Showing results: 2431 - 2445 of 5366 items found.
-
HPC40 -
AMETEK Sensors, Test & Calibration
The HPC40 Series handheld pressure calibrator is the world's first combined pressure and mA loop calibrator to be fully temperature compensated from -20 to 50°C. You can count on the same accuracy whether measuring pressure, current, voltage, or temperature.
-
FTI 5000 -
Focused Test, Inc.
FTI 5000 performs Safe Operating Area (SOA) tests on power devices, such as MOSFET, Bipolar Transistor (BJT), Thyristor and IGBT. The SOA test is defined as the voltage and current conditions over which the device is expected to operate without damage.
-
AK-30 -
Amperis sl
AC voltage source with 4 channels, current source and aux with 6 channels. DC source can be used simultaneously. Amplitude, frequency and phase angle can be adjusted respectively, independently and continuously; Control via PC via Ethernet RJ45 interface
-
STMicroelectronics
A.S.D. (Application Specific Discretes) technology is a vertical integrated power technology using a full planar process. By applying the masking process on both sides of the chip, higher current density is achievable than is possible with epitaxial base or horizontal structures.
-
i6A Series -
TDK-Lambda Corp.
*1/16th Brick Footprint*9-40 Vdc, 9-53 Vdc Inputs*3.3 up to 40, -3.3 to -30 Vdc Outputs*Up to 20 A max Output Current*Non-Isolated*Remote ON/OFF, Sense, Power Good, Trim*Sync, Sequencing
-
RGA Series -
TDK-Lambda Corp.
*1/16th Brick Footprint*9-40 Vdc, 9-53 Vdc Inputs*3.3 up to 40 Vdc Outputs*Up to 20 A max Output Current*Non-Isolated Step-Down*-40 to 110 °C Case Temperature*Rugged 5-sided Aluminum Case
-
LET-400-RDC -
EUROSMC, S.A.
The LET-400-RDC is designed to perform most of the primary tests that are necessary in substations commissioning. It allows to perform with sufficient power, all the primary current injections to test the proper function and wiring of all the elements that compose the protection and measuring section in a substation.
-
M-280 -
MULTI MEASURING INSTRUMENTS Co., Ltd.
*30mmφ CT window and ultra compact size.*Conform to IEC safety requirements.*Low cost and multi-function clamp tester.*Max. and Min.hold function.*Data-hold function and auto power off.*Auto zero adjustment for DC current offset.
-
CS-8000 Series -
IWATSU Electronic Co., Ltd.
The CS-8000 series are equipped with a high-voltage source of up to 5 kV and a high-current source of 2 kA. It features Pulse output, Gate pattern, and very small current measurement capabilities, and it supports the design evaluation of wideband-gap semiconductors such as SiC and GaN.
-
ISL21080 -
Renesas Electronics Corp.
The ISL21080 analog voltage references feature low supply voltage operation at ultra-low 310nA typ, 1.5µA max operating current. Additionally, the ISL21080 family features guaranteed initial accuracy as low as ±0.2% and 50ppm/°C temperature coefficient.
-
Model PMD-503E -
tecsis LP
Programmable meter display, 7-segment, 0.31", 5 digits, Panel mount, 1/8 DIN standard, larger cutout for optional metal case, for pressure/load sensors, 0.5 to 20 mV/V strain gage, optional voltage DC or AC, Current
-
Model PMD-50E -
tecsis LP
Programmable meter display, 7-segment, 0.56", 5 digits, Panel mount, 1/8 DIN standard, larger cutout for optional metal case, for pressure/load sensors, 0.5 to 20 mV/V strain gage, optional voltage DC or AC, Current
-
H62004700 -
6TL Engineering
This module is ideal for switching up to 12A. Composed by eight relays organized in two trees of four with two relays (One in each tree) with NC contact available. The module is shielded in order to reduce the radiated interference in high current switchings.
-
Hilkar
Neutral Earthing (Grounding) Reactors, which resist current flow through inductive elements, are single phase reactors generally connected between ground and neutral of transformers or generators in order to control single line-to-ground faults at a desired level.
-
FlowTracker Handheld-ADV® -
SonTek
Designed with the field user in mind, the FlowTracker Handheld-ADV (Acoustic Doppler Velocimeter) measures 2D or 3D currents, attaches easily to wading rods, and features an automatic discharge computation using a variety of international methods, including ISO and USGS standards.