Electron Spectroscopy for Chemical Analysis
determine the atomic composition of a surface.
-
Product
Atomic Spectroscopy
-
Agilent’s comprehensive atomic spectroscopy software portfolio leads the industry in the simple setup and productivity tools required by routine analytical laboratories, while also providing the flexibility needed for advanced method development in research and academia. Our advanced ICP-MS software, including the powerful ChemStation and MassHunter systems, are used in all of our mass-spec platforms, so you can benefit from a single solution and reduce staff training requirements. Our cutting edge ICP software also enables intuitive control in ICP-MS processes.
-
Product
Power System Analysis Software
DSATools
-
DSATools™ is a suite of leading-edge power system analysis tools that provides the capabilities for a complete assessment of system security, including all forms of stability. DSATools™ offers a complete toolset for power system planning and operational studies. In addition to rich modeling capabilities and advanced computational methods, the software is packed with useful study tools that enable significant productivity improvements.
-
Product
Electronic Testing Services
-
Printed Circuit Board Testing and Repair Services CM Wings Board Testing Inc. was founded in 1983. Its founding was a direct response to theneed for a truly customer service oriented facility for printed circuit board test and repair.
-
Product
Load Cell Electronics
-
All our electronics are continuously evolving to feature faster and more powerful components. This commitment to innovation ensures that we can meet any new challenge or application.
-
Product
Electronic Store Of Resistances
PS8
-
The module is intended for use as part of information measuring systems based on the VXI bus for software setting of resistance values with a given step along three independent channels.
-
Product
Signal Analysis
Cross-Spectrum FFT Analysis
-
The program Cross narrow-band spectrum is used for evaluation of the interrelation between the signals’ parameters obtained from the two primary transducers installed at various parts of the controlled object. This program can be used for detection of noise source location, for sound absorption level evaluation and the researched object acoustic properties control, for evaluation of space-time distribution of the directional energy flux (Poynting vector), for the ground cross-section FR characteristic evaluation (Nakamura method), etc.
-
Product
Fiber Optic Type Chemical Solution Concentration Monitor
CS-100F1 Series
-
The CS-100F1 Series is equipped with fiber optics cable based on the CS-100 Series. It offers real-time, in-line measurements by directly integrating the sample cell into the cleaning system piping and by using a fiber optic cable for light signal transmission. A single concentration monitor can take up to four measurements and monitoring of multiple chemical solutions in a single-bath or single-wafer cleaning system is also possible.
-
-
Product
Analog Waveform Development and Analysis Software
WaveEasy
-
WaveEasy is an interactive analog waveform editor software tool for creating and editing analog waveforms. To view or edit existing waveforms, you can open or save files using various file formats including WaveEasy, ASCII or text (txt, csv, prn), or the NI-HWS (hws) format which is used by many instrument drivers.
-
Product
Fuel Analysis
-
The GRABNER INSTRUMENTS MINISCAN IR Vision is a truly portable and fully automated FTIR fuel quality tester that allows fast and highly precise analysis of gasoline, diesel and jet fuels directly in the field. The ParaFuelTM analyzer is used specifically for process applications.
-
Product
300 Watt Electronic Load Module
N3304A
-
The Keysight N3304A is a 300 W (0-60A, 0-60V)electronic load module for use in either the N3300A or N3301A electronic load mainframe in system applications. The N3304A load module is fast and accurate, for programming in constant current, constant voltage, or constant resistance modes, or for making voltage, current or power measurements. The N3304A can also digitize waveforms.
-
Product
Carbon/Nitrogen Analysis by Combustion
928 Series
-
By incorporating state-of-the-art hardware and an on-board touch-screen software platform, the 928 Series allows you to easily handle the most demanding sample applications. The core capabilities and performance of previous generations of LECO macro combustion instruments have been maintained, while key improvements have been made in throughput, uptime, and reliability. Macro sample mass ability (up to 3 grams for Nitrogen/Protein model regardless of sample carbon content) with rapid cycle times and a resulting low cost-per-analysis make the 928 Series ideal for analysis of characteristically heterogeneous, difficult to prepare, or low analyte level samples.
-
Product
Testing & Analysis Food Services
-
Intertek is a leading provider of testing and analysis services to the global food industry. We can help you implement comprehensive food safety and quality strategies, and achieve compliance with local, national and international regulations. Food testing is integral to the efficient production of safe, quality products. With the food industry increasingly subject to scrutiny, testing to ensure compliance with food safety regulations and to protect public health, is a must.
-
Product
Electronic Autocollimators
-
The concept of autocollimation as an optical instrument was conceived about a century ago for accurate, non-contact measurements of angles. Recent novel photonics upgrades have created a new breed of Autocollimators, offering intricate measurement capabilities for optics, laser profiling, AR/VR/XR goggles alignment, cameras for auto-driving, VCSEL characterization and many more applications with a single instrument packed with multi-tech technologies.
-
Product
Functional/Protocol Debug and Analysis Reference Solution
DDR4
-
Highest confidence in measurement accuracy! Industry’s fastest triggering and data capture for DDR4 analysis, test, and debug.
-
Product
Electronic Test Lead Kit
U8202A
-
Designed for use with the U3606A DMM and DC power supply; includes leads, alligator clips, mini grabbers, and more
-
Product
Dynamic Signal Acquisition and Analysis
-
m+p Analyzer systems are available for field and laboratory use from 4 to many hundreds of measurement channels. From gathering simple time history data to narrowband (FFT) spectra, fractional octaves, wavelets, shock response spectra and much more, m+p Analyzer real time analyzers can be used with a wide range of instrumentation hardware including our own m+p VibPilot, m+p VibRunner and m+p VibMobile systems, National Instruments (CompactDAQ USB, PCI, PXI) and VTI Instruments (PCI). Low cost portable instruments to systems for distributed measurements can be configured for maximum flexibility. Measurement data from all sources are stored in a common format so it is easy to compare and handle results from any measurement source.
-
Product
X-ray Fluorescence, XRF Analysis Services
-
Two XRF systems are available, a wavelength dispersive system (WDXRF) and an energy dispersive system (EDXRF). The difference is the manner in which the x-rays are detected. WDXRF instruments have very good energy resolution which leads to fewer spectral overlaps and improved background intensities. EDXRF instruments have higher signal throughput which can shorten analysis times. The higher signal throughput also makes EDXRF systems suitable for small spot or mapping analysis.
-
Product
Device Parameter Analysis
-
bsw TestSystems & Consulting AG
The complexity of DC Parametric Characterisations has significantly increased with the level of miniaturisation in the semiconductor industry. The demand is not only on the precision of the measurements. New measurement methods have emerged to gain insight into phenomena previously unknown or only of marginal relevance. One example is "Pulsed IV" which is now widely in use. The modular concept of the Keysight B1500A allows users to tailor their instrument exactly to their needs. Flexible upgrades ensure the investment for many years. Together with bsw AG you will get an optimum solution for your application. Our experts provide not only support for the instrument itself but have also working knowledge of all the solutions surrounding it. This includes Cabeling and Adapters, Fixturing for packaged Parts and of course Wafer Probing. We help customers from replacements of broken or worn-out parts to planning and deployment of turn-key-systems.
-
Product
Analysis Tool
CANalarm
-
The CANalarm is a low priced analysis tool that can be installed in the bus permanently. It makes it possible to build up a separate and redundant monitor without change of configuration and program of the master controller. It works passive and is therefore non reactive
-
Product
Bluetooth Stack Analysis Tools
Bluetooth Explorer 400
-
The Ellisys Bluetooth Explorer is a Bluetooth stack analysis tool for traffic monitoring, stacks and drivers debugging, interoperability verification and performance analysis.
-
Product
Software For Data Analysis
Imc FAMOS
-
Data source managementVisualization of measurement data at your fingertipsFull range of analysis functionsReport generation with direct PDF outputQuickly analyze large data sets with 64 bitMulti-layer macro creationProject managementLink data with dynamic maps or video
-
Product
Protocol Trigger And Decode Analysis Software
I3C
-
Tektronix I3C Software runs on Tektronix DPO/MSO5000, DPO7000 and DPO/DSA/MSO70000 oscilloscope series. I3C Software uses the hardware based real-time I3C protocol aware trigger, protocol analysis of long acquisition record length up to 125MB to provide superior I3C Protocol Analysis result at the press of button.
-
Product
Gas Analysis
-
Accurate measurement of gases and their concentrations is critical in many applications, and often poses a major challenge. Sensors' experience with different measurement principles, including NDIR, NDUV, and thermal conductivity, along with the ability to provide special combinations of these techniques within our products, enables us to tackle these challenges. In addition, our experience goes into every detail of our gas analyzers, ensuring reliable results, even under harsh conditions. Our skilled team of experts is happy to assist you in finding the optimized solution for your measurement requirements, with either off-the-shelf components or a customized solution.
-
Product
Gas Analysis
QGA
-
Hiden Analytical supplies precise and user-friendly tools for quantitative gas and vapour analysis. Our compact Hiden QGA system is a high performance gas analyser configured for real-time continuous monitoring of multiple species with an extremely wide dynamic range.
-
Product
Electronic Load System
-
Electronic loads are required for testing fuel cells such as PEMFC, AFC, PAFC, MCFC, SOFC. These electronic loads are designed either in IGBT technology with power, current and voltage ranges according to specific requirements or in transistor technology. Electronic loads in IGBT technology are designed for high voltage ranges up to 900 V, current ranges up to 1000 A, and power ranges up to 480 kW.
-
Product
Automotive Electronic Stethoscope
77109
-
Helps to identify engine and chassis noise. Maintain all health and safety precautions whilst using on running engine. Helps to identify engine and chassis noise. Powered by a 9volt battery (not supplied). Complete with headphones and volume control. CE certificated.
-
Product
ELECTRONIC MEGOHMMETER
MI-5500e
-
The MI-5500e general purposes megohmmeter is a truly portable equipment suitable to measure insulation resistances using test voltages up to 5 kV. It employs high-reliable, state-of-the-art technology for accurate measurements of ultra high insulation resistances up to 10.000.000 MΩ
-
Product
Portable Functional Near-Infrared Spectroscopy System For Research
LIGHTNIRS
-
Shimadzu Portable functional Near-Infrared Spectroscopy (fNIRS) System for Research* Near infrared light, which readily diffuses easily through biological tissue, can be used to measure localized blood oxygenation levels of the brain to monitor where activity occurs in response to a task of stimulus. The portability of LIGHTNIRS allows visualizing brain function activity in real time in a more natural state than other methods. Consequently, it is being used in a wide range of applications including medical research, developmental psychology, education, cognitive science and engineering.
-
Product
Electronic DC Load
DL Series
-
Industry’s Easiest-To-Use DC Load – Vitrek’s DL Series Electronic Loads are available in a multiple configurations to meet your unique application requirements. No other electronic DC load on the market today is easier to use. Equipped with a full color LCD touchscreen display, the unit can quickly be set up for your next test. In addition, the DL is equipped with a comprehensive self-test that ensures that all loading and measurement circuitry is functioning properly.
