Model
construction of a concept.
See Also: Modeling, Modelling, Modelers, Human Body Model, Charged Device Model
-
product
Timers
Omega has timers with large, bright digital readouts. We have them in benchtop models, wall mountable units, and hand-held form factors.
-
product
Metro Expert
MX Series
The VeEX® MX product series offer a complete test solution for Metro Ethernet network installation and maintenance. Powerful features such as symmetrical and asymmetrical RFC2544 conformance testing, Multiple independent stream generation, Stacked VLAN (Q-in-Q) and MPLS tagging, and Dual Port Traffic Generation/ Analysis are available at 10GBase-R, 1000Base-X and 10/100/1000Base-T test interfaces. Fiber Channel testing at 1Gbps and 2Gbps rates is supported on select models.
-
product
Latching/Failsafe, SPDT, 50Ω Impedance, SMA Connectors, DC-26.5GHz
Part No.s CCR-53S/CR-53S
Latching/Failsafe, SPDT, 50Ω impedanceAvailable in Commercial and Elite models, with SMA connectors.DC-26.5GHz
-
product
Piston Gauges
Fluke Calibration piston gauges provide reference level primary pressure measurements for some of the top laboratories in the world. Our piston gauge lineup includes models that offer full automation. Our primary level pressure balances utilize a fundamental equation to determine generated pressure with very low levels of uncertainty. Piston gauge models include PG7000 and PG9000 DHI systems with AMH automated mass handling and other automation hardware; 2465, 2468, 2470 and 2485 Ruska piston gauges and 24xx differential pressure cell and other piston gauge accessories; FPG8601 DHI very low pressure standard; 2482 Ruska differential pressure standard. Standard pressure calibration.
-
product
Pulse generator
9355-1
Solar Model 9355-1 Pulse Generator is designed to provide impulse excitation by means of an injection probe placed around interconnecting cables or power wires. The unit uses a charged transmission line (50 ohms) to generate a pulse with less than 2 nanoseconds rise and fall time, and duration of approximately 30 nS, calibrated in a 50 ohm fixture to deliver up to 5 amperes at a rate of 30 p.p.s. for one minute as required by MIL-STD-461D/E, test method CS115.
-
product
4-Channel 500 MHz A/D and 4-Channel 800 MHz D/A with Virtex-6 FPGA - 6U VPX
Model 58650
- Complete radar and software radio interface solution- Supports Xilinx Virtex-6 LXT and SXT FPGAs- Four 500 MHz 12-bit A/Ds- Two DUCs (digital upconverters)- Four 800 MHz 16-bit D/As- Up to 4 GB of DDR3 SDRAM; or: 64 MB of QDRII+ SRAM- PCI Express (Gen. 1 & 2) interface up to x8- Sample clock synchronization to an external system reference- LVPECL clock/sync bus for multiboard synchronization- Optional user-configurable gigabit serial interface- Optional LVDS connections to the Virtex-6 FPGA for custom I/O- Ruggedized and conduction-cooled versions available- Synchronize up to eight modules with Model 7893 System Synchronization and Distribution Amplifier - PCIe
-
product
Machine Vision Camera
Mako
Mako cameras feature the latest CMOS sensor technologies from renowned manufacturers (Sony, CMOSIS, e2V, Aptina, OnSemi Python). Always get the best image quality for your application with a choice of camera models from VGA to 5 megapixel resolution, and frame rates up to 550 fps. Choose between two plug-and-play interfaces (GigE VisionTM or USB3 VisionTM) for an easy integration into standard image processing systems. Mako camera offer advanced features including camera temperature monitoring, pixel defect masking, separate ROI for auto features for all your application requirements.
-
product
Digital Optical Transport
The ATX GigaWave digital optical transport portfolio is designed to fortify cable operators with maximum flexibility and cost efficiencies to support a range of applications and business models. The GigaWave Digital Link Extender (DLX) is optimized to support distributed access architectures (DAA), including Remote PHY (R-PHY) and Remote MACPHY (R-MACPHY), as well as Passive Optical Network (PON), Small Cell/5G and enterprise business services. The GigaWave Digital Link Amplifier-HUB (DLA-HUB) i...show more -
product
Power Meters
Power meters are an active part of most test solutions. All of EXFO’s modular (IQS line) and benchtop power meters are built for top performance and pinpoint accuracy, and the various models offer a mixture of features and specifications to suit various test setups.
-
product
Signal Acquisition
271
The Model 271 is designed around the Texas Instruments ADS42LB69 16-bit ADC. The 250 MHz sample clock is supplied by either the on-board frequency synthesizer or an external source. The frequency synthesizer can be phase locked to the local 10 MHz TCXO or an external reference can be used to achieve system-wide phase coherence.
-
product
Electrodynamic shakers
EV232
Labtone Test Equipment Co., LTD
Labtone EV series of electromagnetic vibration testing system simulate the vibration environment under the laboratory condition, and test the impact strength as well as reliability of various vibration test applications. In the laboratory, with the aid of vibration testing system, simulations of reproduction of sinusoidal, random, resonant search and dwell, classical shock and road models, etc. can be achieved. It is essential for product quality assurance, new product research and development.
-
product
Dry Contact Relay Card
*UPS Monitoring. Falcon’s Dry Contact Relay Card facilitates UPS status via configurable relay contact activation for simple integration into existing PLC/ monitoring systems.*Flexible Configuration. Easily installs into all SSG and SSG-RP UPS models. Configurable to allow simple selection of active open or closed relay contacts.*Notification & Remote Shutdown Capability. Provides relay contact activation during a UPS event including utility power loss, low battery, UPS fault and bypass cond...show more -
product
Panel Meter Calibrator
1040C/CU
Calibrate panel meters, transducers, circuit breakers and relay units with Model 1040C, a portable, field-ready unit featuring eight key calibration functions.
-
product
Your Automated Microscope For Live Cell Imaging
ZEISS Celldiscoverer 7
Combine the ease of use of an automated microscope with the image quality and flexibility of a research microscope. Whether working with 2D or 3D cell cultures, tissue or small model organisms, you will acquire better data in shorter times with this automated live cell imaging platform. Add LSM 900 with Airyscan 2 to gently image dynamic processes with highest framerates in superresolution.
-
product
1100-Channel GSM Channelizer wih Quad A/D - 6U VPX
Model 57663
- Complete GSM channelizer with analog IF interface- Four 180 MHz 16-bit A/Ds- Two banks of 375 DDCs for upper GSM band- Two banks of 175 DDCs for lower GSM band- PCI Express (Gen. 1 & 2) interface up to x4- LVPECL clock/sync bus for multiboard synchronization- Ruggedized and conduction-cooled versions available- Synchronize up to eight modules with Model 7893 System Synchronization and Distribution Amplifier - PCIe
-
product
Tunable, Pulsed IR SW & LW OPO IR Source
Firefly-IR
Firefly IR is available in short-wave and long-wave models, providing broad wavelength coverage from 1.4-8.5 µm. The compact and sealed design requires no manual alignment, and can be used in a variety of applications in the lab and in the field. Wavelength selection and scanning is automated and performed via web browser or using a TCP/IP command set. Pulsed operation and high repetition rate provide high peak power and rapid data acquisition.
-
product
L-Band RF Tuner and 2-Channel 200 MHz A/D with Virtex-6 FPGA - 3U VPX
Model 52690
- Accepts RF Signals from 925 to 2175 MHz- Programmable LNA boosts LNB (low noise block) antenna signal levels with up to 60 dB gain- Programmable analog downconverter provides I + Q baseband signals with bandwidths ranging from 4 to 40 MHz- Two 200 MHz 16-bit A/Ds- Supports Xilinx Virtex-6 LXT and SXT FPGA- 2 GB DDR3 SDRAM or 32 MB of QDRII+ SRAM- Sample clock synchronization to an external system reference- Clock/sync bus for multiboard synchronization- Optional LVDS connections to the Virtex-...show more -
product
WaveLink Dx20-PT Adjustable Positioner Tip Kit
Dx20-PT-KIT
- Choice of 4 GHz or 6 GHz bandwidth models- Up to 5 Vpk-pk dynamic range with low noise- ±3 V offset range- Low loading and high impedance for minimal signal disturbance- Ideal for DDR2, DDR3, LPDDR2- Deluxe soft carrying case- Innovative QuickLink architecture- Wide variety of tips and leads-- Solder-In Lead-- Optional Positioner (Browser) Tip-- Quick Connect Lead-- Square Pin Lead-- HiTemp Solder-In Lead
-
product
Failsafe, Normally Open (Terminated), SP12T Multi-Throw Switch, 50Ω Impedance, SMA Connectors, DC-18GHz
Part No. CCT-58S SP12T
Normally open, SP12T Multi-Throw switch, 50Ω impedance Includes internal 50Ω terminations on unused ports. Available in Commercial and Elite models, with SMA connectorsDC-18GHz
-
-
product
BJT Modeling
IC-CAP supports a number of bipolar junction transistor (BJT) models. For more information on the various types of IC-CAP supported BJT models, refer to the table below.
-
product
Chemiluminescence 03 Analyzer
Model T265
Teledyne Advanced Pollution Instrumentation
The Model T265 is the only commercially available US EPA Federal Reference Method for Ambient Ozone Monitoring according to the latest US EPA regulatory rules for O3. The instrument uses Chemilumescence with Nitric Oxide (NO) as a reagent, making is safe, stable, and effective for all applications. The NO-CL method for Ozone has several advantages over the conventional UV absorption technology, including the avoidance of positive and commonly found interferrents such as VOCs, fine particulates, ...show more -
product
- Port Miser Port Sharing Device
Model 31
FEATURES: Expands RS-232 Port by Three; Up to 19.2 KBPS; No Power. The Telebyte Model 31 Port Splitter is a passive device which attaches to a modem, printer or computer and allows up to three terminals, monitors or other input devices such as bar code readers, mag stripe units and specialized key pads to be interconnected.
-
product
Bench DC Power Supply - Mixed-mode Regulation With Analogue Controls. Single, Dual Or Triple Outputs, 175 To 420 Watts
EX-R Series
Single outputs, 35V/5A, 18V/10A, 42V/10A, 20V/20ADual or triple outputs, 35V/4AIndependent digital voltage and current meters for each output with 4 digit resolutionSwitchable local or remote sensingConstant voltage or constant current operationVariable 1.5 - 5.0V auxiliary output at 5A (EX354RT)Compact design uses less bench spaceSilent fan-free cooling (not EX202R/EX4210R)DC output switches, automatic mode indicationRS232 or USB controlled models available (35V/5A single)Multi-mode dual model 2x(75V/2A) or 75V/4A or 150V/2A
-
product
Setup software for your Centor Touch
TOUCHCONFIG
TouchConfig is simple and very useful utility software. It enables you to communicate with your Centor Touch model from your computer, and manages its setup.
-
product
Amplifiers
The amplifiers operate in specific C, Ku, DBS and Ka uplink or downlink frequencies and some multi-band models provide the versatility of covering both up and down link frequencies. Alternatively, some models cover more than one link frequency regime.
-
product
FPD Tester Signal Module
A291800-03
The A291800 is an LVDS signal model that can be used with FPD Tester to provide LVDS panel standard signals and related controls for LVDS inspection.
-
product
RS-232 Micro Line Driver - DB9 Connector
Model 209
FEATURES: Compatible with PC; 386/486 Pentium Com Ports; Full Duplex to 19.2 KBPS; No AC or DC Power; Screw Terminals or RJ-11; Small Size. The Model 209F offers all the features of the Model 201 Short Haul Modem but in a package that is approximately one third the volume.
-
product
Power System Multimeter
928A
The Model 928A Power System Multimeter with Floating-Point DSP™ Digital Signal Analysis is an AC Power measurement instrument, providing outstanding performance and flexibility in a small, hand-held package. Not only does the Model 928A measure basic data and power quantities, but it also measures power quality including harmonics, flicker, sags, surges and interruptions. Incorporating a graphic LCD display, serial communications, real time clock and an unprecedented combination of features makes the Model 928A the ideal instrument for the power professional.
-
product
Scalable LXI MEMS Fiber Optic Switching
This LXI Optical Switching range consists of our LXI Scalable Chassis (model 65-200-002) that can be easily reconfigured by the removal and insertion of our optical switching plug-in modules shown below. The unit is purchased as an empty chassis along with the number of plug-in modules initially required (up to six optical matrix or multiplexer modules). As your requirements evolve, additional modules can be easily added, and the control software automatically detects the new configuration. The plug-ins are loaded into the chassis via the front panel, greatly improving the flexibility and ease of maintenance of the unit.
