-
Product
Universal Network Appliance With Intel® Atom™ Processor C3000 For VE-CPE And SD-WAN. Ideal For SD-WAN Deployments.
FWA-1012VC
-
Intel® Atom® C3000, up to 8 Cores, with Intel® QuickAssist Technology2 x DDR4 DIMM slots, up to 64GB2 x 1GbE SFP + 6 x RJ-45 slots4G LTE and Wi-Fi supported (optional)Reserve 1 x SATA3.0 SSD/ M.2 3042 LTE module and 1x Mini-PCIe for Wi-Fi module (optional)2 x PoE supported (optional)
-
Product
AFDX ® /ARINC664P7 Networks Test, Simulation, Monitoring & Analyzer
ACE-FDX-3U-2
-
AFDX®/ARINC664P7 Test and Simulation module for PCIe x1 with 2 full duplex ports programmable for 10/100/1000 MBit/s. Versions available for both Airbus and Boeing variants of ARINC664P7. Test, verification and simulation of AFDX®/ARINC664P7 End Systems, Switches and Networks. Support for Single or Redundant AFDX®/ARINC664P7 operation. Support for Boeing ARINC664 extensions for EDE at the hardware interface layer.
-
Product
1U Rackmount Network Appliance With Intel® Atom™ X5-E3940 Processor And 6 GbE Ports
FWA-2011
-
Intel® Atom™ X5-E3940 Processor, 2 x DDR3L 1333/1600/1867MHz SODIMM up to 16GB. 6 x GbE LAN ports with 2 pairs of LAN bypass, 1 x Advantech network module expansion, 1x mSATA slot, 1 x Mini-PCIe slot.
-
Product
CDNs - Coupling Decoupling Network
-
Coupling Decoupling Networks, commonly called CDNs for IEC-61000-4-6 conducted immunity testing, serve the purpose of Injecting common mode disturbances These CDNs also ensures these signals do not interfere (decoupling) with auxiliary equipment connected to the device under test (DUT)
-
Product
Multi-service Network And Telecom Analyzer
NetProbe 10G
-
Multi-service Network and Telecom Analyzer. The NetProbe 10G is the latest introduction to NetProbe family of handheld testers. The NetProbe 10G comes with 10G Ethernet basic functionality as standard and can be software upgraded anytime with advanced 10G Ethernet, IPTV, VOIP, WIFI and IEEE C37.94 options.
-
Product
Scalar Network Analyzer Extenders
-
A Scalar Network Analyzer is a type of RF network analyzer that is used to measure only the amplitude properties of a DUT (Device Under Test). Unlike a Vector network Analyzer, it does not measure both amplitude and phase of the DUT.
-
Product
5uH Line Impedance Stabilisation Network LISN - CISPR 25
TBOH01
-
The TBOH01 5H LISN is a device required to setup conducted noise measurements of DC-powered devices. It is designed to be used for EMC pre-testing in the frequency range of 150kHz to 110 MHz.
-
Product
Network Analyzers
-
The LanExpert LE80 Inline network analyzer is a single solution for analyzing and troubleshooting networks from the cabling to the packet. The LE80 tests Wiremap, Length, PoE, Tone and Port ID.
-
Product
Inspector / Traffic Data Manager
-
Inspector is a scalable platform able to centralize the data acquired from different cameras distributed on the field. The system is scalable and extensible to perform average speed enforcement control, security applications, traffic statistics and access control. Inspector can analyze collected data according to configurable rules and undertake a number of actions based on the results: opening gates, sending emails, posting messages on variable message panels.
-
Product
Optical Power Meter & VFL & RJ45 Network Test
TM263N
-
◇ Added Network Cable Test ◇ Accurately test whether a single network cable transmits signals normally ◇ Self Calibration ◇ Set the Auto Off ◇ Wavelength Memory function after turn off the tester ◇ High Accuracy, high ,High sensitivity, high linearity ◇ Stable VFL Output ◇ USB Charge port ◇ FC,SC Connector ◇ 18650Li-ion Battery ◇ Lower power consumption design, long standby time ◇ Rubber Out shell, increased the protective properties for field work
-
Product
Comprehensive Simulation of Master, Slave and End Nodes in A 2 B ® Networks
Infotainment Test Device ITD 1024
-
The complexity, cost and weight of audio systems are significantly reduced with the Automotive Audio Bus (A 2 B ® ) from Analog Devices Inc. Regardless of their hierarchical structure or use as master or slave, all A 2 B ® products must be adequately tested before use. This applies, for example, to HiFi amplifiers/loudspeakers, head units, eCall systems, microphones, vibration/noise suppression units, actuators or sensors.Our small and very compact infotainment test system ITD 1024 takes on this task for you: It comprehensively and extremely reliably tests all A 2 B ® signals and communication in all phases of the product development process - during development, for validation and in production.
-
Product
Network, Port ID And Cable Tester
One for All PH-400
-
The One For All is an all-in-one network tester, tone generator, cable tester, and port ID finder. It comes with a remote unit, allowing pin-by-pin tests of installed cables in addition to patch cables. The office ID feature allows the user to check the ID number of up to 100 networks or patch panel outlets without labeling the cables manually, and the tone generator traces cable using a tone detectable by any market tone probe. The network tester blinks the network hub or NIC port light for the cable being tested, allowing easy cable and outlet identification; and it identifies network speed (10 Mbps vs. 10/100 Mbps vs. 10/100/1000 Mbps) and activity. Line tester included for detect live circuits and preventing damage to the tester.
-
Product
Analog/Digital and Network Trace
-
At iSYSTEM, we realize that embedded systems development requires more than just the insights of the microcontroller/processor. Developers need a holistic view, covering external signals and serial bus messages, or even insights into more than one microcontroller/processor and/or traget system at once.
-
Product
Instant performance assessment of complex networks
IxChariot
-
Keysight Network Applications and Security
Instant performance assessment of complex networks from pre- to post-deployment.
-
Product
6GHz 2-port Vector Network Analyzer
VNA-0460
-
The VNA-0460 is a full bi-directional 2-port Vector Network Analyzer that is controlled from a PC through a USB connection.
-
Product
Cable Continuity Tester, DB9, RS232 Mini, Network, 21.01 mm, 35 mm, 45.01 mm
72-9200
-
The 72-9200 is a Mini Cable Tester with USB Power Cable and Battery. Quickly test DB-9/RS-232 cables. No need to carry bulky, expensive cable testers to test only one or two cable types. Mini cable tester fits easily in your pocket or tool box and requires no external power. Confirms conductor continuity with sequential LED's. Save time and money by diagnosing connectivity issues.
-
Product
Vector Network Analyzer
Bode 100
-
With the multifunctional Bode 100 you get an exact picture of your electronic circuits and components in a frequency range from 1 Hz to 40 MHz. The Bode 100 is not only a state of the art Vector Network Analyzer, it also works as: Frequency Response Analyzer, Impedance Meter, Gain Phase Meter, Sine Wave Generator.
-
Product
Network Impairment Simulator
-
Testing system performance under realistic network conditions requires the introduction of impairments that could be expected to be seen on networks, especially public networks which are uncontrolled. There are a number of ways to do this. A basic method is to use network simulation devices that can emulate conditions expected to be encountered.
-
Product
Traffic Signal Controllers
-
Delve into our ATC Controller Modules to augment functionality and intelligence, ultimately optimizing roadway safety and streamlining traffic operations
-
Product
CANbus Network Tester
-
Automatic Pin Test - automatically checks any abnormality on the OBD2 port caused by shorting (i.e., Pin 16 Power shorted to Ground), reverse polarity, and any other abnormalities
-
Product
Network Interface
-
VadaTech offers AMC Network Interface Cards (NICs), FMC networking modules and ATCA rear transition modules (RTMs) with a wide range of connector interfaces to make it easier for you to integrate an embedded computing system into your solution.
-
Product
Live Packet Analysis For Reliable Networks
-
MetaGeek App is the culmination of MetaGeek’s best work in Layer 2 wireless troubleshooting. Enhance and streamline your wireless network performance and resolve roaming issues with ease. MetaGeek App also adds automatic event detection, intelligent client following, and a bunch of other useful capabilities never seen before in a MetaGeek product. With Oscium Nomad (included in the Packets Bundle) you can simultaneously capture on four different channels.
-
Product
Network Cable
-
Maximum speed 50 micron GOLD-PLATED contacts ensures the maximum speed is achieved through low resistance and signal degradation.Heavy Duty durability Lasts up to 10 times longer than other cables due to advanced protection against atmospheric corrosion and low friction.Network support CAT 5e cable will support Ethernet, Fast Ethernet, and Gigabit Ethernet. CAT 5e Cable is completely backwards compatible, and can be used in any application in which you would normally use CAT 5 cable.
-
Product
Network Performance Testing
FortiTester
-
FortiTester helps enterprises and service providers maintain the most secure and resilient infrastructure through continuous validation of effectiveness and performance. With network performance testing and breach attack simulation (BAS), it assesses the people, processes, and technology on which the security of an organization depends.
-
Product
10M/100M/1G Ethernet Network Emulator
VirtualNetTM GE
-
VirtualNet-1G is a high-performance Network Emulator that replicates real world Ethernet network effects such as latency and errors on user traffic in a controlled environment. The VirtualNet-1G emulator uses customized ICs to support full line rate performance at all frame sizes and impairment settings. The emulator can be transparently installed in-line as shown in the diagram below. VirtualNet-1G emulator has an intuitive and easy to use GUI interface and a very powerful TCL based CLI to aid in configuration and testing.
-
Product
Cable Continuity Tester, HDMI 1.4 Mini, Network, 21.01 mm, 45.01 mm, 47.02 mm
72-9225
-
The 72-9225 is a Mini Cable Tester for HDMI 1.4 cable. Mini cable tester fits easily in your pocket or tool box.
-
Product
PSTN Network Analyzers
E1 & T1, Data, DSL, Protocols, BER Analyzers
-
With 20 years of experience in the development and production of test instruments, GAOTek is proud to provide a large selection of PSTN analyzers that meet the requirements of technicians working in the telecom industry for sale to the United States, Canada and Globally. Public Switched Telephone Network (PSTN) was designed to ease the two-way communication between two points or two users. In the beginning, a direct connection between two points was very simple, however the cost was too high depending on the distance and geography. The network engineers revolutionized voice communications by creating PSTN which is still in use today.
-
Product
Copper Network TAPs
-
Network test access points (TAPs) are a hardware tool that allows you to monitor your network. Garland Technology offers copper network TAPs in network speeds of 10/100M or 10M/100M/1000M (1G). Copper TAPs are purpose-built hardware devices used for out-of-band monitoring tools and make a 100% copy of your networks data allowing your monitoring tools to see every bit, byte and packet.®
-
Product
Network Management Software
OpManager
-
Out-of-the-box network monitoring , physical and virtual server monitoring, flow-based bandwidth analysis, firewall log analysis and archiving, configuration and change management, and IP address and switch port management, thereby providing all the visibility and control that you need over your network.
-
Product
Network Interface Controllers for Anonymous Subscriber Messaging (FC-ASM)
Fibre Channel
-
Avionics Interface Technologies
FC-ASM Network Interface Controllers for Avionics applications. The AIT FC-ASM NIC solutions are Quad interface modules providing 4 independent NIC interfaces on a single module. All FC-ASM and Fibre Channel protocol operations are handled onboard, providing an efficient, high bandwidth, FC-ASM protocol offload solution for 1Gbp/s and 2Gbp/s FC-ASM.
