Showing results: 301 - 315 of 600 items found.
-
PNA Series -
Aphena Ltd
The PNA series of network analyzers from Agilent have LAN connectivity as well as GPIB to control the instrument. However, the intended method for programming the PNA is using DCOM (Microsoft's Distributed Component Object Model), which is different from most other LAN-enabled products.
-
Model 366 -
Telebyte, Inc.
FEATURES: DataSpy® Status Display; Implements Low Cost LAN; Supports 32 Users; Uses Single Twisted Pair; External DTE/DCE Switch; Programmable Contention; Selectable Termination. The Model 366 allows interfacing RS-232 based equipment with networks/equipment using RS-485.
-
PROTOR -
Prosig Ltd
PROTOR provides a complete hardware and software solution for vibration monitoring of rotating machines. Acquisition subsystems monitor the machinery and are networked to a central server. Realtime and historical data can be accessed on the server or remotely via a LAN, WAN or VPN. Data and reports are available in graphical and numerical forms.
-
AX93274 -
Axiomtek Co., Ltd.
*PoE-PD I/O board complies with IEEE802.3at standard via an internal cable to power on SBC*100 x 32 mm*1 x LAN cable, 1 x power cable, 1 x thermal module*Compliant products: PICO831, PICO121, PICO841, PICO843
-
NA720 -
Axiomtek Co., Ltd.
The NA720 is built on the server-class Intel® Xeon® D-1527 processor (codename: Broadwell-DE) and Pentium® processor D1508. The NA720 comes with two 10GbE SFP+ ports, eight Gigabit Ethernet ports and two expandable LAN modules supporting 1GbE/10GbE/Fiber/Copper/Bypass with a maximum of 26 LAN ports. Four DDR4-2400 MHz R-DIMM/U-DIMM sockets can provide system memory of up to 128GB and support both ECC and non-ECC memory types. For storage, it supports one mSATA and two 2.5” SATA hard disk drives. This high performance Intel® Broadwell-DE network appliance is an ideal solution for enterprise firewall, network bandwidth controller and UTM applications.
-
Series KLR -
Kepco, Inc.
The KLR Power Supply Series are automatic crossover, 1U high, 2400-watt voltage/current stabilizers with a full rectangular output characteristic within the voltage and current ranges listed in the Models Table.For each model a multitude of limit models can be configured. Limit models allow the unit to be configured to maximum settings below the rated voltage and/or rated current. When a limit model is established the unit will not accept programming values above the user-defined limits.The standard KLR Models (no suffix) have built-in GPIB and RS 232 interfaces. The E-Series models (suffix E) have built-in GPIB and LAN interfaces. The LAN interface is an ethernet-based interface that allows multiple-user access via a standard web browser.
-
QL Series II -
Aim-TTi
Advanced dc power supplies, single or triple outputUp to 112 watts per outputVery high precision, very low noise, excellent dynamicsAdvanced user interface with numeric and rotary controlMultiple voltage/current ranges for increased flexibilityMultiple non-volatile memories for power supply set-upsSwitchable remote sense provides perfect load regulationComprehensive protection including OVP and OCP tripsCompact bench footprint; modular width for rack mountingAuxiliary output fully variable 1.00V to 6.00V at 3A with selectable voltage and current metering (T models)Bus programmable via USB, RS232, GPIB or LAN (P models)LAN interface is LXI compliantDuplicate power and sense terminals at rear (P models)
-
Aim-TTi
Flexible electronic DC loads for general purpose applications. Voltage up to 80V, current up to 80A and power up to 600 watts. CI, CR, CG, CV and CP modes, built-in transient generators. Models with USB, RS232, GPIB and LXI compliant LAN interfaces.
-
PMCE-1553 -
Alta Data Technologies LLC
PMCE-1553™ is an innovative product that provides 1553 operations via 10/100/1000 Ethernet IP/UDP local area networks (LAN) backplane. PMCE-1553 is a standard PMC form factor card, but instead of PCI backplane, PMCE-1553 uses the P4 connector for Ethernet based control and communications.
-
DS8831H -
Deviser Instruments
The DS8831H is a rackmount spectrum analyzer with the same specification as the portable DS8831Q. The 1U spectrum analyzer is designed specifically for monitoring applications and supports a LAN connection for remote access via PC. The RF multiplexer has a full 1 GHz RF performance and can be expanded to support 256 ports.
-
MI 2014 -
Metrel d.d.
Cable Scanner is easy to use LAN tester with wide variety of functions for fault finding and troubleshooting on IT cabling connections. TDR facility with adjustable NVP allows determination of distance to the fault or cable length measurement. Acoustic generator combined with a receiver enables pair determination in multi-pair cables.
-
34110A-11(10KW) -
PRODIGIT Electronics Co, Ltd.
34000A Series has its own control and display panel, CC / CR / CV / CP / Dynamic modes, 150 sets Store / Recall memory which provides load set-up more efficiently, also can be remote controlled via GPIB、RS232、USB and LAN interface.
-
34000C Series(6KW~24KW) -
PRODIGIT Electronics Co, Ltd.
34000C Series has its own control and display panel, CC / CR / CV / CP / Dynamic modes, 150 sets Store / Recall memory which provides load set-up more efficiently, also can be remote controlled via GPIB、RS232、USB and LAN interface.
-
CS-5000 Series -
IWATSU Electronic Co., Ltd.
*Max. Peak Voltage : 5,000V(HV mode)*Max. Peak Current : 1,500A(HC mode)*Equipped all models with LEAKAGE mode (Cursor resolution 1pA)*USB port for display hardcopy, waveform data (CSV format) and measurement setup SAVE/RECALL*LAN interface for Remote Control
-
CS-3000 Series -
IWATSU Electronic Co., Ltd.
*Max. Peak Voltage : 3,000V(HV mode)*Max. Peak Current : 1,000A(HC mode)*Equipped all models with LEAKAGE mode (Cursor resolution 1pA)*USB port for display hardcopy, waveform data (CSV format) and measurement setup SAVE/RECALL*LAN interface for Remote Control