Water Spray
See Also: Water, Water Quality, Water Meters, H2O, Wastewater, Underwater, Water Leak, Water Flow, Sea, Subsea
-
Product
Benchtop Water Quality Meters
LAQUA F-72
-
Water quality analysis is repeatedly performed in laboratories on a daily basis. Our high-end benchtop model was developed to provide simplicity with excellent on-site usability - from operation and maintenance through to troubleshooting.
-
Product
Multibeam Echosounder - Shallow Water
SeaBat T20-P
-
The ultimate combination of portability and performance. With the SeaBat Portable Sonar Processor mobilization time is reduced to help you focus on getting the job done. Fully adaptable to a wide range of applications the T20-P uses compact low-weight transducers in a 1°x1° configuration. The Portable Sonar Processor is water resistant and is capable of time tagging typical support sensors.
-
Product
Safety Test Panel for Water Cooler
-
Electrical Safety is the most primary and essential product conformity requirement for any product that uses electricity. The clauses of safety testing of electrical products laid by worldwide agencies such as UL, CE, BIS, etc. are stringent. The products need to pass through tests such as the high voltage test, insulation resistance test, earth bond test, leakage current test and so on. And to conform to such tests, SCR Elektroniks have developed for the testing of washing machines. In addition to the conventional safety tests, test for performance is also included.
-
Product
Water Hydrazine Analysis
AHM550
-
Prolonging boiler operating life and reducing unplanned maintenance through accurate hydrazine dosing.The Navigator 500 Hydrazine analyzer provides a continuous measurement of the level of hydrazine in boiler feedwater, enabling the chemical dose to be controlled automatically. This avoids both the expense associated with overdosing and the costly corrosion damage caused by under-dosing.
-
Product
1650 HP Water Brake Chassis Dynamometer
TD-36X3
-
Weight Capacity: 30,000 lb (13,608 kg) per axleRoll Brakes: Pneumatically-actuated discShipping Weight: 22,000 lb (9,979 kg)Capacity: 1,650 hp at 45 mph (1,230 kW at 72 kph)Rolls: 36 by 31 in. (915 by 787 mm) 6 fixed rolls to accommodate axle spreads from 48 to 74 in. (1,219 to 1,880 mm) tandem centers and 50 to 64 in. (1,270 to 1,626 mm) tridem centersPit Required Depth: 35 in. (889 mm)
-
Product
Handheld Water Quality Meters
LAQUA PC220
-
- Automatic pH calibration - up to 5 points (NIST, USA pH buffers) / up to 6 points (DIN pH buffers)- 0.01 pH resolution- Offset and average slope display- ORP calibration option- Automatic / manual temperature compensation and temperature calibration function- Automatic (up to 4 points) and manual (up to 5 points) conductivity calibration- Adjustable reference temperature and temperature coefficient- Adjustable cell constant and selectable measurement unit- Conductivity and total dissolved solids (TDS) conversion- Four (4) TDS calibration curves for wide range of applications: EN27888, Linear, 442, NaCl- Two (2) salinity calibration curves: NaCl, Seawater- With real-time clock and date/time stamp for GLP compliance- Auto log data; built-in memory can store up to 1000 data- Auto shut-off (programmable: up to 30 minutes)- Auto stable, auto hold, and real time measurement modes- Calibration alarm (programmable: up to 90 days)- Built-in electrode holder allows 2 electrodes to be attached - Monochrome LCD with white LED backlight: 50 x 50 mm- Phono jack output for connecting meter to computer via PC (USB) cable for data collection and to printer via printer (RS232) cable for printout - Casing is IP67 waterproof/dustproof, shock & scratch resistant, non-slip- Powered by 2 x AA batteries- Packaged with electrodes and calibration solutions in carrying case- 3 years meter warranty
-
Product
Water pressure principle logger version wave height meter
INFINITY-WH AWH-USB
-
Infinity-WH is provided with a high capacity storage memory that enables 0.1 s sampling, allowing you to observe a variety of wave heights, from short to long period waves. With 20 min measurements per one-hour burst (12,000 samples with 0.1 s intervals), the instrument makes one-month long continuous measurements possible.
-
Product
Benchtop Water Activity Meters
AQUALAB
-
Measure water activity with an average 5 minute read time and ±0.003 aw accuracy.
-
-
Product
Water Vapor Permeability Tester
WPT-304
-
WPT-304 Water Vapor Permeability Tester is manufactured based on the gravimetric method and is applicable to test the water vapor transmission rate of plastic films, composite films, sheets, and other materials used in packaging, medical and constructive industry.
-
Product
Snow Water Equivalent and Snow Depth Sensors
-
Campbell Scientific offers two types of sensors for snowpack applications: snow water equivalent (SWE) sensors and snow depth sensors. SWE sensors measure the amount of water contained within a snowpack. Snow depth sensors measure the depth of the snowpack.
-
Product
Water Conductivity and Temperature Probe
CS547A-L
-
The CS547A is a water quality probe that measures both electrical conductivity (EC) and temperature. It connects to a Campbell Scientific datalogger via the A547 interface. This probe is compatible with most Campbell Scientific dataloggers.
-
Product
Water Quality Monitoring Systems
-
We provide instrumentation, test kits, and chemical reagents used for monitoring water quality in a variety of applications. Primary applications used within our industry include drinking water, wastewater, and ballast water.
-
Product
Handheld Digital Multimeter, 4.5 Digit, Water and Dust Resistant
U1272A
Digital Multimeter
Feature sets that meet traditional industrial requirements and improve productivity and safety Improved accuracy and resolution to meet traditional industrial requirements (30,000 counts resolution with 0.6% for ACV accuracy)Intelligent features to improve productivity and safety (LPF, ZLOW, Smart )Better grip Both visual and audible continuity indication in noisy environments Easy access to fuse for simplified maintenance Easy connectivity to PC and internal memory (up to 10,000) for data logging Large rotary switch and buttons that are easy to operate Dust and water resistant casing (IP 54 compliant)Compatible with U1177A/U1117A IR-Bluetooth adapter for remote monitoring & datalogging Altitude: 3000 meters
-
Product
Water Quality Test Kits
-
The range of model shapes, sizes and capabilities of water quality test kits reflects the diversity of potential end users, who could just as easily work for a small laboratory as for a giant water treatment plant. The simplest water test kits are pocket-sized and measure only one water-quality parameter, such as pH or conductivity. A step above these water test kits are test kits able to measure multiple parameters, including total dissolved solids and dissolved oxygen. A bit higher up the price-performance curve are industrial-quality handheld water test kits that measure one or multiple parameters, and may even log the readings to enable trend analysis.
-
Product
Testing Released Water Vapor
Humiditest™ Complete System
-
The James Instruments Humitest System allows the concrete practitioner to monitor and ensure that a new structure is dry enough to proceed with the next phase of construction. This is especially critical for concrete structures requiring a coating, carpeting or similar floor or covering treatment. Installing such treatments before the concrete is sufficiently dry will typically cause expensive failures in the covering treatment. The only accurate way to ensure that the concrete is sufficiently dry enough to safely avoid expensive re-work is via a bore hole humidity test system, such as the Humitest System
-
Product
Benchtop Multi-Parameter Water Quality Meters
-
Labodam benchtop multi-parameter water quality meters come with different measurement modes for quality and testing of water on different parameters such as pH, conductivity, TDS, salinity, and resistivity content from the test sample.
-
Product
pH Pocket Water Meter
LAQUAtwin pH-11
-
The only pocket meter that directly measures pH in 0.1ml sample (or 0.05ml sample with sampling sheet B). Unique sensor allows measurement of viscous liquids, solids, and even powder samples. No need for a beaker to calibrate your meter or measure a sample. Just place few drops of the standard or sample onto the flat sensor. This procedure saves you time and prevents wasting your precious sample.
-
Product
Drinking Water Panel
-
The user-friendly multi-parameter measuring system for drinking water monitoring: New solution – consisting of proven WTW measuring technology.
-
Product
Electromagnetic Water Meter
WATERFLUX 3070
-
WATERFLUX 3070 is the first battery powered water meter for the drinking water industry that is capable of measuring flow, pressure and temperature with one sensor. Communication via Modbus RTU or pulse.
-
Product
1100 HP Water Brake Chassis Dynamometer
TD-36
-
Weight Capacity: 30,000 lb (13,608 kg) per axleRoll Brakes: Pneumatically-actuated discShipping Weight: 13,200 lb (5,987 kg)Capacity: 1,100 hp at 45 mph (820 kW at 72 kph)Rolls: 36 by 31 in. (915 by 787 mm) 4 fixed rolls to accommodate axle spreads from 48 to 74 in. (1219 to 1880 mm) tandem centersPit Required Depth: 35 in. (889 mm)
-
Product
Extended Range Shallow Water Multibeam Echosounder
SeaBat T50 Extended Range
-
The SeaBat T50 Extended Range is the very latest addition to the leading SeaBat T-series product range, engineered from the ground up to evolve with your business. Combined with a very compact Rack-mounted Sonar Processor (RSP), the SeaBat T50 Extended Range produces unprecedented clean data, at unprecedented resolution, providing faster operational surveys and reduced processing time.The SeaBat T50 Extended Range is fully frequency agile from 150 to 420 kHz, allowing for extremely high resolution surveys in very shallow waters and with the capability to operate out to about 900m water depth!The Rack-mounted Sonar Processor comes with an optional industry leading fully integrated Inertial Navigation System for accurate sensor time tagging and motion stabilization.The SeaBat T50 Extended Range is designed for very fast mobilization on any type of survey vessels, securing minimal interfacing and low space requirements – or it can be installed as a permanent installation in a sea chest or on a hoist system.
-
Product
LC/MS/MS Method Package For Water Quality Analysis
-
Shimadzu provides method files, including pre-registered MRM parameters with optimized quantitative and reference ions, LC separation parameters, and retention times and peak identification parameters for each compound, as well as report templates for outputting quantitation results, as a package. If retention times are adjusted when the system is introduced, based on the HPLC configuration delivered, the analysis process can be started as soon as the specified columns, mobile phases, and standard samples are supplied.
-
Product
Field-installation Type Residual Chlorine Meter (Four-Wire Transmission, Water flow beads)
HR-200
-
HR-200 is connected to a residual chlorine sensor (RA-20), which allows the free residual chlorine concentration to be measured with high accuracy. It is sutable for waterworks, pool water sterilization, and desalination systems. The measurement method is a three-pole polarographic method, which enables continuous monitoring of residual chlorine concentrations without using reagents. Stable measurement over a long period was realized by physical polishing cleaning using beads.
-
Product
Salt Spray, Salt Fog & Cyclic Corrosion Testing
-
We service most industry segments with harsh environment, salt fog corrosion testing.If your product is coated or painted for the marine, automotive or military industries, we are equipped to provide accredited testing within multiple chambers.We provide ASTM sample preparation for coated and painted articles to ensure that your test is performed correctly.We also provide custom configurations with varied salt concentrations and temperatures for many customers with products that are used in unique environments. Products like circuit boards, electronic devices and sensors may all have specialized testing requirements.
-
Product
Water Meters
-
Conductivity meters are used to analyze the conductivity of a substance, usually reported as an inverse function of resistivity. ‘Resistivity’ is always measured in ohms/cm. ‘Conductivity’ is measured in mhos/cm.
-
Product
Multiparameter Water Quality Probe
Model GEO-AQUpro
-
Up to 11 sensors (9 + temperature and pH ref) from the following list: Temperature, Optical Dissolved Oxygen, Specific Conductance, Salinity, Total Dissolved Solids (TDS), pH, ORP, Depth, Turbidity, Chlorophyll a, Rhodamine, Blue-Green Algae, CDOM / FDOM, Optical Brighteners, Tryptophan, Fluorescein, Refined oil, Crude oil, Ammonium, Nitrate, Chloride, Sodium, Total Dissolved Gas (TDG), up to 5 User Configurable Parameters (calculated e.g. TSS).
-
Product
IEC60529 IPX5/6 Water Jet Nozzle
-
Shenzhen Chuangxin Instruments Co., Ltd.
IEC60529 IPX5/6 Water Jet Nozzle is designed according to the requirements of IPX5 and IPX6 code of GB4208 and IEC60529 standard. IEC60529 IPX5/6 Water Jet Nozzle is used to test the waterproof performance of the appliance and electronic. The IEC60529 IPX5/6 Water Jet Nozzle consists of a jet handle that is equipped with a pressure gauge and an easy-to-adjust flow valve. The interchangeable nozzles assemble easily to the jet handle. The nozzles are made from stainless steel.
-
Product
Multibeam Echosounder with Built-Ins - Shallow Water
SeaBat T20-R
-
The SeaBat T20-R is a new addition to the world-leading SeaBat T-series platform engineered from the ground up to evolve with your business.Combined with a Rack-mounted Sonar Processor (RSP), SeaBat T20-R provides uncompromising survey data in a highly compact package designed for small vessel use.
-
Product
Water Cooled Active Resistance DC Electronic Load
WRx Series
-
Utilizing Magna-Power’s new patent pending Active Resistance Technology in combination with the company’s internally manufactured microchannel water-cooled heatsinks, the WRx Series addresses high power DC applications where exhaust heat control is essential. The WRx Series greatly increases power density compared air-cooled alternatives. An integrated solenoid controls the flow of water to avoid condensation. Full power can be achieved using conventional water, with water inlet temperatures up to 25 °C.
