Product

Standard Resistor Oil Bath

9400

-

Measurements International Ltd.

9400 - Measurements International Ltd.

Measurements International’s series of fluid baths are used for the maintenance of standard resistors and shunts. The 9400 has been designed after compiling years of customer feedback on existing resistor oil baths.

Product

Standard Panel & Display Products

-

Teledyne Defense Electronics

Teledyne Defense Electronics

Standard Panel & Display Products by Teledyne Defense & Electronics

Product

Standard & High Speed Amplifiers

-

Advanced Energy

Advanced Energy

Advanced Energy's Trek high voltage power amplifiers employ unique and proprietary circuitry. Benefit from closed-loop amplifier systems that feature exceptional DC stability and excellent wideband performance characteristics. And thanks to all-solid-state designs, our amplifiers are protected from output short circuits and overvoltages.

Product

FlexVNX+ Test And Development Platform Aligned To SOSA And VITA 90 Standards

39S08VPX98Y2VAN

-

ELMA Electronic, Inc.

39S08VPX98Y2VAN - ELMA Electronic, Inc.

Elma’s all-new FlexVNX+ Test and Development chassis is the next generation portable test platform designed to accelerate development and test of VNX+ plug-in cards (PICs) aligned to The Open Group® SOSA™ Technical Standard and VITA 90.

Product

SiTek Standard PSD

1L20_CP3

-

SiTek Electro Optics AB

1L20_CP3 - SiTek Electro Optics AB

The SiTek Standard PSD (Position Sensing Detector) has high resolution, fast response and outstanding linearity. It is used in a wide variety of applications, most of them utilizing light sources in the visible or near-infrared part of the spectrum. The spectral range covers the region 400 - 1100 nm. Thanks to SiTek's proprietary AR-coating, optimized around 860 nm, a reflection loss of only 2% is achieved around the responsivity peak. Most of the detectors have a cover window to avoid handling damages.

Product

Standard Probe Station Chucks & Accessories

-

ABET Technologies, Inc.

ABET Technologies, Inc.

In this test solutions section of our website we describe the expanding line of Abet PV IV probe stations for the growing variety of solar cell types and sizes being developed around the world. This page describes a line of vacuum chucks and accessories for top/bottom, top/top, and bottom/bottom solar cells from 3 x 3 mm to 300 x 300 mm. Probe stations for multiple device on a single substrate and multifunction probe stations are described further in the sections highlighted to the left of this page.

Product

Standard Clamp-On Ultrasonic Transmitter

KATflow 100

-

Katronic

KATflow 100 - Katronic

The KATflow 100 is a compact clamp-on ultrasonic flow transmitter with a robust and practical design for permanent installation and flow measurement on single pipes.

Product

600MM 24In Digital Level Bevel Gauge w/ LCD Backlight Screen, Level Bubbles, IP54 Standards

DL406

-

Advance Plus Trading Co., Ltd.

DL406 - Advance Plus Trading Co., Ltd.

Model Number: DL406 Key Specifications/Special Features: 600MM 24INCH Digital Level with level bubbles,LCD bright backlight display, IP54 standards 1. 600mm 24 inch level with 2 bubbles, 600*28*64mm（L*W*H）, net weight: 520g;2. Resolution: 0.05°;3. Horizontal level measuring range: 0 to 360°;4. Accuracy: ±0.3°;5. Measures angle in degrees, IN/FT, mm/m, % slope or pitch;6. Audible tone at level, plump and setting angle;7. Automatic shut-off after 3 minutes;8. Backlight LCD;9. Self checking accuracy;10. Self calibration;11. Hold-function to freeze the measurement;12. Memory recall (9 measurements);13.Handshank design, easy to take and use;14. 2pcs high accuracy horizontal & vertical bubbles, clearly to check;15. Operated by DC 3V (2*LR03 AAA 1.5V batteries, not included); 16. IP54 waterproof & dusyproof industrial standard.

Product

CANbus Controller Standard Interface

PCI360

-

AcQ International

PCI360 - AcQ International

The PCI360 CANbus controller PCI card is based on the SJA1000. The SJA1000 provides an interface to the popular CANbus that support both standard (11-bit) and extended (29-bit) identifier messages. LEDs provide diagnostics information.The CAN network is a serial communication protocol which efficiency supports distributed real-time control with a high level of reliability.

Product

Standard Voltage 50 Pin D-Type Connectors for Pickering

-

Pickering Interfaces Inc.

Pickering Interfaces Inc.

The connectors below are suitable to use with Pickering cards and modules that utilize a standard voltage 50-pin D-type connector.

Product

Standard Mechanical Calibration Kit, DC To 9 GHz, Type-N, 50 Ohm

85032F

-

Keysight Technologies

85032F - Keysight Technologies

The Keysight 85032F calibration kit contains precision 50 ohm type-N standards used to calibrate Keysight network analyzers. Standards include fixed terminations, open circuits, and short circuits in both genders. This kit is specified from dc to 9 GHz.

Product

Electron Multiplication (EM) Standard Image Sensors

-

Teledyne e2v

Teledyne e2v

EM (Electron Multiplication) is a technology that uses on-chip gain in the charge domain to effectively eliminate read noise from an image sensor. This enables advanced ultra-low light applications that require extreme sensitivity at fast frame rates. Examples include life science applications such as single molecule detection, super resolution microscopy and spinning disk confocal microscopy along with physical science applications such as nanotechnology imaging, Bose Einstein condensates and soft X-ray spectroscopy, and astronomy applications such as adaptive optics and lucky imaging. The inclusion of an additional conventional output allows further flexibility for applications such as true 24 hour surveillance.

Product

Conformance Calibration Standard Test Card for GS1-DataBar Symbol Verifiers

AI-CCS-DATABAR

-

Applied Image, Inc.

AI-CCS-DATABAR - Applied Image, Inc.

This test card is ideal for testing verifiers, scanners, and other GS1-DataBar barcode reading equipment. It also can serve as an excellent training aid to ensure new operators are using the proper methodology and are proven competent in the use of verifiers.