Showing results 1 - 15 of 440 products found
-
Company: Monacor International
LED fault indicator, per contact via selector switch adjustableAudible and visual continuity check via enclosed LeadsLED battery status indicatorRobust ...
-
-
-
-
-
Company: Sefelec
Synor cable tester range is an ate (automatic test equipment) dedicated for testing electrical wiring harnesses, backplanes or cables
-
Company: B2 High Voltage
The HVA94 cable tester by b2hv is a portable 0.1 Hz VLF cable test system for the testing of medium and high voltage cables.With its weight of 128 kg the hipot tester provides an excellent power-to-weight-ratio.
-
Company: AEMC Instruments
AEMC's line of hand-held cable testers provides direct and simple push button operation. The testers indicate faults, cable length, common wiring faults and more. All models feature a large, blue electroluminescent backlit display.
-
Company: Sanshine Electronis
The SS8681 series cable tester is used for test and measure wire cable harness, wire harness, like as: auto cable, audio cable, power cable, network cable, telephone cable, USD cable, HDMI cable, video cable, etc. Up to 700Vdc/500Vac Test Voltage. 512 Max test points.
-
Company: Whirlwind
This versatile cable tester checks many varieties of audio cables. It tests most cable combinations of XLR, 1/4" or RCA Phono plugs for shorts, opens, and polarity reverse. The handsfree design allows manipulation of the cable to locate intermittents.
-
Company: Triplett
This is the perfect tester for UTP Cables and LAN devices. Test; speed parameters, cable propagation delay, cable skew, cable typing (Cat 3, 5, 5E, 6), attenuation, cable verification, high accuracy TOR, LAN device tester (advertised and negotiated). RWC also performs basic testing for coax cables. Comes with Tone Generator/Probe.
-
Company: EMO Systems Canford
DMX protocol is a standard means of controlling lighting dimmers remotely from a control desk. The standard uses a three wire connection using 5-pin XLR type connectors. These adapters allow the E445, E446 and E447 table testers to be used to test the primary circuit of such cables. Two adapters are required for each cable tester.
-
Company: Pansco Ltd
The plug‵N′check is our easiest-to use cable tester yet. Simply plug in both ends of a cable, and the easy-to-read LED display explains the cable type and checks whether cable is faulty or good automatically. A shield LED shows results of the shielding check and battery low indicator saves you from misreading the tester in case of low power. Will make work shorter and easier for the layman and the professional alike. Especially suited for installation and maintenance of residential networks.
-
Company: Pansco Ltd
The PH-04 is an easy-to-use tester for UTP/STP cables and BNC coaxial cables, featuring a remote unit that lets you test already-installed cables. It features a tone generator which, used together with a tone probe (not included), allows you to trace cable from source to destination quickly and easily.
-
Company: IDEAL Networks
The LinkMaster Tester consists of two units. The main unit is connected to one end of the cable to be tested and the remote unit is connected to the jack at the far end of the cable (wall outlet, patch panel port, etc.)
-
Company: Whirlwind
This diagnostic cable tester has connectors for analyzing almost any type of cable combination. The convenient rotary switch allows testing of each conductor within the cable and can determine the internal wiring configuration. Tests NL4, 5 pin DIN, BNC, XLR, TRS, RCA and 3.5 mm types.
