Filter Results By:
Products
Applications
Manufacturers
-
product
Backflow Test Kit Repair Calibration & Certification
Meeting Water Safety regulations and standards has become a primary concern for all industries. Most municipal and state regulators demand that Backflow Prevention Testing be carried out no less than once per year and that testing devices be calibrated and if required, certified regularly.
-
product
Certification
Astronics provides domestic and international supplemental type certification services for approval of In-Flight Entertainment, Wi-Fi systems, In-Seat Power systems and other cabin and aircraft systems. Astronics engineers and staff have an extensive understanding of regulatory agency certification practices and requirements.
-
product
Insight Pharmaceutical Metal Detection System
The Insight PH Pharmaceutical Metal Detector is designed for inspecting tablets and capsules after the tablet and de-duster process with throughput of up to 30,000 units per minute. The system is built with a gas strut stand frame offering exceptional manoeuvrability making it convenient for use with all leading tablet presses and encapsulation machines.Designed with throughput of up to 30,000 units per minute, the Insight PH comes complete with full IQ, OQ & PQ validation documents and certification.
-
product
HBM Verification Tester
HBM-VT
High Power Pulse Instruments GmbH
- HBM pulse generator verification tester according ANSI/ESDA/JEDEC JS-001 up to ±10kV- To be used in HBM test and qualification labs for regular pulse generator specification compliance test in order to fulfill lab audit and certification requirements- Fully automatic compliance test and verification of HBM pulse generators regarding ANSI/ESDA/JEDEC JS-001 normative standard at 3 different load conditions: Short Circuit, 500 Ω, and a reference diode at VBR=15 V reverse breakdown voltage, including DC test- Parameter evaluation and verification of the transient HBM current waveforms: Peak Current, Rise Time, Decay Time, Maximum Ringing Current- Optionally available upgrade for all HPPI TLP-3010C, 4010C, 8010A, 8010C, HBM-TS10-A hardware systems in combination with HBM-S1-B (6kV) pulse generators (upgrade on request)- Fully automatic test report generation (PDF)- Electrically floating (no fixed system ground): The HBM loads, current sensor output, USB control interface and the enclosure are electrically floating. There is no limiting system ground which may introduce common-mode interference induced HBM current measurement errors.- Isolated industrial full-speed USB control interface- Isolated power supply derived from USB port- Compact size 126mm x 82.5mm x 44.5mm
-
product
Renesas RA Family Of 32-bit MCUs With Arm® Cortex®-M Core
The flexible Renesas Advanced (RA) 32-bit MCUs are industry leading 32-bit MCUs with the Arm® Cortex®-M33, -M23 and -M4 processor cores and PSA certification. RA delivers key advantages compared to competitive Arm Cortex-M MCUs by providing stronger embedded security, superior CoreMark® performance, and ultra-low power operation. PSA certification provides customers the confidence and assurance to quickly deploy secure IoT endpoint and edge devices, and smart factory equipment for Industry 4.0.
-
product
Software Analytics in the Cloud
Know the risks, the technical debt, the security flaws, the performance issues… create automatic action plans and analyze their progress. Make better decisions, faster, with Kiuwan Software Analytics! Kiuwan is the Optimyth cloud solution for the Certification, Management and Government of the quality and productivity of the source code of your business critical application portfolios.
-
product
Aviation Engine Test Cells
1.Design, manufacture and installation: ● Thrust stand components: thrust measurement system, adapter, superstructure etc. ● Facility subsystems: DAQ, supply systems (fuel, oil) etc.2.Civil construction works: site survey, building works etc.3.Contracting: ● Turn-key – MERA is able to supply a “turn-key” test cell including civil works, thrust stand, DAQ, all necessary facility subsystems, specialized software, throttle control level and etc. ● Joint – MERA is capable to supply specified items such as thrust stand with DAQ and software. The Customer is able to procure necessary items such as test nacelle directly from OEM. 4.Project management in accordance to EPC (Engineering, Procurement, Construction, FIDIC) 5.Certification in accordance to international and local standards and rules (SAE 5305) Engine types: PD-14, PS-90, RD-93, RD-33MK, AL-31FN
-
product
Reference Thermometers
Our Reference Thermapen takes lab accuracy into the field. Each unit is factory calibrated at 5 test points and includes a UKAS accredited calibration certificate with test data. A true "system calibration" is performed matching its Platinum RTD sensor and the built-in electronics so all errors are included in the spec.
-
product
Performance And Quality Testing
Underwriters Laboratories Inc.
Our endless pursuit of the truth helps you provide trustworthy answers to questions about products, processes, facilities and systems. Our testing, certification and verification services—and the UL Mark—provides regulators, purchasers and consumers with the information they rely on to confidently make the decisions that impact your business. Our quality assurance checks help to ensure that components and products meet your—and your stakeholders’—demands.
-
product
Fast Response Flow Controller for Medium Flow
HFM-301 / HFC-303
The HFM-301 / HFC-303 meters and controllers have flow ranges from 0-25 slm to flows of 0-1000 slm; provide analog outputs, are constructed of stainless steel and have normally closed valves. The full scale range is specified by the end user. A NIST traceable calibration certificate is standard. With a choice of elastomers and high pressure options, the HFM-301 / HFC-303 services a wide variety of applications. Cleaning for oxygen service is available.
-
product
Embedded Software
Ansys embedded software development solutions align the design process according to safety standard objectives, reduce development costs, and accelerate time to certification by a factor of two.
-
product
Digital Panel Meters
Accuracy 0.05% F.S.±1digitMeasuring DCA/DCV/ACA/ACV/Potentiometer/Pt-100/Thermocouple/Load Cell/Resistor/etc...Input type J/K/T/E/R/S/B can be modifiedProgrammable rate -19999~99999 digitDecimal point can be modifiedDimension small and High stability CE EMC certification
-
product
EMI Test Receiver
ESRP
The R&S®ESRP EMI test receiver has been designed for diagnostic measurements during development and for precompliance measurements to prepare products for final certification testing. It measures electromagnetic disturbances in the 10 Hz to 7 GHz frequency range, using either conventional stepped frequency scans or FFT based time domain scans to significantly speed up measurements.
-
product
Mass Flow Controller for Medium Flow
HFM-201 / HFC-203
The HFM-201/HFC-203, Teledyne Hastings' flexible, general purpose series of mass flow meters and controllers accurately measure and control mass flow in a variety of applications. Featuring reliability and stability, the 200 Series is chosen for its very stable performance with varying ambient conditions. A wide choice of elastomer seals make this flow controller compatible with most gases.The HFM-201 / HFC-203 meters and controllers have flow ranges from 0-25 slm to flows of 0-1000 slm; provide analog outputs, are constructed of stainless steel and can be configured with normally open or normally closed valves. The full scale range is specified by the end user. A NIST traceable calibration certificate is standard. Many corrosive gases and pressures up to 1000 psig are easily measured. Cleaning for oxygen service is available.
-
product
Electrostatic Potential Monitoring Device
electrostatic potential monitoring device that has an interface for connecting our potential sensors EMS-01 / EMS-01A / KS-2100 and measures static electricity in real time. It is possible to monitor static electricity with simple The compatible potential sensor EMS-01 / EMS . With SD card support, measurement data and alarm history can be collected with a time stamp. Operation using the touch panel display and screen display, and to notify and manage the measurement status with multiple control outputs. ...-01A Has Passed The Intrinsically Safe Explosion-Proof Structure Certification In Combination With The Safety Cage KS-301A, And Can Be Used In A Dangerous Atmosphere.
-
product
Weights
Vetek only sells precision class M1 weights on our webshop. In most cases these act as ideal control weights. If you require weights with a certificate for first time verification, please contact us.
-
product
Cabling Certification
Versiv family
The Versiv family accelerates every step of the certification process. Future-ready design supports copper certification, fiber loss, OTDR testing and hardware upgrades. The revolutionary ProjX management system and Taptive user interface ensures jobs are done right the first time. Analyze test results and create professional test reports using LinkWare management software.
-
product
Industrial Mini-Redundant AC Power Supply, 460W
APS-946XAR
- Power (typical): 460W- AC Voltage Input Range: Universal- Certifications: UL/cUL/TUV/CCC- Dimensions: 195 x 150 x 86 (mm)
-
product
Calibrated Solar Reference Cell
To insure repeatable testing on any solar simulator, OAI offers 2cm x 2cm calibrated reference cells. Standard reference cell calibration cycles can be set up by OAI''s calibration laboratory to insure that your reference cell maintains certification.
-
product
SOFTWARE UPDATE FOR MDHDM LINKED TO MDMAX3 & MDMAX3HD
MDHDAPPUP
*Software update certificate for Maximus 3.0 with HD Module (item# MDHDM) and MDMAX3HD*Subscription is good for ONE year from the date of software renewal
-
product
Network Security
TrustMonitor™
TrustMonitor™ provides continuous monitoring of the trust network by:*(Analyzing content & constraints for validity of credentials*Monitoring that certificate authorities are available to support validation*Easily scaling to incorporate new certificate authorities (no agent required)
-
product
Wireless Device Testing
D.L.S. Electronic Systems, Inc
WI the testing and certification of your Wireless Device will be accomplished with precision and efficiency.
-
product
Signalling Relays
Q Style / BR930
Mors Smitt has expanded its wide range of relay products with the Q-style BR930 signalling relays manufactured by Mors Smitt UK Ltd. in Burton on Trent, UK. We have been manufacturing these relays since the 1960’s and have full Network Rail acceptance certification (formerly British Rail)
-
product
Multilogger
M1300
Universal datalogger with 4 universal hardware inputs. Multilogger can be installed permanently to Ethernet network or work as portable device. Included is traceable calibration certificate in accordance with EN ISO/IEC17025
-
product
40W to 300W - Single Output
DTM Series
*Meets DoE Level VI Efficiency*Medical Certifications*ErP, CEC and EISA Compliant Models*Wide Range AC Input
-
product
Power Supplies
ZP-480B
Many power supplies fail to obtain the 80-Plus certification, which indicates that the power supply can provide 80% plus power efficiency. The ZP series, however, can. It is one of the few power supplies that can give you the power you need at higher efficiency, which means you can use the same power with less energy.
-
product
Explosion Proof UV Inspection Light
he Labino MB Hercules Ex is an extremely durable product specifically developed for use in areas where the risk of an explosion is high. Offshore Oil Rigs, Refineries, Aerospace, and Defense often require explosion proof products to ensure safety for their inspection teams. The Midbeam Hercules Ex has successfully completed extremely tough tests, including tests for thermal conditioning, Impact Tests, Drop Tests and IP tests that led to the ATEX certification (Certificate: ITS17ATEX402144X). This unique product is suitable for use in extreme weather conditions varying from 104° Fahrenheit (+ 40° Celsius) to minus 4° Fahrenheit (- 20° Celsius).
-
product
Product Safety Compliance Testing
We can accommodate any project scope. Whether you have the need for NRTL certification, European Low Voltage Directive (LVD) compliance, or to satisfy internal production control requirements, our Product Safety testing services can meet your needs.
-
product
Thermometer
C0111
Audio and optical alarm of measured temperature. LCD backlight. Minimum/maximum memory. Memory of minimum and maximum temperature included traceable calibration certificate.
-
product
Gaussmeter Probes
2100
Magnetic Instrumentation manufactures Hall Effect Probes in a wide range of styles and sizes. Probes are supplied with magnetic, electrical, temperature stability and calibration data for each measurement range. Probe are supplied with flash memory and a temperature sensor that allow the 2100 Gaussmeter to correct for Hall Element inaccuracies due to temperature change. Probes are supplied with a NIST traceable Certificate of Calibration and test data.
