Filter Results By:

Products

Applications

Manufacturers

AC Clamp Meters

measures AC voltage and current without contacting condutors.


Showing recent results 61 - 64 of 64 products found.

  • Clamp Meter

    KT7160 - Ketai instrument (kunshan) Ltd.

    *Analogue current clamp meter in a handy and compact housing *8 ranges in 4 functions *AC current measurement up to 300A(±5% full scale) *AC voltage measurement up to 600V(±5% full scale) *Resistance measurement up to 200kΩ(±5% full arc) *Temperatur measurement up to 150° C/300 ° F *Maximum jaw opening 20 mm *Power supply: 1×1.5V,IEC LR03/AAA *Fuse 0.5 A/250V *EN 61010,CAT II/300V

  • Energized Cable Sensor

    Hubbell Power Systems Inc

    The purpose of the Energized Cable Sensor is to allow the lineman to readily determine whether a URD cable is energized. The sensor consists of an amplifier which is designed to give a meter reading when the small AC voltage between the semi-conductive sheath and the concentric neutral of the energized URD cable is applied to the test probe. The amplifier is housed in a rugged phenolic case. Sensor may be used to check for energized condition on concentric-neutral cable below an elbow without test points. At cable mid-span (left), hose clamps bridge all strands of concentric neutral at the test location. Sensor’s neutral lead clips to one of the hose clamps. Tip on probe lead contacts only semi-conductive cable sheath to test for voltage presence.

  • AC/ DC mA Current Clamp-on Transducer

    CA-60 - Tecpel Co., Ltd.

    This miniature clamp meter features two Hall effect sensors. For use with any multimeter with 200mV or/and 2V ranges for direct readout input impedance of least 1M ohm. High conversion factor for low DC and AC mA measurement. With the small jaw size it can fit into tight space in circuit panel or wire bundle to take the reading.

  • PC Controlled Bench Top Power Analyzer

    PA2100 - Powertek LLC

    The PA2100 is a PC controlled bench top power analyzer, allowing several electrical power measurements to be taken simultaneously during testing - from just one set of input connections. The PA2100's power measurement ability is a must in research and development, manufacturing and required for certification and traceability of manufactured goods. In addition to power measurements, apparent power (VA), harmonics, voltage, current, power factor can all be viewed and stored with ease. The PA2100 wattmeter simply connects between the ac supply and the load, various current transformer options allow measurement with any size of current from 10mA to 10000A. Typical watt meter applications include appliance testing; microwave ovens, electric stoves, heating, air conditioning, TVs, monitors, computers, electronic lighting, fans and motor controllers. Powertek wattmeters are equipped with 4mm/banana safety terminals along with optional "breakout" boxes and clamp current probes for fast and safe measurement.