UV Sensors
-
Product
Sensors
-
Campbell Scientific sensors measure a broad array of parameters for environmental, water resource, research, and industrial applications. The sensors output electrical signals, which are transmitted to data loggers. In addition to our extensive line of sensors, almost any commercially available sensor can be measured by our data acquisition systems.
-
Product
UV Fluorescence H2S, SO2 Analyzer
Model T101
-
Teledyne Advanced Pollution Instrumentation
The Model T101 H2S analyzer uses the proven UV fluorescence principle to measure hydrogen sulfide at levels commonly required for ambient air monitoring.The Model T101 is equipped with an internally mounted catalytic converter set at 315C to convert H2S to SO2. A switching mode alternately measures H2S and SO2 while showing both readings concurrently on the front display.
-
Product
Rotary Position Sensors
-
We offer a full range of Rotary Position Sensors, in a variety of housings, utilising wirewound, cermet and conductive plastic technology.
-
Product
Karman Vortex Flow Sensor For Water Flurex
WFK2
-
Karman vortex flow sensor for water that covers 0.4 to 250 L/min. Various output switching settings are possible and IO-Link communication is also supported.Equipped with a water temperature measurement function as standard, it supports fluid temperatures up to 95 °C...
-
-
Product
Line Post Sensors
-
These products are designed for distribution circuits only at their rated capacities. They cannot be field modified for capacities other than what was shipped with the units.
-
Product
Salinity Logger Sensor
NUL-228
-
This sensor enables measurements of the salt content in a solution in three ranges: %, ppm and mg/L.The sensor is pre-set factory calibrated and immediately ready to use.
-
Product
MAX31856 Thermocouple Sensor Arduino Shield
SEN-30007-J
-
Quad channel thermocouple Arduino shield based on the MAX31856 universal digital thermocouple interface IC. This is an exciting update of the MAX31855, with improvements in resolution (19 vs 14 bits), on-board temperature reference (6 vs 4 bits), and compensation (fully compensated vs nonlinear correction required). The MAX31856 is interfaced via 4-wire SPI with options for interrupt triggering. An LDO and a high-speed level shifter are included on ALL device pins to allow interfacing with to any Arduino - both 3.3V and 5.0V variants - without sacrificing device performance in any operating condition.
-
Product
Cylinder Sensors
-
Easy fit 'drop from the top' into a slot. Suitable for the most commonly used T-slot and C-slot cylinders. Quick disconnect and prewired versions. Wide range of adapters.
-
Product
Optical Sensor
-
Sendot develops and produces optical sensors that measure with light. Our optics are unique, our intelligent electronics direct the measurements and convert them into measurement results.
-
Product
Software Accelerating Sensor Collection & Real-Time Analytics
BlackStack
-
Introducing BlackStack, a software-accelerating sensor collection and real-time analytics platform. BlackStack enables faster processing at the edge, providing commercial grade infrastructure solutions, and facilitates quicker and more intuitive advanced searches resulting in to-the-second decision abilities.
-
Product
LED Color Sensor
FINN®
-
The FINN® is a compact and durable LED sensor that is able to fit in just about any test setup. There are two different configurations to accommodate your set up needs - right angle and vertical styles. The FINN® is color specific, so pick your style and match to the color of the LED you want to test.
-
-
Product
Barometric Pressure/Temperature/Altitude Sensor
BMP180
-
This precision sensor from Bosch is the best low-cost sensing solution for measuring barometric pressure and temperature. Because pressure changes with altitude you can also use it as an altimeter! The sensor is soldered onto a PCB with a 3.3V regulator, I2C level shifter and pull-up resistors on the I2C pins.
-
Product
Color Sensor
Nix Mini 2
-
*Clearance pricing while quantities last*Instantly match any color with a simple scan*Connects with the free Nix Toolkit app*90%+ hit rate on top brand name paints*Compatible with Pantone, RAL and NCS*Instant real-world RGB, HEX, CMYK and more
-
Product
Standard C23 20x30 Mm Photoelectric Sensors
-
Contrinex Standard C23 20x30 Mm Photoelectric Sensors
-
Product
UV Fluorescence Hydrogen Sulfide Analyzer
Model T101
-
The Model T101 H2S analyzer uses the proven UV fluorescence principle to measure hydrogen sulfide at levels commonly required for ambient air monitoring.The Model T101 is equipped with an internally mounted catalytic converter set at 315°C to convert H2S to SO2. A switching mode alternately measures H2S and SO2 while showing both readings concurrently on the front display.All T Series instruments offer an advanced color display, capacitive touch screen, intuitive user interface, flexible I/O, and built-in data acquisition capability. All instrument set up, control and access to stored data and diagnostic information is available through the front panel, or via RS232, Ethernet, or USB com ports, either locally or by remote connection.The Model T101 comes with NumaView™ Software. NumaView™ Remote PC Software allows for a remote connection with virtual interface and data downloading capability to analyzers operating NumaView™ Software.
-
Product
Temperature Sensor
ITS-7025
-
The ITS-7025 Temperature Sensor was developed to monitor the temperature of liquid-cooled klystron amplifiers. The sensor is designed to clamp directly to the cooling pipe and provide an analog voltage output from 0 to 10 VDC corresponding to 0 to 100 degC with 2 degC accuracy. Two analog outputs are provided; one for connection to a remote data acquisition system, and a second for local service monitoring. A single +28 VDC (other voltages available) powers the sensor which draws less than 100 uA.
-
Product
Sensor Boards
SensorXplorer™
-
Each sensor board can be used together with the SensorXplorer board.The SensorXplorer boards acts as a USB to I2C interface between Vishay's freely available software modules and the sensor boards. The sensor boards also have test pins for the I2C interface, allowing you to connect them to your own platform.
-
Product
MEMS And Sensor Test Automation Platform
Sense+
-
Sense+™ ultra-precise MEMS & sensor test automation platform allows for significant improvement in test accuracy, parallelism for a lower cost of test, and the ability to handle and inspect, small delicate sensors. Fully configured, Sense+ delivers a one-pass automated test, inspection, and metrology for the most complex MEMS devices including <1 mm WLCSP.
-
Product
Fiber Optic Sensors And Amplifiers
-
Omron’s high-performance fiber optic sensors and amplifiers come in a wide variety of configurations to meet your specialized requirements.
-
Product
Vehicle Presence and Data Collection Sensor
TrafiCam x-stream
-
TrafiCam x-stream combines a CMOS camera and video detector in one unit. TrafiCam x-stream sensors detect and monitor moving and stationary vehicles at signalized intersections and collect traffic data at intersections or interurban roads. Via detection outputs or via IP protocol, vehicle presence information is transmitted to the traffic controller so that signal timing can be adjusted dynamically. TrafiCam x-stream offers streaming video at full frame rate, to be used for traffic monitoring in a control room.
-
Product
Reaction Torque Sensor - Miniature Screw Driver
-
Futek Advanced Sensor Technology, Inc.
A generic term for any (usually computerised) instrument (e.g., Formic’s Fusion software), which may be used to capture data so that audit departments can undertake audit projects including document audits, essence of care audits, infection-control audits, identified risk audits, local priority monitoring, national audits, NICE guideline compliance audits, National Service Framework compliance, Standards for Better Health and Commissioner assurance.
-
Product
Machine Tool Sensors
-
Lion Precision’s machine tool inspection capabilities allow you to quickly pinpoint errors that lead to machine downtime and unnecessary scrap. Whether those errors are temperature, position, or dynamic, using our machine tool sensors, we measure machine tools at full operating speeds to drive informed decisions regarding spindle rebuilds, machine acceptance, and job assignments. From production engineers looking for best or worst operating speeds, to production supervisors looking to determine the best machine for a job, or machine builders trying to embed real-time sensing technology to improve a machine’s performance, we have decades of experience helping manufacturers be more productive using our machine tool sensors.
-
Product
Automotive Oxygen Sensor
Model R-17A
-
Teledyne Analytical Instruments
Teledyne has a long and successful history in the development and supply of oxygen sensors for automotive emission testing equipment.The “R” series sensors are used by most automotive emission equipment manufacturers worldwide. We are striving to improve our sensors through aggressive research and development, assuring the highest quality products offered by any supplier of oxygen analyzers.
-
Product
Housed Temperature Sensors
-
Exhaust Gas Temperature Sensors from Variohm are rich in pedigree for Motorsports success and with a strong reputation for high reliability and durability across a broad spectrum of applications for exhaust gas monitoring. The Exhaust Gas Temperature Sensors are based around a type K thermocouple in a robust design which has been well proven in Motorsport and similar demanding environments.
-
Product
Rectangular-shaped Inductive Proximity Sensor
GX-F/H
-
Panasonic Industrial Devices Sales Company of America
The GX-F/H Rectangular-Shaped Inductive Proximity Sensor has a very long and stable sensing range among comparable rectangular inductive Proximity Sensors and is easy to install. Precise adjustment and control of sensing sensitivity greatly reduces individual Sensor differences and variations.
-
Product
Infrared Motion Sensor
ENVIROMUX-IMD
-
Registers movement in the area covered. Condition display via LED. Provides immunity from common-mode signals such as the effect of strong hot or cold air currents, variation in ambient temperature, background radiation and acoustic noise. 24 dual-element detection zones for long, mid and short range protections. Surface or corner mounting. Pulse count or single shot triggering. Good RFI protection. Screw terminal. To connect to the RJ45 inputs use CAT5/5e/6 cable terminated at one end with RJ45 connector. Connect the un-terminated end to the sensor screw terminal. Maximum cable length: 1,000 ft (305 m). Powered by ENVIROMUX-2D/5D/16D. Includes mounting bracket for installing the sensor to a ceiling or wall. Regulatory approvals: CE, RoHS.
-
Product
Sensors
-
Diversified Technical Systems, Inc.
DTS offers a full line of high performance data acquisition systems, sensors, accessories and software to meet a wide range of critical test requirements. Let the DTS team of experienced engineers and test professionals help you find the right instrumentation for your application.
-
Product
Field Sensor
TR_B
-
The terraTEM TR_B Field surface sensor has been fully integrated to work seamlessly with the terraTEM. Recording three components of the Earth’s magnetic field simultaneously, the TR_B Field sensor comes with solid state rotation elements to be used in conjunction with the terraTEM inbuilt rotation software. The sensor also has automatic nulling of the ambient B-field.
