Holding Informtest
Informtest Holding is a Russian manufacturer of measuring equipment in open international standards AXIe, LXI and VXI and since 1996 has been specializing in the development, manufacture, integration and maintenance of various instrumentation, installation quality control systems and functional control systems, including the development and supply software.
- +7 495 983 1073
- inftest@inftest.ru
- Savelkinsky proezd, 4
6th floor
Moscow, Zelenograd 124482
Russian Federation
-
Product
Oscilloscope
MOSTS6
-
*MOSTS6 is the first Russian instrument (oscilloscope) with a direct sampling rate (8bit ADC), 5 Gigasemp / s per channel. M-module MOSTs6 is designed to work as a part of information measuring systems based on the VXI bus magister as a digital oscilloscope. The M-module is made in the form of a triple-width mezzanine, is installed on a mezzanine carrier and is connected to it via a local information highway.*MOSTS6 is designed to convert instantaneous voltage values of an electrical signal into a digital code, measure instantaneous voltage values, measure time intervals between two instantaneous voltage values through two independent channels.MOSC6, according to the conditions of use, meets the requirements for measuring instruments of group 3 in accordance with GOST 22261-94.
-
Product
Cable Testers
TEST-9110 Series
-
Designed to measure and control the DC resistance, electrical capacity, insulation resistance of electrical circuits and check the electrical insulation strength of electrical circuits.
-
-
Product
Interface Module
MRS4
-
The mezzanine provides connection of up to four input and four output interface lines.
-
Product
Mezzanine Carrier
VXI NM-M
-
HM-M is a carrier of mezzanine modules in the VXI standard, it is a VXI module of the size C-1. NM-M ensures the functioning of various modules installed in it, made in the form of mezzanines. NM-M is intended for use as a mezzanine carrier in multichannel systems for collecting / issuing information, both digital and analog. The carrier of the NM-M mezzanine modules is used as part of information measuring systems based on the VXIbus trunk. Made on a C size board in accordance with the requirements of the IEEE Std 1155-1992 standard.
-
-
Product
Software
AFK-9110
-
Wired testers of the TEST-9110 series have been produced in series since 2006 and are well known to Russian and foreign consumers. As of the beginning of 2017, more than 250 sets of TEST-9110 series systems are in operation. Up to now, two types of software have been supplied with them: this is the AKM software and the cyclogram translator software. Now these programs have been revised into the AFK-9110 software.
-
Product
Voltage Meter
MN6I
-
The mezzanine is designed to measure instantaneous voltage values through six isolated channels with differential inputs.
-
Product
4-slot Chassis LXI
DBK - 308
-
BRK308 is designed to control boards of relay switches RK36, RK27 or similar.
-
Product
9-slot Chassis
CH-09 AXIe-0
-
The 9-slot chassis in AXIe-0 format is intended for use in modular measurement information systems based on the AXIe standard.
-
Product
Arbitrary Waveform Generator
MGHCH
-
MGHCH is designed to reproduce arbitrary waveforms, as well as to reproduce sinusoidal signals with amplitude, frequency, phase modulation or without modulation. MHVCh can be used for research, tuning and testing of systems and devices used in radio electronics, automation, computing and measuring technology, instrument making.
-
Product
System Module
CM AXIe-0
-
CM AXIe-0 is intended for use as part of AXIe-0 standard racks with the number of slots (slots) no more than 14. CM AXIe-0 meets the requirements of the AXIe-0 standard for system modules of the AXIe-0 trunk.
-
Product
Voltage Meter
MN8IP
-
The mezzanine module (mezzanine) MN8IP is designed to measure instantaneous voltage values over eight differential channels isolated from each other and control circuits.
-
Product
6 Slots Chassis
Monoblock AXIe-0
-
The monoblock is a device that ensures the functioning of various AXIe-0 instrument modules installed in it, under the control of an embedded personal computer.
-
Product
Voltage Meter
MN6SV
-
The M-module is intended for use as part of an automated measuring system for monitoring any object, the output signal of which is high voltage, for example, telemetry circuits, etc.
