Showing product results. 46 - 60 of 2220 products found.
-
Control Company
Meter reads from 0 to 1,999 foot-candles (resolution 0.1 to 1). Bright 1/2-inch-high digits make it an easy to read pocket light meter. The simplicity of the two-button operation eliminates the need to refer to directions. Functions are on/off, and range. The meter can be zeroed with the simple turn of an adjustment screw
-
OS420 - Advanced Fiber Solutions
The OS420 light source is for premises and campus cabling networks with multimode fiber, or single-mode fibers under 5km. The ST connector outputs can be adapted to any cable plant with hybrid adapters or hybrid cables. The OS420 becomes a powerful low cost troubleshooting and maintenance tool when used with an Advanced Fiber Solutions OM120 or OM220.
-
UVM-SP-JW - SAN-EI ELECTRIC CO.,LTD.
Readouts of UV intensity and cumulative luminescence count are prompted either on the front panel or via the externally connected remote signal control. The UV intensity detection segment is intended to measure a specific intensity of light signals, while the cumulative luminescence count is designed to tally a cumulative count on all UV intensities measured, in conjunction with real-time calibration.
-
PLMT56 - Pyle Audio Inc.
Light Meter Measures In LuxOver-Range IndicatorLong-Life Silicon Photo Diode InsideMeasurement Rate: 1.5 Times per SecondMax Range: 50,000 LuxAccuracy: +/- 5% Under 10000 Lux, +/- 10% Over 10000 LuxMax Resolution: 0.1 LuxDimensions: 7.40' H x 2.52' W x 0.96' DAccessories Included: 12V A23 Battery, Photo DetectorSold as : Unit
-
OS405 - Advanced Fiber Solutions
The OS405 (635nm) visible laser cable fault locator allows the operator to find faults in fiber optic cables, even in the OTDR dead zone, optimizing splices and tracing fibers. By injecting a bright red visible light in the fiber, locations of losses such as breaks, bends, or bad connectors can be detected visually, even through the typical yellow or orange jacket used on most single fiber cables.
-
Halls Instrumentation.
Hall’s have designed and manufactured products for oil, industrial, farming, commercial, and transportation markets. Products such as truck and trailer light testers, bop savers, early engine warning systems, oil spinners, engine control panels, dashes for service rigs, drillers panels, and sandline controls. Halls have been involved with over the rebuilding from scratch of over twenty service rigs.
-
LS 150 Xenon Arc Lamp Source - ABET Technologies Inc.
Model LS-150 is a Patented US Pat. No. 8116017 low cost, high output 150 watt Xe arc lamp based light source. The entire source, power supply, lamp, and optical compartment are housed in an extremely compact enclosure, 9 x 6 x 11 inches. The unit's base allows mounting on inch or metric spaced optical tables with the optics centered over the hole pattern to allow for easy integration with the rest of your setup.
-
PLMT68 - Pyle Audio Inc.
Light Meter Measures In Lux and Foot Candles (User Selectable)Over-Range IndicatorAuto RangingPeak Hold, Max and Data HoldRelative ModeLong-Life Silicon Photo Diode InsideMeasurement Rate: 1.5 Times per SecondMax Range: 400,000 LuxAccuracy: +/- 5% Under 10000 Lux, +/- 10% Over 10000 LuxMax Resolution: 0.1 Lux/FCAccessories Included: 9V Battery, Carrying Case, Photo DetectorDimensions: 6.50' H x 2.99' W x 1.69' DWeight: 14.22 oz.Sold as : Unit
-
Tenmars Electronics Co., Ltd.
Ideal for measuring mercury, xenon, metal halide or fluorescent lamps, commonly used for studies in the UVA region, as well as sunlight.
-
LI-250A - Li-Cor Environmental, Inc.
Direct Digital Readout: Instantaneous sensor output or 15-second averages can be shown on the LI-250A's display. Measurement units for any LI-COR sensor (mol, lux, klux, or W m-2) are also displayed.
-
DL1076 - Pacer Instruments
Switchable between LUX and FC (footcandles)Auto-rangingAuto-zero at turn-onDisplay hold functionAnalog output (2 VDC F.S.)
-
TES Electrical Electronic Corp.
Dual Display, 4 digit LCD reading.Spectral Sensitivity close to CIE phototropic curve.Measuring levels ranging 0.001 to 1999kAccurate and instant response. Luminance ratio A/B
-
ams AG
ams provides the industry’s broadest portfolio of high-performance and high-sensitivity digital discrete and integrated module optical sensors.
-
OT-3000 - Radiantech, Inc.
The OT-3220/3221 is designed for a high performance stabilized laser source, especially in practice for FTTX networking installation and maintenance fieldworks environment requirements. It is usually applied as stable laser sources for wide range of optical testers and tools in optical fiber cabling and transmission systems.
-
UVF-502S - SAN-EI ELECTRIC CO.,LTD.
In combination use with the uniform exposure unit, selection of uniform irradiation area in the range of 80mm200mm is possible.
