IR
electromagnetic radiation of wavelengths 700nm to 1mm which are longer than visible light but shorter than microwaves.
See Also: Infrared, Long-Wave InfraRed, Short-Wave InfraRed, NIR, FTIR, MWIR, LWIR
-
Product
Tunable, Pulsed IR SW & LW OPO IR Source
Firefly-IR
-
Firefly IR is available in short-wave and long-wave models, providing broad wavelength coverage from 1.4-8.5 µm. The compact and sealed design requires no manual alignment, and can be used in a variety of applications in the lab and in the field. Wavelength selection and scanning is automated and performed via web browser or using a TCP/IP command set. Pulsed operation and high repetition rate provide high peak power and rapid data acquisition.
-
Product
IR-Emitters
-
Our IR emitters are almost exclusively used in chemical analysis. There is a distinction to be made between broadband and narrow-band emitters. Planck’s emitters are broadbanded, whereas IR lasers are narrow banded.
-
Product
Fused Visible & IR Testing
-
SBIR offers a visible/NIR/I-Squared/IR target projector that features a fused visible and thermal source capability by combining a MWIR and LWIR differential blackbody source with a visible/NIR integrating source. A beam-combiner allows the thermal energy and the visible energy to be processed simultaneously on the optical centerline of the collimator.
-
Product
IR Carbon and Sulphur Analyzer
LD-LCSA-A10
-
IR Carbon and Sulphur Analyzer LD-LCSA-A10 is a unit for determination of sulphur and carbon equipped with two treatment units including a high frequency induction burner and flexible temperature settings with automatic control. With an analysis time of 20 to 100 seconds and a sensitivity of 0.1 ppm the multi-shielded isolation circuit prevents the machine for high frequency interference. High speed 24-bit sampling improves sensitivity and accuracy.
-
Product
Fixed Gas Find IR Camera
FLIR GF77a
-
The FLIR GF77a is the first uncooled autonomous leak detection camera from FLIR designed specifically to visualize methane gas. This affordable, fixed-camera solution provides upstream and midstream gas processors, producers, or operators the features they need to continuously monitor for potentially dangerous, invisible methane leaks. Small and lightweight, the FLIR GF77a is packed with FLIR-patented features, such as High Sensitivity Mode (HSM), for improved gas visualization. The GF77a can help oil and gas companies maintain valuable capital equipment, avoid product loss, meet emissions reduction metrics, and ensure safer work practices.
-
Product
In-Line IR Sensor
ILA
-
10:1 Distance to Target Ratio, 32 to 932F. Dwyer Series ILA Non-Contact Sensors, measure temperatures from 32 to 932F (0 to 500C) and provide a linear 4 to 20 mA, 0 to 5 VDC or thermocouple output. The 2-wire signal is compatible with almost any indicator, controller, recorder, data logger, etc., without the need for special interfacing or signal conditioning.
-
Product
C/I Non-Contact IR
-
* Safe, non-contact temperature measurement. * Laser spot indicator shows approximate center of target measurement area.* Display temperatures in either Fahrenheit or Celsius.* Adjustable emissivity for optimum temperature reading accuracy on a wide range of materials and surfaces.* Min, Max, Difference and Average temperature functions. * Backlight display for easy readings in any environment.* Auto power off for longer battery life.
-
Product
Standard IR Target Projectors
-
Santa Barbara Infrared’s 14000Zi Series reflective infrared target projectors are turnkey test systems for electro-optical (E-O) testing of FLIRs and other infrared (IR) imaging systems. The standard target projectors are assembled from SBIR’s STC Series Collimators, Infinity Blackbodies and 300 Series Target Wheels. SBIR also offers a standard athermal target projector with a 5.7° field of view (FOV).
-
Product
SparkFun IR Array Breakout
55 Degree FOV, MLX90640 (Qwiic)
-
It's time to say hip hip array for this IR Breakout! The MLX90640 SparkFun IR Array Breakout is equipped with a 32x24 array of thermopile sensors creating, in essence, a low resolution thermal imaging camera. With this breakout you can detect surface temperatures from many feet away with an accuracy of ±1.5°C (best case). To make it even easier to get your infrared image, all communication is enacted exclusively via I2C, utilizing our handy Qwiic system. However, we still have broken out 0.1"-spaced pins in case you prefer to use a breadboard.
-
Product
-AC/DC/IR Hipot Tester
Sentry 30 Plus
-
Wuhan Fanke Transformer Manufacture Co., LTD
Sentry 30 Plus - AC/DC/IR Hipot Tester
-
Product
Multi-spectrum IR Flame Detector
FL4000H
-
The FL4000H is an advanced multi-spectrum infrared (MSIR) flame detector that provides superior false alarm immunity with the widest field of view.
-
Product
Laser 4P (Fiber & IR)
-
This easy to use and time-saving device has a highly accurate axis and renders sharp laser focus during cutting. What’s more? It is efficient, optimized, user-friendly and comes with an in-built chiller.
-
Product
Temperature Measurement IR Sensors & Detectors
M34
-
A thin-film thermopile in a TO-5 package with an active area of 3.16mm x 0.4mm that offers low noise output.
-
Product
IR Thermometers
-
Is a sensor that consists of a lens to focus the infrared (IR) energy on to a detector, which converts the energy to an electrical signal that can be displayed in units of temperature after being compensated for ambient temperature variation.
-
Product
HDMI HDBase-T Extender with IR
ST-C6HD-HDBT
-
The XTENDEX® HDMI HDBase-T Extender transmits uncompressed digital HDMI signal and IR up to 328 feet over a single CAT5e/6/7 cable using HDBase-T technology. Each video extender consists of a local unit that connects to an HDMI source and a remote unit that connects to an HDMI display.
-
Product
C/I Non-Contact IR
Dual Laser Infrared Thermometer
-
*Both TG-1000 and TG-2000 offer:*Safe, non-contact temperature measurement.*Laser spot indicator shows approximate center of target measurement area.*Display temperatures in either Fahrenheit or Celsius.*Adjustable emissivity for optimum temperature reading accuracy on a wide range of materials and surfaces.*Min, Max, Difference and Average temperature functions.*Backlight display for easy readings in any environment.*Auto power off for longer battery life.
-
Product
IR Sensor
-
The sensor measures a very useful 0.17 mm in thickness and is made of plastic. Essentially it is a piece of robust plastic that can be used “bare” – without protective housing, such as a metal casing commonly used by other producers. The sensor it is less than 0.2 mm. thin and it is made using plastic membrane. This configuration makes the sensor so robust it can be used “bare” – without protective housing such as a metal container. Due to the fact thatSince the sensor chip can be used applied bare, means it can be used in a totally new ways, which can re-defines todays the current view on application design and reduces the cost of the entire system, and not just the sensor-element as such.
-
Product
Temperature Measurement IR Sensors & Detectors
ST60 TO-18
-
A single-channel silicon-based thermopile provides lowest cost solutions in a small active area of 0.61mm x 0.61mm in a small TO-18 package. Time constant of 18ms with Nitrogen encapsulation gas. Delivers a very low Temperature Coefficient of Responsivity of -0.04%/C. This detector has a very short thermal shock response to ambient temperature change.
-
Product
4 MP OV4682 RGB IR Camera Module
e-CAM40_CUMI4682_MOD
-
The e-CAM40_CUMI4682_MOD is a 4 MP RAW RGB-IR MIPI OV4682 camera module with the M12 S-mount lens holder. The e-CAM40_CUMI4682_MOD RGB IR camera module is based on OmniVision's OV4682 1/3" Optical format CMOS Image sensor, that captures high-resolution images and videos as well as IR information. Its dual RGB-IR Camera capabilities allow it to bring a host of additional features to machine vision applications and by combining RGB - IR in a single camera module reduces the total cost and saves space. Customers can evaluate e-CAM40_CUMI4682_MOD with See3CAM_CU40 over USB 3.0 interface and e-CAM40_CUTK1 over MIPI interface. e-CAM40_CUMI4682_MOD camera module can stream the 4MP(2688x1520) unprocessed 10-bit RAW data video upto 40 fps.
-
Product
Temperature Measurement IR Sensors & Detectors
ST150 With Diffractive Lens
-
A single-channel silicon-based thermopile with integrated diffractive lens and internal baffle that delivers a very low Temperature Coefficient of Responsivity of -0.04%/C with a high output voltage, 19.5 FOV and a quick time constant of 38ms. This Low-cost detector comes in a TO-5 package and has a very short thermal shock response to ambient temperature change.
-
Product
Temperature Measurement IR Sensors & Detectors
ST60 High Temperature
-
A single-channel silicon-based thermopile that will withstand operating temperatures of 225C, with a small active area of 0.61mm x 0.61mm in a TO-5 package. The reduced height package functions as an internal aperture. Two thermistor options provide ambient package temperature measurement. Currently only available with 8-14um silicon window. Time constant of 18ms with Nitrogen encapsulation gas delivers a very low Temperature Coefficient of Responsivity of -0.4%C. This detector has a very short thermal shock response to ambient temperature change.
-
Product
IR Temperature Sensor with GigE (Manual Focus)
FLIR A35
-
The FLIR A35 is a thermal imaging temperature sensor for condition monitoring, process control/quality assurance, and fire prevention applications. The A35 integrates seamlessly into existing systems, offering comprehensive visual temperature monitoring. As part of the Ax5-Series, the A35 is among the only thermal imaging temperature sensors on the market to provide temperature linear output through GenICam™ compliant software.
-
Product
Standard IR Target Projectors
-
Santa Barbara Infrared’s 14000Zi Series reflective infrared target projectors are turnkey test systems for electro-optical (E-O) testing of FLIRs and other infrared (IR) imaging systems. The standard target projectors are assembled from SBIR’s STC Series Collimators, Infinity Blackbodies and 300 Series Target Wheels. SBIR also offers a standard athermal target projector with a 5.7° field of view (FOV).
-
Product
Programmable RS-232, IR, and I/O Controller
HR-4P
-
The Model HR-4P is a programmable RS-232 device designed for control & automation of a Projector, LCD, or any other device with serial or IR port.
-
Product
Thermal IR Camera
LIR320
-
*LIR320 is the perfect system for IIoT and Machine Vision applications.*With a resolution of 320×240 pixels and state-of-the-art pixel pitch of 12 μm, it is offered with two optical options, 4 mm and 9.1 mm, giving you calibrated, high-quality thermal images, at a frame rate of 27 Hz.*The camera LIR320 is a cost-effective imaging solution that provides maximum performance in multiple industry applications.
-
Product
ATEX-Compliant IR Temperature Sensors
FLIR A310 ex
-
Explosive atmospheres need to be protected from ignition sources. Selecting equipment and protective systems which meet the requirements of the ATEX Product Regulations or similar regulations is essential. FLIR A310 ex is an ATEX compliant solution, with a thermal imaging camera mounted in an enclosure, making it possible to monitor critical and other valuable assets also in explosive atmospheres. Typical applications for the A310 ex include process monitoring, quality control, and fire detection in explosive locations. Because the FLIR A310 ex is rated IP 67, it can be installed in dusty environments. The Flame-Proof Enclosure "d"prevents any explosion transmission from the inside of the enclosure to the outside.
-
Product
IR Radiation Systems And Systems
-
Irradiation systems with infrared are used in test applications when a high heat input to the test object is required. In our portfolio you will find a wide range of different designs and areas of application for IR systems. From simple radiation modules to highly complex radiation systems.
-
Product
(Visible and IR) Streak Cameras
AXIS-PV
-
Our ultrafast cameras are well-suited for time-resolved spectroscopy of ultrafast events in the X-rays as well as in visible light.
-
Product
Near IR Image Plates
-
The IR Display Plate is a versatile instrument that presents clear, high contrast images of all near IR laser beams. These displays are made on infrared sensitive phosphors which offer a variety of unique features, variable image retention times for pulsed lasers, high resolution for CW YAG, and a good response to gallium arsenide light-emitting diodes. All near IR lasers are capable of being displayed over a wide sensitivity range.
-
Product
ILT UV-VIS-IR Light Meters, Lux Meters & Radiometers
-
International Light Technologies
International Light Technologies has been developing and manufacturing high-performance light meters and measurement systems for over 50 years. Our comprehensive portfolio of light measurement products include radiometers, photometers, optometers, dataloggers, lux meters, chroma meters, spectrometers and spectroradiometers.
