Interface Test Adapters
Interface Test Adapter; Interface Connector Adapter: Interface Device Also known as: ITA
See Also: Test Adapters, Interface Adapters, ITA
-
product
Signal, Contact, ITA, TriPaddle, 10 Amp, 14 AWG
610110147
Signal, Contact, ITA, TriPaddle, 10 Amp, 14 AWGThis contact primarily used in CASS applications.Operating Voltage & Current 10 Amps Max. Continuous (14 AWG)Contact Resistance 4 mOhms Max.Measured at 50 mV @ 100 mAContact Body BrassContact Plating 50µ” Au over 100µ” NiContact Termination Crimp/SolderCycle Life 20,000 CyclesRoHS Directive 2011/65/EU Status CompliantREACH Article 33 Status CompliantECHA Article 59 of Reach Regulation Compliant
-
product
Receiver, 9025, 25 Module, Slide Mount, Telescopic Handle - Left Side
310104498
The 9025 is a 25 module receiver designed to fit into a standard 19" rack. This model is equipped with a telescopic handle on the left side. This handle is designed to rest flush against the side of the receiver as a standard handle, or can be extended out to the left up to 3" to accommodate a larger ITA enclosure or other obstruction that may prevent normal handle operation/ engagement.As with the standard 9025, a microswitch is included. Mounting flanges and an instrument bracket are also included for slide mounting. A slide kit is required, but not included. See 9025 procedure sheet/ user manual for instructions on choosing the correct slide kit length for your test rack. *Please note: Consult procedure sheet/user manual for information regarding slight slide mechanism bracket protrusion downward into next U height on test rack on both sides of receiver.
-
product
Coax, Patchcord, ITA, 36", Micro Coax, RG316 Tan to MCXS Plug
7-361116582-036
Coax, Patchcord, ITA, 36", Micro Coax, RG316 Tan to MCXS Plug.
-
product
Coax, Module, Receiver, 75 Ohm, 90 Series, 32 Position
510104249
Primary mating module 510108179. (May mate with other ITA modules, as well.)
-
product
Signal / Micro Power/ Micro Coax, Module, Receiver, QuadraPaddle, iCon Series, 100/15 Position, loaded w/twin female contacts
510160112
This module comes fully loaded with twin female contacts (p/n 610138200), iCon modules mount from the rear of the iCon/i1 receiver allowing installation and removal of pre-wired cable blocks. Primary mating module 510161107. (May mate with other ITA modules, as well.)
-
product
Signal, Module, TriPaddle, ITA, 90 Series, 64 Position
510108101
Primary mating module 510104134. (May mate with other Receiver modules, as well.)
-
product
Keying Pin Kit, ISeries, Receiver And ITA
310113461
The iSeries keying pin kit includes a set of two hex keys. One hex key will allow 6 different options and two can provide 36 different keying options. The keying kit provides a way to isolate your connectors to prevent operational mismatch.
-
product
Signal/Micro Coax, Module, ITA, TriPaddle, 90 Series, 77/8 Position
510108278
This hybrid module provides 77 TriPaddle Signal positions and 8 Micro Coaxial or Micro Power positions in a single wide module slot enabling consolidation of wiring and preserving valuable space in the ITA.
-
product
ITA, S6, 6 Module, With Protective Cover
410122100
The S6 ITA Frame has a powder coated finish adding an extra layer protection against the elements. It is an integral part of this rugged Mass InterConnect system. The S6 ITA has module positions screened on top for ease of module placement. Protective Cover included.
-
product
Tool, Inspection Depth Gauge, Mini Coax, ITA
910121157
Used to verify the depth setting of the center conductor of the ITA mini coax contacts.
-
product
Protective Cover, S6, ITA
410112700
The vinyl ITA Protective cover is durable and shock resistant to protect your contacts and modules in case of harsh impact.
-
-
product
Adapter Plate, ITA, f/ G20x or G40x
410112996
The G20x adapter plate allows the G20x or G40x ITA to accept 2 modules (iCon) in the lower tier.
-
product
VTAC, Patchcord, ITA, 36", VTAC, eSATA, to eSATA 7-pin Male
7-141899730-036
VTAC, Patchcord, ITA, 36", VTAC, eSATA, to eSATA 7-pin Male.
-
product
G12x Slide Mount
For maximum versatility and easy access to instrument-side wiring and cable assemblies, VPC offers a selection of slide kits designed to fit most common rack depths. The G12x uses the same platform and slides as the G12, providing support up to 180 lbs (81 kg) to accommodate the largest fixtures. G12x accepts ITAs designed for both the G12 and G12x.
-
product
Signal, Module, ITA, QuadraPaddle, 90 Series, 480 Position, Unloaded
510151106
NOTE: Part # 510151106 Rev E and higher utilize captive screws that cannot be replaced with screws from currently VPC- offered screw kits.Primary mating module 510150116. (May mate with other Receiver modules, as well.)
-
-
product
VPC Receiver Frame
ABex REC21-84TE-EXT
Robust and flexible interconnect solution for test fixtures. Designed for the use with ABex PXIe Rack 18 it provides support to equip all 21 slots with VPC interconnect modules. In addition, it offers 6 more slots on the bottom, below the ABex rack to feed through signals from external measurement devices.The interface uses the well-known Virginia Panel connectors with more than 20.000 guaranteed mating cycles. To build DUT specific test fixture, we also provide the corresponding ITA mounting frame (ITA = Interchangable Test Adapter).
-
product
Tool, Extraction, TriPaddle and Thermocouple, Receiver and ITA
910110102
Tool, Extraction, TriPaddle and Thermocouple, Receiver and ITA
-
product
Signal / Micro Power/ Micro Coax, Module, ITA, QuadraPaddle, iCon Series, 100/15 Position
510161107
Primary mating module 510160107. (May mate with other Receiver modules, as well.)
-
product
Mini Fiber Optic, Patchcord, ITA, 36", Polymer Optic Fiber, Single Ended
7-413845000-036
Mini Fiber Optic, Patchcord, ITA, 36", Polymer Optic Fiber, Single Ended.
-
product
Signal, Module, Receiver, TriPaddle, 90 Series, 64 Position
510104134
Primary mating module 510108101. (May mate with other ITA modules, as well.)
-
product
Signal/ Mini Power/Mini Coax, Module, Receiver, TriPaddle, iCon Series, 64/8 Position
510160103
Signal/ Mini Power/Mini Coax, Module, Receiver, TriPaddle, iCon Series, 64/8 Position Primary mating module 510161103. (May mate with other ITA modules, as well.) *Please note: VPC receiver modules must be separated into two pieces in order to extract contacts. For detailed instructions please consult the user manual/procedure sheet for this module before extracting contacts.
-
product
Signal, Contact, ITA, TriPaddle, 7 Amp, .025" Square Post for Wire Wrap
610110145
Signal, Contact, ITA, TriPaddle, 7 Amp, .025" Square Post for Wire Wrap.Plated in 50µ" gold
-
product
Signal, Module, Receiver, QuadraPaddle, 90 Series, 192 Position, Fully Loaded w/ Twin Female Contacts
510150130
Primary mating module 510151105. (May mate with other ITA modules, as well.)
-
product
Tool, Locator, Mini Coax, 24 AWG Wire
910104128
Used with Crimp Tool p/n# 910101118 to crimp 24-26 AWG wire to mini coax ITA contacts.
-
-
product
Micro Coax, Patchcord, ITA, 36", 50 GHz, Flex 405, to 50GHz Receiver
7-372105371-036
Micro Coax, Patchcord, ITA, 36", 50 GHz, Flex 405, to 50GHz Receiver.
-
product
PCB Adapter, ITA, SIM, VTAC, 32 Pos, 6 Slot, to (1) HDMI
510171113
PCB Adapter, ITA, SIM, VTAC, 32 Pos, 6 Slot, to (1) HDMI.
-
product
Signal, Contact, ITA, TriPaddle, 10 Amp, 14-18 AWG, Crimp/Solder
610110172
Primary use in CASS applications.
