Showing results: 481 - 495 of 867 items found.
-
-
DX-101 -
Dexing Magnet Tech. Co., Ltd
DX-101 Gaussmeter is based on the Hall effect magnetic field strength of the latest developments in instrumentation, the design of desktop-type Gauss meter. Maximum range 330.0mT and 3000mT two tranches, the minimum basic error of 1.0%. Test probe connectors is imported, stable and reliable connection.
-
HGM09 -
MAGSYS Magnet Systeme GmbH
Data storage on a personal computer via keystroke. The HGM09s is easy to use and has a good price/performance ratio. The handheld gaussmeter HGM09s is used to measure magnetic DC and AC fields. The measurands are flux density in Tesla or Gauss and the field strength in Amps per meter.
-
CONAT -
F. W. Breithaupt & Sohn GmbH & Co.KG
*Rugged high-quality pressure-cast housing*Tracing edge with 110mm graduation*Mirror of chromed brass with sighting slot*Front to rear sight 110mm*Liquid damping of magnetic needle*Graduation 360° in 5° steps*Alternative: Conat with 6400-mil graduation and full mil specification
-
Cryogenic Ltd.
Magnets for NMR experiments are required to have a high homogeneity, which can be maintained over a wide range of field. Experiments are performed at fixed frequency and the spectrum is obtained by sweeping the magnetic field. This requires the field to be stable in spatial homogeneity and change steadily and repeatedly over time.
-
GEM Advanced Magnetometers
In the past, magnetic observatories relied on a combination of Overhauser, fluxgate and theodolite instruments for obtaining measurements. GEM then introduced the dIdD (delta Inclination / delta Declination) system for high precision results. Now, the dIdD has been enhanced significantly with the development of the Suspended dIdD system
-
MEET International Ltd.
*Detect through the shielded cable*Instantaneous finding of AC current*Tracing cables*Monitoring current status in applicances*Compares the AC current*Tracing cables inside the wall*Locating underground cables*Detects magnetic field*Low voltage high current detection
-
Denshijiki Industry Co., Ltd.
The Magnetizing Device Is Also Called Magnetizer / Magnetizing Power Source. It Is Used When Magnetizing A Magnet In Combination With A Magnetizing Yoke And A Coil. Charging The Internal Capacitor From The Commercial Power Supply And Discharging The Energy To The Magnetizing Yoke Generates A High Magnetic field and magnetizes.
-
WFG-140 -
Wuntronic GmbH
The WFG-140 magnetometer is a complete 3 Axis Fluxgate Magnetometer system packaged in a rectangular package of dimensions 1.5\"x1.5\"x4.65\". With low noise and small size, the instrument can be used wherever small magnetic fields (3 x 10-7 to 1 Gauss) need to be measured.
-
PCAN GPS -
PEAK-System Technik GmbH
The PCAN-GPS is a freely programmable sensor module for position and attitude determination. It has a satellite receiver, a magnetic field sensor, an accelerometer and a gyroscope. The recorded data can be transmitted on a CAN bus and logged on the internal memory card. The data is processed by a microcontroller from the NXP LPC4000 series.
-
Model SST500X500 -
Gopal Electronics
Gopal Make single sheet tester SST is developed as per IEC 60404-3. It can be attached as probe to Ep400 Main unit and user can test specific total loss, specific apparent power, and r.m.s value of magnetic field strength as well as B/h curve in the software.
-
Iris Power LP
Air Gap monitoring on Hydro Generators can help identify many geometric problems including misalignment, magnetic unbalance, rotor shorted turns, loose pole and stator movement that would otherwise lead to damage from magnetically induced heating or rotor-to-stator rub.
-
Thingsee POD & TAG -
Haltian Oy
The Thingsee POD and TAG sensors can be used to measure temperature, luminosity, humidity, air pressure and motion. In addition, the sensors can, for example, enable monitoring of magnetic switches in doors and various types of valves. The Thingsee sensors are easy to customize for other measurement needs as well. IoT Platform Sensors
-
Mitsubishi Electric Automation, Inc
A type of starter for AC motors that combines a magnetic contactor and an overload relay. The MS-T (10-32 amps) and MS-N (35-400 amps) series motor starters offer a compact design and provide reliable protection for your motors against overload and short-circuit conditions in any industrial application.
-
MAGMESS Magnet-Messtechnik
Reference Magnets with different magnetic field strenghts and dimensions. Available field strenghts ranging from 10mT to 1,4T. We deliver the Reference Magnets with a Factory Certificate. Zero Chambers are required to set zero of gaussmeters. We deliver two different types of Zero Chambers.