Sensors
detect a physical event then translate to a representative analog signal.
See Also: Measurement, Detectors, Meters, Transducers
-
product
PCI Resistor Card 2-Channel 2 Ohm To 65.5k Ohm With SPDT
50-293-133
The 50-293 is a Programmable Resistor card with either two channels of 16-bit or four channels of 8-bit resistor chains in a single PCI card. The card is ideal for simulating sensors for control and management systems under test, allowing the user to verify system response in design verification or manufacturing test applications.
-
product
Humidity and Temperature Transmitter
T3111Ex
Relative humidity, temperature sensors at probe on the cable. Measured values are also converted to other humidity interpretation: dew point temperature, absolute humidity, specific humidity, mixing ratio, specific enthalpy.
-
-
product
ATEX approved Temperature Products
ATEX approved Temperature Products including transmitters such as the SEM210X universal input, TTR200X for RTD sensors and TTC200X for Thermocouple Sensors
-
product
Special Use Sensors
Structures can, and do, break, and this may be important and sometimes dramatic. It’s critical to determine whether a particular object made from a particular material can carry a particular load. If a true stress is ignored, the cost of not acting is usually far higher than the cost of dealing with the problem earlier. A good example is in ductile materials. The crack moves slowly and is accompanied by a large amount of plastic deformation around the crack tip. The crack will usually not extend unless an increased stress is applied. Geometrical irregularities, such as cracks, sharp corners and holes – which many times are ignored – may raise the local stress.
-
product
PXI High Density Precision Resistor Module, 6-Channel, 4Ω to 2.97MΩ
40-298-051
The 40-298-051 is a high density programmable resistor module with 6 channels which can be set between 4Ω and 2.97MΩ with 0.25Ω resolution The 40-298 range provides a simple solution for applications requiring accurate simulation of resistive sensors. The 40-298 is available in a variety of resistance ranges and resolution capabilities that meet the needs of most functional test systems.
-
product
PCI Precision Resistor Card 9-Channel, 1Ω To 239Ω
50-297-113
The 50-297 provides a simple solution for applications requiring accurate simulation of resistive sensors. The 50-297 is available in a variety of resistance ranges and resolution capabilities that meet the needs of most functional test systems. It is particularly well suited to applications such as the testing of engine controllers where resistive sensors provide information on parameters such as temperature.
-
product
Handheld Laser Power & Energy Meter
Nova ΙΙ 7Z01550
*Compatible with all standard Ophir Thermopile, BeamTrack, Pyroelectric and Photodiode sensors.*Large, high definition LCD display.*Both digital and analog needle display.*USB and RS232 output to PC with Statistics package.*Select between English and Japanese interfaces*Analog output.*Soft keys and menu driven functions with on line help.*Log every data point at up to 4000Hz with pyroelectric sensors.*Non-volatile data storage up to 59,400 points.*Laser tuning screen and power log.*2 position kickstand.*System Integrator Tools included: LabVIEW VIs, COM Object Interface.
-
product
Liquid Calibration Baths
Designed for calibration of temperature control devices that contain hazardous or corrosive fluids. Meets Class 1, Division 1 requirements for operation in a hazardous environment. CSZ explosion proof liquid calibration baths are designed to calibrate a large number of temperature sensors which contain a variety of different types of hazardous fluids. The sensors are typically calibrated in the same fluid used in the sensing element of the control devices per specification.
-
product
Motion Reference Units And Wave Sensors
MRU And WS
The Motion Reference Unit (MRU) product line was first released in 2004 when Inertial Labs MEMS-based sensor solutions began to compete in performance with traditional FOG units. Easy integration of the MRU product line for the end user means competitive performance at no extra cost.
-
product
Surface Temperature Sensors
Campbell Scientific offers two types of surface temperature sensors: infrared temperature (non-contact) and surface contact. Infrared temperature sensors measure the surface temperature of an object or surface by sensing the infrared radiation given off by the subject. Surface contact sensors attach directly to a surface and measure the temperature via physical contact.
-
product
DAQ Systems
Data acquisition systems (DAQ or DAS) collect information from connected sensors and other instrumentation to measure and record electrical and physical quantities, such as voltage, current, temperature, strain, pressure, shock, vibration, distance, displacement, RPM, Angle, and weight. A DAQ System typically consists of sensors, measurement hardware with signal conditioning and an Analog-to-Digital converter, and a computer with programmable software for data logging and analysis.
-
product
Proximity Sensors
600 Series
600 Series Proximity Sensors are active digital sensing devices that generate one pulse per pass of an actuating target within their sensing field. No direct contact with target material is necessary. Each sensor is entirely solid state with no moving parts to wear out.
-
product
Navigation & Sensors
Honeywell Aerospace Technologies
Honeywell is a trusted leader with decades of experience engineering and manufacturing high-performance navigation and sensor products for commercial, defense, industrial and space applications.
-
product
Digital Gauge Pressure
ZET 7012-I VER.2
ZET 7012-I VER.2 digital gauge pressure (open membrane) is used for fast and simple overpressure measurements and measured values data transfer in digital format via RS-485 or 4-20 mA interface. ZET 7012-I VER.2 digital gauge pressure (open membrane) is intended for integration into various technological processes automated control systems. Open membrane type enables sensors operation in viscous, pasty and rapidly polymerizing environments.
-
product
Test Pattern Generator Delay & AV Sync Analyzer
VQDM-100
Versatile compact and robust multi-purpose tool for R&D and glass-to-glass QA/QC Instant visual-aural quality estimation plus automatic latency, AV sync and 3D LR sync measurement Multi-channel time-line analysis, including video frames continuity testing 4 Light Sensors with vacuum caps, 4 Audio inputs (standard line levels) 2 channels of AV timing analysis, simultaneous measurements of Video and Audio Latencies Real time multi-channel data acquisition via USB port Unique sophisticated set ...show more -
product
Color Sensors
Leuze electronic GmbH + Co. KG
Color sensors detect colors by comparing the detected color value with a previously stored reference value. They are the right solution whenever the color of an object or marking can serve as a sorting or inspection criteria. Depending on the configuration and specified tolerance values of the system, the result is output as a switching signal.
-
product
Visibility Sensors
Campbell Scientific offers visibility sensors that use infrared forward-scatter technology. These sensors report meteorological observable range (MOR) for fog and snow. Visibility sensors are often used in road, marine, aviation, and wind-energy applications.
-
product
Software / Data Management
Provides a central hub for a facility monitoring system. The Processor communicates with cleanroom sensors, including particle and microbial monitors, while buffering data and checking tolerances for alarm activation.
-
product
PXI Three Channel Function Generator
Our PXI Function Generator is capable of generating sine, square and triangle waveforms to 10MHz with 48-bit frequency resolution referenced to the 10MHz PXI clock or to an external standard. It can generate fast swept frequency signals, permitting the output to emulate the operation of variable speed devices. The module can also generate arbitrary waveforms loaded into its internal 256k memory, allowing the emulation of many waveform types including the typical waveforms of automotive and aerospace sensors.
-
product
Automotive Sensor & Control Devices
We supply a variety of automotive sensors, infrared cameras, and molded parts made from metal, resin and other materials to the automotive and transportation equipment industries, contributing to vehicle safety, comfort, and fuel economy.
-
product
Systems Tool Kit
STK
STK is a free 2D and 3D modeling environment used by engineers, mission analysts, operators and decision-makers from more than 700 global organizations to model complex systems (such as aircraft, satellites, ground vehicles and their sensors) to evaluate their performance in real or simulated time. Built on a time-dynamic, physics-based geometry engine, AGI software answers fundamental questions essential to solving dynamic analysis problems
-
product
*Irradiance And Dosage Sensors
This sensor family provides cosine corrected irradiance measurement in W/cm² and dosage measurement in J/cm². The sensors are calibrated over their entire spectral range, and are thus ideal for irradiance and dosage measurement of UV, VIS and IR LED based light sources
-
product
Voltage Input Device For FieldDAQ
The Voltage Input Device for FieldDAQ measures up to eight ±10 V channels with 24-bit resolution and simultaneous sample rates up to 100 kS/s/ch. Some models can power sensors, such as pressure sensors, with up to 24 V per input channel. This device offers 500 V channel-to-channel isolation, protecting instrumentation from high-transient voltages. Additionally, the device is IP65 and IP67 rated to be dust-proof and water-submersible, can operate in -40 °C to 85 °C environments, and can sustain 1...show more -
product
Radar solution for positioning drilling rigs
With OndoSense radar sensors, the distance between the drilling tower tip and the drilling unit can be determined quickly and accurately. This allows the drilling rig to be precisely aligned and the penetration depth of the drilling unit to be reliably determined.
-
product
Computer Vision and Visualization
Fraunhofer Institute for Telecommunications
The Computer Vision and Visualization Department consists of three research and development groups working on innovative technologies in the field of monocular, stereoscopic and multichannel video processing. It covers the entire processing chain from original capture to rendering, with a focus on advanced 2D and 3D analysis, post-production synthesis, computer vision, image understanding, human-machine interaction, and immersive media , The department also has expertise in processing complex systems consisting of multiple cameras, sensors, displays, projectors or screens.
-
product
Pressure Sensor
Futek Advanced Sensor Technology, Inc.
Pressure Sensors manufactured in US by FUTEK Advanced Sensor Technology (AST), one of a handful of companies producing high quality pressure sensors, using metal foil strain gauge technology. Metal foil Strain-gauge technology is one of the most common types of pressure sensors in the market and is also commonly known as pressure transducers.
-
product
Optical Metrology
Complex measurements can be performed quickly and easily with optical measuring solutions from ZEISS. With a high degree of automation and state-of-the-art sensors, they reduce operating errors and guarantee high measuring accuracy.
-
product
Condition Monitoring
m+p Coda is a versatile monitoring system that captures and records signals coming from sensors such as accelerometers, thermocouples, strain gauges, and pressure transducers. Limit checking and alarm monitoring is provided for every active channel. The active channels are clearly displayed in a separate window, out-of-limit data can be seen at a glance. Alarm events are entered into a log file and can be reviewed at any time. You have the option to change the alarm limits online at any time without stopping the data acquisition.
-
product
General Data Acquisition Device With Strain Gage Measurement
Spider-80SG
The Spider-80SG is a high precision, general purpose data acquisition device featuring strain gage measurement. This device can be used in a variety of physical and measurement tests. The Spider-80SG can acquire data from a strain gage or a wide range of measurement quantities. A variety of general purpose and strain gage based sensors are supported.
