ECU
a vehicle system's Electronic Control Unit.
See Also: ECU Testing, ECU Simulation, Vehicle Electronics
-
Product
PXI-2510, 68-Channel, 2 A PXI Signal Insertion Switch Module
778572-10
Fault Insertion Unit
68-Channel, 2 A PXI Signal Insertion Switch Module—The PXI‑2510 fault insertion unit (FIU) is designed for hardware‑in‑the‑loop (HIL) applications and electronic reliability tests. Each module has a set of feedthrough channels that you can open or short to one or more fault buses. You can use this architecture to simulate open or interrupted connections as well as shorts between pins, shorts to battery voltages, and shorts to ground on a per-channel basis. When controlled with the LabVIEW Real-Time Module, the PXI‑2510 is ideal for validating the integrity of control systems including engine control units (ECUs) and full authority digital engine controls
-
Product
Lambda Sensor
KS60121
-
Konstar Electric Industrial Co., Ltd
An oxygen sensor, also known as a lambda sensor, continually detects the oxygen content in the exhaust gases of an engine. The oxygen sensor output signal informs the vehicle's ECU (Electronic Control Unit) whether the AFR (Air-Fuel Ratio) is lean or rich. Based on this, the ECU adjusts the amount of fuel injected into the engine to achieve an optimal AFR.
-
Product
PXI FlexRay Interface Module
FlexRay Interface
PXI FlexRay Interface Modules provide two fully functional FlexRay interfaces, allowing an individual electronic control unit (ECU) to be connected to the interface when other cold-start nodes are not available. You also can use the interfaces individually to connect two separate FlexRay networks while maintaining full performance on each interface. PXI FlexRay Interface Modules work well in applications such as hardware-in-the-loop (HIL) simulation, rapid control prototyping, bus monitoring, and automation control.
-
Product
Indirect Sequential Injection
-
The ECU is designed to exploit the chemical-physical characteristics of the gas fuel used in Otto engines while maintaining the level of emissions of the exhaust gas according to the original standard car.The connector used in Air 48 is automotive type 48- Poles . The connection to the engine signals , offers exceptional qualities of connective security and protection against water infiltration .
-
Product
Industrial Communication Gateway With TI Cortex A8, 2 LAN, 2 COM, 4 DI & 4 DO
ECU-1251D
-
TI Cortex A8 600MHz CPU with DDR3L 256MB RAMOnboard IO - 4DI / 4DOSupport web service for remotely on-line monitoringFirmware update by SD card and online updateData logger on SD cardSupport dual SIM slots for communication redundantSupport MQTT Client for cloud communicationWide Operating temperature: -40 ~ 70°C
-
Product
4-Port Isolated RS-232/422/485 With IRIG B Card
ECU-P1624D
-
industrial communication module designed for high-reliability, time-synchronized serial data transmission. It supports four software-configurable RS-232/422/485 ports, often including isolation for interference protection, alongside an IRIG-B time synchronization input, commonly used in substation automation.
-
Product
8-Port SFP/RJ45 Gigabit Ethernet Card
ECU-P1528
-
Network interface controller (NIC) that allows a computer to connect to a network at speeds up to 1,000 Mbps (1 Gbps), or 1 billion bits per second.
-
Product
Hyundai Oxygen Sensor
KS60113 - Hyundai
-
Konstar Electric Industrial Co., Ltd
An oxygen sensor, also known as a lambda sensor, continually detects the oxygen content in the exhaust gases of an engine. The oxygen sensor output signal informs the vehicle's ECU (Electronic Control Unit) whether the AFR (Air-Fuel Ratio) is lean or rich. Based on this, the ECU adjusts the amount of fuel injected into the engine to achieve an optimal AFR.
-
Product
Volvo Oxygen Sensor
KS60113 - Volvo
-
Konstar Electric Industrial Co., Ltd
An oxygen sensor, also known as a lambda sensor, continually detects the oxygen content in the exhaust gases of an engine. The oxygen sensor output signal informs the vehicle's ECU (Electronic Control Unit) whether the AFR (Air-Fuel Ratio) is lean or rich. Based on this, the ECU adjusts the amount of fuel injected into the engine to achieve an optimal AFR.
-
Product
Configurable Simulation Of ECU Diagnostics.
TestCUBE2
-
Softing Automotive Electronics GmbH
The ECU simulation TestCUBE2 is the counterpart for all cases of application in which an ECU is not yet (e.g. preparation of workshop tests) or no longer (e.g. tester regression test) available. TestCUBE2 is a configurable hardware and software solution for simulating ECU diagnostics with real bus communication. With just one device, you can simulate several ECUs or even an entire vehicle at the same time.
-
Product
Industrial Communication Gateway With TI Cortex A9, 2 LAN, 2 COM & 2 CAN
ECU-1252
-
TI Cortex A9 600MHz CPUDDR3L 2GB RAM16GB eMMC for system storage1 x Micro-SD Slot2 x CAN port2 x RS-232/485 isolated serial ports2 x 1000 Base-T Ethernet ports1 x Mini-PCIe for WIFI/Cellular/4GSupport web service for remotely on-line monitoring
-
Product
2-Port SFP Gigabit Base Ethernet Card With HSR/PRP
ECU-P1524PE-B
-
PCIe or embedded module supporting dual 1000Mbps fiber connections, designed for high-availability networks.
-
Product
High-Performance All-In-One Gateway For Battery Energy Storage Systems
ECU-1170
Edge Gateway
Quad-core Cortex-A55 processor, 1.8GHzConnectivity: 4 GbE, 8 RS-232/485, 2 CAN, 1 mPCle and 1 M.2I/O: 20 DI, 6 DO, 8 Relay, 2 AIBattery-powered RTC, Watchdog, and optional TPM supportWide operating temperature range: -40~70°COptional 5 sec power backup with SupercapacitorSupports IEC 61850, IEC 104, DNP3, Modbus, MQTT, and OPC UAPreloaded with Yocto Linux and EdgeLink or Ubuntu Linux
-
Product
Embedded System Test Automation Software
ECU-TEST
-
ECU-TEST is the software for automation tests used in the validation of embedded systems within the automotive industry. It can be used when designing, implementing, and evaluating different tests. It will generate intuitive test reports.
-
Product
Industrial Communication Gateway With TI Cortex A9, 2 X LAN & 4 COM
ECU-1251 V2
-
Cortex A9 600MHz processor with 2G RAM16GB eMMC system storage and 1 x Micro-SD Slot4 x RS-232/485 isolated serial ports2 x 10/100 Ethernet ports and 1x mPCIe for wireless communication expansionSupport web service for remotely on-line monitoringSupports SD cards and OTA firmware updatesEdgeLink IoT software for data acquisition and cloud communicationWide Operating temperature: -40 ~ 70°C
-
Product
Automotive Ethernet Interface Device
Ethernet Interface
The Automotive Ethernet Interface Device converts unshielded twisted pair (UTP) Automotive Ethernet to standard Ethernet. This device is ideal for developing applications that require Automotive Ethernet to test and validate automotive electronic control units (ECUs). It includes ports for Automotive Ethernet connections and ports for 100BASE-TX Ethernet connections. You can use switches on the front panel to configure each 100BASE-T1 port as master or slave. The device also provides LED on the front panel so that you can monitor the linkage and activity on the various ports.
-
Product
8-Port Non-Isolated RS-232/422/485 Ethernet Card
ECU-P1618D
-
enables 8 legacy serial devices to communicate over a standard LAN/Ethernet network. It supports multi-protocol operation (RS-232, RS-422, or RS-485) and acts as a gateway for data, often featuring virtual COM port redirection and high-speed data transfer.
-
Product
Expandable Industrial IoT Gateway With TI AM6734 Quad Cortex A53
ECU-1270
-
TI AM6734 Quad-core Cortex A53 CPU up to 1.4GHzLPDDR4 2/4GB up to 8GB, eMMC 32GB for system storage2x isolated serial ports, configurable for RS232/4852x 10/100/1000 Ethernet portsAdd-on modules available for CAN FD/serial/digital I/O expansionSlim, robust, and fanlessSupports SD cards and OTA firmware updates
-
Product
2LAN 4COM Modbus/BACnet/101/104/DNP3/PLC/Azure/AWS IoT Gateway
ECU-1251
-
TI Cortex A8, 800MHzDDR3L 256MB RAM1 x Micro-SD Slot4 x RS-232/485 isolated serial ports2 x 10/100 Base-T Ethernet ports1 x Mini-PCIe for WIFI/3G/GPRS/4GSupport web service for remotely on-line monitoringSupport SD card & on-line firmware updateSupport Modbus, IEC-60870-101/104 protocolSupport Data logger on SD cardRED ComplianceOperation Temperature -40~70°C
-
Product
Ignition Driver Units
-
A compact inductive ignition drive unit which drives two banks of five ignition coils. The drivers are controlled via direct logic signals from a host ECU and provide fire-by-fire diagnostics back to that unit via CAN. The coils can be run at voltages up to 30V with this unit in order to minimize dwell times for optimum response.
-
Product
Skoad Oxygen Sensor
KS60113 - Skoad
-
Konstar Electric Industrial Co., Ltd
An oxygen sensor, also known as a lambda sensor, continually detects the oxygen content in the exhaust gases of an engine. The oxygen sensor output signal informs the vehicle's ECU (Electronic Control Unit) whether the AFR (Air-Fuel Ratio) is lean or rich. Based on this, the ECU adjusts the amount of fuel injected into the engine to achieve an optimal AFR.
-
Product
Oxygen Sensor
KS60003
-
Konstar Electric Industrial Co., Ltd
An oxygen sensor, also known as a lambda sensor, continually detects the oxygen content in the exhaust gases of an engine. The oxygen sensor output signal informs the vehicle's ECU (Electronic Control Unit) whether the AFR (Air-Fuel Ratio) is lean or rich. Based on this, the ECU adjusts the amount of fuel injected into the engine to achieve an optimal AFR.
-
Product
Compact High-Performance IoT Gateway With NXP I.MX8M Quad Core Cortex A53, 2 LAN, 2 COM & 1 USB
ECU-150
-
NXP i.MX8M Quad Core Cortex A53 1.3G CPUDDR4 2GB RAM, 16GB eMMC for system storage2 x RS-232/485 isolated serial ports2 x 10/100/1000 Ethernet ports1 x Mini-PCIe for WIFI/Cellular/4GSupport web service for remotely on-line monitoringSupport SD card & on-line firmware updateSupport Modbus, IEC-60870-5, DNP3.0, OPC-UA, BACNet protocol （ECU-150-12A1&ECU-150-12A1U need container EdgeLink）Support Data logger on SD card
-
Product
2-Port SFP Ethernet Card
ECU-P1524PE
-
2-port SFP Ethernet cards supporting HSR/PRP (IEC 62439-3) are specialized NICs designed for zero-delay, high-availability industrial networks. These cards feature dual SFP ports to operate as Dual Attached Nodes (DAN) in HSR ring topologies or parallel PRP networks.
-
Product
4-Ch Isolated Relay Output With IRIG-B Card
ECU-P1761
Relay Output Module
specialized interface module that combines four independent, electrically separated (isolated) relay contact outputs for switching external devices with a dedicated input/output port for receiving or transmitting IRIG-B serialized time codes.
-
Product
PCI Express Communication Card
ECU-P1524LSE
-
A specialized network interface device designed to provide zero-packet-loss, zero-recovery-time redundancy (IEC 62439-3) for critical infrastructure. It typically features 2-3 SFP ports for HSR/PRP, connects to a host system via PCI Express, and supports SR-IOV to enable multiple virtual machines (VMs) to share the card's resources for high-availability communication, often used in substation automation or industrial IoT.
-
Product
Fanless Server
ECU-4784
-
IEC 61850-3 Certified Fanless Server with Intel® 6th/9th Gen. Core™ Processors
-
Product
PXIe-2514, 7-Channel, 40 A PXI Signal Insertion Switch Module
780587-14
Signal Module
PXIe, 7-Channel, 40 A PXI Signal Insertion Switch Module—The PXIe‑2514 fault insertion unit (FIU) is designed for hardware‑in‑the‑loop (HIL) applications and electronic reliability tests. Each module has a set of feedthrough channels that you can open or short to one or more fault buses. You can use this architecture to simulate open or interrupted connections as well as shorts between pins, shorts to battery voltages, and shorts to ground on a per-channel basis. When controlled with the LabVIEW Real-Time Module, the PXIe‑2514 is ideal for validating the integrity of control systems including engine control units (ECUs) and full authority digital engine controls (FADECs).
-
Product
Citroen Oxygen Sensor
KS60113 - Citroen
-
Konstar Electric Industrial Co., Ltd
An oxygen sensor, also known as a lambda sensor, continually detects the oxygen content in the exhaust gases of an engine. The oxygen sensor output signal informs the vehicle's ECU (Electronic Control Unit) whether the AFR (Air-Fuel Ratio) is lean or rich. Based on this, the ECU adjusts the amount of fuel injected into the engine to achieve an optimal AFR.
-
Product
Industrial Communication Gateway With TI Cortex A8, 2 LAN & 6 COM
ECU-1152
-
TI Cortex A8 800MHz CPUDDR3L512MB RAM1GB Micro-SD card for system storage1 x Micro-SD Slot6 x RS-232/485 isolated serial ports2 x 10/100 Base-T Ethernet ports1 x Mini-PCIe for WIFI/3G/GPRS/4GSupport web service for remotely on-line monitoringSupport SD card & on-line firmware updateSupport Modbus, IEC-60870-101/104 protocolSupport Data logger on SD cardNo RED CertificationOperation Temperature -40~70°C
