Showing results: 271 - 285 of 683 items found.
-
310120146 -
Virginia Panel Corporation
*Please note: Consult procedure sheet/user manual for information regarding slight slide mechanism bracket protrusion downward into next U height on test rack on both sides of receiver.
-
ICS Electronics
ICS's 2363 Serial Digital Interface provides a fully enclosed parallel interface that is suitable for benchtop or rack mount applications. OEM board versions available for inclusion in test chassis.
-
ICS Electronics
ICS's 2363 Serial Digital Interface provides a fully enclosed parallel interface that is suitable for benchtop or rack mount applications. OEM board versions available for inclusion in test chassis.
-
Rapidox 2112 -
Cambridge Sensotec Ltd
The Rapidox 2112 Multiplex is housed in a 19″ rack mount unit and allows a programmed sequence of gas samples to be fed to a single gas analyser, thus saving money and space requirements.
-
cPCIS-6230R/ 6240R Series -
ADLINK Technology Inc.
The cPCIS-6230R and cPCIS-6240R Series sub-systems are designed for 6U cPCI boards with 80mm RTMs and are suitable for computer telephony applications. The chassis is 2U height and standard 19" rack mount width.
-
MS-500 series -
NF Corp.
The MS series is suitable for pre-processing analog signals.The plug-in units of filters, differential amplifiers, isolation amplifiers, etc. can be installed into their frames.(16 channels at maximum/the JIS rack size)
-
63-924-001 -
Pickering Interfaces Ltd.
This chassis mounting kit is designed for use with the our 8-slot PXI chassis (40-924) and our 7-slot LXI modular switching chassis (60-102D), allowing installation into a standard 19" rack.
-
ELMA Electronic, Inc.
Elma Air Transport Rack (ATR) enclosures offer a standardized, cost effective solution for VME, VME64x, CompactPCI, VXS, VPX and Small Form Factor (SFF) based applications.
-
Joule Technologies
Joule mechanical design and manufacture capabilities allows us to create other custom projects to meet your test needs. Joule can design burn-in racks, jigs and stand-alone test station.
-
310113395 -
Virginia Panel Corporation
The 19" rack mounting panel offers three mounting positions for the G2 receiver without the hinging feature and is beneficial in cases where you may want to restrict wiring or instrument access.
-
Virginia Panel Corporation
Platform solutions offer all the benefits of VPC rack panel solutions plus a table for ITA fixtures. This table allows easier engagement, proper alignment, and takes up minimal space.
-
310113328 -
Virginia Panel Corporation
The G18 9U Vertical Hinged Mounting Frame accommodates an 18 module receiver in a PXI chassis within a rack. This is designed for exclusive use with a VPC G18 receiver #310 120 101.
-
cPCIS-6418U -
ADLINK Technology Inc.
The cPCIS-6418U Series Subsystem is designed for maximum density and has 8 horizontal slots for 6U cPCI boards with 80mm RTMs. The chassis is 4U in height and standard 19" rack mount width.
-
310113727 -
Virginia Panel Corporation
The receiver backshell is used with the i1 Receiver. It is not mounted to a rack or panel. The backshell provides protection for exposed wiring and is ideal for use with the i1 Receiver and ITA when used in a cable-to-cable application.
-
310113341 -
Virginia Panel Corporation
This G6 Vertical Hinged Mounting Frame is for use with standard rack or PXI chassis. These mounting frames attach to flanges supplied by the chassis manufacturer and allow the receiver to hinge down for wiring access.