Showing recent results 271 - 285 of 594 products found.
-
EW-86417-00 - Cole-Parmer Instrument
Ultrasonic leak detectors have a decided advantage over conventional leak detectors?they ?listen? for leaks and alert you to their presence. There is no gas sensor to become clogged or faulty, and no gas interferences to worry about.
-
First Sensor AG
Silicon photomultipliers (SiPMs) from First Sensor are innovative solid-state silicon detectors with single photon sensitivity. SiPMs are a valid alternative to photomultiplier tubes. The main benefits of these detectors are high gain, extremely good timing performance and low operating voltage. They are insensitive to magnetic field and have a high integration level. The detectors are optimized for Near Ultraviolet (NUV) light detection.
-
Pony Industry Co.,Ltd
Up until the introduction of SID-A50, X-ray inspection systems has been using detectors such as Image Intensifier (I.I.) and C-MOS Flat Panel Detectors, which needs to convert X-ray into optical light first, in order to visualize X-ray.These Indirect Conversion Method X-ray Detectors comes with multitude of issues. These problems include but not limited to; Low Sensitivity, Fuzziness, Time Degradation, Inadequate Life
-
XIA LLC
The microDGF is a variant of the highly successful microDXP, with the analog front end upgraded specifically for high resolution gamma spectroscopy with HPGe detectors. Premium energy resolution is achieved with HPGe detectors, even at moderate to high count rates.
-
TL105 - MSA
The TL105 is a battery operated test lamp designed specifically to test General Monitors Flame Detectors. The TL105 is an explosion-proof test lamp that can be used with the FL4000H MSIR flame detector as well as any of the FL3100 Series Flame Detectors.
-
-
-
ORM400 - Bentham Instruments Ltd
The ORM400 Optical Radiation Meter has a USB 2.0 interface and is supplied with powerful calibration features and data display functions. It is ideally suited to display the measurements from the DH400 range of detectors as well as third party current generating detectors.
-
270 - Elcometer Limited
The Elcometer 270 Pinhole Detectors Inspection Kit utilises the wet sponge technique and has been designed to set a new standard for wet sponge detectors - a high quality, low voltage detector with similar accessories to a high voltage spark tester.
-
First Sensor AG
Silicon photomultipliers (SiPMs) from First Sensor are innovative solid-state silicon detectors with single photon sensitivity. SiPMs are a valid alternative to photomultiplier tubes. The main benefits of these detectors are high gain, extremely good timing performance and low operating voltage. They are insensitive to magnetic field and have a high integration level. The detectors are optimized for Near Ultraviolet (NUV) or red, green and blue (RGB) light detection with peak sensitivities at 420 nm or 550 nm.
-
IMR Environmental Equipment, Inc.
Leak Monitors and Leak Detectors for Refrigerants and Combustible Gases. Refrigerant Leak Monitors are continously operated systems that monitor the ambient air for refrigerants and are used for safety compliance and/or leak reduction. Portable Leak Detectors can be used to find leaks in various HVAC-R applications.
-
2713 PU - Standard Electric Works Co., Ltd
● Designed to proof: -Phasing sticks. -High voltage detectors (contact type only, not to be used with non contact proximity detectors.) -High voltage and voltage testers.● Battery operated.● Led indicates when power is “ON”.● Small and hand-held.● Quick connection with normal 4mm test leads.
-
H 6000 - ATEQ Aviation
The H 6000, a new comer in the ATEQ range of leak detectors, is one of the finest gas tracer and hydrogen leak detectors on the market today.This gas is less expensive than Helium gas. Furthermore, it's a volatile, non-toxic and nonpoisonous gas without any environmental impact.
-
SDi
UL ListedReduces false alarms a huge problem in the industryBattery operated and easily portableSimple to useSuits most detectors both ionization and photoelectricCalibrated and results in % / ftAutomatically self-calibrates before each testMeasures actual detector sensitivitySelf calibrates before testingTest detectors in place. No need to remove detector
-
CELL03 - SDi
SDi offers a wide range of alarm component test tools to compliment our detector test equipment. These tools include devices for testing auxiliary components of alarm systems, such as batteries and audible appliances, as well testing solutions for more specialized fire detectors, such as duct and flame detectors.
