Human Body
See Also: Human, Human Body Model, Face, IEC 61000-4-30
-
product
Temperature Logger For Human Body Range
HBTS 2.0
The HBTS is designed to monitor the temperature of parts, gas or liquids associated with intended/unintended heat to the patient. High accuracy and resolution is achieved in a range of 0-75°C. Typical standards are IEC 60601-1 (Table 24), IEC 60601-2-18 (endoscopes), IEC 60601-2-19 (infant incubators), IEC 60601-2-21 (radiant warmers), ISO 80601-2-74 (humidifiers).
-
product
human body vibration module
Human and Whole Body Vibration TestingThe human and whole-body vibration module tests and measures the effect of vibration on the human body. The extracted parameters allow the simple assessment of the injuries risk for workers, exposed to constant vibration. Our solution supports the whole-body and hand-arm vibration measurement are supported according to all relevant international standards - ISO 5349, ISO 8041, ISO 2631-1 and ISO 2631-5.
-
product
Static Tester
DRK151
Shandong Drick Instruments Co., Ltd.
The tester is applicable in testing the surface potential and the properties of anti-static products .This tester applies to test electrostatic voltage of charged object such as conductor, insulator, and the human body.
-
product
ESD Wrist Strap & ESD Heel Strap (Footwear) combination Tester
ESD Wrist Strap and ESD Footwear being the front line defense against electrostatic build-up on the human body, must remain electrically perceptive for the user. Thus, it is very important to test every wrist strap and heel strap regularly. This combination Tester does the job efficiently without the hassle of juggling several gadgets.
-
product
ESD & Latch-Up Test Service
MASER Engineering has automatic test equipment for the most common ESD test pulse models. MIL - JEDEC - ESDA - IEC standards. IC level Human Body Model. IC level Machine Model. IC level Charged Device Model. System level IEC 61000 HBM. AEC-Q100 Field Induced Gate Leakage test. Static Latch-Up test. Dynamic Latch-Up test.
-
product
3D Scanner
Artec Eva Lite
Eva Lite is the budget version of the bestselling white light Artec Eva 3D scanner. It features the same accuracy specs, but with reduced functionality: Eva Lite has geometry only tracking and capture. As a result, this affordable 3D scanner can be used for making high quality textureless 3D scans when scanning geometrically rich objects, such as the human body.
-
product
Pressure Mapping
BPMS
Measure pressure distribution between the human body and support surfaces such as seats, mattresses
-
product
Body Scanners
3D human body scanners obtain 3D images and models in seconds, making this an ideal solution for full body digitizing and human body modeling.
-
product
HBM Discharge Simulator
PSD-510
The PSD-510 is a low cost, light weight, battery powered Human Body Model (HBM) simulator designed to help customers determine the HBM ESD sensitivity of a device in accordance with ANSI/ESDA/JEDEC JS-001.
-
product
EST Thermal Cameras
Elevated Skin Temperature Thermal Cameras are designed for monitoring temperature changes of human body. As COVID-19 spreads across globe, human devote to find a way to retard or stop virus spread. Even though Elevated Skin Temperature Thermal Cameras cannot directly diagnose COVID-19, it still can control virus spread through monitoring the temperature changes of human body. Combined with mounting bracket, intelligent alarm system and professional analysis software, it is widely used in crowed public areas such as Airport, Shopping Mall, Railways, etc.
-
product
Manual Test Solution
Titan
Titan is an easy to use, low cost Human Body Model (HBM) or Machine Model (MM) manual test solution. It can be used for design, engineering, and characterization of your devices. Ranging from 50 V to 16,000 V the Titan will have the largest voltage range of any HBM tester.
-
product
EMR Testing
It is widely accepted that exposure of the human body to high levels of Electromagnetic Radiation (EMR), Electromagnetic Energy (EME) or Electromagnetic Fields (EMF) may lead to adverse health effects. To ensure the protection of personnel in the workplace and to protect members of the general public, it is essential that the EMR levels comply with relevant exposure limits set by regulators in each country.
-
product
Thermal Imaging Camera
TI160 - P5
TI 160-P5 is a special thermal imaging camera for human body temperature measurement only. Its has Accurate temperature measurement, real-time imaging, ability to quickly lock the hot-spot. It is been widely used in airports, docks,railway stations, schools, shopping malls and other public places to check human body temperature abnormalities. Palmetto design, compact and lightweight, integrated visible light function. Reliable performance and accurate temperature measurement can effectively improve the efficiency of detection.
-
product
SAR Testing
RF transmitters used in close proximity to the human body must be evaluated against human Exposure standards which set basic restrictions for the Specific Absorption Rate (SAR) of RF energy by any part of the human body. This may include two-way radios, cellular phones, smartphones, spread spectrum, Bluetooth devices, wireless EFTPOS terminals and WLAN devices used in PDA/notebook/laptop/tablet computers. In Australia and Europe, virtually all devices exceeding the power threshold of 20mW (13dBm) and used in close proximity to the human body must comply with SAR requirements. There is no such blanket exemption in the USA and Canada where each product must be assessed against frequency/power level criteria.
-
product
Non-Contact Temperature Measurement
These non-contact temperature measurement solutions are a diverse selection of industrial fixed, industrial handheld and human body temperature devices.
-
product
Transmission Line Pulse Testing
Transmission Line Pulse testing, or TLP testing, is a method for semiconductor characterization of Electrostatic Discharge (ESD) protection structures. In the Transmission Line Pulse test, high current pulses are applied to the pin under test (PUT) at successively higher levels through a coaxial cable of specified length. The applied pulses are of a current amplitude and duration representative of the Human Body Model (HBM) event (or a Charged Device Model – CDM – event in the case of Very Fast TLP, or VF-TLP).
-
product
UVB Logger Sensor
NUL-230
There are different wavelengths of ultra violet light. The UVB wavelength range is 280-320 nm, which is 2% of the total UV radiation. The UVB radiation affects the vitamin generation in the human body, the immune suppression, skin cancer and cataract. The intensity of this light is measured in mW/m2 (milliwatt per square meter).
-
product
Human Potential Measuring Instrument
KSD-4000 / KSD-4100
Electronic devices and metal tools carried by workers have individual capacitance to ground and are charged at human potential. When the charged electronic device touches the ground or a metal tool touches the electronic device, a transient current with a high peak current flows at high speed, Causing A Failure. By Using The Human Body Potential Measuring Device, The Potential Of The Human Body Can Be Measured Accurately, And It Can Be Immediately Determined Whether Or Not The Electronic Device Is Damaged By The Potential. You Can Also Find Out How Much Static. .. .electronic meters such as conductive floors, electrostatic mats, electrostatic shoes, and wrist straps reduce the human potential.
-
product
Active Dual Loop Antenna
KH30936
Beijing KeHuan Century EMC Technology Co,.LTD
KH30936 active dual loop antenna is used for adjusting, testing, measuring and other receivers. It has many advantages:1. The antenna coverage frequency is wide: 150KHz ~ 30MHz .2. The field strength value is measured according to the correction coefficient within the effective frequency range, which is convenient to use.3. The antenna power is supplied by the host, which is convenient for outdoor measurement.4. Compared with the single loop antenna, the advantage is to read the maximum value directly, which eliminates the tedious steps of rotating the antenna to find the maximum value and the interference of the human body to the signal.
-
product
SAR Measurements
SAR measurements, ie the measurement of the specific absorption rate, checks the amount of radiated high-frequency energy that a human body z. B. is exposed while using a mobile phone, laptop, data card. SAR measurements enable an assessment of the relative safety of radio devices with low power (low-power transmitters), which are used in close proximity to the human body.
-
product
ESD Testing & Latch-Up Testing Services
EAG is an industry leader in ESD testing (Electrostatic Discharge) and Latch up testing. Our highly experienced engineering team use their industry leading knowledge and years or real world experience of the latest semiconductor technologies, circuit design, and device physics to optimize our customer's ESD and latch-up results. Human Body Model (HBM) and Machine Model (MM), Charged Device Model (CDM), Latch-up, Transmission Line Pulse (TLP).
-
product
Tensile Strength Tester
DRK101C
Shandong Drick Instruments Co., Ltd.
DRK101C tensile strength tester is designed adopting modern mechanical design concept and human body engineering design criterion with advanced microcomputer processing technology .It has a novel design, excellent performance, and beautiful appearance.
-
product
Electrostatic Discharge Simulators
ESS Series
EMC test equipment to evaluate the resistibility of electronic equipment when electrostatic charges on a human body or object has been discharged to the electronic equipment.This product can be used for evaluating performance degradation of any types of electronic products.
-
product
ESD Test System
58154 Series
ESD (Electrostatic Discharge) Test Systems are PXI/PCI controlled module to simulate electrostatic discharge pulse during electronic device testing. The 58154 series offer both ESD STM5.1-2001-Human Body Model and ESD STM5.2-1999-Machine Model. The user friendly software offers programmable and flexible features, such as sampling test on a wafer, ESD model, ESD pulse polarity, ESD pulse interval in a sequence, and automatic testing function.
-
product
Human Body Temperature Measuring Thermal Camera
Zhejiang ULIRvisionTechnology Co., LTD
The infrared thermal imaging camera detects the infrared radiation emitted by human body and forms an image of the surface temperature distribution. The higher the temperature of the object, the greater the infrared radiation energy will be. The thermal imager obtains the temperature distribution on the surface of the human body through the received infrared energy. The following are our featured human body temperature measuring thermal camera.
-
product
ESD & Latch-Up Test System
Identify and help correct ESD and latch-up susceptibility issues on sensitive integrated circuit components prior to full-scale production with the Thermo Scientific™ MK.2-SE ESD and Latch-Up Test System. The MK.2-SE test system provides advanced capabilities to test high pin count IC devices to Human Body Model (HBM) and Machine Model (MM) ESD standards. The system’s pulse delivery design addresses wave form hazards such as trailing pulse and pre-discharge voltage rise, and performs Latch-Up testing per the JEDEC EIA/JESD 78 Method.
-
product
Human Radiation Spectrometers
Human radiation spectrometer is designed for express control and measurement of the activity of 137 Cs and 134 Cs gamma-emitting radionuclides in the human body, as well as for assessing the internal radiation dose (“sitting in a chair” geometry).
-
product
Vibration Meters
A vibration meter is used in manufacturing for machine condition monitoring, product testing and quality assurance. Many machine maintenance technicians use vibration meter devices in tandem with sound level meters to analyze frequency. A vibration meter also can be used in civil engineering to measure the vibration of structures such as buildings, roads and bridges. In addition, specialized vibration meter devices can be used to measure the vibration of the human body. Any vibration meter will measure one or more of the following parameters: vibration acceleration, vibration velocity (speed) and / or vibration displacement.A vibration meter is typically a portable device with a memory for storing measurements. Most vibration meter models feature a built-in data logger for collecting and recording vibration measurement data over time. In this way, vibration measurement data can be acquired with great precision.
-
product
Sensor Bodies
The armature - assembled sensor body - is the central component of an inline photometer. We have already designed more than 1000 different sensor bodies and more than 50 types are always on stock. All optek inline sensor bodies are made from high quality materials and are machined with extreme precision. The quality-tested manufacturing tolerances allow optical path lengths of up to 1000 mm, for which the accuracy of the incoming and outgoing light beam is ensured by testing a laser-based coaxiality tolerance test to the reference axis. To cover a wide spectrum of different process conditions, optek sensor bodies can be manufactured from various materials (also for aggressive chemicals or with NACE MR 0175) and adapted with regards to:
-
product
Body Neasurement App.
MySizeID
MySizeID offers shoppers the best online shopping experience. All a shopper need is a smartphone and MySizeID does the rest! Shopping for apparel online can be frustrating, but when shoppers know their RIGHT size, they can be confident that they are purchasing items that will fit them accurately, leading to increased loyalty and fewer returns. MySizeID uses patented technology and unique algorithms to capture a person’s measurements using smartphone sensors, without the need to use a camera. For more information about MySize patented technology contact us via email: contact@mysizeid.com
