Bulb
-
Product
Humidity Temperature Meters
-
TES Electrical Electronic Corp.
Triple LCD displays barometric pressure.Temperature and relative humidity.Dew point and wet bulb temperature reading.Absolute humidity, mixing ratio and enthaply reading.Water vapor pressure and water saturation pressure reading.
-
Product
Radiometers
-
UV Intensity Meters & Visible Intensity Meter for Light Curing Systems. Dymax UV and visible radiometers are simple to operate and allow operators to monitor and document a UV/Visible light curing process. A low UV/Visible intensity measurement signals an operator to replace the bulb, reflector, or lightguide. Radiometers can also be used to confirm that operators are properly shielded from UV/Visible exposure. Degradation of curing bulbs, lightguides, and reflectors can decrease intensity, resulting in incomplete cures.
-
Product
Continuity Tester, LED
26330
-
If the bulb lights up, continuity exists. If the bulb fails to light, the circuit is open. Not for use on live circuits, but incidental contact with 12V supply will not burn out LED bulb.
-
Product
Psychrometers
-
All psychrometers derive an environment's wet-bulb and dew point temperatures from a precise measurement of relative humidity. The original psychrometer had two thermometers mounted together with a handle attached on a chain. One thermometer was ordinary. The other had a cloth wick over its bulb and was called a wet-bulb. New, digital versionslike General's EP870X family improve on this basic design, offer HVAC technicians a better tool for recharging the refrigerant of a residential or commercial A/C system.
-
Product
Third Rail Voltage Tester
4E2-1
-
The Knopp 4E2-1 Voltage Tester is designed to detect electrical potential (voltage) between the third rail and ground on high voltage electrified transit systems. Two, redundant neon bulbs are used to indicate the presence of voltage. The prod handle and the tester housing are both made from moisture- and oil-resistant laminated phenolic. The prod tips are made from stainless steel. The tester housing includes a rubber hand guard to guide the operator in proper placement of his or her hand. There are no exposed metal parts other than to the two prod tips. All internal connections are soldered.
-
Product
Continuity Tester
26200
-
Just clip lead to one end of wire in question. Probe other end of wire. If bulb lights up, there is continuity. If bulb fails to light the circuit is open. Not to be used on live circuits or computer sensor feed circuits.
-
Product
Dual Fuel Gauge
1U432-series
-
The 1U432 dual fuel gauge is packaged as a compact, 3” instrument. It has dual D’Arsonval movements that are driven by two resistive bulb transducers in the fuel tanks. The two opposing pointers stand out sharply from the non-reflective black background.
-
Product
WBGT Index Measurement
HD32.2
-
HD32.2 is a thermal microclimate data logger to measure WBGT (Wet Bulb Globe thermometer temperature) Index in Hot Environments according to ISO 7726 and ISO 7243.
-
Product
Voltage/Continuity Tester
CT-01
-
Standard Electric Works Co., Ltd
● Audible and optic continuity test.● Audible and optic voltage check.● Voltage protection : 600V● Robust and ergonomic housing.● For checking electric light bulbs, securings, wirings and so on.● Application : resistor, voltage, semiconductor, capacitor and so on.
-
Product
pHTestr® 30+ Waterproof Pocket Tester
-
Waterproof pHTestr 30 is great for outdoor applications such as taking pH measurements in lakes and streams. Designed to float in water, you can even attach a line to the housing for easy retrieval. Valox sensor housing resists most chemicals.The pHTestr 30 has a replaceable sensor for easy maintenance. pHTestr 30 purchased before Oct. 2019 use replacement sensor 35624-38. pHTestr 30 purchased after Oct. 2019 use replacemenr sensor 35634-03. Double-junction electrode sensor handles wastewater and solutions containing sulfides, heavy metals, and TRIS. Electrode sensor offers a clog-resistant Kynar® junction and a recessed, glass pH bulb to protect against breakage.The keypad clicks to confirm operation, and allows access to a variety of functions. Calibrate up to three pH points with the auto-buffer recognition at both USA and NIST standard buffers. Additional features include a automatic temperature compensation (ATC), hold function, auto-off function, self-diagnostic error messages, and a three-segment battery-life indicator.
-
Product
Thermostats
-
Omega has a large selection of thermostats to choose from, including humidity thermostats, in-line thermostats, rugged bulb and capillary thermostats, and so much more.
-
Product
WBGT Index Measurement
HD32.2A
-
HD32.2A is a thermal microclimate data logger to measure WBGT (Wet Bulb Globe thermometer temperature) Index in Hot Environments according to ISO 7726 and ISO 7243.
-
Product
Natural Ventilation Wet Bulb Probe
HP3201
-
Natural ventilation wet bulb probe with cable for WBGT measurement. Pt100 sensor.
-
Product
Anemometers/ Tachometers
-
TES Electrical Electronic Corp.
Fast response propeAir flow volumeInstant/ avg/ V max flow measurement. VelocityTemperature and Humidity measurement. Calculate Dew point temperature, Wet bulb
-
Product
Thermometer Calibrators
Check-Set Series
-
Tel-Tru® Manufacturing Company
The Check-Set series is the perfect temperature reference device for plant quality assurance, process control, food safety, instrument calibration and service, and HACCP compliance (Hazard Analysis Critical Control Points). It is easy to use, reliable, accurate, and compatible with a wide range of dial and digital thermometers, filled system bulbs, and electronic temperature sensors.
-
Product
High Power White Light LED Light Sources
LS-HP1
-
The LS-HP1 is a series of high-power, high brightness light sources for liquid light guides (LLG). It is characterized by its outstanding luminance and thus delivers very high light output from liquid light guides.The LS-HP1 works with the latest generation of high-power LEDs with up to 100W power from an area of less than 15mm² and is significantly brighter than a conventional halogen light bulb with 150W. The LS-HP1 is available for liquid light guides with core diameters of 3 or 5mm.
-
Product
Air Flow
-
UEi Test & Measurement Instruments
Designed with 6 HVAC/R must have parameters in one instrument. These are included in a portable battery operated instrument for measuring humidity, air temperature, dew point and calculating wet bulb, air velocity and air volume.
-
Product
Dry Bulb Temperature Probe for WBGT
TP3207.2
-
Dry bulb temperature probe used for calculating the following indices: IREQ,WCI, DLE, RT, PMV, PPD, WBGT, SR and mean radiant temperature. Pt100 sensor.
-
Product
Indoor Air Quality
-
Measuring Indoor Air Quality (IAQ) is an important factor since poor air quality may cause tiredness, inability to concentrate, and even illness (i.e., Sick Building Syndrome). Our IAQ meters measure CO2, Humidity, Dew Point, Air Temperature, Wet Bulb Temperature, and Oxygen (O2).
-
Product
Dewpoint Calculator
114
-
The Elcometer 114 Dewpoint Calculator provides accurate values of Dewpoint and Relative Humidity (RH) from the wet and dry bulb temperatures measured by a Whirling or Sling Hygrometer.
-
Product
Digital Anemometer w/ Humidity Tester
DAFM3B
-
UEi Test & Measurement Instruments
The DAFM3B Anemometer/ Psychrometer meter is designed with 6 HVAC/R must have parameters in one instrument. These are included in a portable battery operated instrument for measuring humidity, air temperature, dew point and calculating wet bulb, air velocity and air volume. The sensor is built into the remote fan and is specially protected by a twist cap. While in operation, open the cap for accurate temperature and humidity readings.
-
Product
pHTestr® 50 Waterproof Pocket pH Tester,
-
The Oakton pHTestr 50 has a replaceable double junction sensor for longer life, an expanded number of applications, and easy maintenance. Double-junction electrode sensor handles wastewater and solutions containing sulfides, heavy metals, and TRIS. Electrode sensor offers a clog-resistant Kynar® junction and a recessed, glass pH bulb to protect against breakage. Valox sensor housing resists most chemicals. The keypad clicks to confirm operation, and allows access to a variety of functions. Calibrate up to three pH points with the auto-buffer recognition at both USA and NIST standard buffers. Additional features include an automatic temperature compensation (ATC), hold function, auto-off function, self-diagnostic error messages, and a three-segment battery-life indicator.
-
Product
Double Probe for Thermal Comfort
HP3217DM
-
Double natural ventilation wet bulb probe and temperature probe (dry bulb) to be used with HD32.1 Thermal Comfrot multifuction data logger.
-
Product
Industrial Ovens
-
Curing, drying, ageing, annealing or any heat processing tests at higher temperatures Envisys has the oven to meet your needs Whether it is a standard conventional drying application using shelves or conveyor drying or drying through infrared bulbs Envisys provides all types of drying solutions with custom configured designs and sizes.
-
Product
Hydrogen Fluoride Gas Monitor
GASERA ONE HF
-
Hydrogen fluoride, chemical formula HF, is a colorless, highly irritating already at very low ppm levels, corrosive gas and can exist as a fuming liquid. Reaction with water is rapid, producing heat and hydrofluoric acid. Hydrogen fluoride (HF) is used in manufacturing of refrigerants, herbicides, pharmaceuticals, high-octane gasoline, aluminum, plastics, electrical components, and fluorescent light bulbs, among others. Hydrogen fluoride (HF) is very soluble in water and is readily absorbed in the upper respiratory tract.
-
Product
Sealed Beam Bulb Testing System
H710019SSL
Test Platform
EOL test for manufacturing of bulbs with LED for applications requiring to ensure watertightness: vehicles, marine, swimming pools, operating rooms, classified areas (Ex Zone), etc. The test system checks in a short time all the light and electrical characteristics of the bulb. A high precision Micro Leakage Meter also checks that there are no leaks between the environment and the inside of the bulb. The test results are recorded on the PC and can be printed on a quality control label attached to each unit.
-
Product
Air Humidity Meter
-
Since air humidity is an important factor in many sectors including but not limited to manufacturing, agriculture, construction, restoration, remediation and heating, ventilation and air conditioning (HVAC), PCE also carries a number of air humidity meter devices designed for specific applications such as evaluating heat stress risk in hot work environments like boiler rooms, factories, construction sites and commercial bakeries. To accurately assess heat stress risk, an air humidity meter capable of detecting and classifying temperature in relation to the amount of moisture content in the air is recommended. The global standard description for heat stress is the Wet Bulb Globe Temperature Index (WBGT).
-
Product
Continuity Tester
69133
-
Quickly reveals shorts or broken circuits in all types of electrical devices and controls.Tests for continuity of circuit with power off.Bulb in handle glows when circuit is complete (bulb included).Pointed 3-3/4'' (95 mm) probe gets right to the problem.Deluxe 4'' (102 mm) long handle with removable nylon cap holds replaceable bulb and battery.36'' (914 mm) test lead with alligator clip.Uses one AAA battery (not included).Replacement bulb (Cat. No. 69131)
-
Product
Near Field Moving Detector Goniophotometer
LSG-1900B
-
LSG-1900B Goniophotometer is near field Type C automatic goniophotometric instrument for luminous intensity distribution measurement. The LSG-1900B uses a constant temperature detector. It is for industrial laboratory photometric data measurements of small luminaires, such as down light, bulb light, etc.
-
Product
Mini Temperature and Humidity Meter
PTHM15
-
Auto Power OffFast Response TimeDew Point TemperatureDual Display Temperature & HumidityData Hold FunctionHumidity Range: 0-100%RHTemperature Range: -20 - 80 C / -4 - 176 FDew Point Temperature: -20 - 80 C / -4 - 176 FWet Bulb Temperature: 0- 80 C / 32 - 176 FHumidity Accuracy: +/- 3% RHAir Temperature Accuracy: +/- 0.5 C @ 25 CResolution: 0.01% RH, 0.01 C/FResponse Time: %RH: 105 (90% at +25C still air)Battery Type: 9V (Included)Operating Temperature: 32 F to 104 F, <80% RHStorage Temperature: 14F to 140 F, <80% RHDimensions: 6.89' H x 2.28' W x 1.38' DWeight: 5.04 oz.Sold as : Unit
