Personal Computer
Checking personal computers and using a pc as host to perform test.
-
product
Datalogging Thermometer
S0110
Temperature data logger is designed for record of temperature. Values are stored to a non volatile electronic memory. Data transfer to the personal computer for further analysis is performed via USB, RS232, GSM or Ethernet interface by means of a proper adapter.
-
product
Thermometer Hygrometer Data Logger
S3120E
Data logger is designed for record of temperature and humidity. Values are stored to a non volatile electronic memory. Data transfer to the personal computer for further analysis is performed via USB, RS232, GSM or Ethernet interface by means of a proper communication adapter.
-
product
PCI 24-Bit Digital I/O Cards
PCI-DIO-24D/H
These cards are 24-bit parallel, digital input/output cards designed for use in PCI-Bus computers. The difference between the models is that I/O connections to PCI-DIO24D are via a standard 37-pin D-sub connector while I/O connections to PCI-DIO24H are via a 50-pin connector. The cards are 4.80 inches long (122 mm) and may be installed in any 5V PCI-bus slot in IBM and compatible personal computers.
-
product
Thermometer
S0121
Thermometer is designed for record of temperature. Values are stored to a non volatile electronic memory. Data transfer to the personal computer for further analysis is performed via USB, RS232, GSM or Ethernet interface by means of a proper adapter.
-
product
Datalogging Thermometer
R0110
Temperature datalogger is designed for record of temperature. Values are stored to a non volatile electronic memory. Data transfer to the personal computer for further analysis is performed via USB, RS232 or GSM.
-
product
68HC11D Simulator
SIM11D
Simulate your M68HC11 microcontroller designs on your personal computer. Helps find hidden errors easily and efficiently.
-
product
Torque Tester
WDISR-RL series
Separate type digital torque driver. The detector is compact and lightweight, for the control of small torque . Interlocking with a personal computer or PLC, the torque measurement can be managed at a higher level. Various screw tightening tests, final tightening checks, tightening data storage, etc.
-
product
Power Supply Units
converts mains AC to low-voltage regulated DC power for the internal components of a computer. Modern personal computers universally use switched-mode power supplies.
-
product
Data Logger
S7841
Four-channel data logger is designed for record of two-state events. Values are stored to a non volatile electronic memory. Data transfer to the personal computer for further analysis is performed via USB, RS232, GSM or Ethernet interface by means of a proper communication adapter.
-
product
Turns Ratio Meter 3 Phase Rack
TR-MARK III R 250V
The TR-MARK III R 250V is the successor of the famous TR-MARK III R. Besides an extended test voltage up to 250V, it offers new features and increased accuracy to make it a perfect system. A color LCD with back lighting and touch screen increases handling and user comfort. Two USB interfaces make it easy to store measurements on external storage devices and transfer easily to a personal computer or download nameplate data of xformer to test.
-
product
Electronic Components
We supply a wide range of components and materials to the electronics industry, such as: integrated circuits for personal computers, semiconductor materials for system LSI, optical communication materials for telecommunications, components for display devices seen in smartphones and projectors, and materials used in solar cells and lithium batteries.
-
product
LV Iron Core Harmonic Filters
Nonlinear loads such as power electronics based equipment and electric furnaces are sources of harmonic currents leading to harmonic distortion, which is one of the most important parameters for defining the power quality. Most of the commercial loads such as personal computers, photocopy machines, power supplies, and compact fluorescent lamps; and industrial loads such as AC and DC motor drives inject harmonic currents into the network that they are connected to.
-
product
Measuring Complexes
K-5000
As a measuring unit of the complex, the NI cDAQ data collection platform was chosen. The measuring system consists of the following components:a personal computer or laptop;measuring block - chassis cDAQ with installed on it measuring modules.The complex measures and records the following parameters:working water pressure;water flow;turnovers;moment.
-
product
Handheld Gaussmeter
HGM09
Data storage on a personal computer via keystroke. The HGM09s is easy to use and has a good price/performance ratio. The handheld gaussmeter HGM09s is used to measure magnetic DC and AC fields. The measurands are flux density in Tesla or Gauss and the field strength in Amps per meter.
-
product
PCMCIA Card
DAS-429PCMCIA/RT10
Both cards contain 68 Kbytes of true dual-port RAM, for data blocks, control registers and Look-up table, mapped within the Common Memory space. The card also contains a FLASH-based Card Information Structure (CIS) within the Attribute Memory space.The cards comply with the Personal Computer Memory Card International Association (PCMCIA Release 2.1) standard, including Plug and Play. The card's small size and suitability for PCMCIA compatible notebook computers with Type II and Type III slots make it a complete solution for developing and testing ARINC-429 interfaces and for performing system simulation of the ARINC-429 bus, both in the lab and in the field.The cards are supplied with C drivers, including source code, Mystic Windows software and may be used with Exalt, Excalibur’s Analysis and Laboratory Tools, a Windows monitoring application.
-
product
Indoor Air Quality Meter CO, CO2, Temp, RH%
AQM4
UEi Test & Measurement Instruments
Four measurements in one instrument; carbon monoxide (CO), carbon dioxide (CO2), temperature and relative humidity. Use calculated 8 hour Time Weighted Average (TWA) and 15 minute short term exposure limits of CO2 for compliance testing and CO measurements for safety testing. Record, recall or download all readings to personal computer for later analysis or record keeping.
-
product
PCI to PMC (PCI Mezzanine Card) Extender
SKU-013-0X
The PCI-to-PMC Extender was designed to convert any standard PCI slot of a PC to a PMC (PCI Mezzanine Card) slot. It allows a standard personal computer to be used as a testing/development platform for PMC interface cards. The adapter allows easy access to the PCI (PMC) logic signals, overcurrent protection and hot-swap capability.
-
product
Thermometer
S0122
Thermometer is designed for record of temperature. Values are stored to a non volatile electronic memory. Data transfer to the personal computer for further analysis is performed via USB, RS232, GSM or Ethernet interface by means of a proper adapter.
-
product
COM Express Type 6 Development Kit
COM Express Type 6 Starter Kit Plus
The Type 6 Starter Kit Plus consists of a COM Express Type 6 module with ATX size Type 6 reference carrier board that offers one PCI Express x16 slot with proprietary pinout for DDI adapter card that convert DDI signal to DP or HDMI signal, one PCI Express graphics x16 slot, one PCI Express x4 slot, three PCI Express x1 slots, Serial ATA, VGA, LVDS, USB3.0/2.0, Gigabit LAN and Super I/O. All necessary cables are included.
-
product
Thermo-Hygrometer
R3120
Data logger is designed for record of temperature and humidity. Values are stored to a non volatile electronic memory. Data transfer to the personal computer for further analysis is performed via USB, RS232, GSM or Ethernet interface by means of a proper communication adapter.
-
product
COM Express® Compact Size Type 2 Module with Intel Atom® E3800 Series or Intel® Celeron® Processor SoC (formerly codename: Bay Trail)
cExpress-BT2
The cExpress-BT2 is a COM Express COM.0 R2.1 Type 2 module supporting Intel Atom® processor E3800 Series and Intel® Celeron® N2930/J1900 processor SoC (codename: Bay Trail).
-
product
Computer-On-Module
Open Standard Module (OSM)
OSM form factor is the first computer-on-module form factor for solderable BGA mini modules that is natively capable of supporting both ARM and x86 designs. OSM modules are significantly smaller than previously available modules, with the largest measuring 45mm x 45mm. For a growing number of IoT applications this standard helps to combine the advantages of modular embedded computing with increasing requirements regarding cost, foot print and interfaces. The BGA design makes it possible to implement more interfaces on a small footprint. The largest Size-L (Large) measures 45mm x 45mm with 662 BGA pins. The modules are completely machine processible during soldering, assembly and testing.
-
product
COM Express Basic Size Type 7 Module with Intel Atom® C3000 SoC
Express-DN7
The Express-DN7 is a COM Express® COM.0 R3.0 Basic Size Type 7 module supporting the 64-bit Intel Atom® C3000 processor (formerly “Denverton-NS”) system-on-chip (SoC). 16 CPU cores with 31W TDP and integrated 10G Ethernet make the Express-DN7 especially suited for customers who need excellent computing performance with low power consumption, such as edge computing applications, in a long product life solution.
-
product
OSM Size-L Module With NXP® I.MX8M Plus Series
OSM-IMX8MP
The OSM-IMX8MP is an OSM R1.1 Size-L module featuring NXP® i.MX 8M Pluss series processor with 4-core Arm Cortex-A53 and M7, up to 8GB LPDDR4L memory and up to 128GB eMMC storage. With its in-SoC 2.3 TOPS NPU and Vivante GC7000UL graphics, the module is made for edge solutions needing on-device AI processing at ultra-low power.
-
product
COM Express Type 6 Prototyping Kit based on Intel® 12th Gen Core™ i5-12600HE
COM Express Type 6 Alder Lake-P
The cExpress-BT is a COM ExpressR COM.0 R2.1 Type 6 module supporting the Intel Atom® processor E3800 Series and Intel® Celeron® N2900/J1900 processor SoC (codename: Bay Trail). The cExpress-BT is specifically designed for customers who need high-level processing and graphics performance with low power consumption in a long product life solution.
-
product
Laboratory EM current meter / water level and wave height meter
ACM2-RS and ACM3-RS are 2-D and 3-D electro-magnetic current meters for laboratory experiments. The models provide digital output, a high-speed sampling rate and insusceptibility to electro-magnetic noise. ACH-600RS is a highly sensitive capacitance water level meters. With the new system, a maximum of four different sensors can be connected to the compact interface unit, enabling simultaneous recording on a personal computer. Additionally, the system can provide analog output as well as necessary. While conventional water level and wave height meters cannot be used near velocity sensors, our instrument can be as near as 5 cm without increasing noise, due to its special isolated circuit. The result is an innovative system that is capable of achieving highly accurate data.
-
product
COM Express Compact Size Type 6 Module with AMD Ryzen™ Embedded V2000 APU (Zen 2 architecture)
cExpress-AR
The cExpress-AR, featuring the new AMD Ryzen™ V2000 APU with its high performance integrated Radeon™ graphics, is the first Type 6 module on the market to support an octa-core (8-core) embedded SoC, with up to 16 threads and an impressive turbo boost up to 4.2 GHz. Compared to earlier embedded quad-core V1000 processors, the additional cores combined with AMD's Zen 2 architecture result in a more than two-fold performance increase and double the performance-per-watt efficiency.
-
product
Computer-On-Module
ETX®
ETX is one of the earliest successful computer-on-module form factors. Today it is still widely used in applications such as industrial automation, transportation and medium and low level medical appliances. While high-end Intel® Core™ applications have mostly migrated to COM Express, ETX is still very much alive in the lower power segment, mostly notably using Intel Atom® SoCs.
-
product
COM Express® Type 6 Reference Carrier Board in ATX Form Factor
Express-BASE6
The Express-BASE6 is an ATX size COM Express Type 6 reference carrier board. Together with the COM Express Type 6 module of your choice and off the shelf add-on cards, you can quickly emulate the functionality of your desired end product for software development and hardware verification.
-
product
SMARC® 2.1 Short Size Module With NXP I.MX95
LEC-IMX95
ADLINK LEC-IMX95, based on the powerful NXP i.MX95 (6x Arm Cortex-A55 + 1x Arm Cortex-M7 + 1x Arm Cortex-M33) processor with an integrated ISP and eIQ Neutron Neural Processing Unit (NPU) operating at up to 2 TOPS., is the latest SMARC revision 2.1 compliant module. It combines power-efficient high-performance compute, immersive Arm® Mali™-powered 3D graphics, innovative NXP NPU accelerator for machine learning, and high-speed data processing with safety and security features.
