Filter Results By:
Products
Applications
Manufacturers
- InterWorking Labs, Inc.
product
Network Emulator
KMAX
The KMAX network emulator helps network engineers test and measure performance in order to identify and remove defects. Network emulators turn well behaved development and test networks into the kind of slow, congested, and less-than-reliable services encountered on the internet. In addition, unlike the real internet, network emulators allow the operator to control these conditions so that products and apps can be subjected to controlled and repeatable tests, by routing selected packets through a series of impairment nodes.
-
product
Extra-safety Auto Identify Multimeter with TRMS
VA51 VA51R
Shanghai Yi Hua V&A Instrument Co., Ltd. CO.,LTD
VA51/VA51R Extra-safety auto identify multimeter with TRMS.
-
product
Advanced Identify Friend Or Foe (IFF) System
Model MD500L IFF
Kratos Defense & Security Solutions, Inc.
The Model MD500L IFF Transponder is an L-Band augmentation device ideally suited for use in aerial target drones, unmanned vehicles, and cruise missiles as a radar enhancement device that provides automatic radar identification in response to interrogations from L-Band IFF and Air Traffic Control (ATC) radars. It also supports Mode C (altitude reporting) operation.
-
product
1553Guard
MIL-STD-1553 bus architecture is a threat that adversaries can leverage to compromise your equipment and spread malicious software through your Serial Data Bus (SDB) system. You need a solution that can not only identify current and future cyberattacks in real-time but also instantly eliminate those threats before they wreak havoc and interrupt the mission.
-
product
8:1 Distance-to-Spot IR Thermometer
UTLIR1
UEi Test & Measurement Instruments
The UTLIR1 Infrared Thermometer makes it easy to check the temperature of vents, various rooms, motor bearings, power panels and fuses. And a amazing variety of other applications. It includes laser sighting to help identify your temperature target. And is backed by a 1-Year limited warranty.
-
product
AC Resonance Test System
Shanghai Guantu Technology Co., Ltd.
AC withstand voltage test is an effective and direct method to identify the insulation strength of electrical equipment. During the operation of power equipment, the insulation will gradually deteriorate under the action of electric field, temperature and mechanical vibration for a long time, including overall deterioration and partial deterioration, forming problems. question.
-
product
Active Network Assessment and Monitoring Platform
Hawkeye
Keysight Network Applications and Security
Network performance and user experience are critical aspects of your business. It is vital to understand customers’ perception of your website, application, and network services. NOT knowing impacts your revenue stream. Ixia’s Hawkeye continually measures network performance and service status. If there is an issue, Hawkeye helps you identify it, quantify it, and ultimately resolve it – before your customers experience it.
-
product
Advanced High-Performance Logging & Tracing for .NET, Java & Delph
SmartInspect
SmartInspect is an advanced .NET logging, Java logging and Delphi logging tool for debugging and monitoring software applications. Identify and fix software bugs faster. Monitor and analyze applications in real-time. Find solutions to user-reported issues. Debug production systems while they run.
-
product
Advanced IR Gas Analyzer For Process Monitoring
T-Series
T-Series Inline Gas Analyzer improves gas measurement accuracy over the traditional non-dispersive infrared (NDIR) analyzers using Tunable Filter Spectroscopy (TFS™), a spectroscopic scanning technique capable of generating slices of spectra in the infrared region. Each scan produces an absorption spectrum which is used to identify compounds and provide concentration values. TFS technology improves gas identification accuracy and selectivity by subtracting out spectra from interferent gases within the same infrared regions. This spectral processing capability also provides multi-component measurement.
-
product
Advanced Laser Source
SLS-50
SLS-50 can generate highly stable optical signals at multiple wavelengths to precisely measure optical link loss and identify optical fiber paired with ShinewayTech OPM-50 Intelligent Optical Power Meter.
-
product
Advanced PM
OPM-50
OPM-50 paired with SLS-50 Intelligent Stabilized Laser Source can be used to identify fiber, measure attenuation and loss, verify continuity and evaluate fiber link transmission quality.
-
product
Advanced Traffic Monitor
Datarec Loop Monitor
Vehicle and bicycle detection is based on inductive-loop technology for accurate counting. It utilizes inductive pattern recognition to identify which type of vehicle is passing, providing a precise classification. The product can be delivered as a stand-alone traffic counter or as an advanced part of a complete traffic monitoring system.
-
product
Advanced Vehicle Classifier
Datarec 7 Signature
Traffic registration is based on inductive-loop technology that also utilizes inductive pattern recognition to identify which type of vehicle is passing, providing a precise classification. The product can be delivered as a stand-alone traffic counter or as an advanced part of a complete traffic monitoring system.
-
product
Air Core Inductors
Osborne designs our Air Core Inductors to realize their advantage of high linearity. We also work with our clients to identify and mitigate any potential disturbances that could result from electromagnetic fields created. The air core design approach is known to create strong electromagneticfields. Osborne develops electromagnetic circuit models, if necessary, to ensure that our clients build effective and reliable circuits.
-
product
Air Data Computer (ADC) Tester
MS 1122
The ADC tester is used in 2nd line maintenance is to check the functionality of ADC. This unit is a rugged customized hardware based on full functionality test of ADC. The Air Data Computer (ADC) Tester is a fully automated GO/NOGO tester with full functional testing in 2nd line maintenance. This tester is to test ADC at unit level and identify faulty Shop Replaceable Unit (SRU). This tester is also used to carry out PI checks on ADC before clear them for installation on aircraft. ADC Interface board designed to test full functionality of ADC. The Air Data Computer (ADC) test equipment shall be used for testing ADC of Tejas Aircraft. ADC test equipment shall verify the functionality against specifications during second line maintenance and pre-installation on the aircraft.
-
product
All-Purpose Radionuclide Identification Device
identiFINDER® R4xx Series
With over 20,000 devices deployed globally, the identiFINDER® R400 is the most widely deployed handheld radionuclide identification device (RID) in the world. It is used to detect, locate, measure, and identify radioactive sources and produces rapid visible, audible, and tactile alerts that expedite response measures. The identiFINDER R400 provides operators the ideal balance of size and weight for a wide variety of monitoring scenarios including all-purpose surveying, emergency response, and environmental monitoring.
-
product
Alpha Spectroscopy
Alpha spectroscopy is used to identify and quantify radionuclides based on the alpha particles emitted in the decay process. Similar to Gamma Spectroscopy, energy spectra are generated with high precision detectors and electronics and analyzed with special software. Typically, samples are measured following chemical separation to isolate the radionuclides of concern due to the complexity associated with correcting for these interferences with spectrum analysis software as is common for many Gamma Spectroscopy measurements.
-
product
Analyze RTL
ASICs and FPGA routinely have millions of gates with memories, transceivers, third party IP and processor cores. Problems can be time consuming and complex to debug in the lab and through simulations. Designers need verification tools that can identify problems quickly to reduce their verification and debug time before simulation, before synthesis, and definitely before burning chips in the lab.
-
product
Ancillaries - Radiated
EMC emissions can be at very low signal levels and pre-amplifiers can help to improve S/N ratio. The low level of emission signals can make them difficult to identify in noisy environments. RF filters are designed to attenuate the major sources of noise, thus making the task of measurement easier.
-
product
Application Monitoring Tool
Strong application monitoring tool enables IT teams, to get thorough insights into application health and response-time data. Go proactive with Motadata, which is one of the best application performance monitoring tools (APM) to identify potential threats that might bring operations down and fix the issue before it becomes a problem. Real-time metrics dashboard helps you stay on top of your application performance. Resolve application performance management issues before they impact your users or customers.
-
product
Application Penetration Testing:
Penetration testing (or pen testing) is a simulated security exercise in which ethical hackers attempts to exploit the vulnerabilities of an application system (web or mobile). The objective of this exercise is to identify any possible loopholes present in the system’s defence mechanism which the real hackers could take advantage of. QA Mentor practices the following stages while exercising this:
-
product
Application Security Platform
Sentinel
WhiteHat Sentinel is a Software-as-a-Service (SaaS) platform that enables your business to quickly deploy a scalable application security program across the entire software development lifecycle (SDLC). Combining advanced scanning technology with the world’s largest application security research team, we accurately identify your vulnerabilities and scale to meet any demand without slowing you down.
-
product
Arc Flash Analysis
ETAP Arc Flash Analysis allows you to identify and analyze high risk arc flash areas in your electrical system, and it also allows simulation of several different methods used by engineers to mitigate high incident energy.
-
product
Artificial Intelligence And Machine Learning Testing
AI and ML testing framework can efficiently recognize pitfalls and with constant updates to the algorithms, it is feasible to discover even the negligible error. Essentially, Artificial Intelligence (AI) and Machine Learning (ML) tech are well-trained to process data, identify schemes and patterns, form and evaluate tests without human support. This is made possible with deep learning and artificial neural networks when a machine self-educates based on the given data sets or data extracted from an external source such as the web.
-
product
ASI Test Equipment
ASI has designed its own line of aviation electronics test equipment utilizing modern design and manufacturing techniques. Being primarily a service facility, ASI is able to identify what type of test equipment is required in the avionics field from a service technician's view. This equipment is designed with the technician in mind, for ease of operation and maintenance.
-
product
Atlas SCR Thyristor and Triac Analyser
SCR100
Thyristors and Triacs need special test conditions to analyse effectively - that's where the new Atlas SCR comes in. The SCR100 can apply gate test currents from 100µA up to 90mA (with test load currents of up to 100mA) so it's not limited to sensitive parts.It will automatically identify the type of part (Thyristor or Triac), identify all three leads and also categorise the gate sensitivity. This new version takes a standard Alkaline AAA battery.
-
product
Auto Circuit Tracer
7411
Peaceful Thriving Enterprise Co Ltd
Find short and open circuits quickly and easily in DC circuits from 6-42V. Designed to identify and trace wires or cables without damaging the insulation.
-
product
Automated AC Digital Hipot Tester
Educated Design & Development, Inc.
1 button testing - No setup required, just plug right in! Or, make a plug for your cordless product, and plug right in! EASY!Easy to identify PASS / FAIL visible and audible indicationAuto Test Time (1 sec. / 60 sec.)+ - No need to set a timer or clock watchSafety Protected Start Switch -- Protects user from shock!Performs the Low Current Ground Continuity test at the same timeMeets UL, CSA, CE, EN, IEC, MIL and all other international safety agency requirements as well as UL 120Kohm requirementsIncludes ISO/IEC 17025 Accredited Calibration Certificate, accredited by ACLASS (Internationally accepted results... equivalent to A2LA)
-
product
Automated Screenshots of Webpages for Accelerated Layout Testing
Auto-generate full-paged screenshots of your webpages across multiple devices, operating systems, browsers, and resolutions - in a single go! LambdaTest Automated Browser Screenshot feature accelerates your UI and Layout testing helping you quickly identify layout issues across browser versions and screen sizes.
-
product
Automated Shock Test Systems
AutoShock-II Test System
The AutoShock-II is a fully automated series of shock test systems used to measure and identify product fragility levels and evaluate protective packaging. With the simulation of real world shock pulses and impact energy levels, manufacturers can systematically test and optimize product design and packaging. L.A.B. Equipment, Inc.''s fully automated computer controlled shock and data analysis test systems are the critical path in accomplishing this optimization.
-
product
Automotive Electronic Stethoscope
77109
Helps to identify engine and chassis noise. Maintain all health and safety precautions whilst using on running engine. Helps to identify engine and chassis noise. Powered by a 9volt battery (not supplied). Complete with headphones and volume control. CE certificated.
