-
product
Interferometers
S-Series
Converge faster, polish surfaces 5X further from final formCorrect at the right spot with >10X lower image distortionControl 6X finer mid–spatial frequenciesRobust vibration tolerant and vibration insensitive data acquisitionFast, 6 seconds from measurement–to–custom report
-
product
Impulse-Calibration-System
KAL1000 Series
The impulse calibration system KAL1000 is a modular system to perform tests on complete impulse voltage measuring systems and on digital recorders for the measurement of high impulse voltages and impulse currents. The modular design allows an optimal KAL-configuration depending on the actual application.Additional, this modularity allows to up-grade or modify and existing KAL1000 system in case of changing or additional requirements
-
product
Millimeter-Wave Noise Source, R-band, 26.5 to 40 GHz
R347B
The Keysight R347B noise source covers a 26.5 to 40 GHz frequency range. This waveguide noise source allows you to make accurate and convenient noise figure measurements on millimeter-wave devices. The R347B provides highly precise broadband noise at the input of the system or component under test. The noise figure meter then processes the ON/OFF ratio of noise power present in the system IF, and provides an accurate reading of noise figure and gain. The R347B noise source has remarkable ENR stability over time, which allows longer recalibration cycles and more accurate noise figure measurements.
-
product
Rogowski AC Current Probe, 23 MHz, 3000 A
N7040A
The Keysight N7040A Rogowski coil current probe is designed for measuring AC currents up to 3,000 A with the bandwidth ranging from 3 Hz to 23 MHz. The probe is easy to use because it has a thin, lightweight, flexible and simple-to-use clip-around Rogowski coil that enables current measurement in the most difficult to reach parts and confined spaces of a circuit under test. It can also measure large AC current without increase in transducer size.
-
product
Centor Touch Star R,advanced force gauge external load cell
CNR CTR
Centor Touch Star is the most advanced force gauge currently available, it has become the benchmark tool for force measurement. Functionality, accuracy formerly reserved for expensive and complex material testing equipment are now available with Force Gauges. The functionality of material testers previously reserved for research or development applications are now available to the production floor with the introduction of the Centor Touch Force Gauge.
-
product
Sound Level Meter
3M SE-402 | VP 185057
Maschinenbau Haldenwang GmbH & Co. KG.
The 3M SE-402 of quality class 2 is the ideal sound level measuring device for almost every acoustical environment. The frequency weighting can be done according to the characteristics A, C and Z and the time weighting can be set to 'Fast' or 'Slow'. Ergonomically arranged buttons and the clear digital display (resolution 0.1 dB) ensure a high level of user-friendliness.
-
product
Level Testing Instrument
LIKON
F. W. Breithaupt & Sohn GmbH & Co.KG
*Instrument to determine the sensitivity and precision of the level curvature in mounted or unmounted condition*Testing instrument for instruments up to 20kg*250x160mm tiltable base with micrometers*Measuring range +1500’’ bis -1000’’*Made in Germany
-
product
Moisture Meter and Thermal Imager with MSX®
FLIR MR265
The FLIR MR265 is a professional pin and pinless moisture meter with thermal imaging designed to show you exactly where to investigate issues related to moisture, air leaks, and insulation voids. Featuring IGM™ (Infrared Guided Measurement) and MSX® (Multi-Spectral Dynamic Imaging enhancement) technology, the MR265 helps you quickly scan and target problem areas, visually guiding you to the spot where you can confidently take measurements, analyze readings, and ensure that problems are fixed. Us...show more -
product
AC/DC Clamp Milliammeter (CE)
M-740
MULTI MEASURING INSTRUMENTS Co., Ltd.
*High sensitive for low range leakage current*Suitable for measurement of 4-20mA DC controlled circuit*DC mV analog signal output*Lowest influence from Magnetization and Terrestrial magnetism*Wide measuring ranges - up to DC 1000mA and AC10A
-
product
Layer Thickness Meter
CHY 113
It is usded to measure the thickness of metallic coatings (eg paint) only on substrates with ferromagnetic alloys (eg steel). The meter is designed to provide easy operation in one hand.
-
product
Primary Test Equipment
LET-4000-RDM
It allows to perform with sufficient power, all the primary current injections to test the proper function and wiring of all the elements that compose the protection and measuring section in a substation.
-
product
UV TOCONs
SiC based UV sensor with integrated amplifier and 0 – 5 V voltage output. Measures intensities from 1.8pW/cm² up to 18W/cm². Spectral response for broadband UV or filtered for UVA, UVB, UVC or UV-Index. Also available for blue light (GaP chip) or visible light (Si chip) measurement. Available in TO5 housings or as miniature sensor probes (stainless steel or plastic). Special TOCONs for hydrogen flame sensing (TOCON_F) and for fire detection (TOCON_N) available. Also available for operating temperatures up to 120°C (standard is 85°C). Please learn more about the sglux TOCONs here: TOCON selection guide and here: TOCON User Guide.
-
product
Power-Switching Test System
High Voltage Switching Test System
The Accel-RF Power-Switching Test System is capable of measuring reliability under a variety of conditions for switching power applications up to 1kV (off) and 25A (on) at rates up to 1MHz switching frequency, dependent on voltage. By leveraging technology developed for the RF burn-in tray platform with new fast switching measurement techniques, this system can support testing of multiple devices under elevated temperature stimulus in a small physical area, and offers the flexibility to test both soft- and hard-switching applications. The Accel-RF Power-Switching System is the most flexible and accurate power switching platform available.
-
product
Electronic Component Counter
ZE 300
REINHARDT System- und Messelectronic GmbH
Instead of the widely used photoelectric barrier technology a new measuring technology is used in the new electronic component counter ZE 300: The laser technology offers a measuring beam with higher energy density and therefore more precise counting and faster counting speed. The ZE 300 component counter is microprocessor-controlled.
-
product
Audio Multimeter
AMM-1
The purpose of this tool is to enable the user to: Measure True Amplifier Power output into any load reactive or resistive Measure Common DC voltages Measure DC voltage drops during quick transients on cable runs or battery / charging systems Measure Impedance of speakers at any power or frequency from 20Hz - 1kHz (box rise) Measure Phase Difference between Voltage and Current into reactive loads (Power Factor) Find Tuning Frequency of subwoofer enclosures Tune subwoofer enclosures for maximum power transfer Measure AC Volts (amplifier output) Measure AC Amps (amplifier output)
-
product
Isolated 16-Bit Analog Output Board
MSXB 076
The Microstar Laboratories Isolated 16-Bit Analog Output Board, part number MSXB 076, provides isolated analog outputs for Data Acquisition Processor (DAP) systems. Use these boards to eliminate ground currents – a potential source of noise in your measurement and control signals – as well as to eliminate phase errors from analog outputs in your application.
-
product
Brix Refractometer, Sugar Concentration & Refractive Index
PA202
Dual-scale digital refractometer with scales for measuring both Brix (to 85) and refractive index (to 1.5000). Brix is a measure of sugar concentration and is used extensively in the agriculture and food and beverage industries. Refractive index is a fundamental physical property of a solution and is related to the speed light travels through it. Both the Brix and refractive index scales can be used to measure a nearly unlimited number of fluids.
-
product
Handheld Multi-Angle Spectrophotometers
MA Family
This family of handheld multi-angle spectrophotometers enables consistent measurement of traditional and special effect paints and coatings from the lab through manufacturing.
-
product
Mobile Light Meter
BTS256-E
BTS256-E - mobile light meter for photopic and scotopic illuminance, EVE factor, luminous color, color rendering index and luminous spectrum. The BTS256-E is a high-quality light meter that is well suited for illuminance and luminous color measurements in all application areas thanks to its compact design, high-quality light sensor and precise cosine field of view function.
-
product
Nutrient | Oxygen | PH Sensors: PH Sensors
pH (potential Hydrogen) is a measurement of the level of acids and bases in water. Our pH sensors have been used extensively to research ocean acidification, coral reefs, coastal marine biology, and to conduct environmental monitoring.
-
product
RefRad Comb Generators
RadRad is a battery-operated comb generator as well as a field source. It is a valuable tool for engineers ensuring the quality of radiated and conducted EMC and EMF measurements.
-
product
1000 Amp AC/DC Inductive Amp Clamp
6043
• A great tool for accurate measurement of current sources up to 1000 amps• Use with most digital multi-meters• 1mV/Amp output guarantees easy reading on your meter• Ideal for checking starter draw, alternator output or parasitic battery drain testing• Design allows accurate current readings without breaking the circuit• Low battery indication – auto power-off• Switch settings OFF/200A/1000A• Large jaw opening, 2.2″ and large jaw space, 2.2″ x 2.75″• Imported
-
product
xDSL PDH Analyzers
Wuhan Sunma Technology Co., Ltd.
xDSL / PDH Analyzer mainly used for comprehensive transmission test of SDH/PDH network and equipment and widely applied in the R&D, manufacture, acceptance inspection, performance monitoring, maintenance and measuring of networks and equipment. The instrument SunmaFiber provided can insert and measure varieties of errors and alarms in PDH and SDH systems (including on-line and off-line test), perform performance analysis on various errors as well as modulate and test jitter signals at a max. test rate of 2488MHz (STM16).
-
product
3D Automated Optical Inspection
Zenith UHS
High-speed full 3D AOI that brings about a revolution in SMT process management Industry-leading speed for full 3D measuring inspection equipment skill solutions- Only solution in the industry to set inspection criteria according to IPC-610 standards- Performs defect diagnosis through measurement-based data and eliminates the causes of possible errors- Powerful 3D solder joint inspection
-
product
Monitor and Test Video Quality
Torque Electronic Couch Potato (ECP)
The ECP is designed to monitor and test video quality of experience. This affordable, compact, palm-sized monitoring probe monitors true customer viewing experience by providing measurements from the end users’ point of view, after the STB. Scanning through available channels or navigating through interactive content menus via an external IR blaster, the ECP provides a single dashboard highlighting service quality across all channels.
-
product
Ranging Sensor Heads
A ranging sensor head that is designed and manufactured for short range measurements of a moving or stationary target's range, speed and direction.
-
product
Software
Measuring, evaluation and management software enables you to increase the performance of all your metrology operations.
-
product
Model T8: Thin Materials Moisture Meter
MRC001970
Uses radio frequency capacitance to measure moisture. Provides average moisture content down to a penetration of 1/8 to 1/4 of an inch. Has three concentric rings that cover an area 3 inches in diameter
-
product
Cables
Cables connect test and measurement devices to other NI and third-party hardware accessories or to individual header pins. They range from multipurpose coaxial cables to device-specific cables, all with industry-standard connector types to fit your system.
-
product
Portable Dew Point Meter
HDPM
Hention Electrical Equipment Co., Ltd.
The dew point transmitter of HDPM with high performance of Finland Vaisala Company is adopted as the core measurement unit of the entire system, it integrates multiple up-to-date research achievement and proprietary technology in measurement of dew point, and it is equipped with precision sampling system for sample gas and intelligent digital processing display, and it is one of existing dew point measurement instruments with the most advanced technique and the most powerful function.
