Showing results: 1141 - 1155 of 5366 items found.
-
RMO-H -
Amperis sl
The RMO-H is a portable, battery-operated micro-ohmmeter based on state-of-the-art technology, using the most advanced battery mode and switching technique available today. The high-capacity Li-Po battery allows the generation of a ripple-free DC current of up to 300 A. The test current is user-selectable and generated in an automatically regulated test ramp. During the test, the RMO-H increases the current before the measurement and decreases it afterwards. This significantly reduces magnetic transients.
-
Part No. LPD60a -
Teledyne Defense Electronics Relays & Coax Switch
The LPD60a is a dual-output 28Vdc plastic relay with internal thermal protection. The relay utilizes optical isolation to provide excellent input-to-output isolation. The LPD60a offers a current limiting output to protect itself and associated load circuits from transient current overloads. During an overcurrent condition, the LPD60a clamps the current to a safe operating value.MSL 6Available options include:LPBD60a 0.25Adc, 28Vdc Load; 4-7Vdc Control;
-
Chroma ATE Inc.
Regenerative battery energy dischargeEnergy savingEnvironment protectionLow heat generateChannels paralleled for higher currentsCharge / discharge mode (CC, CV, CP) Constant current Constant voltage Constant powerDriving cycle simulationHigh precision measurement accuracyFast current conversionSmooth current without over shootTesting data analysis functionData recovery protection (after power failure)Independent protection of multi-channelBMS data recordingThermal chamber control integration
-
40-183-011 -
Pickering Interfaces Ltd.
The 40-183 supports 6 off high current SPST switches into two slots of PXI chassis. Each SPST switch uses a fully isolated solid state relay which has been designed to offer fast operation under hot switching conditions and high inrush current with no operational life degradation. Each SPST switch can support 30A of continuous current and switch up to 40V signals.
-
Digitrax, Inc
.672” x 1.074” x .259” 17.08mm x 27.28mm x 6.6mmDigitrax Easy Connect 9 Pin Harness1.5 Amp/2 Amp Peak Current Rating6 FX3 Functions, 0.5 Amp Total Function Current Rating
-
KT-3084 -
KILTER ELECTRONIC CO.,LTD
Digital clamp meter designed for leakage current measurement. Least affected by external stray magnetic field. The minimum resolution is 0.1mA. Four AC current ranges:400mA/4A/40A/400A. Data hold function,peak hold function
-
PA60Bi -
Ponovo Power Co., Ltd.
PA60Bi is the panel-mounted power amplifier, which can produce 3-phase current, with maximum RMS phase current of 60A and maximum output power of 800VA, and 4-phase voltage, with maximum RMS phase voltage of 120V and maximum output power of 60VA.
-
Landt Instruments, Inc
The multi-current range battery test systems M340A and G340A are designed for precision battery charge/discharge test, coulombic efficiency (current efficiency) test and supercapacitor test. Voltage and current test accuracy go down to 0.01% of the selected range.
-
40-194A-001-HI -
Pickering Interfaces Ltd.
The 40-194A-001 is a 7-Channel PXI Fault Insertion switch with hardware interlock and one fault bus, designed for the simulation of fault conditions in automotive systems. As well as high current handling of 20A, very low currents can also be switched.
-
MT305-804 -
ALTINEX, Inc.
HDMI input/outputsHDCP compliantSignal Status LEDsFull matrix400mA Output Current
-
-
-
U60 -
LEMSYS
To measure leakage current ID, IR at given voltage range.
-
SK-6597 -
Kaise Corporation
Current measurement up to AC / DC 400mA.Penlight and backlight LCD.
-
369A910 -
Di-Log
The only check box to provide comprehensive verification of 17th Edition and PAT test equipment. The Powercheck tests for full earth continuity, insulation, resistance, RCD trip time, RCD trip current, touch current and flash test verification.