Systems
are interconnected groups of purpose.
See Also: Equipment, Test Systems, System Integrators, System Test
-
product
Record and Analyze Flight Data
TDS AND MRC
AMPOL's TDS and MRC-150 are complete legacy solutions that can record and analyze flight data from a number of sources. These solutions are especially useful in the air for flight-test and integration phases, as well as on the ground for pre-flight tests. The TDS is a complete solution for recording and analysis of telemetry data from multiple sources. Installed on a fighter jet's wingtip, in an air-to-air missile pod, the TDS's airborne unit is sealed and has a removable, solid-state Flash disk...show more -
product
Powertrain Analysis System
KiBox2
With the KiBox2 analysis system, you have all the data related to vehicle powertrains under control.
-
product
Safety Relay Modules & Sensors
Using safety relay modules, you can reliably implement safety functions in machines and systems. They monitor signals from emergency stop buttons, light grids, and safety door switches, and initiate a safe state where necessary.
-
product
Residual Gas Analyser For Process & Research
(QMS)
Quadrupole Mass Spectrometer Analyser System for low volume, quick responding gas measuring with large dynamic range Quadrupole Mass Spectrometer (QMS) for low volume, quick responding process gas measurement with large dynamic range.
-
product
Battery Pack Drop Tester
Guangdong Bell Experiment Equipment Co.,Ltd
DGBell's Battery Pack Drop Tester Relevant standards requirement:Test object: battery pack and systemTest procedure: The test object is most likely to fall in the direction of actual maintenance or installation. If it is not possible to determine the most likely fall direction, fall in the Z-axis direction, and the battery pack will fall from the height of 1 m to the concrete floor and observe for 2 hours.Accept standard: The battery pack or system has no electrolyte leakage, fire nor explosion.
-
product
Universal Data Acquisition System
(UDAS/USB2250)
The Universal Data Acquisition System(UDAS) Sensor Interface provides real world data acquisition for your PC via the USB port. 16 sensor inputs in any mix or combination are accepted by the UDAS. No external signal conditioning is required. The UDAS includes configuration and data acquisition software.
-
product
Inspects MEMS and Wafer Level Devices
NorCom 2020-WL
The NorCom 2020-WL is specifically designed for wafer-level inspection and leak tests up to 1000 devices per cycle. The system can inspect up to an 8” wafer on or off a saw frame. It is designed to test MEMS and other wafer level devices that have a cavity.
-
product
NI-9266, 8-Channel C Series Current Output Module
785047-01
8-Channel C Series Current Output Module - The NI‑9266 is ideal for interfacing and controlling industrial current-driven actuators. The module has built-in open-loop detection, which generates an interrupt in software when an open loop is detected as well as zeroing outputs to ensure safety and avoid driving actuators at system power on. The NI‑9266 includes channel‑to‑earth ground isolation for safety and noise immunity.
-
product
3-slot Network Attached File Server
DTS3
Curtiss-Wright Defense Solutions
The Data Transport System 3-slot (DTS3) is a rugged Network Attached Storage (NAS) file server for use in mobile vehicles, field ground stations, and aircraft. The DTS3 is easily integrated into network centric systems providing an easy-to-use, turn-key, rugged Network File Server (NFS). The system houses three Removable Memory Cartridges (RMC) that provide quick off load of data.
-
product
Measuring Systems For Night Vision Systems
MTF Test Bench For Image Intensifier Tubes (IIT) And Night Vision Devices (NVD)
Optik Elektronik Gerätetechnik GmbH
The MTF MASTER NVD was specially designed to measure the MTF of Night Vision Devices (NVD) and of Image Intensifier Tubes (IIT).
-
product
Vector Signal Generator
MGKS
The MGKS vector signal generator is designed to reproduce arbitrary waveforms, as well as sinusoidal signals with amplitude, frequency, phase modulation or without modulation. The generator can be used for research, tuning and testing of systems and devices used in radio electronics, automation, computing and measuring technology, instrument making.
-
product
Industrial Internet of Things (IoT) Software Platform
ADEPT
Applied Dynamics International
ADEPT is the industry’s leading Industrial Internet-of-Things (IoT) computing and connectivity software platform providing open virtual and real-time computing for the world’s most demanding applications. It achieves this by connecting all your digital engineering and manufacturing assets, regardless of manufacturer or software, to create one fully connected system.
-
product
Coverage Products
For over 35 years Bird has designed, manufactured, and sold distributed antenna system networks. Our current blend of products can support wireless voice and data services (GSM, EDGE, UMTS, CDMA, LTE) as well as other applications such as broadcast and public safety communications (FM, TETRA, P25).
-
product
Anemometer, 0.8m/s to 30m/s, 0 °C, 50 °C, 80%, 180 mm
72-6638
An instrument to accurately measure air velocity and wind speed in air conditioning and heating systems as well as for environmental monitoring.
-
product
LXI Microwave Multiplexer, 50Ω 4-Channel 16-Bank 18GHz SMA
60-802-216
The 60-802-216 is a 4-channel, 16-bank RF multiplexer suitable for switching 50Ω signals up to 18GHz. It is part of Pickering Interfaces’ range of LXI Microwave Multiplexers which are available with bandwidths between 6GHz and 40GHz and support for 4, 8 12 or 16 banks of 4 or 6-channel multiplexers. It is ideal for constructing complex microwave switching systems for many applications. Connection is by high performance front panel mounted SMA or SMA-2.9 connectors.
-
product
Automated Programmer Superpro Sb05
※ Four Pick & Place nozzles, Eight socket pressing actuators and 2 tape feeders※ High throughput up to 2400UPH※ Embeded with eight ultra-high speed programmers SuperPro / 7500, each with up to 4 sockets, totally 32 sockets. Throughput 60 times higher than SuperPro / SB01 for eMMC devices※ Supports over 80,000 devices from over 300 IC manufacturers※ Supports tray, tape and tube input and output. Supports laser and ink marking※ Short change-over time※ Intelligent s/w cuts learning curve and se...show more -
-
product
9U 8-Slot CompactPCI® Chassis with Redundant Power Supplies
cPCIS-3330 Series
The cPCIS-3330 Series is a 19" 8-slot 6U CompactPCI Subsystem ideally suited to Network Equipment Providers, Computing Telephony Integrators and Voice over IP applications. This flexible and reliable development platform with optimized I/O and storage provides the best solution for equipment manufacturers and system integrators and shortens time-to-market for fast growing business revenues.
-
product
acA3088-57uc, Color USB3 Vision, 6 MP, 57 FPS Area Scan Camera
787070-01
The acA3088-57uc is a Color Basler Ace USB3 Vision Camera with a 6 MP resolution and a maximum image acquisition speed of 57 frames per second. The acA3088-57uc uses a IMX178 sensor and is quality tested and calibrated for high performance and reliability. This camera can be used with NI hardware and software to build machine vision systems.
-
product
Vibration Control
m+p VibControl vibration controllers for advanced vibration control and shock testing from 4 to hundreds of input channels are used by many of the leading environmental test laboratories throughout the world. The endusers appreciate the intuitive operation, the extensive analysis and reporting functions, the numerous upgrade possibilities and, of course, the excellent stability and high quality level of the m+p vibration control systems. Applications range from normal to very extreme conditions, and also include rough transportation circumstances.
-
product
Motion Simulation
Exail's motion simulators are at the forefront of calibrating and testing inertial sensors, navigation systems, and optronic payloads across diverse applications, from traditional land vehicles and aircraft to emerging sectors like autonomous vehicles and wearables. With 60 years of expertise, Exail's rate tables deliver unparalleled performance, accuracy, and reliability, offering a cost-effective solution tailored to meet customer needs at every stage of product development. From concept to maintenance, Exail provides comprehensive support, ensuring the success of each project
-
product
Ultrasonic Imaging System
USPC 3010
Ingenieurbüro Dr. Hillger Ultrasonic-Techniques
Detects internal defects in new materials and metals. The wide frequency range up to 35 MHz enables highestresolution. A-, C-, and D-scans can be recorded. The imaging in B-scans is an option.
-
product
Cable Free ATE
CABLEFREEATE
Digalog Systems customizes resources to provide requirements or more cost-effective requirements that are not currently on the market.The CableFreeATE™ technology also affords lower cost and easier integration of some common offerings:- VPC 64 SPST Reed Relay- 0.1" Discrete Header 64 SPST Reed Relay- DL1-156R 72 SPST Reed Relay
-
product
TPI With 4-20mA Dual Outputs
TX-205
NMC's Digital tap position indicators, Type: TX-205 Are instruments used to indicate the tap position of the power transformers with OLTC. TX-205 Comes With 4-20mA Single / Double output for SCADA systems.
-
product
Battery Conductance and Electrical System Tester
MDX-P300
The MDX-P300 is the first tester available from Midtronics which features an integrated printer allowing for immediate printing of test results. Now it is easier than ever to show thecurrent state of the battery and electrical system by providing customers with a printed result of the battery and system test. Using patented Conductance Technology, perform a quick, simple, and accurate battery or system test in seconds, and review the printout with the customer for added impact to preventive maintenance routines and customer service.
-
product
14-Slot Combination PXIe Chassis
GX7100e Series
The GX7100e Series are 14-slot combination PXIe chassis that accommodate a 3U PXIe embedded controller or a MXI express controller as well as 3U & 6U PXI / PXIe insruments in 4U of rack space. The GX7100e’s unique format includes seven 6U slots and seven 3U slots arranged horizontally to reduce the overall size of the chassis, providing the versatility and high-density necessary to address many PXI / PXIe applications and requirements. The backplane architecture supports Gen 2, 4x4 PCI Expre...show more -
product
NVIDIA® Jetson™ TX2 Edge Inference Platform
DLAP-201-JT2
- Deep learning acceleration with NVIDIA® Jetson™ TX2- Compact fanless system 148(W)x105(D)x50(H)mm- Wide temperature range from -20°C to 70°C
-
product
VPX Chassis 4U/50HP 5 Slots
This 5 slot Hartmann VPX 4U system chassis provides an intelligent, practical packaging solution for high-performance processors. The 50HP wide, rack-mountable enclosure for vertical mounting of boards is outfitted with a 300W ATX power supply and a 1U removable, bottom mount fan tray.
-
product
Riser Cards
Advantech Riser Cards provide scalability and flexibility for PCI Express(PCIe) expansion slots and 1U/2U systems with Advantech industrial motherboards.
-
product
Emergency Alternative EDFA system
Telecommunication systems are vitally important in our daily lives, even more so during the rescue and recovery processes upon natural disasters, such as the earthquake hitting the east-coast of Japan in 2011. The deadly earthquake rattled the nation coast before unleashing a deadly tsunami that swept away cars, homes and businesses as it touched land. The communication infrastructure was among the victims. Rapid rebuilding of the telecommunication system becomes an absolute priority.
