Insulation Resistance Meters
-
product
Moisture Meter
ZhangZhou Weihua Electronic co.,ltd
an instrument for determining the percentage of moisture in a material (as timber, flour, soil, or tobacco) commonly by measuring its electrical resistivity.
-
product
Chlorophyll Content Meter
CCM-300
The CCM-300 uses a proven fluorescence ratio technique for chlorophyll content measurement at an affordable price. Readout is directly in chlorophyll content mg/m2, and measurement ratio.
-
product
Portable Power Factor Meter
ST-2000 Cos∮
Standard Electric Works Co., Ltd
● Principle : Phase angle sensing transducer● Rated Accuracy : ±3% phase angle● Scale : Power Factor：Lead 0 – 0.3 – 1.0 – 0.3 – 0 Lag Power Angle： Lead 90° – 0° – 90° Lag● Effective Power Factor Measuring Range : Lead 0.5 – 1.0 – 0.5 Lag● Scale Length : Approx. 135mm(5-3/8”)● Frequency Influence : Within ±1.5° phase angle at 45 to 65Hz
-
-
product
Scale / Weight Meter
Equipped with a DC or load cell signal conditioner, this Laureate offers special firmware for scale / weighing applications: two tare functions; count by 1, 2, 5, 10, 20, 50 or 100; auto-zero function; setpoint offset, and dummy right-hand zero for display to 999,990. Built-in excitation for up to four 350-ohm load cells in parallel.
-
product
SWR / Power Meters
SX100
Frequency range:1.6 to 60MHz. Power display range:30W 300W 3KW. Accuracy:±10%. Minimum power at SWR measurement:3W. Insertion loss:Less than 0.1dB. Measurement function:Forward RF
-
product
Leakage Current Tester and Clamp-On Earth / Ground Resistance Tester
10µA Ultra High ResolutionLarge Conductor Diameter (30mm)AC Current in 5 Ranges (40mA, 400mA, 4A, 40A, 60A)Wide Frequency Response (40Hz-1KHz)ACA, ACV, Ω and ContinuityLarge 3¾ Digit LCD (4000 Count)40 Segment Fast Bargraph Display (20 times/sec.)Data Hold and Max / Min HoldRelative Measurement600 Vrms Overload Protection in Resistance Range
-
product
Non-contact Io/Ior Leakage Clamp Meter
M-340IRV
MULTI MEASURING INSTRUMENTS Co., Ltd.
・Safety by non-contact sensor, not touching live part directly (prevention of electric shock, short-circuit, etc.).・Easy to carry and operate, clamp CT + display part integrated type.・Measurable line current + leakage current + resistive leakage current by one unit.・Palm size mini clamp type.・High accurate measurement with min. resolution 0.001mA.
-
product
Optical Power Meter
TM233
TM233 Handheld OpticPower Meter(TM233-OPM ) are mainly used for continuous optical signal power measurement，Low power microprocessor is used for control，The TM233-OPM has the advantages of fully functional and reliable performance. Widely used in optical fiber construction and maintenance, optical fiber communication, optical fiber sensing, optical CATV and other fields. Instrument mould adopts advanced cold shell molding process; beautiful and durable, Instrument mould Design meets Ergonomic requirements. The TM233-OPM uses the built-in detector, which can be protected well. With a small shape, you can choose the backlight display and automatic shutdown function, with ultra wide optical power testing range.
-
product
Moisture Meters for Restoration
Delmhorst pin and pinless moisture meters and thermo-hygrometers are a must for restoration professionals. Testing for moisture in building materials is the only way to evaluate the extent of water damage, monitor the drying progress, and verify the structure is dry before removing any drying equipment.
-
product
Digital (1kV up) H.V. Insulation Tester
6212A IN (Ranges: 0.5kV to 10kV 0.5kV increment steps)
Standard Electric Works Co., Ltd
● Microprocessor-controlled.● 2 ×16 characters; large intelligent LCD module.● 20 Insulation test voltages 500V, 1kV, 1.5kV, 2kV, 2.5kV, 3kV, 3.5kV, 4kV, 4.5kV, 5kV, 5.5kV, 6kV, 6.5kV, 7kV, 7.5kV, 8kV, 8.5kV, 9kV, 9.5kV, 10kV.● Ener-Save™ feature to extend battery life.● Bargraph indicates test voltage; rise and decay can be observed.● Visual and audible warning if external voltage is present(>500Vac or Vdc.)● Insulation resistance; auto-ranging on all ranges.● Overload protection.● Low battery indicator (read time battery voltage measurement).● Measures insulation time duration of the test.● Low battery consumption.● Better than 10% accuracy on all ranges.● Auto-off.
-
product
Photocurrent Meter
I 520
display range 0.01 nA (last digit) to 7 999 μA4-digit display (0-7999) with dimmer for brightness controlV.24-(RS 232-) Interface, analog outputranging auto/manual or remote programmableapprox. 2.5 readings/s, attenuator 100% to 0dark current compensationpower supply for thermostatic stabilized LMT photometer headspower supply 230 V, 50-60 Hz, power cable with Euro plug
-
product
Static Meter
EX715
The EX715 handheld LCD static meter enables you to investigate and scientifically analyze static problems in hazardous area , showing where and how the static is generated, plus its magnitude and polarity.
-
product
Fiber Loss Meter
Testing for loss (also called "insertion loss") requires measuring the optical power lost in a cable (including fiber attenuation, connector loss and splice loss) with a fiber optic light source and power meter (LSPM) or optical loss test set (OLTS.)
-
product
Waterproof Portable pH/Conductivity Meter
CyberScan PC 10
Waterproof and Dustproof Housing - IP67 rated, ideal for rugged harsh conditions. Plus it floats! :: Multi-parameter - toggle between pH/temperature and Conductivity/temperature at touch of buttons
-
product
Light Meters For Horticulture (PAR, UV And NIR)
Light meters for measuring horticultural lighting in terms of PAR, UV and NIR irradiance.
-
product
Optical power meter with Optical laser Source
Shanghai Baudcom Communication Device Co.,Ltd.
The Multimeter combines a power meter with a 2-wavelength laser source,for optical fiber network installation and maintenance. With the large capacity of data storage,it's very convenient for field testing and transfering the test results to PC through USB interface.
-
product
Skid (Portable Skid Resistance Tester)
(also known as the British Pendulum Tester) is an essential tool for anyone with a duty to minimize the risk of accidents arising as a result of slippery roads and floor surfaces. This device is also used to investigate the cause of accidents after they have taken place.
-
product
Pen Type Oxidation-Reduction Potenial Meter
Pen type ORP (oxidation reduction potential) meter is set pH measurement and control and redox measurement and control in one multi-function intelligent instrument. Simultaneously displayed ORP value and temperature. Its full function, stable performance, easy to operate and so on. Making it the best choice for enterprises wild and laboratory testing and control ORP value. The ORP value monitoring is widely used in the chemical, pharmaceutical, electronics, food and other industries.
-
product
10-Channel Field-Strength-Meter
H10
10-Channel tabletop-unit for constant and alternating magnetic field.
-
product
Handheld Meters
Omega carries a wide variety of handheld meters including anemometers, temperature and humidity meters, clamp meters, vibration meters, gauss meters, hardness meters and many more.
-
product
Coating Thickness Meter for Ferrous and Non-Ferrous Substrates
CM8822
- Operating principle: magnetic induction/eddy current (F/NF)- Measuring range:0-1000um- Resolution; 0.1/1- Accuracy: 卤1-3%n or 卤2.5um- Min. measuring area: 6mm- Min. sample thickness: 0.3mm - Battery indicator: low battery indicator- Metric/ imperial: convertible- Power supply: 4x1.5V AA(UM-3)battery- Auto power off- Operating conditions:0-+45鈩?/span>(32鈩?/span>-104鈩?/span>),鈮?0%RH- Dimensions: 160x68x32mm- weight: 250g(not including battery)- Optional accessories: other range 0-200um to 15000um
-
product
Meter Socket Logger
PM2000
The PM2000 Meter Logger (USA only) is a 5-channel data logging system built into an electric meter housing. It is ideal for responding to residential voltage complaints and power consumption problems.
-
product
Clamp Meters
A clamp meter is an electrical tester that combines a basic digital multimeter with a current sensor. Clamps measure current. Probes measure voltage.
-
product
Clamp Meters
With HT Instruments you can find the Clamp Meter suits your needs thanks to the most complete range of Clamp Meters on the market.
-
product
Turbine Flow Meters
CT800
Flows up to 800 lpm (210 US gpm)Pressure up to 480 bar (7000 psi)Choice of 4-20mA and 0-5V outputs2-3 top ports as std for temperature / pressureBSP or SAE inlet / output portsFor use with oils, fuels, phosphate-estersBi-directional
-
product
METES - Meter Test Systems
Dramatic advances in the field of measurement technology and the use of state-of-the-art micro-electronics have led to the development of a new generation of electricity meters which are far more accurate than their predecessors of just a few years ago. As well as measuring the exact amount of energy used, a high level of integration enables electronic meters to perform a number of additional functions. As a result, these meters are also more sensitive to network irregularities. This means that regular testing is the only way to ensure that a meter functions correctly, both during final factory tests and during the entire life span of a meter.
-
product
Insulation Multimeter Series
Insulation Multimeter is a new category of test tool that combines a full featured True-rms DMM and a megohmme- ter. It's an integrated tool for maintaining and troubleshooting motor systems, electrical distribu- tion, and production equipment.
-
product
Digital Earth Resistance Testers
This groundmeter is designed for testing ground wire of electric power net, as well as earth voltage test in the fields of household electric power system and delectric appliance application.
-
product
BOMBARDING A.C. MILLIAMPERES METER
A Bombarding A.C. Milliamperes Meter is one of the four instruments essential for proper luminous tube processing. This instrument monitors the level of bombarder current in milliamperes that is generated by the bombarder, through the tube being processed. It is necessary to accurately monitor the current for the tubing and electrode sizes used to ensure that the right amount is applied at the appropriate time. To do otherwise may cause damage to the electrodes, fluorescent coating inside the tube and adversely affect the glass structure.
