Showing results: 646 - 660 of 1278 items found.
-
P100-2-N -
PASI srl
A valid and ecological alternative to old 90V battery, P-100-2-N represents a renewable energy source for Vertical Electrical Soundings (VES). More accumulators can be connected in series to obtain up to 1000V.P-100-2-N is compatible with all PASI earth resistivity meters.
-
SX-ULPGN-BTZ -
Silex Technology
SX-ULPGN-BTZ is a dual band a/b/g/n Wi-Fi, Bluetooth low energy (BLE), 802.15.4 combo module for the Internet-of-Things (IoT). It is a single stream 1x1 WLAN, BLE 5 + 802.15.4 based on Qualcomm's QCA4020 System-on-Chip (SoC).
-
DLP® NIRscan™ Nano -
Texas Instruments
The DLP NIRscan Nano is a compact battery-operated evaluation module (EVM) for portable near-infrared spectroscopy solutions. Featuring the DLP2010NIR digital micromirror device (DMD), the NIRscan Nano supports Bluetooth low energy to enable mobile lab measurements for hand-held spectrometers.
-
LCV -
Bitrode, Inc.
Configurations for testing to industry standards: IEC, SAE, BCILife Cycle Testing: Perform charge/discharge cycling of batteries or modules to obtain charge and discharge capacity, energy and DC internal resistanceAutomotive Battery TestingStarting, Lighting and Ignition (SLI) TestingTraction Battery Testing
-
Rockwell Automation
Our signal interface products provide signal conversion and electrical isolation between sensors and other field devices and a control circuit. Intrinsic safety modules add Zener diodes, which limit the amount of electrical energy on intrinsically safe circuits.
-
AYA-Instruments
Application:Watt Transducer, Current Transducer, KWH Meter, Demand Meter, Power Factor Meter, Current Sensing Relays, Energy Management SystemsContinuous Thermal: Rating 1.25 at 30° C, 1.0 at 55° C Standard 5-amp secondary. Others available.
-
CPM-12 -
Chuan Sheng Electronics Co., Ltd.
CPM-12 multifunction power meter provide high accuracy single phase and three-phase measuring and displaying, energy accumulating, power quality analysis, and data communication.Hardware can be option a a RS485 Modbus communication port.Auto wiring change (Note) via softwareCE and FCC approved
-
Contrel Elettronica s.r.l. Company
The DIN rail and front panel multimeters are ideal for installation in secondary distribution panels. Measurement of the main electrical parameters. Measurement of active, reactive and apparent energy. Modbus RTU, Modbus TCP, Profibus, M-Bus protocol. Digital outputs programmable as alarms or pulses.
-
Appointech, Inc.
light-emitting diode (LED) is a two-lead semiconductor light source. It is a pn junction diode, which emits light when activated. When a suitable voltage is applied to the leads, electrons are able to recombine with electron holes within the device, releasing energy in the form of photons.
-
Applied Meters, a.s.
Three-phase multifunctional static electricity meters AMT B0x-FxxTIIx are determined for measurement of active and reactive electric energy, instantaneous active power for consumption and supply, maximum demand, voltage, current and power factor in threephase four wires networks in diredct or indirect connection.
-
6572 -
Peaceful Thriving Enterprise Co Ltd
6572 Infrared (IR) Thermometer is the non-contact way to make safe and quick temperature checks on mechanical equipment, electrical circuits and building systems while in operation. Regular monitoring of heat (infrared energy) emitted from surfaces can prevent potential problems and failures.
-
Speedgoat GmbH
Electric vehicles (EVs) rely on batteries as their primary source of energy storage. As battery packs require battery management systems (BMS) to operate safely and reliably, it is vital to test control algorithms for state of charge (SoC) estimation or cell balancing at an early stage.
-
DIGAMEL Subestaciones
The digital relay and meters test system type DRTS 34 is a programmable and automatic current and voltage source, that permits for the automatic test of digital protection relays, such as those used in Medium and High voltage networks, and of energy meters, power quality meters and transducers.
-
LCN -
Bitrode, Inc.
Full featured test system for quality control and R&DLife Cycle Testing: Perform charge/discharge cycling of batteries or modules to obtain charge and discharge capacity, energy and DC internal resistanceAutomotive Battery TestingStarting, Lighting and Ignition (SLI) TestingTraction Battery Testing
-
SPCL-00597 -
K&L Microwave
This device is placed after the DUT to protect the Spectrum Analyzer from high-power fundamentals and provide harmonic measurements. The non-reflective functionality prevents energy from bouncing back to the DUT and raising the noise floor level.Broadband matching improves dynamic range and reducesmeasurement uncertainty.