).
-
CMP-400 -
Sonel S.A.
The CMP-400 meter is a small portable instrument for direct measuring of alternate current up to 400 A. The meter, when used with additional measurement cables, enables measuring the AC/DC voltage up to 600V. It can also measure resistance with acoustic continuous signal.
-
CMP-1006 -
Sonel S.A.
The CMP-1006 meter is a portable instrument for direct measuring of alternate and direct current up to 1000 A. The meter, when used with additional measurement cables, enables measuring the AC/DC voltage. It can also measure frequence, capacitance and resistance with acoustic continuous signal.
-
CMP-200 -
Sonel S.A.
The CMP-200 meter is a small portable instrument for direct measuring of AC/DC current up to 400 A. The meter, when used with additional measurement cables, enables measuring the AC/DC voltage up to 600V. It can also measure resistance with acoustic continuous signal.
-
DD-3 -
MISCO Refractometer
The DD-3 Digital-Dairy Refractometer will provide reliable estimates of colostrum quality blood serum total protein concentration, the percent solids in waste milk, and calf hydration. The MISCO Digital-Dairy™ refractometers are specifically designed to help professional dairy farmers and calf ranchers to rear healthy calves. They are rugged enough to withstand the demands of farm use, yet precise enough to give laboratory-quality readings.
-
ESU-2050P -
BC Group International Inc.
Calibration quality analyzer; uses external precision non-inductive test loads and wide band current transformer. The Pulsed Model is compatible with all continuous output generators (same as standard model), plus generators with pulsed output waveforms.
-
Techcon
dispenses low, medium and high-viscosity fluids accurately and consistently. Is immediately usable anywhere in the world with its accompanying tools, accessories and universal power supply.
-
PROMAX Electronica
The instrument is equipped, in addition to the 20 Hz-160 MHz input, a second input for measurement up to 2.4 GHz with an impedance of 50 Ohms.
-
GPS3/MGPS3/UGPS3 -
CKD Corporation
The wide range gap switch is digitally displayed, making it even easier to use.First in the industry! High-precision 2-point output makes operation easy.
-
THL270 -
TMTeck Manufacturing Limited
Pen type Leeb hardness tester Converts to all common hardness scales (HL.HV,HB,HRC,HRB,HRA,HS). The machine also include interface to connect with impact device C, DC, G, D+15, DL
-
565 -
Summit
Air flow 0.2 to 20m/s(Units km/h, ft/min, knots/h, miles/h). Temperature -20 to 80(5 to 175), ±1% of reading ±0.5 ±3digit. Data recording, Serial output(RS232)
-
VME-1182A -
Abaco Systems Inc
A multifunctional intelligent controller allows COS, SOE, pulse accumulation, debounce times and time tagging control on a per-channel basis.
-
IOD-144 -
Acces I/O Products, Inc.
This is a 144-bit full-size card. A Programmable Peripheral Interface chip, type 8255-5 provides three 8-bit ports (A, B, and C) for each 24-bit group. Each port can be independently programmed for either input or output. Port C can also be configured as two 4-bit ports. These cards fully implement Mode 0 of the 8255 PPI chip. (Consult the factory if you desire to operate in Mode 1.) Type LS245 bi-directional transceivers sink 24 mA (optionally 64 mA) and source 15 mA. These transceiver buffers provide hysteresis correction on inputs and added drive capability on outputs. The direction of the transceivers is set by software.
-
SDIT300 -
Summit
ACV ; 600V. Safety standard ; IEC1010-1, IEC1557, CAT. 600V. Operating Temperature ; 0 to 40. Operating Humidity ; RH 70% MAX. Storage Temperature ; -10 to 50. Storage Humidity ; RH 80% MAX