Showing results: 16 - 30 of 213 items found.
-
PCIe8LXMCX2CB -
Dynamic Engineering
A powerful PCIe 24 lane switch is at the center of the PCIe8LXMCX2CB design. The switch has many capabilities including operating from 1-8 lanes, operating at Gen 1 or Gen 2 or mixed IO rates, supports lane reversal and polarity inversion (in case your XMC is not quite right), Support for max payload size transfers up to 2048 bytes ea., fully compliant with the PCIe base specification 2.0. The switch has 8 PCIe lanes connected to the PCIe "gold fingers" and 8 to each of the XMC´s.
-
Curtiss-Wright Defense Solutions
FPGA-based mezzanine cards provide a flexible approach to adding in high-speed processing and data I/O. An XMC FPGA card adds functionality without occupying an extra slot, enabling system integrators to meet the most demanding performance requirements and SWaP constraints. They combine the high-performance throughput of an FPGA with direct ADC/DAC and digital I/O. Tested to meet the requirements for the most challenging rugged environments, our XMC FPGA cards are designed for applications such as radar, electronic warfare (EW), signals intelligence (SIGINT), and communications intelligence (COMINT).
-
PCIe8LXMCX2 -
Dynamic Engineering
Embedded applications frequently require real time processing coupled with special purpose IO. With the PCIe8LXMCX2´s two positions a PrXMC can be matched with another XMC to make a high bandwidth processing node. The PrXMC can communicate with the host for set-up, and then use the switch to interconnect with the special purpose IO card.
-
XF07-518 -
Curtiss-Wright Defense Solutions
The XF07-518 is a rugged quad channel 500MSPS 14-bit digital receiver XMC. The ADC devices are controlled by a user programmable Xilinx FPGA which allows high performance processing such as Digital Down Conversion (DDC), filtering and custom algorithms. The combination of direct high-speed, high-resolution analog I/O port and FPGA processing makes the XF07-518 ideal for demanding applications including radar, imaging and test equipment across commercial and defense market spaces.
-
XMC-1553-2-IO -
ALPHI Technology Corporation
The XMC-1553-2-IO-2 uses a DDC® Total-ACE® communication device as its 1553 bus controller, or as a remote terminal with concurrent bus monitor terminal. Dual controller has a dual redundant channel with built in transceivers and transformer. The controller has the capability to emulate up to 31 RT addresses simultaneously.
-
XF07-516 -
Curtiss-Wright Defense Solutions
The XF07-516 is a rugged quad channel 250MSPS 16-bit digital receiver XMC. The ADC devices directly interfaces to a user programmable Xilinx FPGA which allows high performance processing such as Digital Down Conversion (DDC), filtering and custom algorithms. The combination of direct high-speed, high-resolution analog I/O ports and next FPGA processing makes the XF07-516 ideal for demanding applications including radar, imaging and test equipment across both commercial and defense market spaces.
-
Data Patterns Pvt. Ltd.
The FPGA Mezzanine Card is used by Data Patterns to implement signal interface with external world compatible FPGAs mounted on the FMC carrier there are primarily used for high speed analog interface for digitization (ADCs) and waveform generation (DACs). This form factor is also utilized for special I/O Interfaces such as various avionic protocols and buses. FMC I/O signals may be routed via front panel connectors or through Mezzanine connectors that route the signal back to the carrier board for routing through rear I/O of the Chassis. The system interface is designed for routing to FPGAs using a VITA 57 0.05 Pitch Terminal Array Assembly.
-
4876 -
Technobox, Inc.
The Technobox, Inc. P/N 4876 PCI Express-to-XMC Adapter is a development/diagnostics tool that permits the testing of a PCIe card in an XMC site. Up to 8 lanes are supported via the P15 connector. Several activity LEDs located at the edge of the board give an indication of key XMC and PCI Express signals and voltages.
-
XF07-523 -
Curtiss-Wright Defense Solutions
The XF07-523 is a rugged Kintex-7 FPGA based XMC with digital IO. The combination of direct high-speed I/O ports and FPGA processing makes the XF07-523 ideal for demanding applications including radar, imaging and test equipment across commercial and defense market spaces. The XMC form-factor is ideal to SWaP constrained platforms such as UAVs and fighter aircraft.
-
MIC-6131 -
Advantech Co. Ltd.
MIC-6131 is a 3U OpenVPX XMC carrier. MIC-6131 complies with the MOD3-PER-1F-16.3.2-3 profile, and the VITA 46.0, 46.4, 46.9 and VITA 48 specification. The MIC-6131 Data Plane has the PCIe Gen 3. Input, up to x8 lanes, and provides the optional PCIe gen. 3 output with another x8 lanes. With this design, MIC-6131 is able to support the most powerful XMC with the 75W power consumption*, and doesn’t sacrifice the full fabric bandwidth from the main board. For the XMC pin out, MIC-6131 has the X24S X8D X12D pin field on the VPX connector P2, and enables the vast capability of customization of the customer.
-
XMCspan -
ELMA Electronic, Inc.
SMART Embedded Computing’s XMCspan allows users to customize and expand I/O options when coupled with MVME7100 and MVME4100 SBCs, adding up to 4 XMC or PMC slots.
-
XMC-528 -
Curtiss-Wright Defense Solutions
The XMC-528 is a high-performance, user-programmable processing and FPGA resource for embedded security applications or use as an FPGA co-processing engine.
-
XM61000 -
LinkedHope Intelligent Technologies Co.,Ltd.
XM61000 is an XMC display control card independently developed by Linghao Intelligence®. It is mainly targeted at high-performance embedded graphics image processing and GPU general computing processing (GPGPU) applications.
-
XM61002 -
LinkedHope Intelligent Technologies Co.,Ltd.
XM61002 is an XMC display control card independently developed by Linghao Intelligent®. It is mainly targeted at high-performance embedded graphics image processing and GPU general computing processing (GPGPU) applications.
-
XM61001 -
LinkedHope Intelligent Technologies Co.,Ltd.
XM61001 is an XMC display control card independently developed by Linghao Intelligent®. It is mainly targeted at high-performance embedded graphics image processing and GPU general computing processing (GPGPU) applications.