ESD Monitors
-
Product
Mechanical Fixtures Available w/ESD Plates & ESD Pressure Pins
-
H+W Test Products has developed a series of inexpensive mechanical test fixtures. These fixtures are designed for testing low volume runs of printed circuit boards or prototype applications requiring approximately 150 test points.
-
Product
Portable Sulphuric Acid Dewpoint Temperature Monitor
-
The fuels used in boilers, such as coal, heavy oil and natural gas, contains S. during the combustion process, S and O₂ form SO₂, and a small amount of SO₂ is converted into SO₃ under catalysis of Fe₂O₃, V₂O₅ and other catalysts. Under normal circumstances, the volume of SO₃ in the boiler flue gas is 1×10-6～50×10-6, and the water vapor is about 10%. When the temperature of the flue gas is below 200°C, SO₃ and the water vapor are completely combined into H₂SO₄ vapor. A small amount of H₂SO4 vapor will significantly increases the acid dew point. When the surface temperature of the boiler heat exchange equipment is lower than the flue gas acid dew point, the H₂SO₄ vapor will condense on the surface to become sulfuric acid solution with a concentration of about 80%, which will adhere to the surface of the heat exchanger and cause acid corrosion. Typical equipment that is prone to corrosion includes air preheaters, induced draft fans and flue walls.
-
Product
Microbial Contamination Monitors
-
Is an active sampling method that is superior to the usage of settle plates, that additionally creates validated and actionable data.
-
Product
Load Monitoring Units (LMUs)
-
Magtrol's Load Monitoring Units are used for measuring load, force and weight from signals generated by strain gauge transducers. Specifically designed for use with Magtrol's Load Measuring Pins and Load-Force-Weight Sensors, the LMU Series provides excitation voltage while conditioning the bridge output signal. Each unit contains DIP-switches and jumpers for greater flexibility and complete adaptability
-
Product
Temperature & Humidity Monitor
-
A humidity sensor (or hygrometer) senses, measures and reports the relative humidity in the air. It therefore measures both moisture and air temperature. The warmer the air temperature is, the more moisture it can hold.
-
Product
Heavy Duty Vibration Monitor
VUM-800
-
Features • Heavy-duty sensing probe • DPDT 10 amp relay • Optional 230 VAC operation • Control unit remotely mounted • Failsafe operation
-
Product
Integrated Performance Monitoring Software
SQlive
-
SQlive™ is compact, ready-to-install software for monitoring the performance of streaming video, IPTV and Voice over IP. Compact and highly resource efficient, SQlive can be embedded into mobile handsets, media players, set-top boxes, home gateways and other CPE and end system devices.
-
Product
Online Residual Oxident and Chlorine Monitor
CLX
-
User selectable features and innovative design sets the new CLX Online Residual Oxident and Chlorine Monitor apart from the competition. Cycle times that are adjustable from 110 seconds to 10 minutes, 4-20mA and Modbus outputs that can control feed pumps and user settable alarms equates to low operating and maintenance costs. A new flow through design maintains cuvette cleanliness and allows for viewing of optical operations. The strong, shatterproof case that opens to facilitate reagent replacement also allows easy access to all service functions which reduces maintenance time. Unattended operation and low chemical usage equates to low operating cost.
-
Product
A Serial Data Link Monitor for Windows
Listen
-
Listen is a Data Link monitor designed to assist debugging & troubleshooting serial communications links. Listen utilizes standard Windows COM port drivers to tap into RS-232 transmit signals for monitoring bi-directional communications between two devices.
-
Product
Gas Monitoring System
TRIGARD
-
Designed to meet a variety of demanding applications, from wastewater facilities, to light industry and commercial applications, the TRIGARD Gas Monitoring System features MSA's precision craftsmanship and detects chlorine, sulfur dioxide and other toxic and combustible gases.
-
Product
Monicon Gas Monitors
-
Monicon Gas Monitors are innovative, cost-effective, wall and rack mounted units, with the ability to monitor single or multiple channels. Before ordering, customers can select from a range of toxic gases, combustible gases and oxygen, for monitoring in a wide range of applications.
-
Product
Fiber Optic Type Chemical Concentration Monitor
CS-600F
-
The CS-600F achieves a higher level of functionality best suited for manufacturing, such as the ability to perform in-line measurement of high temperature chemical solutions in various applications, stable operation for reduced downtime, and compact size for improved space productivity in order to meet the precise chemical solution concentration management required in leading-edge semiconductor wet process.
-
Product
Single Phase Powerline Monitors
-
a Voltage disturbance detector and recorder. This device is designed to be plugged into a 120V or 240V AC line and will monitor this line for voltage disturbances and temperature or Humidity variations.
-
Product
Spectrum Monitoring Systems
RFeye®
-
The product range includes entry level systems for dense network deployments through to best-in-class systems for military applications. RFeye Nodes are recognized as the "industry standard" for fixed remote distributed monitoring. In addition, we supply portable and vehicle based systems and a range of RFeye Arrays that are an extremely cost-effective alternative to traditional direction finders
-
Product
Battery Monitoring
-
Eagle Eye Power Solutions’ advanced battery monitoring systems are designed to optimize performance, enhance safety, and ensure compliance. Explore reliable solutions for real-time monitoring and maintenance of critical power systems.
-
Product
ESD Testers
-
Hanwa Electronic Ind. Co.,Ltd.
◆Adaptable to the following international standard waveform;JEDEC, ESDA, AEC, and JEITA◆This system’s uniquely short discharge circuit is made possible by its original mechanical design.◆The short circuit minimizes the influence of inductance and capacitance on the data.◆The use of a single circuit ensures data stability for each device pin tested.
-
Product
Monitor / Annunciator
RTP-1
-
The RTP-1 Monitor is a general purpose annunciator. Designed for 19 “ rack installations, the RTP-1 is complete with a noise immune filter. The ten point RTP-1 features latching memory. Easy to install and easy to operate, this low power monitor has front panel plug-in replaceable LEDs for indication and a single system Test and Reset buttons.
-
Product
Water Quality Monitoring System
WQMS
-
Water Quality Monitoring System (WQMS) is a facility to measure pollutants such as Chemical Oxygen Demand (COD), Total Phosphates (TP), Total Nitrogen (TN) etc. The required parameters are customized according to the type of factory and discharge regulations.
-
Product
ESD Personal Lonizer
PR588
-
The PR588 Personal Ionizer is compact and lightweight. This is an auto-balance Ionizer and the emitter pin can be clean and replace easily. It has a maximizing neutralization efficiency and overall performance
-
Product
Remote Display Gas Monitor
Chillgard® 5000 Remote Display
-
The Chillgard® 5000 Remote Display provides gas monitor information before room entry where potentially hazardous gas levels may exist. It mimics the Chillgard 5000 Gas Monitor readings for gas concentration, alarm status, calibration.
-
Product
Military Monitoring Systems
-
Antenna Technology Communications, Inc.
ATCi provides several products and services designed specifically for Military/ Government applications. Package offerings include our all inclusive Warrior Package, encrypted data, video and voice transmission solutions as well as mobile trucks and trailers that allow ubiquitous satellite and cellular field services.Call ATCi today for a Capabilities Presentation.
-
Product
Electromagnetic Environment Online Monitoring Systems
OS Series
-
Beijing KeHuan Century EMC Technology Co,.LTD
Beijing KeHuan Electromagnetic Environment Online Monitoring Systems
-
-
Product
I2C Bus Monitor - USB
Model JI-216
-
The JI-216 I2C Bus Monitor is a low cost, easy-to-use PC hosted instrument specificallydesigned for troubleshooting and debugging I2C networks. The JI-216''s FPGA basedarchitecture provides for the capture and display of all valid or invalid messages and I2Cbus events. Captured I2C messages are available for display in two modes: real-timestreaming, or triggered. These modes provide optimized data display for either hardwareor software development. The SDA/SCL timing display aids in tracking down and solvinghardware timing problems. JI-216''s broad bandwidth (DC 3.4Mbits/s), wide input signalrange (0 15.0V), and variable signal filtering provides flexibility in monitoring a variety ofI2C bus systems. An intuitive Windows application manages instrument setup andcontrol. Communications and unit power is provided via a USB 2.0 link.
-
Product
VMware Monitoring & Management
Hyperic HQ
-
Hyperic HQ for VMware is a pioneering new solution that enables data centers to consolidate complete discovery, monitoring, analysis and control of all application, system and network assets, both inside and outside of the virtual machines powered by VMware.
-
Product
ESD, Latch-up testing / design service
ESDdoctor
-
ESDdoctor consulting service can identify, diagnose, and solve any ESD/EOS problem quickly and definitively, at a surprisingly low entry cost. You can choose testing and diagnosis only, or add ESD design services to the consulting package. ESD, Latch-up testing: HBM (ANSI/ESDA and JEDEC) on packaged dies. MM (ANSI/ESDA and JEDEC) on packaged dies. Latch-up JEDEC on packaged dies TLP on packaged and bare dies.VF-TLP on bare dies.
-
Product
Network Monitoring Services
-
Products such as IntraVUE™ Software and SynapSense® Monitoring Systems, deliver optimal solutions for documenting and monitoring your plant floor, data centers, and other Network Infrastructure applications.
-
Product
ESD Protection
-
Protection against electrostatic discharges (ESD) is part of EMC Immunity (Electro Magnetic Compatibility) requirements. It is the ability for equipment to properly operate in its electromagnetic environment by limiting the reception of electromagnetic energy that may cause physical damage. ESD can be either conducted under the form of a transient voltage or can be radiated due to its fast rising time: powerful harmonics will generate erratic behavior by the application by coupling with other signals. Printed circuit boards must be protected against the effects of electrostatic discharge.
-
Product
PXI Monitored Multiplexer, Dual 32-Channel, 1-Pole
40-619-202
Multiplexer Module
The 40-619-202 is a high density PXI 2 A multiplexer module in dual 32-channel configuration using high quality electro-mechanical signal relays allowing each channel to switch current up to 2 A and voltage up to 250 VAC/DC.
-
Product
Bus Analyzer, Monitor, Debugger and Programmer
BusPro-I
-
In the world of rapidly accelerating product development cycles, engineers developing products which utilize the I²C and SMBus interfaces need a bus analyzer that is easy to use—fast and simple.Unforeseen problems such as functional bugs can cause schedules to slip so it is important to have the right tool to resolve them quickly by isolating the root cause.The Corelis BusPro-I analyzer is designed with that idea in mind—the right tool at the right price. Open the box and plug it in; everything just works.
