Systems
are interconnected groups of purpose.
See Also: Equipment, Test Systems, System Integrators, System Test
-
product
Power Relays
Replace your large, slow, unreliable EM relays with the Ideal Switch. Enable a new era of connected and better protected buildings (residential, commercial, hospitals, airports), transportation (eMobility, Rail, Marine), factories (Robots and Systems), and power distribution (solar, wind, grid, battery).
-
product
PXI-2547, 2.7 GHz, 50 Ω, 8x1 PXI RF Multiplexer Switch Module
778572-47
2.7 GHz, 50 Ω, 8x1 PXI RF Multiplexer Switch Module—The PXI‑2547 is an RF signal multiplexer switch module. The higher channel count of the PXI‑2547 makes it ideal for test systems that require the switching of a large number of RF signals, such as switching several devices under test to a single channel on the RF analyzer. The module also features excellent insertion loss, voltage standing wave ratio (VSWR), and isolation parameters to minimize signal degradation. You can use the onboard relay count tracking feature to predict relay lifetime and reduce unexpected system downtime.
-
product
4-Channel 200 MHz, 16-bit A/D with Virtex-7 FPGA - 6U VPX
Model 57760
- Supports Xilinx Virtex-7 VXT FPGAs- GateXpress supports dynamic FPGA reconfiguration across PCIe- Four or eight 200 MHz 16-bit A/Ds- 4 or 8 GB of DDR3 SDRAM- PCI Express (Gen. 1, 2 & 3) interface up to x8- Sample clock synchronization to an external system reference LVPECL clock/sync bus for multiboard synchronization- Optional user-configurable gigabit serial interface- Optional LVDS connections to the Virtex-7 FPGA for custom I/O- Ruggedized and conduction-cooled versions available- Supports GateXpress® FPGA-PCIe Configuration Manager- Synchronize up to eight modules with Model 7893 System Synchronization and Distribution Amplifier - PCIe
-
product
Battery Analyzer
KT-97C
● Battery ImpedanceRange: 60mΩ / 600mΩ / 6 Ω / 60Ω (auto-range)Accuracy: ±1.0% of reading ±3digits Resolution: 0.01mΩ● DCV Range: 6V / 60V (auto-range) Accuracy: ±0.8% of reading ±3digits Resolution: 0.001V●StorageCan storage 50 groups data (impedance and voltage) and veryconvenient for you to number the batteries for detection.●Connect to PC RS-232 interface ● Display impedance and voltage of battery together. ●Supplied with lithium batteries, it is very convenient to test outdoors and indoor...show more -
product
Profibus-DP I/O Modules
900PB Series
Each module provides a direct network interface for your I/O signals. Unlike "block I/O" devices that combine large, expensive processor blocks with snap-on I/O terminal blocks, 900PB modules handle the network interface and I/O processing in one, compact multi-channel module. This space-saving approach is very cost-effective for systems that need to add a small quantity of I/O channels at existing control sites or network to new remote sites.
-
product
PoE / Data Splitter
XPS1
The NG Systems PoE/Data Splitter (XPS1) is an installation device which allows PoE power to be delivered to a camera whilst allowing a direct connection to a laptop or other device (e.g. Pinger). This significantly simplifies camera configuration or lens focusing and shortens installation time.
-
product
Shielded Bag Test Kit
PBT-531
The PBT-531 is a complete system kit designed to evaluate the performance of electrostatic discharge shielded bags and other packaging materials.
-
product
Industrial And Mining
Rapiscan® Systems is a manufacturer and supplier of conveyor tramp metal detectors model Metcorr 117C and the Satmagan 135 Saturation Magnetization Analyzer for industrial and mining applications.
-
product
6-Slot LXI/USB Modular Chassis
60-106-001
Pickering Interfaces’ 60-106-001 modular LXI/USB chassis occupies only a small, 1U rack-height form factor, making it suitable for portable and space-restricted rack-mount applications. The chassis features remote control via USB or LXI Ethernet. Remote control over a network enables the switching function of a test system to be located as close as possible to the target equipment.This chassis is also available with built-in scan list sequencing and triggering (model 60-106-002).
-
product
SMPTE Studio Camera Hybrid Fiber Converters & Power Supplies
SMPTE-HUT Series
We work in an industry of hybrid workflows and solutions, but sometimes we need authentic innovation that changes how we work. MultiDyne’s next-generation SMPTE-HUT Series is the definition of a pure solution that elevates the live production workflow. SMPTE-HUT universal camera transceivers free SMPTE-based camera chains from the limitations of hybrid copper and fiber cabling, and removes interferences associated with copper connectivity. Camera operators instead have a plug-and-play system tha...show more -
product
15kV Subsea Power System
The Teledyne Oil and Gas 15kV subsea power electrical connection system is a three-phase system rated to 220 A and 8.7/15 (17.5) kV. The electrical connection system is designed to provide power to subsea production systems.
-
product
LXI Microwave Multiplexer, 50Ω 4-Channel 14-Bank 26.5GHz SMA
60-802-314
The 60-802-314 is a 4-channel, 14-bank RF multiplexer suitable for switching 50Ω signals up to 26.5GHz. It is part of Pickering Interfaces’ range of LXI Microwave Multiplexers which are available with bandwidths between 6GHz and 40GHz and support for 4, 8 12 or 16 banks of 4 or 6-channel multiplexers. It is ideal for constructing complex microwave switching systems for many applications. Connection is by high performance front panel mounted SMA or SMA-2.9 connectors.
-
product
Vapor Source Mass Flow Controller With Viscous Laminar Flow
The 1152C Vapor Source Mass Flow Controller is a pressure-based measurement and control system designed to meter and control vapor from low vapor pressure liquid and solid sources directly, without the need of a carrier gas. The 1152C consists of a fixed flow element and two capacitance manometers for flow measurement, with a proportioning solenoid control valve for flow control.
-
product
Technical Software Engineering
Technische Software Entwicklung Plazotta
TSEP is a system house that has specialized since 1988 in the development of system-related software in the fields of communications technology, telecommunications, instrumentation and automotive. Since 2005 TSEP also develops hardware solutions for its customers. Here TSEP offers not only the hardware solution (schematic, layout, production, etc.), but also the software technical integration of hardware into the operating system and the application. These solutions are characterized by the fact that both the hardware and the software are perfectly matched.
-
product
PCI Express x1 PMC Carrier
TPCE261
The TPCE261 is a standard height PCI Express Revision 2.0 compatible module that provides one slot for a single-width PMC module used to build modular, flexible and cost effective I/O solutions for all kinds of applications like process control, medical systems, telecommunication and traffic control. The TPCE261 is a versatile solution to upgrade well known PMC I/O solutions to the PCI Express signaling standard.
-
product
Monitoring System
TriGas X5000
The TriGas X5000 Monitoring System is an integrated gas detection solution that helps plant operators comply with NFPA 820. The system monitors for combustible gases, hydrogen sulfide and oxygen with on-board alarming and communication interface to plant and remote location control stations.
-
product
Single Pin Horizontal EFS
Teledyne DGO offers an advanced, high-reliability subsea wellhead single channel electrical feedthrough system for use in intelligent completions with permanent downhole instrumentation. The connection system is designed for long-term reliability in the demanding subsea and downhole environments with sour well (H2S) conditions, as well as aggressive production and packer fluids.
-
product
Load Cell Simulator
A High-Stability adjustable Load Cell Simulator. It is specifically designed for Load Cell Fault and System Fault Diagnosis. It also provides a useful Development Tool for any System which relies upon Load Cells. The Output Signal is adjustable from -0.1 to +3.1 mV/V.
-
product
Dynatrol® Red Goose V2 Cell For Pipeline Products
The Red Goose v2 Pipeline Products Inline Sampling System can be used on gasoline, diesel fuel, jet fuel and other refined petroleum products. It was designed so no removal is needed during pipeline maintenance and utilizes a retractable scoop used for pigging or scraping operations.
-
product
MCCI Catena® 4450 Node for LoRaWAN™ Technology
The MCCI Catena® 4450 Node for LoRaWAN™ technology is a powerful open-source IoT device designed specifically for use with The Things Network. Based on the Adafruit Feather M0 system, the Catena 4450 is a ready-to-use platform for LoRaWAN 1.0 and 1.1 wireless IoT applications.
-
product
Optional Expansion Modules Compatible with Industrial Modular PCs
i-Module Series
i-Module series comprise optional expansion modules that are compatible with industrial modular PCs such as MIC-7000 series systems.
-
product
PXI Single 92x4 Matrix, 1-Pole Switching
40-535-021
Typical applications include signal routing in Functional ATE and data acquisition systems. These PXI matrix modules are constructed using high reliability sputtered Ruthenium reed relays, offering >109operations to give maximum switching confidence with long life and stable contact resistance.
-
product
HV DC Voltage Generators
Fivestar HV Testing Equipment Co., Ltd.
HV DC voltage generators are used to generate high voltage DC test voltages for routine, type and development test on components and complete systems found in electrical power supply systems and operating on DC voltage (HV transmission systems etc). There are K and M series, and available for indoor and outdoor.
-
product
Pylon ITA Mount Linear Testfixture Cassette and ITA Frame Not Included, UUT 306 x 248 mm
MG-02 VGR12
FEATURES• Linear click system with ball bearings, using gas springs• 10 mm ESD-proof top cover with aluminium reinforcement bars• Steel base cabinet with aluminum backpanel for a Genrad VGR12 Pylon frame• Detachable interchangeable case system with an 8 mm spring loaded probe protection cover• Base cabinet fitted with a telescopic guide rail and catchTECHNICAL SPECIFICATIONS• Max. number of probes (2000N) 1300 units• Max. PCB height: 60 mm• Linear travel: 12 mm• Max UUT: 306 x 248 mm (wxd)• Outer dimensions: 470 x 490 x 100 x 170 mm (wxdxh1xh2)• Designed for changeable cassette
-
product
Tracing-Type Non-Contact Inspection System For LCD/STN/Touch Panel/FPC
TTS
*"Probe + Non-Contact Sensor" enables to delect SHORT after sticking LCD*No Fixture in LCD Inspection*Applicable to FPC Inspection
-
product
CAMGATE Test Kits
Series 453
LThe GR Series 453 CAMGATE mechanical kits, utilizing the patented CAM mechanism, offer precise Z axis linear motion when testing higher point count and finer pitch test centers. By using the Z axis motion, side load of the test probes is minimized thus increasing probe life and performance. The Series 453 provides interface compatibility using the GR2270 Style, 12 block interface. This interface accepts the industry standard I/O, power, and coax blocks. The CAM/GATE utilizes a cam roller system...show more -
product
Vision Systems
Starrett Video-based measurement systems combine high-resolution images, powerful intuitive software and precision mechanical platforms to deliver superb accuracy and repeatable measurement results for a wide range of precision measurement applications.
-
product
Batteryless System Logger
SKU-004-01
The Batteryless System Logger is a unique device that was designed to log system data from any serial port, and store the data in the Logger’s non-volatile memory; this is done in the event of a system crash or power outage. The Logger is ideal for companies in the embedded appliance market.The System Logger connects to the embedded system via the serial RS-232 port. It continuously receives log info from the system, and stores this log info on an internal cycle buffer. This info can be retrieved via the serial interface at any time.
-
product
ROTV Based Systems
The involvement of the MacArtney Group in the design and manufacture of remotely operated towed vehicle (ROTV) systems reaches back to 1989, when the development of the first generation of FOCUS systems was initiated. The range was later expanded to include the TRIAXUS oceanographic data acquisition ROTV and the FOCUS 2 towed survey system.
-
product
Digital Voltage Divider
SGB-C / 590
Wuhan Huatian Electric Power Automation Co., Ltd.
Used for measuring ac high voltage and dc high voltage in power system and electrical equipment manufacturing department.
