Product

AC Voltage Tester

-

AllWin Instrument Science and Technology Co., Ltd.

AllWin Instrument Science and Technology Co., Ltd.

1. AC voltage tester2. TFT LCD3. PLC,RS232C,RS485 interface4. MCU control technology

Product

Surge Voltage Generator

SSG 2100

-

BAUR

SSG 2100 - BAUR

Cable fault location with the BAUR SSG 2100. Surge voltage generators are used for pre-location and pinpointing of high- and low-resistive as well as intermittent faults in power cables. The energy stored in a high-voltage capacitor is released at regular intervals or as DC voltage. The thus generated acoustic signal at the fault position can be recorded with a ground microphone and a universal receiver.* High surge voltage up to 32 kV* Continuously adjustable voltage* Voltage monitoring through kV meters with 3 measuring ranges* Automatic discharge unit

Product

Voltage logger0 to 25V

TK-4702

-

Gemini Data Loggers Ltd.

TK-4702 - Gemini Data Loggers Ltd.

Supplied with an input cable, this logger can measure voltages up to 25V DC and can be connected to many industry standard devices, such as CO2 sensors and current clamps, enabling the logging of a wide range of process parameters.

Product

NI-9220, cDAQ-9171, and cRIO-9940 USB Voltage Measurement Bundle

865685-01

-

NI

865685-01 - NI

NI-9220, cDAQ-9171, and cRIO-9940 USB Voltage Measurement Bundle - The USB Voltage Measurement Bundle with NI-9220, cDAQ-9171, and cRIO-9940 includes the NI-9220 C Series Voltage Input Module and the cDAQ-9171 CompactDAQ Chassis for voltage measurements. This bundle also includes the cRIO-9940 Backshell for strain relief and operator protection from high-voltage signals. The included NI-9220 features 16 channels and 16 simultaneous differential analog inputs with 250 Vrms CAT II or 60 VDC CAT I isolation. Additionally, you can use the NI-9220 to generate 3.2 MB/s of data at the maximum sampling rate.

Product

Dual Voltage Buffer with Current Drive

BUF-01

-

Viewpoint Systems, Inc

BUF-01 - Viewpoint Systems, Inc

The BUF-01 Voltage Buffer is a dual channel buffer capable of driving up to 50 mA of current on each channel at up to ±10 V output. The buffer has a 2nd order low pass filter with 3 dB point of 119 kHz to remove high frequency noise. The unit’s differential inputs are built to withstand high DC over-voltages up to ±50 VDC and greater than ±100 V transients. Gain of the unit is 1 allowing for minimal insertion issues.

Product

Multi Voltage Glow Plug Tester

4110

-

Peaceful Thriving Enterprise Co Ltd

4110 - Peaceful Thriving Enterprise Co Ltd

*Auto switch off.*With CE Approval.*Voltage supply by 9V battery.*Tester probe/clip is easy to replace.*Rubber coating for tester protection.*Initialization for different testing probe/clip.

Product

High Temperature Axial Extensometers

-

Epsilon Technology Corp.

Epsilon Technology Corp.

4 models cover a variety of applications for high temperature testing 1 un-cooled model for use inside chambers up to 600 °C (1000 °F) Other models for use with split furnaces and induction heating, up to 1600 °C (2900 °F)

Product

High Density, Low Noise, Floating Low Voltage Power Supply System

PL500 Series

-

W-IE-NE-R, Plein & Baus GmbH

PL500 Series - W-IE-NE-R, Plein & Baus GmbH

The WIENER PL500 is a high density, low noise, floating low voltage power supply system. The PL500-Series has been designed  to power lowest noise electronics with medium to high currents (10A to 500A current/channel range) over long distances in voltage or current controlled mode. Operating in either un-sensed or sensed mode the dynamic behavior can be set internally or by software for short, medium or long distances.

Product

Standard Voltage 50 Pin D-Type Connectors for Pickering

-

Pickering Interfaces Inc.

Pickering Interfaces Inc.

The connectors below are suitable to use with Pickering cards and modules that utilize a standard voltage 50-pin D-type connector.

Product

Pulsed High Field Magnetometer

TPM

-

TOEI INDUSTRY CO, LTD.

TPM - TOEI INDUSTRY CO, LTD.

This is the equipment evaluating the magnetic properties of rare-earth such as Js, Jr, Hcb, Hcj, (BH)max, HK and SR etc.

Product

PCIe - High Performance Radios

-

Silex Technology

Silex Technology

Supports up to 150 Mbps data rateCompliant with IEEE802.11 b/g/n standardsCompliant with IEEE 802.11b, 802.11d, 802.11e and 802.11g standards and the 802.11i specification Includes signal-sustain technology (SST) rate-over-range enhancements such as low-density parity check (LDPC), and maximum likelihood demodulation (MLD)Supports all mandatory IEEE 802.11n features as well as several optional features such as HT40, half-guard interval in HT40 and Rx space-time block coding (STBC)Supports low-power sleep modes and wake-on-wireless (WoW) LANFeatures the Atheros AR3012 Bluetooth 4.0 + HS chipset and Bluetooth Class 1 RadioUSB 2.0 device interface supports standard HCI USBRoHS compliant

Product

Programmable Withstanding Voltage & Insulation Test

LS9923

-

Lisun Electronics Inc.

LS9923 - Lisun Electronics Inc.

LS9923 programmable withstanding voltage & insulation test system is high-performance testing device special for AC&DC Withstanding Voltage and Insulation Resistance Test, It allows setting the output voltage. The warning value,testing time and some other parameters can be set in the screen.It with a variety of automatic test functions. The testing is quick and high accuracy which is not only applied in the production line but also in the develop research.

Product

High Speed ADC > 10MSPS

-

Analog Devices Inc.

Analog Devices Inc.

Analog Devices high speed A/D converters (ADCs) offer the best performance and highest sampling speed in the market. The product offerings include high IF ADCs (10 MSPS to 125 MSPS), low IF ADCs (125 MSPS to 1 GSPS), integrated receivers, and wideband ADCs (>1 GSPS). The High speed ADC portfolio offers solutions for all high speed conversion applications.

Product

5k Voltage Probe (set Of 3)

5KVPSet

-

Summit Technology, Inc.

5KVPSet - Summit Technology, Inc.

5KVPSet is a set of three voltage probes that allow direct connection to up to 5,000 Vrms 3 phase power.

Product

HIGH VOLTAGE SCR CONTROLLED POWER SUPPLY

xPS Series

-

Carl E. Holmes Company

xPS Series - Carl E. Holmes Company

High Voltage SCR Controlled Power Supply, P/N 18278PS Power Rating: 350 KW. Input: 480 VAC, 3 PH, 60 Hz Output: 0 to 5000 VDC, 70 Amps max Ripple: 2 % approximately at maximum rated voltage Configuration: 12 pulse externally SCR controlled rectifier system Protection Devices: Input contactors Overload relay shutoff Input surge suppressor Thermal switches Output current limiting resistor (made with 5 Ohm Kanthal heating element) Emergency power shutoff Cooling: Each 6 pulse rectifier assembly is cooled by three 10” fans Interface: 4/20 ma converter interface for output voltage and output current to SCR controller. Enclosure: The overall dimension of the unit is (78”H x 38”W x 53”D). It is comprised of two separate enclosures each with dimensions of (78” H x 38” W x 26” D) which are integrated together to form a single enclosure. Each half enclosure has one 6 pulse transformer and one 6 pulse high voltage rectifier. Weight: Approx. 5000 lbs. SCR Controller: The 12 pulse SCR controller is supplied by the customer. We were responsible for the 12 pulses Transformer and 12 pulses Rectifier section. Portability: Unit can be lifted up with a fork lift. It can also be moved around with a 5000 lb pallet jack. Transformer: Two 200 KVA transformers are used to step 480 VAC to 3750 VAC each in a 12 pulse configuration Rectifiers: Two 6 pulse rectifier assemblies capable for 5000 VDC and 60 Amps output were used. The high voltage rectifier assemblies are isolated and protected in a fiberglass plenum within the enclosure. Blocking Diode: Each diode of the 6 pulse rectifier consists of 10 diodes in series to offer a blocking voltage of 12000 V (PIV)

Product

JFET Voltage Preamplifier

SIM910

-

Stanford Research Systems, Inc.

SIM910 - Stanford Research Systems, Inc.

The SIM910 and SIM911 are low-noise, programmable preamplifiers which are ideal for a wide range of small signal applications. The primary differences between the two models are their input impedance and input noise. 

Product

High Current Connectors

-

Panasonic Industrial Devices Sales Company of America

Panasonic Industrial Devices Sales Company of America

Panasonic’s offering includes various High Current Board-to-Board Connectors suitable for applications that require a connection to a power source/battery. These High Current Connectors have low mated height profiles, high reliability, and are manufactured with Panasonic's Tough Contact technology.

Product

80-1000V AC Non-Contact Voltage Tester

5226

-

Peaceful Thriving Enterprise Co Ltd

5226 - Peaceful Thriving Enterprise Co Ltd

This non-contact voltage tester, can be used to test the presence of AC voltage from 80V~1000V, no need of metallic conduction, easy to read by visual and audio indication. Locates breaks along live, insulated wires and power cords. Adjustable sensitivity allows tracing of wires behind walls, around switches or receptacle.

Product

High Frequency (RF) Testing

-

C.C.P. Contact Probes Co., LTD.

C.C.P. Contact Probes Co., LTD.

CCP designs high frequency testing probes, coaxial probe sockets and pressurized conductive rubber sockets.

Product

Modular High Density Servers

-

Mercury Systems, Inc.

Mercury Systems, Inc.

Achieve optimum performance and precise functionality for a multitude of applications by mixing over six “plug and play” compute, storage, networking, PCIe expansion, management, and GPGPU modules.

Product

HIGH FREQUENCY DC BIAS

6565 SERIES

-

Wayne Kerr Electronics, Ltd.

6565 SERIES - Wayne Kerr Electronics, Ltd.

The 6565 HF DC Bias Unit is intended to be used with a Wayne Kerr 6500 analyzer, either the 6500B Precision Impedance Analyzer or the 6500P HF LCR Meter. Its function is to provide a source of DC bias current through the Device Under Test (DUT) while the analyzer is making AC measurements. Each 6565 unit can provide up to 10 A of DC current, and up to six 6565 units can be connected in parallel to supply a maximum 60 A. A digital ammeter on the front panel allows the user to see the dc bias current value and an indicator LED shows when the bias current is enabled.

Product

Low Voltage Power Supplies

-

FuG Elektronik GmbH

FuG Elektronik GmbH

We offer low-voltage power supplies in the power range up to 100,000W (customer-specifically even higher). , They are designed for maximum output voltages of 6.5V to 350V and are continuously adjustable from zero to maximum. Our low-voltage power supplies can be operated in constant voltage mode as well as in constant current mode. This enables unlimited operation at any time with the maximum current that can be supplied (even in the event of a short circuit). They are suitable for ohmic loads as well as inductive or capacitive loads and are characterized by a service-friendly design,