-
product
OPTICAL PHASE NOISE TEST AND MEASUREMENT SYSTEM
OEwaves’ HI-Q® Optical Test Measurement System utilizes a homodyne methodology for automated measurement capable of testing ultra-low phase noise laser sources. The user friendly test system is capable of rapidly measuring laser phase noise and estimating its FWHM linewidth down to < 3 Hz without complex setup or reference lasers normally required to make such a narrow linewidth measurement.
-
product
PAM4 Bit Error Rate Tester.
BERT-1102
The BERT-1102 is a 4 or 8-channel PPG and Error Detector for the design, characterization and manufacturing test of optical transceivers and opto-electrical components with symbol rates up to 29 GBaud/s in both NRZ and PAM4 formats. With scalability and exceptional signal fidelity, it is a cost-effective test solution for up to 400 Gb/s communication eco-systems.
-
product
Optical Contact POF Ext Ø 1mm For VPC RCV Mini Power 510104123
AN396
Optical contact probe for sensing LEDs.
-
product
Loopbacks
Loopbacck plugs are used for network diagnostics, system configuration testing, and device burn-in. Looping back the signal allows for testing of the optical network.
-
product
Digital Output Board, 32 Isolated Channels, 24V
APCI-2032
32 digital outputs, 24 V or 5 V, 500 mA/channel Optical isolation 1000 V Overvoltage protection Short-circuit protection WatchdogAt power-on the outputs are reset to ì0î
-
product
8 Channel A/D & D/A Zynq UltraScale+ RFSoC Processor - SOSA Aligned 3U VPX
Model 5550
- Now available in RFSoC Gen 3 with the Model 5553- Supports Xilinx® Zynq® UltraScale+™ RFSoC FPGAs- 16 GB of DDR4 SDRAM- On-board GPS receiver- 10 GigE Interface- 40 GigE Interface- Optional VITA 67.3C optical interface for backplane gigabit serial communication- Dual 100 GigE UDP interface- Compatible with several VITA standards including: VITA 49, VITA 46, VITA 48, VITA 67.3C and VITA 65 (OpenVPX™ System Specification)- Ruggedized and conduction-cooled versions available- Model 8256 3U VPX SO...show more -
product
3D Automated Optical Inspection Systems (3D-AOI)
3Di Series
Saki’s 3Di Series applies cutting edge technologies to improve production efficiency and enhance production quality across the entire assembly line.
-
product
Calibration Services
For over 25 years, OAI (Optical Associate Inc.), is the leader in NIST traceable calibration of instruments for measuring Ultra Violet (UV) light. Originally designed to meet the demanding needs of the semiconductor wafer fabrication industry, OAI developed the most repeatable NIST traceable calibration in the industry.
-
product
VOA MUX/DEMUX (DWDM) With VOA Dense Wavelength Division Multiplexer
DWDV-1000 (100GHz)
Hangzhou Huatai Optic Tech. Co., Ltd.
Huatai DWDV-1000 series, integrate of DWDM and Electronically controlled variable optical attenuator (VOA) in 1RU or 3U chassis, each channel of DWDM has one high-resolution electronically controlled variable optical attenuator, adjust the optical power. Compact and simple device structure reducing the number of connections between devices, improve the system parameters and device reliability. It can be easily and flexibly used in DWDM system inter-channel power adjustment and automatic balance, optical add-drop multiplexing (OADM).
-
product
PXI/PXIe MEMS Optical MUX, 4-Channel, Multi-Mode, 50/125 Fiber
40-850A-514-M50-HI
The 40/42-850A-514-M50-HI is a PXI/PXIe 4-channel multiplexer with ST connectors, includes hardware interlock and is part of Pickering's range of PXI Fiber Optic MEMS Switching modules. They are available in many high density formats with a choice of different connector styles to suit most applications: FC/APC (for optimal performance), FC/PC and SC/PC for general applications and LC and MU for high density applications.
-
product
Real Time PCR Systems
Learn about Agilent’s Real Time PCR system including the newest generation AriaMx system, and find everything you need for your qPCR applications, from kits, instruments, enzymes, master mixes, reagents, optical cartridges, plastics, supplies to software and more. The AriaMx Real-time PCR System is a fully integrated quantitative PCR amplification, detection, and data analysis system. The AriaMx amplifies your productivity with its unique modular and flexible design, intuitive touch-screen interface, advanced, easy-to-use reporting, and 120+ attributes monitored via the built-in on-board diagnostics to help pinpoint assay or instrument issues as they arise.
-
product
Routing Products
Routing Products by Senko - in-line polarizer, PM filter WDM, OM Optical circulator, PM filter coupler, PM polarization combiner/splitter, isolator, circulator, and more
-
product
Thermo-Hygro-Barometer
C4141-4
Audio and optical alarm of measured temperature. Minimum/maximum memory. memory of minimum and maximum temperature included traceable calibration certificate. LCD backlight.With external air temperature-humidity probe on a 4 meters cable. Probe diameter is 18mm, length 135mm. Built-in indoor temperature and air pressure sensors.
-
product
Microscopes
A digital or traditional optical microscope can help engineers check on their high-speed probing activities much more easily. It will assure the probe tips will touch on the right contact(s), with correct contact angle and right amount of force. We use both digital and optical microscopes in our own lab. The information in this page is to help you choose a microscope best suits you.
-
product
Single Frequency Lasers: 355 nm – 1064 nm up to 3 W
Cobolt 05-01 Series
High power, single frequency CW diode pumped lasers: 355 nm – 1064 nm up to 3 W. Perfect for holography, interferometry, Raman, optical tweezers, super resolution microscopy, laser doppler velocimetry
-
product
Compact Optical Environment Test Measurement System
Durability test with temperature, humidity and "sunlight"●Espec SH-241 small environmental tester combined with a solar simulator for durability testing under temperature, humidity and light environments●Software is also available.●Please inquire about the system configuration individually.
-
product
Rolling Seal 8 Optical Connector - APC (RS8 APC)
The Angled Physical Contact Rolling Seal 8 Connector (RS8 APC) from Teledyne ODI is a wet-mateable optical connector with angled endfaces. The design reduces signal interference due to reflections at the connector face, supporting the next generation of subsea optical communication equipment. The Rolling Seal design provides isolation from seawater and silt when the connectors are unmated. As the seals rotate, the fibers join inside a clean, oil-filled conduit, resulting in a reliable optical throughput. The RS8 APC incorporates RS8 Mark III design features to enhance operational efficiency and reduce risks during ROV intervention.
-
product
White Light Continuum Generator
JIBE
A powerful coherent light source. Due to its amazing wide spectral band, the white light continuum is being applied in different areas such as optical parametric amplification, optical metrology, optical coherence tomography, materials characterization, etc.
-
product
Powerful and Cost Effective Spectroscopic Ellipsometer
Smart SE
The Smart SE from HORIBA Scientific is a versatile spectroscopic ellipsometer for fast and accurate thin film measurements. It characterizes thin film thickness from a few Angstroms to 20µm, optical constants (n,k), and thin film structure properties (such as roughness, optical graded and anisotropic layers, etc).The spectral range from 450 to 1000nm is measured in a few seconds and ellipsometric data are analyzed using the DeltaPsi2 software platform. The software integrates two levels of software to fulfil both routine analysis with predefined recipes and advanced analysis with state-of-the art ellipsometric modelling.
-
product
Flexible High-Performance Spectrometer
MCS Series
MCS UV-NIR has remarkable performance in the 190 - 1015 nm spectral range with great flexibility thanks to different optical entrance and housing designs and detector options for exceptional signal/noise or highest sensitivity.
-
product
HFC 7 Ways Return Path Optical Receiver 1 Way Reverse Optical Transmitter
HR2071A, HR2071B
Hangzhou Huatai Optic Tech. Co., Ltd.
HR2071 series of HFC seven-way return path receiver, one way reverse optical transmitter, mainly used at the head-end to convert upstream optical signal to RF signal at the user side. Moreover, send back the data at sub-HE to main head-end through one way of DFB return path transmitter. Eight independent units integrated into a 1RU 19" casing to provide service for HFC network terminal of ONTs. The receivers’ low noise design of -22dBm receive sensitivity, allow to supply service to farther dis...show more -
product
Fibre Optic Converters
In complex testing environments it is often needed that electrical signals have to be transmitted into the chamber or out of the chamber to the test equipment.For that purpose we offer a variety of different interfaces that convert electrical signals into optical signals and back. Such the signal can be transported via fibre optics and is immune against electrical fields.
-
product
Probe Series
VEGA Series
MPI VEGA Prober series is ready to meet the diverse test and material handling requirements of the Laser Diode (VCSEL, EEL) and optical module markets. MPI VEGA probers are based on a highly flexible and reliable platform, enabling the test of a wide variety of device types (Wafer, Package & Singulated Die) over temperatures with the ability to handle thin/warped wafers. Multiple probing schemes are also supported with the ability to probe small pads with well-controlled needle force.
-
product
PXI/PXIe MEMS Optical Switch, Quad Insert/Bypass, Single-Mode, 9/125 Fiber, LC Connectors
42-860A-442
The 40/42-860A-442 is a PXI/PXIe quad insert/bypass switch with LC connectors and is part of Pickering's range of PXI Fiber Optic MEMS Switching modules.
-
product
Single 2x2 Insert/Bypass F Optic FC/APC
40-820-012
Pickering PXI Fiber Optic Multiplexers connect a single channel to one of two or four channels. They are available in single or dual multiplexer configurations supporting single-mode or multi-mode fiber. A wide choice of connectors types is available. The 40-810 multiplexer connects the optical channel by redirecting the optical signal into a selected output fiber.
-
product
Thermo-Hygrometer
C3121P-4
Thermometer, hygrometer is designed for direct measurement of temperature, relative humidity for compressed air up to 25 bars with 4 meters cable. Audio and optical alarm of measured values. Memory of minimum and maximum measured values. Function Hold - manual storing of actual values for later displaying.
-
product
640 Gb/s Digital Signal Processor
M8132A
The M8132A is a powerful digital signal processing module featuring two customers accessible Xilinx Ultrascale+ FPGAs, four optical data interfaces (ODI) running at up to 160 Gb/s in+out each, and a PCIe Gen3 x8 link to the AXIe backplane. In addition, the module provides a trigger input and output, synchronization input and outputs for deterministic latency between compatible digitizers and AWG modules as well as a 10-general purpose I/O pins. The M8132A is part of Keysight’s Wideband Solution Platform that consists of a portfolio of compatible instruments, including digitizer, arbitrary waveform generator, digital signal processor and storage modules.
-
product
PXI/PXIe MEMS Optical MUX, 4-Channel, Multi-Mode, 62.5/125 Fiber, MU Connectors, With Interlock
42-850A-314-M62.5-HI
The 40/42-850A-314-M62.5-HI is a PXI/PXIe 4-channel multiplexer with MU (mini SC) connectors, includes hardware interlock and is part of Pickering's range of PXI Fiber Optic MEMS Switching modules. They are available in many high density formats with a choice of different connector styles to suit most applications: FC/APC (for optimal performance), FC/PC and SC/PC for general applications and LC and MU for high density applications.
-
product
Aircraft Hygrometer
1011C
Buck Research Instruments, LLC
The 1011C Aircraft Hygrometer is a complete chilled mirror optical dew point system for monitoring atmospheric dew and frost points. It provides three stages of thermoelectric cooling, and can reach frost points as low as -60 to -90 C, depending on mounting configuration and operating conditions. No auxiliary coolants are required.
-
product
Optical Encoders
Rotary encoders are ideal for use as digital panel controls or position sensing devices in a wide range of applications where digital circuitry is used. These devices are available in contacting and optical types and in various resolutions. Some models are available with push momentary switch and detents.
