-
product
Semiconductor Curve Tracer
CS-5000 Series
*Max. Peak Voltage : 5,000V（HV mode）*Max. Peak Current : 1,500A（HC mode）*Equipped all models with LEAKAGE mode (Cursor resolution 1pA）*USB port for display hardcopy, waveform data (CSV format) and measurement setup SAVE/RECALL*LAN interface for Remote Control
-
product
Force Tensiometers
Sigma 700/701
The outstanding versatility of Sigma 700 and 701 force tensiometers makes them suitable for research and development, industrial quality control, routine measurements as well as academic research. Both instruments are computer controlled and have a high level of automation.
-
product
PCI Resistor Card 4-Channel 1 Ohm To 63.7 Ohm With SPDT
50-293-111
The 50-293 is a Programmable Resistor card with either two channels of 16-bit or four channels of 8-bit resistor chains in a single PCI card. The card is ideal for simulating sensors for control and management systems under test, allowing the user to verify system response in design verification or manufacturing test applications.
-
product
Ethernet-based 4-axis Motion Controllers
EMX-100
EMX-100 is a 4-axis Ethernet-based external motion control box with high scalability and minimal maintenance cost makes it the great choice for adding the motion function expansion ability within non-standard equipment, for all kind of general motion application.
-
product
Analog Control Variable Gain Amplifiers (VGAs)
Analog Devices voltage controlled variable gain amplifiers provide continuous gain control over a wide dynamic range for a variety of audio and optical frequency bands. Our VGAs improve the dynamic range of a circuit by allowing users to adjust a signal’s amplitude in real time, which is invaluable for ultrasound, speech analysis, radar, wireless communications, and instrumentation-related applications.
-
product
Gavia AUV Software and Data Handling
The Gavia autonomous vehicle control software is implemented using a 'crewmember' paradigm. This means it is organized using a distributed architecture modeled on the division of responsibilities among the crew of a marine vessel. The Gavia Intelligent Artificial Crew (IAC) comprises a full set of modules responsible for the safe navigation of the vessel together with project modules responsible for meeting the goals of the mission. The Captain has the a set of responsibilities suitable for the...show more -
product
CPCI 48 Input I/O Card with Zilog Z8536 I/O Controller
CPCI-48IN
The input board consists of three Zilog Z8536 controllers for DC input control. An FPGA provides the timing and control. Each input has its own optical isolation, and supports a hardware adjustable resistor/opto-diode combination for various input voltage ranges. An AMCC PCI controller provides the interface to the host computer. All I/O is accessible from the front panel.
-
product
R37F-37M-1, 37-pin Female to Male Ribbon I/O Cable, 1m
779195-01
37-Pin Male IDC to 37-Pin Female D-SUB, I/O Ribbon Cable - The R37-37 is an unshielded ribbon cable for use with PC-based PC-based measurement and control systems featuring CompactDAQ Chassis.
-
product
24 Block Desktop Receiver
VGR24-RM1
VG Mass Interconnect products provide a common Universal interface for your custom test rack and simplifies functional test across your product line. Mass interconnect bench-top and rack mount receiver Plug and play interface blocks for signal, coax, high current, pneumatic controls, and more Stable proven products with 25 years in service Best cost of ownership Fast delivery next day on key products! Compatible to currently available test instrumentation and platformsThere are...show more -
product
Contraband Detection EOD
Security Intelligence Technologies, Inc.
Contraband Detection for EOD and Law Enforcement users now have an edge with LED fiberscopes and the Dirty Bomb Detector. These can be used with our Bomb Jammers when dealing with the inspection for radio controlled weapons.
-
product
PXI/PXIe MIL-STD-1553 Multiplexer, Single 8-Channel, 2-Pole
40-739-003
The 40-739-003 (PXI) and 42-739-003 (PXIe) are single 8-channel 2-pole multiplexers designed specifically for physical layer multiplexing or demultiplexing differential signals that conform to the MIL-STD-1553 specification. The module can be supplied as a single or dual 16-channel 2-pole multiplexer with each signal pair having a controlled 78 Ohm differential impedance.
-
product
Lightweight Vehicle Surveillance System
LVSS
The skid-based LVSS converts a standard commercial pickup into a rapidly deployable command and control center. Within minutes, a single operator can set up the LVSS and report for full perimeter duty from the comfort of the cab. When it’s time to relocate, the mast and its mounted FLIR cameras, radar, and sensors, stow out of sight for covert transportation.
-
product
BACnet
BOSS Explorer
Softdel’s BACnet BOSS Explorer is the ideal tool to easily monitor, manage, debug and control any BACnet network and connected devices. BOSS Explorer is a full-featured BACnet explorer program that runs on any Windows® computer connected to the network. It has an intuitive interface that is easy to use for both professionals and BACnet novices.
-
product
MASTER CONTROL
DL SERIES
The DL Series Master Control is the same as the D series except all units feature larger ports and greater fuel flow capacity.
-
product
Quad Channel Mixed Signal Oscilloscope
BS445
BS442 combines 4 independent analog channels and 8 time synchronized logic channels in one powerful test instrument. Consider modern embedded systems, component video, 3-phase motor control, process control, 3D robotics, and automotive systems.
-
product
RF Adapter Module For FlexRIO
RF Adapter Modules for FlexRIO feature frequency coverage from 200 MHz to 4.4 GHz, with up to 200 MHz instantaneous bandwidth. When paired with a PXI FPGA Module for FlexRIO or the Controller for FlexRIO, you can program the FPGA using LabVIEW to implement custom signal processing, including modulation and demodulation, channel emulation, spectral analysis, and even closed-loop control. These modules are all based on a direct conversion architecture and feature an onboard local-oscillator which can be shared with adjacent modules for synchronization. RF adapter modules also provide digital I/O capability for interfacing with external hardware.
-
product
Drive Controller Function Test
General functional test system based on LXI instrumentation for high mix / low to medium volume manufacturing. DUTs are tested which are mainly used as communication and measurement modules in power plant technology, grid management and electrical drives.
-
product
Wireless HDMI Video Transport
1B-HDMI-W-TX/RX
QuestTel''s long range wireless HDMI Transmitter/Receiver kit fully compliant with HDCP, extends high definition audio and video to any HDTV display up to 650 feet (up to 200 meters). It supports HD resolutions up to 1080p. Wirelessly transmit the HDMI signal to any HDTV over the AIR, it also supports IR remote control function to control source device content from long distance.
-
product
Electrical Circuits Control Device
ZET 452
ZET 452 is an automated module for electrical circuits parameters control that is used for electrical circuits impedance and insulation resistance monitoring in automated mode. The monitoring is performed in accordance with the set participation and without participation of an operator. ZET 452 allows to reduce the time necessary for verification procedure more than in 20 times if compared with the standard measurement instruments normally used for these purposes.
-
product
OTP-Based Test System
Power electronics assemblies often cannot be tested using conventional technology for their electrical performance. Due to the adaptability of the instrumentation, the OTP concept offers an ideal platform even beyond the space requirements of several control cabinets. In order to achieve high test flexibility with different assemblies, the system was equipped with three-phase AC sources and AC loads as well as a precise three-phase power meter. DC sources and loads with different current and vol...show more -
product
USB CCTV Joystick Controller
X-Assist X3200
X-Assist is the latest, new generation USB joystick controller from NG Systems, specifically designed to provide maximum independent control of Milestone’s XProtect® video management software. It features 39 dedicated keys and an industry-standard, three-axis, multi-function joystick which operates as a standard PTZ controller in Live Mode and provides jog, shuttle and speed control functions in Playback Mode. Additional features include fast selection of View, Camera and Presets by name or number plus On-Screen Menus, Audio ‘Talk’ control and a special ‘Mouse’ mode that allows the joystick to function as a standard mouse pointing device.
-
product
0.5-18GHz Switch Multiplexer
SA004
Teledyne Defence & Space’s (TDS) patented designs have produced many different types of filters incorporating switches. These are all generally wideband for Electronic Warfare applications and enable the control of the frequency spectrum into any given system. These units, also known as Switch Multiplexers, are configured with a single or multiple inputs to single or multiple filtered outputs.As an example, the SA002 features 8 channels switchable over the frequency range 2-18 GHz while the ...show more -
product
Wireless Data Logging System
MicroLogPLUS
A wireless data logging system for remote monitoring of up to 200 data loggers via the cradle technology and transmitting all real-time measurements to the PC. Handles data from up to 200 MicroLogs at up to a distance of 300m (120m US Version). Two open collector output for controlling other devices set at low and high alarm levels
-
product
GPIB Instrument Control Device
GPIB Instrument Control Devices offer IEEE 488 controllers that are compatible with ExpressCard, PMC, PCMCIA, PCIe, PCI, and USB slots as well as Ethernet, RS485, RS422, and RS232 ports. Some models can control multiple GPIB devices, and others offer sustained data transfer rates and no microprocessor interruption in data transfers. GPIB Instrument Control Devices include a license for the NI-488.2 driver software, providing maximum reliability for connecting to third-party instruments via GPIB. The devices are completely IEEE 488.2 compatible, have industry-standard transfer rates, and offer easy system configuration through NI software.
-
-
product
NI-6581B, 100 MHz, 54 Single-Ended-Channel, Kintex-7 FPGA-Support, Digital I/O Adapter Module for FlexRIO
783887-01
100 MHz, 54 Single-Ended-Channel, Kintex-7 FPGA-Support, Digital I/O Adapter Module for FlexRIO—The NI-6581B is a digital I/O adapter module that, when combined with a PXI FPGA Module for FlexRIO or the Controller for FlexRIO, creates a digital instrument for interfacing with 54 single-ended digital pins. A digital I/O adapter module for FlexRIO can be used to do real-time interfacing of standard protocols and implement customized protocols. The NI-6581B can operate sample digital waveforms at up to 100 MHz. It includes support for common transistor-to-transistor logic (TTL) voltage levels, or other voltage references can be sourced externally using a front panel connector.
-
product
PON Fiber Optical Monitor System
PON FOMA
PON FOMA ( PON Fiber Optical Monitoring Alarm System) is integrated RTU ( Remote Test Unit )、Center Monitoring Server and its management software to be integrated operation、remote control、periodic fiber scan、predictive analysis and support the instant fiber with status information and alarm warning, accurate of long-term fiber data record, fiber analysis and management. RTU monitoring station is embedded Linux system which is with the advantage of high security, stability, efficiency.
-
product
6U OpenVPX 10-Slot Profile BKP6-CEN10-11.2.6-3
1OVX610WX6-1X01R
VPX Dual Star central switches with expansion and control planes, channel Gbaud rate up to 6.25.
-
product
Medium- to High-Power DC Load ISSRs
Part No. S60DC40
Series S60 relays switch medium- to high-power DC loads. These devices feature the latest-generation MOSFET technology as well as an innovative isolated driver to ensure fast power turn on and off. The relays feature triggered control input to avoid linear control risks and fast switching times. The relays also offer an LED for status.Available options include:S60DC40 40A, 0-350 Vdc Load; 4.5-32 Vdc Control
-
product
Touch Portable Hearing Aid Analyzer
FONIX FP35
Move your hearing aid fittings into the world of the touch screen! The new FP35 Touch adds a new interactive dimension to hearing instrument verification. Touch the screen to navigate to the desired test screen or to make changes to important settings. Swipe the screen and move to the next one or call up local menus—real control at your fingertips!
