Organic LED
Light Emitting Diode with emissive electroluminescent layer composed of organic compounds.
-
Product
Total Organic Carbon Monitor
HT-110
-
The continuous online TOC-Analyzer HT-110 is suitable for the measurement ot total organic carbons in Purified Water (PW), Water For Injection (WFI) and Highly Purified Water (HPW). The unit is operating according to USP 643. It is applicable for pharmaceutical and/or semiconductor manufacturing. The measuring principle is based on UV-Oxidation and measurement of the difference in conductivity. TOC concentration measurement (TOC concentration 500 ppbC or lower) is necessary to perform quality control according to GMP (Good Manufacturing Practice).
-
Product
LED Tester For Packaging Machine
-
LED-501 is a single crystal packing tester. It can be utilized in electrical test.Two test results. Pass (GO) or fail (NG).Electrical Testing: Forward：VF Reverse：VZ,IRFour-wire measurement and contact resistance in case of deviation.Auto polarity identification and preheat function.Provide OPEN\SHORT count.Compatible mechanical interface.Connected with computer for measurement data collection.
-
Product
LED CIRCUIT TESTER, 6-12V AND 24V
MD1646
-
Checks high and low voltages on 6-12V and 24V circuits. Connect the red lead to a power source and the black lead to a ground source. Tester will light up red for power and green for ground during testing.
-
Product
White Light LED Illumination System
pE-300lite
-
CoolLED's pE-300liteis a simple white light LED illumination system that offers intense, broad-spectrum LED illumination for imaging most common fluorescent stains. The pE-300lite Light Source can be fitted directly to the microscope or specified with a liquid light guide. The system is a mercury-free alternative that is safer, more controllable, and repeatable than conventional high-pressure gas discharge illuminators. Spectral coverage is from the UV (DAPI excitation) to the Red region (Cy5 excitation). The system is perfect for hospital and regular research laboratory environments and is affordable within consumables budgets.
-
Product
Double LED Arrays | Red / Red | 2 Or 10 MA
LED-D-r/r-2/10
-
Pre-mounted double LED, high luminosity with low power consumption and adapt to DIN41494
-
Product
27" Flat Touch Display With Surround LED Strip
IDP31-270W
-
27" flat touch display with surround LED strip, full HD resolution and multiple input sources VGA/DVI/DP. 27" Full HD 1920 x 1080 resolution, 0 ~ 45 °C range operating temperature, P-cap touchscreen and glass solutions.
-
Product
LT-500A Aging-Life Test System For LED Luminaires
-
Hangzhou Everfine Photo-E-Info Co., LTD
LT-500A system is widely used for normal /accelerated aging, lumen maintenance measuring, chromaticity shift measuring, lifetime evaluation and temperature characteristic testing for LED luminaires, arrays, and modules. The extrapolation of lifetime by programmable models is also available to estimate the lifetime of LED luminaires.
-
Product
Underwater LED Floodlight, 20,000 Lumen
LED-V-Series
-
The Teledyne Bowtech LED-V-Series is a high powered underwater LED floodlight, with a 20,000 lumen output. The light features our latest LED technology.Rated to operate at 6,000 metres ocean depth, the lights are manufactured with anodised aluminium, offering proven corrosion resistance.The 80° wide beam angle light produced, is ideal for illuminating large areas for HD viewing tasks.
-
Product
10.1" WXGA TFT LED LCD Thin-Client Terminal With Intel® Celeron®/ Intel Atom® Processors
TPC-310W
-
Industrial-grade 10.1" WXGA TFT LCD with 50K lifetime and LED backlightIntel® Elkhart Lake (EHL) Atom® x6425E Quad-core / Celeron® J6412 Quad-coreCompact, fanless embedded system with aluminum alloy front bezelWide operating temperature range -20 ~ 60 °C (-4 ~ 140 °F)True-flat ultra slim bezel design with IP66 water proof of front panelSupport high speed M,2 2280 NVMeTouchscreen with P-CAP multi-touch controlSupports AC/DC input with optional power adapterChassis grounding protection
-
Product
Carrier Demodulator with LED Display
CD23/223
-
The CD23 and CD223 Digital Transducer Indicators are designed for use with variable reluctance and differential transformer transducers. The CD23 accepts input from a single transducer, and the CD223 accepts two switch-selectable inputs, with Zero and Span controls for each input. The indicators provide 5 Vrms, 5 kHz carrier excitation voltage to the transducer(s) and solid state circuitry to amplify, demodulate and filter the transducer output signals. A 3 1/2 digit front panel display is standard, with a 4 1/2 digit display optionally available.
-
Product
LED Testers
-
PeakTech Prüf- und Messtechnik GmbH
An extremely practical component tester for LEDs and other components. The device outputs an automatically raised output voltage between 0 to 300 V DC, which adapts to the connected load so that the sensitive components are not destroyed. Particularly suitable for the service and repair workshop.
-
Product
High Power LED Test System
Lumere-GM
-
Evolusys Technologies Sdn. Bhd.
Lumere GM is a LED test and measurement system for various parameters of LED light. It is a high-accuracy system with a temperature-controlled CCD, its geometry conforms with CIE-Publication 127, and the test program is easy to configure and adjust. The Lumere GM is used in laboratory applications and in the production of high-power LEDs.
-
Product
Mini Multimode Power Meter and Mini LED Source
-
The KD Optics Mini Multimode power meter and Mini LED source are designed for the 850nm and 1300nm testing of multimode links, fibre continuity testing, connector testing, transmitter power testing etc.
-
Product
[WinCE] 5.7" QVGA TFT LED LCD TI Cortex-A8 Touch Panel Computer
TPC-61T
-
TI Cortex-A8 processor on board5.7" QVGA TFT LED LCDSuper slim and compact design with plastic housingFanless cooling systemIP65 compliant front panelBuilt-in micro SD card with Windows® CE OS1 x SD card slotAutomatic data flow control RS-485Supports 1Mbit FRAM for data back-up
-
Product
Garmin LIDAR-Lite V4 LED
Distance Measurement Sensor (Qwiic)
-
The LIDAR-Lite v4 Qwiic from GARMIN is a high-performance, wireless optical distance measurement sensor that doesn't require any soldering to get started. This is the ideal solution for drone, robot, IoT, or unmanned vehicle operations when space is tight and power is limited. This sensor has up to a 10 meter range, 1cm resolution, and requires 85mA during data acquisition. The user can read and write to the LIDAR-Lite v4 using the I2C protocol; this is where the addition of the SparkFun Qwiic system really shines. The LIDAR sensor requires 5V to operate but runs on 3V3 logic. With a 5V boost circuit and an easy-to-use Qwiic connector you can power the sensor and get distance measurements over Qwiic all with a single piece of hardware.
-
Product
16-Ch Source-Type Isolated Digital Output Module With LED
ADAM-5056SO
-
Optical Isolation: 2500 VdcOver Voltage Protection: 70 VdcPower Consumption: 0.6 W (max.)16-channel
-
Product
12-42V LED Heavy Duty Circuit Tester
1651A
-
Peaceful Thriving Enterprise Co Ltd
*Check on 12 - 42V systems. *Automatic voltage identification: BLUE LED for General car / RED LED for Hybrid car.
-
Product
SparkFun LED Driver Breakout
LP55231
-
The SparkFun LP55231 LED Driver Breakout is a self-contained solution for developing and deploying the nine-channel I2C LED controller. Remarkably simple, the breakout is equipped primarily with just the LP55231 LED controller IC, plus three RGB LEDs. It also features pads and jumpers for replacing the onboard LEDs with external ones, and configuring the I2C bus, which allows you to daisy-chain up to four LP55231s. This breakout drives the LEDs using Pulse Width Modulation (PWM), so it is well-suited for variable intensity and color-mixing applications!
-
Product
PicoBuck LED Driver
-
The PicoBuck LED Driver is an economical and easy to use driver that will allow you to control and blend three different LEDs on three different channels. By default, each channel is driven at 330mA; that current can be reduced by either presenting an analog voltage or a PWM signal to the board. Version 12 of the board adds a solderable jumper that can be closed to increase the maximum current to 660mA. The new voltage regulator also increased the voltage rating on the various components on the board, allowing it to be used up to the full 36V rating of the AL8860 part.
-
Product
LED Phosphorescence Light Sources
SpectraLED
-
Innovative and affordable pulsed light source for phosphorescence measurements from deep UV to NIRThe SpectraLED is a novel light source designed specifically for the measurement of phosphorescence lifetimes. These phosphorescence sources are based on LED technology and the emission wavelengths range from the deep UV to the NIR.
-
Product
LED Illumination Systems
pE-100
-
The pE-100 series is a mercury-free family of compact and simple to use LED illumination systems which can be configured to deliver light directly to a microscope, or via a liquid light guide or multimode fiber. Systems can be specified at any one of 20 different LED wavelengths. Operation is by a remote manual control pod with instant on/off and intensity control from 0-100%. Remote control is available via a TTL trigger.
-
Product
Single LED Arrays | Blue | 20 MA
LED-S-b-2/10
-
Pre-mounted single LED, high luminosity with low power consumption and adapt to DIN41494
-
Product
Modular DC Electronic Load LED Simulator
6310/A
-
Chroma Systems Solutions, Inc.
Chroma 6310A Programmable Electronic Load integrates microprocessor capabilities into each load module and mainframe to provide simple and accurate parallel operation to optimize the speed and control among multiple load modules. All load modules may be configured to work synchronously, to test multiple outputs simultaneously, thus simulating real life applications.
-
Product
LED Color Sensor
Ultra FINN
-
The Ultra FINN™ is designed to make testing LEDs as simple and reliable as possible. Improved accuracy provides measurements for a wider color range, greater discrimination between hues and increased precision. The Ultra FINN’s small size and streamlined shape allows for testing very closely spaced LEDs and its faster speed decreases test times significantly.
-
Product
7" WSVGA TFT LED LCD Thin-Client Terminal With Intel® Elkhart LakeR
TPC-307W
-
Industrial-grade 7" WSVGA TFT LCD with 50K lifetime and LED backlightIntel® Elkhart Lake (EHL) Atom™ X6211E 1.30 GHz, dual core processorCompact, fanless embedded system with aluminum alloy front bezWide operating temperature range -20 ~ 60 °C (-4 ~ 140 °F)True-flat, IP66-rated front panelFront-facing LED indicators to show operating statusTrue-flat touchscreen with P-CAP multi-touch controlSupports AC/DC input with optional power adapterChassis grounding protection
-
Product
SparkFun LED Driver Breakout
TLC5940 (16 Channel)
-
The TLC5940 is a 16 channel PWM unit with 12-bit duty cycle control (0-4095), 6 bit current limit control (0-63), and a daisy chainable serial interface. This breakout board is a good way to take full advantage of this useful IC. All 16 PWM channels are broken out to standard 0.1" headers, which run alongside convenient voltage and ground rails. Also, because the TLC5940 can be daisy-chained, the breakout is designed to support that feature. On the left-hand side of the board all serial inputs are broken out to 0.1" headers and likewise with output on the right-hand side.
-
Product
LED Flash Drivers
-
Analog Devices LED flash drivers support general LED lighting, building technology, scanning equipment, and a range of other technologies. A range of features, such as automatic phototransistor controls and overtemperature protection, as well as compact size and diverse programmability options, allow these devices to be used in a number of applications including:
-
Product
Underwater LED Lights, 120Vac, 4,200 or 7,300 Lumen Output
LED-R-Series
-
The Teledyne Bowtech LED-R-Series underwater LED lights are 120Vac and available with 4,200 or 7,300 lumen output. These lights feature our latest LED technology and are now a real alternative to AC incandescent lamps.Due to Teledyne Bowtech's continued history of innovation, these lights feature the latest and best underwater LED lighting technology available.
-
Product
50-Pin DIN-Rail Wiring Board W/ LED Indicators
ADAM-3951
-
Low-cost DIN-rail mounting wiring terminal module for PCI-1752/1754/1756 with 50-pin SCSI female connectorScrew-clamp terminal blocks allow easy and reliable connectionsEach LED indicates its current bi-directional I/O logic status with either green or red lightCase dimensions (W x L x H): 77.5 x 179.5 x 41.5 mm (3.1" x 7.1" x 1.6")To Be Used With PCI-1752U, PCI-1754, PCI-1756
-
Product
Mini LED Backlight Module Automatic Optical Test System
7661-K003
Test System
Chroma 7661-K003 Mini LED Backlight Module Automatic Optical Test System contains a 71803-2 2D color analyzer to measure chromaticity and brightness
