Showing results: 76 - 90 of 190 items found.
-
Ion Science, Ltd.
ION Science OEM Gas Sensor portfolio offers market-leading photoionization technology, capable of detecting extremely low levels of volatile organic compound (VOC) gases, to be used alone or for successful integration into products.
-
Ion Science, Ltd.
ION Science recommends that your instruments are recalibrated on an annual basis to ensure they continue to provide you with accurate, reliable results and that they maintain their extended warranty. Choose the right calibration solution from our range below.
-
CI-IN128 -
Shanghai ChangAi Electronic Science & Technology Co.,Ltd
CI-IN128 oxygen analyzer is with ion current principle, which is capable of oxygen purity measurement range 0-10/100/1000ppm, 25%. - See more at: http://en.ci-ele.com/8aedb8bf-ef48-4f8c-127a-797c939a6181/ba0a71a9-7d65-03f5-b15e-d4bc86cbbbd7.shtml#sthash.4gq1qbYn.dpuf
-
ASE Sources -
Fibotec Fiberoptics GmbH
Fiber optic broadband light sources use amplified spontaneous emission (ASE) within optically pumped rare earth doped fibers. The spectral width of the light source can be determined by the developer in a range of a few nm to the full width of the emission spectrum of the active ion (eg, erbium ion). The optical power density of fiber optic ASE sources is typically higher than that of fiber-coupled broadband semiconductor light sources with simultaneously lower intensity noise (RIN). These properties, and the lack of resonator interference, of good incoherence make ASE sources a preferred instrument for use in metrology applications.
-
Kasuga Denki, Inc.
The electrostatic resistance of electronic devices is declining, and the number of ionizers installed is increasing. Ionizers cause deterioration of static elimination performance and imbalance of ions due to dirt and wear of the discharge electrode needle. Charging of electronic devices is also caused by ion blow. of an ionizer that is out of balance due to dirt and wear, and reaches a level that destroys advanced electronic devices.The atmospheric ion monitor measures the potential of the charging plate (detector), which has almost the same capacitance as the device's ground capacitance , with high accuracy, and is the most suitable measuring instrument for checking the effect when installing the ionizer and for daily management.
-
Rocky Mountain Laboratories, Inc.
Auger Analysis, Auger Electron Spectroscopy (AES or Auger) is a chemical surface analysis method. AES measures the chemical composition of the outermost 100 Å of a sample. Measurements can be made at greater depths by ion sputter etching to remove surface layers.
-
BMS -
Comemso
Efficiency, reliability and safety of modern lithium ion batteries for electric vehicle drives strongly depend on the battery management system (BMS) as their electronic control unit.
-
Bruker microCT
Innovations such as Trapped Ion Mobility (TIMS), smartbeam and scanning lasers for MALDI-MS Imaging that deliver true pixel fidelity, and eXtreme Resolution FTMS (XR) technology capable to reveal Isotopic Fine Structure (IFS) signatures are pushing scientific exploration to new heights.
-
SKZ1043 -
SKZ Industrial Co., Ltd
Used for the detection of index with potential capacity analysis, can be used as special instrument for the detection of penicillin, by measuring the change in electrode potential, to measure the ion concentration, widely used for the pharmaceutical industry, food industry, petrochemical industry, metallurgy, environmental protection, electroplating materials industry.
-
National Technical Systems
Chemical testing and analysis spans a wide variety of services, from ion chromatography to high voltage arc tracking. With the assistance of international standards for guidance, chemical testing can ensure regulatory compliance while also providing information about the chemical composition of product material.
-
GNL-2100 Series -
Shanghai ChangAi Electronic Science & Technology Co.,Ltd
GNL-2100 analyzer is the online intelligent measurement instrument, which adopting advanced ion current oxygen sensor with single chip technology. N2%=100%-O2%. It has been widely used in the fields of nitrogen separation from air, fertilizer, petrochemicals and biological fermentation.
-
Model 156A -
TREK, INC.
The Trek Model 156A Charged-Plate Monitor System is designed to provide quantitative measurements of the effectiveness of air ionization systems, as to audit ionizer performance. The Model 156A employs a revolutionary charged-plate monitor design that utilizes an ultrahigh-impedance, high-voltage follower to monitor the ion collecting plate voltage.
-
MR-3 -
Stefan Mayer Instruments
3-axis magnetic field cancelling system for electron microscopes (SEM and TEM), electron and ion beam experiments, nanotechnology, biomagnetic investigations, etc. High reliability through rugged analog design. No tedious programming, no chrashs. More than 1000 MR-3 systems sold worldwide.
-
CyberScan Ion 510 -
Thermo Scientific
Low Cost Plus High Performance - offers laboratory-quality readings for a very economical cost :: Multi-Point Push-Button Calibration (up to 3 points) with Auto-Buffer Recognition - choice of USA and NIST pH buffer standards for quick calibration with no calibration mistakes
-
Zero-Ion G3 -
Manncorp
For two decades, thousands of electronics assemblers have relied on the Zero-Ion cleanliness testing to verify the cleanliness of post-reflow printed circuit assemblies and bare boards. Over time, as PCB assemblies have become more complex and more densely populated with surface mount components, and as vigorous quality standards such as ISO, TQM and Six Sigma have become commonplace, the ability to meet—and confirm—cleanliness levels has grown in importance. The Zero-Ion ROSE tester has kept pace with customer requirements, and the Zero-Ion G3 is the most advanced Zero-Ion ever designed, capable of testing assemblies reflowed with any solder paste, including no clean—yet its also one of the most affordable cleanliness testers on the market as well, with performance and ease of use second to none.
