-
product
Monitoring & Drive Test Antennas
Linear polarized half-wave dipole with 1:1 balun and fixed element length for fieldstrength measurements at TETRA (terrestrical trunked radio) networks.
-
product
PM 2.5 Indoor Air Quality Monitor
This meter can make 5 measures of air quality once a time, including CO2, PM2.5, PM10, temperature and humidity.
-
product
Temperature Monitor
SIM922A
Stanford Research Systems, Inc.
The SIM922A has a programmable, precision 10 µA current source to provide sensor excitation. Results can be displayed in either kelvins or volts.
-
product
Clamp type AC Current Sensor／for Power Monitor
ZCT-23
MULTI MEASURING INSTRUMENTS Co., Ltd.
*Compact size*AC 0.1A～120A*Current measurements of terminal feeder
-
product
Power Monitoring Kit For SAR System Validation
PMK
Test labs have a daily requirement to ensure SAR measurements are highly accurate. SAR systems must be vigorously checked to ensure the measuring accuracy meets the system manufacturer uncertainty budget. The PMK features technologies usually found in more expensive equipment at an affordable price. The ability to measure the S11 parameter for dipoles and antennas while continuously monitoring their linear behaviour differentiates the PMK from other systems. The ART-Fi PMK is an all-in-one solution that requires only three connections to perform automatic, highly precise validations and verifications. The lack of moving parts also leads to improved durability and fewer bugs, faults, and workarounds.
-
product
Ground Fault Protection Monitors
The Earth Fault Resistance Monitor (EFREM) and the Rotor Health Monitor (RHM) provide wireless rotor ground fault and temperature monitoring for generators and motors. The systems replace older slip ring contact ground fault detectors on any synchronous generator or motor.
-
product
Snap-on RF Current Monitoring Probe
TBCP2-250
The TBCP2-250 is a snap-on RF current monitoring probe. The probe has a very flat response with a 3dB bandwidth of 250 MHz and is characterized over the frequency range from 30kHz to 300 MHz. Upon request, it can also be supplied with a test protocol covering the frequency range 1 kHz to 350 MHz. The aperture of the RF current monitoring probe is 32 mm. Its transfer impedance is > 12 dB Ohm in the range from 700 kHz to 300 MHz.
-
product
Process And Chamber Monitoring Software & Systems
MKS process and monitoring solutions feature real-time, web-enabled, hardware, software, and systems to support a variety of tools and processes. These solutions improve performance and yield while reducing tool damage and false alarms.
-
product
Granville-Phillips® 835 Vacuum Quality Monitor System
The Granville-Phillips® Series 835 Vacuum Quality Monitor (VQM™) combines the highest performance gas analysis technology with intelligent functional design that transforms complex measurement into actionable information. The 835 VQM is the world's fastest, lowest power mass spectrometer with full data collection, spectral deconvolution, and data logging at 85 ms capture rates for the full 1-145 amu measurement range or 125 ms for 1-300 amu.
-
product
Solar Monitoring Stations
EKO Instruments unique Solar Monitoring Station (SMS) is the primary reference to collect high quality solar irradiance data on-site. The innovative turn-key system provides all fundamental solar radiation and meteorological parameters for PV site evaluation, performance monitoring and cell optimizing.
-
product
3 Phase Power Monitors
The PM7000 portable monitor, the PM7503 panel mounted monitor and the PM7000 Fault Level Monitor have 4 current inputs and 4 voltage inputs while the PM3000 portable monitor has 3 current and 3 voltage inputs. All 4 different models record data using our patented Single Cycle Adaptive Store recording regime whereas the PM7000, PM7503 and PM7000FLM also have 3 other unique and distinct recording regimes:
-
product
Industrial Panel Mount Monitors, PCs, and HMIs
Explosion- Proof HMIs Corvalent Panel Mount all-in-one system HMIs are water, dust, and explosion-proof. Our Explosion-Proof Industrial HMIs are compliant with IP66, NEMA 4X, and C1D2 standards and are the best solution for environments prone to explosion. -Visio Z15R-XP Explosion-Proof -Visio Z19R-XP Explosion-Proof -Visio Z21.5R-XP Explosion-ProofAll-In-One Industrial HMI Displays Corvalent’s full line of Industrial HMIs is rated IP65 to IP69K, as well as ATEX Marine. These all-in-one HMI systems are available in a wide variety of display sizes, ranging from 7“ to 21.5“.Industrial Panel Monitors Corvalent’s Industrial Panel Monitors are built with the highest quality materials. They are rated ATEX Marine, as well as IP65 to IP69K. Industrial Panel Monitors are available in display sizes ranging from 7” to 21.5”.Industrial Panel PCs Corvalent’s Industrial Panel PCs are built with longevity in mind. They can withstand the stresses an industrial environment places on technology rated IP65 to IP69K and ATEX Marine. -Visio PPC-17RES -Visio PPC-19RES -Visio PPC-21RES -Visio PPC-24PCT
-
product
Fiber Optical Monitoring Alarm System
FOMA
FOMA (Fiber Optical Monitoring Alarm System) is integrated RTU (Remote Test Unit) 、Center Monitoring Server and its management software to achieve integrated operation、remote management、unattended monitor、periodic fiber scan、predictive analysis and support the instant fiber with status information and alarm warning, accurate of long-term fiber data record.
-
product
Low-PIM, Low-Power Filter Solutions for Monitoring Broadband Emissions
Bandpass/Bandstop, Notch, and HighpassCompact Design for Rack Mounting of Several BandsSuitable for Monitoring Emissions from Semiconductors,TX/RX Chipsets, SAW/BAW Filters, Cell Phones,Printers, PDA’s, etc.
-
product
AS-Interface Power Supplies and Monitors
*High noise immunity and electromagnetic compatibility*Wide input voltage range*Excellent short-circuit and overload protection*Excellent power reserve*Robust metal housing for secure mounting
-
product
Monitoring Solar Panel Strings, DC 30A, Φ10mm
CTF-30-10DC
MULTI MEASURING INSTRUMENTS Co., Ltd.
・Compact, Space-saving, Low Cost DC Current Sensors.・Split-core type, easy to apply to existing circuit.・Easy to use by unipolar +5V power supply.・High speed responsibility – less than 10μsec. 0 rated primary current.・Suitable for monitoring solar panel strings.
-
product
Wireless Temperature Monitor
VAT820-CO2 / VAT820-CO2-VOC99
Shanghai Yi Hua V&A Instrument Co., Ltd. CO.,LTD
Indoor air quality monitor :CO2 monitor , indoor air quality including CO2,VOC temperature ,humudity.
-
product
Electrical Resistance (ER) Monitoring
The electrical resistance (ER) technique is an "on-line" method of monitoring the rate of corrosion and the extent of total metal loss for any metallic equipment or structure. The ER technique measures the effects of both the electrochemical and the mechanical components of corrosion such as erosion or cavitation. It is the only on-line, instrumented technique applicable to virtually all types of corrosive environments.
-
product
Wired Hazard Monitoring
Grain dust is extremely volatile and can easily explode with the proper ignition source in confined spaces. OSHA has mandated that grain elevators in Class II, Division 1 environments must have the 3 monitoring sub-systems for elevator safety (1910.272(q)(4)(ii), 1910.272(q)(5), 1910.272(q)(5)).
-
product
Power Transformer Monitoring
Optimize the efficiency of your transformers by relying on our flagship DGA monitoring system with long-term stability, no maintenance needs, no false alarms and a revolutionary method for detecting ambient air ingress.
-
product
Vibration Monitors
Monitor vibration with these full-featured modules, available in portable and standard formats.
-
product
Dust Monitors
Kanomax USA offers highly accurate and convenient dust monitors for various applications, including our Digital Dust Monitor and Piezobalance Dust Monitor. These instruments provide solutions for things like construction dust monitoring, machining particle monitoring, and oil mist monitoring.
-
product
Water Monitoring Modules
Unidata offers a wide range of instruments to suit the measurement of conductivity, evaporation, water depth and temperature. In addition to those water instruments, Unidata also offers Starflow QSD ultrasonic Doppler velocity and depth SDI-12 Instrument.
-
product
CARGOMASTER® – Monitoring and alarm software
The CARGOMASTER® system provides measurement of all relevant data.
-
product
Vibration Monitors
VS1 / VS2
Features • VS1 protects against excessive vibration levels • VS2 is ideal for use deliberately vibrating machinery • Settable RMS vibration velocity alarm trip-point and delay time • LED’s provide an instant view of machine status • Isolated SPDT relay output or transistor output • 24 VDC (18-30 VDC) powered
-
product
Kafka Monitoring With RTView®
RTView Enterprise provides turnkey Kafka monitoring with pre-built dashboards. With over 30 pre-defined alerts and over 15 pre-built monitoring dashboards, users can deploy quickly without the time, skill and expense necessary to build or configure their own monitoring applications or dashboards.
-
product
Monitor Holder for 19" Rack Installation
ZZ-0017-01
- Monitor holder for 19 “rack installation- 9 U (400 mm)- Can be used universally with LED, LCD and plasma monitors- Compatible with the VESA standards 75 x 75 and 100 x 100 mm- Record in portrait and landscape format
-
product
MultiGas™ TFS™ Gas Monitor For Multi-Compound Gas Analysis
The MultiGas™ TFS™ Monitor is an online, multi-compound, trace gas monitoring system in a stand-alone 19-inch rack enclosure. It uses an innovative tunable filter spectroscopy technology enabling high selectivity and stability measurement. Low detection limit (sub-ppm levels for most gases) is achieved through the use of high throughput optics coupled with a long-path gas cell and a high sensitivity detector.
-
product
Explosion Proof Area Hydrogen Monitor
HY-ALERTA™ 2620
H2scan’s 2620 Explosion Proof Area Hydrogen Monitor provides hydrogen-specific leak detection and measurement for hydrogen concentrations as low as 4000 ppm and can be scaled to any concentration up to 5% hydrogen by volume, a range representing 10% to 125% of hydrogen’s low flammability limit. The monitor is designed for either ceiling or wall mount. H2scan’s hydrogen-specific sensor technology has no cross sensitivity to other combustible gases, thus eliminating false positive alarms and ensuring safety system reliability.
-
product
Dissolved Oxygen Monitor in Low Concentration
HD-960L
High stability measurement dissolved oxygen in low concentration HF. Automatically switches between three measurement ranges from μg/L to mg/L. Measurement range : 0 - 20.00 mg/L.
