Gas Detectors
See Also: Gas Sensors
-
Product
Work Area Voltage Detectors
-
*Warns of high voltage electric fields using WAVi technology - Work Area Voltage Indication*Visual and audible warning indicates the location of energized fields in a red-yellow-green sequence*Detectors communicate with each other within a mesh network*Remotely control detectors through the Lookout mobile app*Battery life of up to 500 hours in Monitor mode and up to 8 hours in Alert mode*Durable water-resistant housing
-
Product
Phase Detector
Paula
-
BAUR paula phase detector. The paula phase detector is used for clear phase identification in earthed and shorted medium and high-voltage cables. With the help of the measurement procedure tried and tested over many years, paula delivers precise phase allocation without scope for interpretation and corresponds to the highest safety standards for tasks on and close to electric equipment.* Clear phase determination possible in cable lengths up to 40 km* Highest level of safety when used on earthed and shorted cables in compliance with EN 50110-1 (DIN VDE 0105-100)* Suitable for all switchgear constructions due to compact design of the signal injectors* Ready for operation for up to 2 weeks (standby mode)
-
Product
Exhaust Gas Analyzer
IMR 1440FL
-
IMR Environmental Equipment, Inc.
The exhaust gas analyzer, IMR 1440FL/COFL, is designed to measure exhaust gases of Forklift Trucks, Generators, and heavy Machinery that are powered by a variety of fuels. According to US regulations, the IMR 1440FL/COFL can measure soot and CO for Forklift Trucks.
-
Product
Ultrasonic Leak Detector
VPX-WR
-
The Superior AccuTrak Model VPX-WR represents THE state-of-the-art technology for ultrasonic air leak detection! This ultra-durable and waterproof instrument incorporates our patented and trademarked circuitry we call "DND" (Dynamic Noise Discrimination). Older detectors using only the heterodyne technique, simply cannot offer the same leak detection abilities, especially in loud plant environments.
-
Product
Planar-Doped Barrier Diode Detector, 0.01 to 50 GHz
8474E
Diode Detector
The Keysight 8474E is a high-performance detector using a gallium arsenide, planar-doped barrier detecting element. It features extremely flat frequency response over its entire band of operation and very good frequency response stability versus temperature. The Keysight 8474E is also very rugged with high resistance to ESD damage. The Keysight 8474E detector is available with a 2.4-mm (0.01 to 50 GHz) connector. This detector offers the options for optimal square-law loads (Option 102) and for positive polarity output (Option 103). Because the unit-to-unit frequency response tracking of this device is typically better than plus or minus 0.3 dB, no matched response option is offered.
-
Product
Metal Detectors
-
Turn-on-and-go, well balanced and lightweight Pinpoint mode with depth indicator (CM or IN) Motion discrimination mode Variable tone breakpoint Large 2-digit numeric Target-ID numbers, from 1-99 Adjustable sensitivity and discrimination Fe-Tone - Adjustable Iron Audio 8-inch concentric waterproof searchcoil
-
Product
Noise Reduction Water Leak Detector
DNR-18
-
With digital noise reduction that removes intermittent sounds like barking dogs and passing vehicles. DNR-18: the advanced digital CPU eliminates intermittent interfering noises, like passing vehicles, people talking, and pedestrian footsteps.
-
Product
Digital Sound Detector
FSB-8D
-
The FSB-8D is a small, compact electronic sound detector for finding water leaks.Especially, FSB-8D is well-suited to Water Leak Surveying on pipe of Plastic pipes like PVC and PE.
-
Product
Gas Flow Sensors
ESRF-HF Transmitter
-
The ESRF-HF is a family of mass flow transmitters which enable fast and accurate measurements of gas flow over a wide dynamic range. Each transmitter integrates a MEMS flow sensor and readout electronics inside a housing with very small form factor made from stainless steel. The duty pressure of the flow transmitter is 11bar. All measurement data are fully calibrated, and temperature compensated on board, leading to a reduced temperature coefficient and high measurement accuracy.
-
Product
Plasma Emission Detectors for Gas Chromatographs
-
Our patented Plasma Emission Detector is available for integration into any gas chromatography system or installation. It has been designed for ‘plug and play’ installation and to allow for analysis of impurities from PPB to % levels using either capillary or packed columns.
-
Product
Walk Through Metal Detectors
VAT 620-CO2 VAT 622-CO2 VAT 63
-
Shanghai Yi Hua V&A Instrument Co., Ltd. CO.,LTD
It can control the indoor co2 ,temperature and humidity through detection with analog output or switch.
-
Product
100-600V AC Non-Contact Electric Voltage Detector With Buzzer
1969
-
Peaceful Thriving Enterprise Co Ltd
*With cUL and RoHS Approval.*Check voltage on 100-600V AC.*Two LR44, 1.5V batteries which is included.*Audible and visual indication for easy operation.*Four-section power and sensitivity switch (H, L, M and off).*Locates breaks along live, insulated wires and power cords.
-
Product
Motor Exhaust Gas Analyzer
MEXA-1300R
-
MEXA-1300R is a motor exhaust gas analyzing system for two and four stroke engine assembly lines and has an integrated sample handling system for removal of oil and moisture. The measurement of CO, CO2, HC and O2 (optional) in exhaust gases is made simply by inserting the sample probe into the tail pipe. AFR and Lambda are also calculated from the exhaust gas concentrations.
-
Product
Single Gas Transformer DGA
-
Hydran composite gas Dissolved Gas Analysis (DGA) products provide essential online monitoring of transformer oil. The Hydran line is the perfect cost-effective application for small- and medium-sized transformers where customers need to know about developing fault conditions that could cause unscheduled outages.The Hydran products allow for the addition of expansion to the base unit, allowing for greater measurement accuracy
-
Product
Carbon Monoxide Detector, CO
ENVIROMUX-CMD
-
Continuous air monitoring. Pre-set alarm points alert at: 70 ppm after 60 to 240 minutes; 150 ppm after 10 to 50 minutes; and 400 ppm after 4 to 15 minutes. Flush or surface mount. Test functionality of electrochemical CO sensing cell. Connect to RJ45 or digital input sensor ports. Screw terminal. To connect to the RJ45 inputs use CAT5/5e/6 cable terminated at one end with RJ45 connector. Connect the un-terminated end to the sensor screw terminal. Maximum cable length: 1000 ft (305m). LED indicators for operation status and system test. Powered by ENVIROMUX-2D/5D/16D. Regulatory approvals: UL.
-
Product
Measurement of Gas
TRANSMITTER EVO
-
Has developed for the development and production of their own devices.
-
Product
Conductivity Detector
CDD-10AVP
-
Low noise, low drift and wide dynamic range assure proven performance of the Shimadzu VP series HPLC. Data acquired by the CDD-10AVP is transferred to the SCL system controller via an optical fiber interface and are digitally processed by workstation. By adding the optional cell (dual kit NS), a low-cost and compact non-suppressor type dual ion chromatograph, which detects anions and cations simultaneously, can be made.
-
Product
Multimeter With No Contact Voltage Detector V&A Multimeter
VA20/VA20B/VA20C/VA21
-
Shanghai Yi Hua V&A Instrument Co., Ltd. CO.,LTD
DIGITAL MULTIMETER : Misplug alarm Autorange multimeter with no contact voltage detector function.
-
Product
Gas Control
-
Teledyne has decades of experience to offer a full line of thermal mass flow meters and mass flow controllers. Our products provide solutions for a wide range of applications which include high and low flow ranges, corrosive gases and very high-temperature environments. With the assistance of our experienced application engineers and global sales network, we will help you find a reliable, repeatable and durable solution for applications in both laboratory and industrial environments. Your needs can be met by using quality flow instruments designed and manufactured by Teledyne Hastings.
-
-
Product
Air Quality / Gas / Flow Sensors
-
Panasonic Industrial Devices Sales Company of America
Panasonic offers compact, high sensitivity Air Quality, Gas and Flow Sensors for use in equipment or automation processes. Designed for air quality / IAQ monitors and home appliances, the Laser Type PM (Particulate Matter) Sensor can detect dust particles down to the 0.3 m size.
-
Product
CGS500 Combustible Gas Sensor
-
The Monicon CGS500 thermocatalytic combustible gas sensor has been designed to measure concentrations of combustible gases in the range 0-100% LEL. The CGS500 is fitted in an EExe certified junction box.
-
Product
Gas Meter Synthetical Test Bench
SY8506
-
Hong Kong Songyang Industrial Ltd.
The test of the error of the rate of flow:Using the gas flow standard device (in the shape of the bell prover) as our standard equipment, we can figure the standard volume of the tested gas by using the high-precision revolving encoder to measure the descending displacement of the bell prover.
-
Product
Flue Gas Analyzer
IMR 1400C
-
IMR Environmental Equipment, Inc.
The IMR 1400C is a portable, continuous measuring flue gas analysis instrument housed in an aluminum case.
-
Product
Cable Detectors
-
PeakTech Prüf- und Messtechnik GmbH
This cable detector works acoustically and offers a quick and inexpensive solution to find voltage-free lines in the house installation, to test telephone lines, to identify individual cables / wires or to carry out a continuity test.
-
Product
Refrigerant Gas Sensors
-
Dynament offers a range of refrigerant non-dispersive infrared gas sensors that measure R32 and R454b gases over the LEL range for use in refrigeration service and maintenance.
-
Product
Radar Detectors
-
Explore our collection of premium radar detectors designed to fit your driving style and preferences.
-
Product
Nitrous Oxide Gas Sensors
-
The PST Dynament nitrous oxide (N2O) Platinum sensors are designed with patented non-dispersive infrared technology and contain all the necessary optics, electronics and firmware to provide a linearized, temperature-compensated output.
-
Product
Package Leak Detectors
-
Packages should be absolutely leak tight. However, even with the utmost care in the process, faulty packaged products cannot be completely avoided. Defects in the sealing process or in the material can easily lead to leaks, sometimes microscopically small.
-
