-
Product
Impulse Magnetic Field Immunity Tester
IMF61000-9
-
IMF61000-9 impulse magnetic field immunity tester is high performance test instrument which special designed for to do impulse magnetic field immunity test and fully meet IEC61000-4-9, EN61000-4-9 and GB/T17626.9 standards, also it come with high intelligent, high stable performance and easy operation characteristics.
-
Product
Logarithmic Periodic Broadband Antennas
Standard LPDA
-
Is a demountable logarithmic- periodic broadband Antenna (LPDA). For transport and space saving storage, it is delivered with fast links. The fast links allow to demount the rear elements within a few seconds without any tools.
-
Product
RF Downconverters
-
Today’s high-band signal standards are using higher frequencies and wider bandwidths than ever before for applications such as next generation 5G wireless services, satellite communications, electronic warfare, and more.
-
Product
Millimeter Wave Antennas
-
Ducommun millimeter wave products include ACH, ARH and ALC series circular, rectangular gain horn antennas and lens corrected horn antennas for system applications. Low side lobes, ridged configuration and low cost are the main features of these antennas. The standard gain value and half power beamwidth at mid-frequency point of each waveguide band are 23 dBi and 9 degrees, respectively. Other gain values are available as customer order. These antennas cover the frequency range of 18 to 110 GHz.
-
Product
4 Antenna Phase Controller
StackMaster
-
This controller comes in two versions and is configurable to support all of the Array Solutions products. The version with the 11 output relays is meant to be used with the StackMaster and is described below.
-
Product
RF Systems
-
With our detailed, end-to-end knowledge of beam generation systems and the way platforms operate in the field, we deliver state-of-the-art radio-frequency and x-ray systems. These integrated and effective systems are built with optimised components and interfaces to achieve the performance, reliability and ease-of-use expected by platform designers, manufacturers and end-users.
-
Product
Telemetry Antennas
-
Communications & Power Industries
CPI SAT is a multinational manufacturer of high-performance, highly engineered antenna systems used for critical satellite communications, telemetry, tracking and control (TT&C), general telemetry, earth observation (EO), radar, electronic warfare, search and rescue and other specialty applications. Offering advanced antenna systems for land, air and sea, with a full range of solutions and capabilities to meet any military requirement, and its Orbital Systems operations design and manufacture antenna systems that meet the high performance, accuracy, and high reliability needs of demanding satellite tracking applications and mission-critical uplink and downlink applications.
-
Product
RF Socket
-
With unparalleled technology, coaxial structure, and high-precision machining equipment, LEENO can provide RF test socket with high bandwidth, impedance matching and high frequency up to 40GHz.
-
Product
Magnetic Field Sensor
-
Vernier Software & Technology, LLC
The Magnetic Field Sensor can be used to study the field around permanent magnets, coils, and electrical devices. It features a rotating sensor tip to measure both transverse and longitudinal magnetic fields.
-
-
Product
Remote Antenna Switch
RATPak System
-
This switch is designed to give you reliable performance even at veryhigh power and SWR levels. This indeed should be the last antennaswitch you should have to purchase. It is also designed so that in caseof a failure of a relay or other device, it can be easily disassembled and repaired. This is not the least expensive switch on the market but we believe you will appreciate the quality that went into its design.
-
-
Product
D C DIELECTRIC STRENGTH TESTERS ( HIPOTS )
DV-50V-5
-
D C DIELECTRIC STRENGTH TESTERS ( HIPOTS )
-
Product
RF Connectors
PSMP Connectors
-
Amphenol RF PSMP connectors are the perfect solution for board-to-board applications requiring high power. With a minimum board spacing of 12.6 mm, the three-piece design allows maximum flexibility for high-density board spacing, and is an ideal solution for blindmate situations.
-
Product
Antenna, Log Periodic
EM-6956 | 500 MHz – 3 GHz
-
The Electro-Metrics EM-6956 Log Periodic Antenna operates over the .5-3 GHz frequency range. The broadband frequency capacity of the EM- 6956 eliminates the need for band switching, element extension or external tuning.
-
Product
Active Antennas
-
Is an antenna that contains active electronic components such as transistors, as opposed to most antennas which only consist of passive components such as metal rods, capacitors and inductors.
-
Product
Millimeter Wave Antenna Testing
-
If you are involved in antenna or system level design using mmWave or THz frequencies, then you understand the importance of dependable testing equipment. It may be that you are designing passive phase array or that you are designing a mmWave radar sensor system, but when it comes to validation of your design, simulation can only bring you so far. Phased array antennas have to be measured over the air (OTA) to ensure the radiation pattern of your design efficiently conducts energy in the right direction which is where the MilliBox comes in.
-
Product
RF Adapters
N-Type Adapters
-
One of the most important classes of radio frequency adapters as they are often used to bring radio frequency connectivity outdoors.
-
Product
Antenna
-
The multifunctional antennas are designed to meet the harsh environmental conditions and limited space availability found on submarines. This is achieved by utilizing a unique stack array enclosed within a protecting fibre glass dome.
-
Product
Base Station Antennas
-
Fiberglass Collinear 118-960 MHz Omni Patterns - 500 Watts Standard connector is a recessed N-Female. 7-6 DIN available
-
Product
Antenna Tuning Unit
MS 2012
-
Antenna Tuning unit is used to automatically tune the notch antenna impedance. Microprocessor does tuning through tuning inbuilt algorithm. It has RS485 interface for external control unit interface. Capacitor unit (CU), Inductor unit, (IU) and RF Element are subunits of this antenna-tuning unit. System maximizes transmission.
-
Product
Dielectric Strength Tester
HY
-
Chongqing Lushun Scientific & Technological Development Co., Ltd.
The instrument is designed and made as per the National Standard GB/T 507 "Test Methods for Breakdown Voltage of Lubricating Oil". It can be widely used to determine dielectric constant of lubricating oils in the field of railway, aviation, power plant, petroleum industry, and scientific institutes.
-
Product
Bi-Sector Array Antennas
-
*Dual 33 degree beam antennas with a 65 degree pattern foot print*Multi-band capable*IIndependent tilt control for each beam**RemoteElectricalTilt (AISG 2.0)*Increase site capacity & data throughput
-
Product
50 Ohm BNC to SMA Adaptor Assembly
40-978-511-1m
-
Pickering Interfaces offer a range of RF cable assemblies to complement our extensive range of PXI, LXI, PCI, VXI and GPIB switching products. All cable assemblies are made from high quality materials and use best practice assembly methods to ensure the cabling matches the performance of the switching modules they support.
-
-
Product
RF Components
-
Using a Vector Network Analyzer (VNA) for RF component testing for design and manufacturing is based on how the component performs. The analyzer is used in multiple ways from design to manufacturing to tuning, field monitoring and maintenance of antennas, filters, mixers, amplifiers, circulators, isolators, and other RF components. Key considerations component designers should pay attention to when finding an analyzer that fits their needs is a great dynamic range, low trace noise, and fast measurement speed.
-
Product
Monitoring & Drive Test Antennas
-
Linear polarized half-wave dipole with 1:1 balun and fixed element length for fieldstrength measurements at TETRA (terrestrical trunked radio) networks.
-
Product
Bluetooth Antennas
-
Our portfolio of Bluetooth antennas includes products for internal/embedded mounting within IoT devices as well as externally mounted antennas for access points, gateways, and larger fixed infrastructure applications. Many of our internal/embedded Bluetooth antennas have an adhesive mounting retention type. Externally mounted antennas come in a variety of mounting styles, including direct mount to pole and mast mount options. Multiple connector and cable options are available for our customers to make the best choice for their applications Custom antenna developments are regularly undertaken to meet specific customer requirements. Our Bluetooth antenna portfolio includes products manufactured by TE Connectivity, Laird Connectivity External Antennas, and Hirschmann Car Communications.Read Less
-
Product
Antennas
-
Dual polarized 6 dBi omni-directional antenna. Included with each antenna is a unique mounting bracket that allows the Ubiquiti® RocketM2 radio to be attached directly to the antenna. Also included are a pair of 195-series low-loss cable assemblies to connect the RocketM2 to the antenna. Customers can enjoy the cost saving of these kits compared to purchasing an Ubiquiti® antenna to use with the RocketM2 radio.
-
