Network Simulators

The PacketStorm4XG IP network emulator providesWAN emulation for multiple 1Gbps and 10Gbps ports. The PacketStorm4XG has over 64 million packets per second throughput. Up to four 10Gbps or thirty-two 1Gbps ports can be installed in one chassis. The PacketStorm4XG impairs IP and non-IP traffic. ...more

The PacketStorm2600E IP network emulator provides wan emulation and network simulation. The PacketStorm2600E emulates any network condition in a repeatable and controllable lab setting. To re-create any network condition, the emulator can impair IP and non-IP traffic, provide dynamic, time-varying impairments, and use a fully independent and f ...more

The PacketStorm1800E IP network emulator provides wan emulation and network simulation. The PacketStorm1800E emulates any network condition in a repeatable and controllable lab setting. To re-create any network condition, the emulator can impair IP and non-IP traffic, provide dynamic, time-varying impairments, and use a fully independent and f ...more

PacketStorm Communications has a full family of IP network emulators and network recording devices. Typical uses include WAN emulation and network simulation for Enterprises, network devices, and software applications. The family of IP network emulators ranges from the Tornado software to the 40 Gbps PacketStorm4XG. All of the hardware IP netw ...more

The Hurricane II IP network emulator provides wan emulation and network simulation. The Hurricane II emulates any network condition in a repeatable and controllable lab setting. To re-create any network condition, the emulator can impair IP and non-IP traffic, provide dynamic, time-varying impairments, and use a fully independent and flexible ...more

Anue GEM Advanced Ethernet Network Simulators are ideal for testing 10/100/Gigabit Ethernet or IP based networking solutions in a lab environment. Ethernet Network Simulators can reproduce the delay and impairments experienced by Ethernet signals across MANs and WANs regardless of the underlying transport mechanism. ...more

NetDisturb is an IP network emulator - simulator software that can generate impairments (latency, delay, jitter, limited bandwidth and lost packets) over IP networks. It works on 10/100 and 1 gigabit platforms. Download free trial. ...more

Anue XGEM Advance Ethernet Network Simulators are ideal for testing 10 Gigabit Ethernet or IP based networking solutions in a lab environment. Ethernet Network Simulators can reproduce the delay and impairments experienced by Ethernet signals across MANs and WANs regardless of the underlying transport mechanism. ...more

The Model 3540 is a two-channel DSP-based instrument that can be configured as a Central Office (FXS) on one or both channels, and/or as Telephony Equipment (FXO) on one or both channels. Central Office Simulation allows the Model 3540 to generate DC Voltage plus a wide range of country-specific SMS, Caller ID, FSK, Ringing, Call Progress, Noise, ...more

The Simulator 3 offers users the ability to simulate in the lab both serial and IP satellite networks. The unit provides an environment for the validation of an application or network design, before it’s deployed over a live satellite link. ...more

The second generation ICA (in cell amplifier) is an extremely high performance stain gauge amplifier, converting a strain gauge input to a volt or a mA output. ...more

802.11 a/b/g/e Network associated all parameters and analysis and statistics information. 802.11 a/b/g/e Network forecasting analysis through the the simulation. ...more

PNNI (Private Network-to-Network Interface) is a hierarchical, dynamic link-state routing protocol, designed to support large-scale ATM networks.  ...more

802.16e WiBro Network Research simulates the input parameters of Link Level. System Levels net constructions. ...more

Telecommunication networks are exposed to lightning events. Therefore telecommunications equipment being connected to the outside world need to have appropriate protection to show an acceptable immunity to surge transients in order not to fail in case of lightning events. Telecom Surge Simulators of the TSS 500 series are used to proof the immunity ...more

Telecommunication networks are exposed to lightning events. Therefore telecommunication equipment being connected to the outside world need to have appropriate protection to show an acceptable immunity to surge transients in order not to fail in case of lightning events. Telecom Surge Simulators of the TSS 500 series are used to proof the immunity ...more

Electronic and electrical equipment may be affected by voltage dips, short interruptions and voltage variations of the power supply. Dips and interruptions are caused by faults in the public supply network, in installations or by sudden large change of load. Testing to such phenomena is required to proof that electronic and electrical equipment do ...more

The PDS Clarinet test system is a very well respected and established solution for a wide range of protocol analysis, simulation and development applications. Physical interface pods are available for E1/T1, S/T-U and LAN (Ethernet 10/100 Mbit/S). The Clarinet system includes a Run-Time software license and Clarinet pod(s) supporting the relevant i ...more

The UCS 200N Ultra-Compact Simulator for Automotive Transients unifies the capabilites of an EFT/Burst simualtor, a Micropulse simulator and the required coupling network into one box. The UCS 200N is equiped to meet all international and car manufacturer specifications from around the globe. ...more

Telecommunication networks are exposed to lightning events. Therefore telecommunications equipment being connected to the outside world need to have appropriate protection to show an acceptable immunity to surge transients in order not to fail in case of lightning events. Telecom Surge simulators of the TSS 500 series are used to proof the immunity ...more

The UCS 500N4 ultra-compact simulator is the most versatile tester to cover transient and power fail requirements according to international standards (basic and generic standards) and product/product family standards. ...more

The OCS 500M6 includes test capabilities for ringwave up to 6kV (as per IEC 61000-4-12) and the damped oscillatory waves at 100kHz and 1MHz up to 2.5kV (as per IEC 61000-4-18). The Ringwave is a non-repetitive damped oscillatory transient occurring in low-voltage power, control and signal lines supplied by public and non-public networks. ...more

The Fibre Optic Network Simulator or FONS provides a technician with a true optical fibre path of different lengths which can be tapped to add or reduce the effects of attenuation and time delay to equipment under test. The FONS is simple to use and is available in standard 25, 50 and 100 Km. total lengths. The lengths can then b ...more

Telecommunication networks are exposed to lightning events. Therefore telecommunication equipment being connected to the outside world need to have appropriate protection to show an acceptable immunity to surge transients in order not to fail in case of lightning events. Telecom Surge Simulators of the TSS 500 series are used to proof the immunity ...more

Spirent Communications’ Avalanche product line simulates real-world user behavior, network conditions, and large web and application infrastructures. Avalanche eliminates the need for expensive testing infrastructures by emulating the behavior of up to two million users in a single, compact device. With Spirent’s range of next generation testing so ...more